Durango :: Grinding / Rattling Noise From Front Driver Side
Jan 9, 2012
At this point I'm baffled. I've been hearing a grinding/rattling noise from the driver side wheel well for a couple months now. I was positive it was being caused by a bad hub, but the problem persists. Here is what I've done so far:
replaced brake pads and rotors -- twice; once before the hub went bad and once after. The bad hub warped the driver side rotor and afterwards passenger side would not stop squealing for some reason. replaced faulty wheel hub -- The bearing was totally shot, nearly 20* of play in it, should be totally rigid replaced faulty CV axle -- I suspect vibration from the bad hub destroyed the outboard CV joint, making popping/grinding noise while turning or going over bumps filled front differential -- it was a bit low on gear oil The grinding/rattling noise shows up when driving at freeway speed (around 55mph) and gets more pronounced as speed increases. The truck does not do this under acceleration but after speeding up, the rattling is the worst at light throttle (around 2k-2.5k RPM, in 4th gear/overdrive above 55mph).
I noticed that if I shift into neutral at freeway speed, the noise continues until the truck decelerates.
So at this point my thoughts are that it could be a bad differential, but I doubt it because the noise is almost imperceptible in the passenger seat. It could be a bad differential bearing on the drivers side (sounds like a worn out bearing to me). It could be any number of things in the transfer case or transmission.
View 5 Replies
Advertisement
I have a 1996 Ford Explorer (4WD model). Approximately 4 months ago I had a new set of tires put on it, and in the process of replacing the tires the shop noticed that I had a bad ball joint and one of my wheel bearings was going bad. They said the ball joints were known for completely failing, but the wheel bearings usually didn't, so they recommended that the ball joint be replaced first. That is what I had them do. I haven't had the money to get the wheel bearing replaced yet. This past week it got worse to the point where I can hear it now.
At low speeds I can hear a grinding/rattling-type noise from the front drivers side (that's the side that has the bad wheel bearing). At higher speeds the grinding/rattling-type noise fades away due to road noise, but I can still hear a humming-type of noise that is a bit loader than normal - this noise just started a couple of weeks ago so I'm suspecting that this might also be related to the bad bearing.
I won't have the money to get this fixed for another 2 weeks. In order for me to have the money in 2 weeks I will need to continue working at my job 2 days a week. It's approximately 2 hours round-trip from my home to my job. Obviously with the bearing sounding significantly worse I don't want to drive it any more than I have to, but the only way I can get the money to fix it is to keep driving it back and forth to work.
Here's my question. What risks am I running by continuing to drive this? Am I running the risk of the wheel falling off while I'm driving down the freeway at 70 mph? Am I likely to experience other damaged parts in that area of the vehicle?
View 14 Replies
First issue started a few weeks ago. When turning left at a speed > 20mph or when turning wheel quickly I get a rattling noise, which is more prominent with the driver window down, so it sounds like it comes from the driver side front wheel, but not quite sure. It is fairly loud as I have had pedestrians look at my car when turning because they can hear the rattle.
Second issue started this morning but has persisted every time since. When the car is cooling down, we get that whirring noise, which I presume is thr coolant pump. That noise also happens now when I enter the car, and it is accompanied by a knocking noise as if somebody is hitting the outside of the car repeatedly. This is quite unnerving as it sounds like something is hitting the bodywork of the car. It stops immediately when the normal whirring stops.
I had the steering and water pump recall done in november last year, could this be related to that? Forgot ti add the car has done 49000miles....
View 14 Replies
I'm new to the forum and Excursion ownership but was hoping someone could save me some time and aggravation chasing a rattle in my 2004 2wd 6.0 PS. It seems to be coming from the front driver's side since I can feel it through the steering wheel. As of now, it's nothing major since it doesn't seem to affect tracking but I'm afraid it's getting worse.
I'm thinking it's a worn bushing but as I'm less familiar with the vehicle as y'all are, maybe you can point out the weak points that may be causing my issue. I plan on jacking up the front end tomorrow and inspecting for play. I'll let you know what (if anything) I find. Are there any known issues I should be aware of?
View 11 Replies
I have a 1996 Honda Accord (automatic) with just over 149,000 miles. In the 5 years since I've owned it it's required little more than some new spark plugs and tune up. I currently drive about 30 miles a week, but starting tomorrow I'll be driving much, much more to a new job. Living in Chicago with awful potholes, salt, and traffic, I'm concerned about what may happen in the near future...
I've been getting a grinding noise on the front driver side for years and have never fixed it and never noticed a change...I know it's the tie rod ends/ball joints. I've been warned that the wheel could come off, and as much as I believe them and don't want this to happen, nothing has ever happened. Is this something to do since there has been no change in symptoms or car performance in a couple years?
Other than that, any tips for keeping the car in good, working order? I do oil changes, but are they really necessary every 3000 miles? I have to make it last as long as possible and actually love the car anyway!
View 9 Replies
First off I have a 2009 F150 4wd 4.6L truck...we have noticed a grinding noise on the front driver side wheel...we have replaced the auto locking hub acuator and the hub assembly but the noise is still there....it has us puzzled now not sure what it could be. I have read many different threads on this issue an it seems that it might be something to do with the vacuum. The noise is only on the driver side and only in 2wd, when its in 4wd it doesn't make the noise at all. Also while in 2wd the noise seems to go away when we let off the gas.
View 5 Replies
A year ago I heard occasional metal grinding noise coming from the front, sounding like front driver side. Sounded like CV joints that I heard before. The mechanic said it's transfer case/transmission problem, so I replaced the transmission but the noise came back a few days later. The mechanic said to drive it for a while and the noise may go away, if getting worse he can fix it since it has 2-year warranty.
Now a year later the noise becomes predicable and easily reproducible, I went back and asked them to check. They said it may be passenger side axle. I am feeling being manipulated.
View 1 Replies
My wife's car has a grinding type noise (like a key being burnished on a grinding wheel, but lower in pitch). We've had our regular mechanic check the braking system and he finds no irregularities and also says that he didn't see any loose items underneath the engine area. The sound wasn't one of the ones on your excellent 'noises' list, however. The noise comes from the driver side at the front of the car. The car is 2002 Honda Accord LX with 135,000 miles on it. The transmission was replaced under warranty at 70,000 miles.
View 4 Replies
2011 F150 Limited 4wd 6.2 liter. I just bought the truck a few weeks ago with 26,000 miles. Late last week I began hearing a mild grind/rustling noise that appears to come from the driver's front. It's not terribly loud (loud enough to hear), but it's annoying. It happens when I slow down (on and off the brake and below 25-30 mph) as well as let off and begin to speed up. It doesn't last but a second after I let off the brake and speed up though. The kicker is it does not happen all of the time. I drove it home from work last night and it did not do it one time, but driving to work this morning it happened every time I did what I described above. I have taken it to our local tire/suspension shop and they claim they could not reproduce the sound which does not surprise me. They did a full inspection and found nothing.
View 14 Replies
I have a 2wd 2011 F150 90K with grinding noise coming from the drivers side front tire. Even though it was happening when coasting I thought it might be pads but they are real good. Turning the hub with no tire on it I can hear a little grinding. So I suspect bearings. I want to remove the hub but can't find out how to pull that off.
Where I would expect to find a spindle nut there is an area where it looks like you put a puller in. Can't find any videos or other information on the "Internets". Maybe I'm the first to have bad bearings? Anyway, how to remove the hub?
View 9 Replies
My 2006 AWD LTD 500 has about 52000 miles on it; a slight rattle/clunking noise is intermittently heard on driver's side in engine compartment. Took it in to dealer who says motor mount is cracked and front stabilizer bar joints are worn and both need replacing. Car has only been driven on highways or for short trips (3-4 miles) and has had no impacts nor been driven over rough roads or run over any potholes or such. Should the motor mount be damaged? At 52K miles?? Never heard of such a thing. Ditto, the stabilizer bar joints: worn out in under 60K miles? What can I do about this? Who seek relief from? Ford warranty is, of course, over, and supplemental warrenty will only cover motor mount replacement but not stab bar. Are these parts routinely wearing out at such an early date that repair shops can reap the rewards???
View 4 Replies
I've been hearing a rhythmic, metallic ringy grinding noise coming from the driver side front end of the car that seems to be in time with wheel rotation. It happens between 5 and 40mph, worsens while the steering wheel is turned even the slightest to the right, goes away completely during left turns, reduces and becomes intermittent above 45mph, and between 0 and 5mph, as I turn the wheel to the right from any position, I hear squeaking. I recently had the front control arm, ball joints and struts replaced. It has 140k miles. What could it be?
View 4 Replies
When I slam on my brakes there is a grinding noise coming from the front driver side wheel and the smell of rubber. Also when I do a u-turn the same thing happens. I own a 1999 Honda accord v6....
View 1 Replies
I leased a 2010 Honda Civic (non-hybrid) in March of 2010. I had to replace the front brake pads at 8K miles, 18.5K miles and now again at 27K miles. Each time, I get a screeching, grinding noise from the driver-side front wheel. At 8K, I went to a dealership (not the one where I got the car) who replaced them for free "as a courtesy" (apparently, brake pads aren't covered under the warranty). At 18.5K, I went to the dealership where I leased the car from; they said that it didn't look like the other dealer had actually performed the work (yet somehow, the screeching noise went away). They charged me $250 to replace the brake pads and buff the rotors. Now, at 27K, the screeching noise has returned. The dealership has warrantied their prior work and isn't charging me. They claim that there is nothing wrong with the braking system. When I asked them why the pads keep going after 9K miles, they said they don't know, and maybe its the way I brake. I do 80+% highway driving and while I do encounter stop and go traffic on a daily basis, I don't think this is normal.
View 6 Replies
I have a 2002 Ford Explorer Sport and after a brake job I noticed that while under braking at slow speed there would be a grinding sound on the front left. I replaced the brakes and wheel bearings the first time. After a while I ended up replacing the caliper itself but it still grinds. I don't notice any wheel shaking, pulling and it hasn't locked up although once I did notice a some smoke under hard braking but only once. I also don't hear any grinding while not braking.
View 5 Replies
I have a 2003 Impala. Over the past couple of months I have had an occurance every so often, very random with my front driver side brake. In both rain and dry conditions, braking hard and just slowing to break I will hear what sounds like grinding when I brake, like you do when the pads are gone. Well, I have had the car in and the pads and rotor are fine, the place I took it to even test drove it and tried but couldn't get the sound. I posted here a while back on this issue and the view was that it might be the ABS, but when this occurs the ABS light doesn't come on and the sound is just coming from the driver side front. What my next move should be?
View 7 Replies
I have a 4x4 5.2L 99 Durango. Everything was running great and the all of a sudden I started it to go to work one morning and it would not move. Now its making a grinding/whining noise when its not in park, it tries to move when I put it in gear but has the grinding/whining noise and is real sluggish. Then after its running for about 5 min it wont move or go in gear at all. I have had reg. transmission fluid changes and was running great. now this. Ive checked the fluid and its full to.
View 7 Replies
About 3 months ago I started having a grinding sound from the front driver side hub area. I replaced it and it fixed the problem. I read where you should do both because he other one is soon behind it but I waited. Now I started hearing it from the passenger side too. So I replaced it today and all was good until I tested it from 4 wheel back to 2 wheel. Once I went back to 2 wheel the clicking that sounds like bearings going out to me, was back. What is it?
View 1 Replies
I have a 2010 Prius 2 with 58K. A few weeks ago, mainly when turning right, my car makes a strange sound on the driver side (never on the passenger side). This noise is not very loud and almost sounds like two chains hitting. It usually makes this noise when I turn, but not every time I turn, and it usually happens when I first start driving.
View 3 Replies
Recently when I first start my car in the morning, there is a rattling noise, which sounds like it's coming from the driver's side of the engine bay, or possibly just under the drivers side door. It only lasts for a couple of minutes. It will increase I accelerate, and then decrease as soon as I lift off the gas. After a couple minutes, the rattling goes away, and everything is right in the world. Today I drove it around the block and parked while it was still rattling away. When I put it in park the rattling went away. I put it back in drive and it came back. Then as usual it finally went away whether in drive or park. I'm completely stumped on this one. It's an '08 2.4l GLS and has 138,000 miles.
View 9 Replies
My truck has an intermittent shake with a grinding/binding kind of noise. It seems to happen at lower speeds, generally when slowing down and turning. When I apply the brakes or speed up it seems to stop the noise.
The rubber/plastic seal on the back of the wheel hub is loose on both drivers and passenger side but I don't think that is the problem. I'm wondering if it is the u-joints or something.
The brakes look shiny and i don't see any scratches on them so I don't think there is a rock or something in there. I have the wheel hubs in the auto setting, and it is a 4x4. The truck is a early 99 7.3L with a leveling kit and 230k miles.
View 4 Replies
