Accent LC (2000-05) :: 2002 - Code P0121 / Idle Surging Between 1500 - 2500 Rpm
Apr 2, 2010
I have a 2002 Accent 1.6L 72K miles, idle surging between 1500 - 2500 rpm after stopping from 50 mph, (with Code P0121) replaced TPS - No Luck . I reset the DTS error codes, ran it with a new TPS and same exact problem, Code P0121 came back, and surging continued, this happens when I decelerate from high speed- 50 mph or so and it will not go to normal idle, surges between 1500 and 2500 rpm when in park.
If I give the throttle pedal a good kick, the problem goes away, and it idles fine, nice and smooth and at normal rpm, the DTS code will clear, and stays cleared, mil light goes out. It almost seems like something is sticking, I know its not the throttle itself because when I do a live data, the TPS shows "0", if I manually push the throttle shaft closed at the throttle body, it is fully seated shut, so I know its not a sticking cable or anything. Can a sticking MAF sensor cause this? Maybe what I'll try tomorrow is rapping the throttle body with a rubber mallet while its surging, maybe something is not returning to its normal position in there.
View 14 Replies
Advertisement
Granddaughter showed up with her '02 Accent idle varying between 600 and 2500 rpm. Disconnected Idle Speed Control Actuator and engine runs at very high idle so apparently the ECM is unsuccessfully attempting to manage the idle and the ISC is functioning. Reading P0507 code. Checked for vacuum leaks beyond throttle body, found none.
The car was involved in a fender bender accident a couple days before the idle issue. No CEL until a couple days after the accident. The varying idle started many days after the CEL.
The wreak cut a half dozen wires in the area outside of the battery. She repaired them and I just finished redoing with solder and shrink wrap. Found no faults with her twist and tape repairs or any other damage to wiring. Varying idle still there.
View 3 Replies
2001 1.5L 5-speed Accent
I did a search on this problem and found several people posted the same P0121 code. Strangely many people wrote that replacing TPS did NOT fix it. The code came back in 30 miles or so. Most of them didn't follow up what finally fixed it and only 2 people did by saying they got the code cleared by fixing/replacing:
1. Leak in the intake manifold, bad plug wires, etc.
2. New Head & ECM.
Is there any known fix for the P0121 on Accent 1.5L other than above?
View 8 Replies
My car is standard 5 speed transmission, when my car is running my idle varys between 800ish to 1500 intermittently within seconds and if I don't drive it after starting the car it will stall on me (in neutral) after the rpms go up and down about 9 times.
The thing I found is if I disconnect my idle air control valve attached to my throttle body it stops the jumps in rpm. I have tried replacing the valve with one of my friends control valve Hyundai accent 2004 that works and fits perfectly on his doesn't work on mine. Right now I have my idle air control valve disconnected at the moment but i want to fix this issue because my rpms are at 1300 at idle.
View 7 Replies
My 2008 Accent started to stutter between 1500 and 2500 rpms. Now the check engine light has come on, and the engine is idling rough.
View 3 Replies
My MIL is on!!!! I went to Autozone, they told me the error code is P0121. The car is running funny, with uneven idle, and bucking/not shifting.
View 6 Replies
Mechanics say they don’t know what wrong… I had some transmission work done on my truck – mostly an leak and replacing the harness – and ever since then after it rains or if we have a heavy dew my truck does the following:
Driving from O to 49 miles an hour truck is fine, as soon as I hit 50 the truck starts surging and you can see the tachometer jumping from 2000 RPM to 2500 RPMs. I drive around 17 miles to work where my truck will sit for seven hours. On the way home the truck is fine. I find this to be more of a problem when the truck has sat for a day or two over the weekend without driving it. Sometimes the “check engine” light will come on, sometimes not.
I have taken it to two different places and neither one says they can find anything wrong with the truck. I have driven this truck for over 11 years and know it very well. There is something wrong, but what? 1993 Chevy Silverado 3500 Diesel....
View 10 Replies
!995 honda accord, 5 speed. Idle is fine until the engine warms up, then fluctuates between 1500 to 2500 rpms. The idle control valve was cleaned- no change. Valve was also replaced -also with no change. Put old valve back on. Computer was disconnected after cleaning and also after each valve change.Would the next step be to remove and clean the fast idle thermo sensor? Also how do you check the coolant lines coming in. Anything else I would need to check, clean or replace.
View 2 Replies
My wife drives a 2002 Hyundai Elantra GT. Recently the car started idling very rough with rpm jumps back and forth from 1500 to 2500 rpm. The check engine light came on and threw a code for the IAC. I also notice a clicking sound coming from the engine and I can see sparks arching at the coil/plug wire. The arching is happening at the coil with the numbers 1 & 4.
The car is difficult to drive. It shakes and surges and isn't pleasant to drive at all. These issues started happening very recently. The car ran great up until now. We've stopped driving it for the time being until we solve the problem.
We had the car serviced a few years ago and they changed the IAC and mentioned something about a gray wire that we should watch out for.
I'm not really sure what the issue is. I don't know if it is the spark plugs, wires, or coil. Or it could be the IAC or something else. I'm comfortable working on the car myself, but I would rather not try fixing many things if it is just one thing actually wrong.
So far, the only thing I've tried is to spray some carb cleaner into the throttle body towards the IAC in hopes that it would clean it and solve my problems.
Where the IAC is located. I want to try remove and clean it, but I'm unsure of exactly where it it. I know it is somewhere on the throttle body or intake manifold, but I'm not sure exactly what I'm looking for.
View 8 Replies
Ok had a check engine light. It directed me to replace the IAT sensor.. After some research I found it was integrated into the MAP sensor. Purchased a new sensor and replaced. Drive about 15 miles CEL throws another code. P0106 (sensor i just replaced) faulty Map sensor.
Followed procedure to replace sensor.. unhook battery cable reset ecm. After reset engine is hard to start. Followed by RPM changes (assuming its the ECM re-adjusting). Then CEL flashes 5-6 times and goes out, Drive 15 miles. Map sensor code reappears. (note i only purchased one sensor But repeated install 2 times).
My thought is against wiring. since the codes refer to different signal wires one for IAT one for MAP sensor. Faulty replacement sensor?
2002 Accent 1.6L
View 3 Replies
I just replaced the front and back motor mounts on my 02, 1.6 automatic accent. The front replacement mount was 1/2 inch too wide at where the bolt goes through, but made do. Now, the idle, but that's it. Before, it was vibrating somewhat at idle and lots of steering wheel vibration at highway speed. Now, I have no vibration of the wheel at highway speed, so it's like I eliminated one problem and made the other worse. I am hoping that the mount being too wide is the problem as I ordered the correct one. While taking it apart, I also noted the bolt through the front motor mount is incredibly small compared to the hole and this was true on both the original and the too big replacement. Why is this? Assuming that I swap out the too big mount for the proper and it still vibrates, than what?
View 1 Replies
I would like to know if for the Accent 2003 there is a component that commonly fails and causes a P0108.
Vacuum seems to be ok. At least I can't find any leaks. Pressure at idle is normally at about 30kPa (4.3PSI). It ranges normally between 30 and 50kPa (7.2PSI). When the fault was set it indicated 125kPa (18PSI).
Sometimes the engine runs unstable at idle.
It seems to be an intermittent fault. If I clear the fault it can take about 2 days to reappear.
Otherwise I will have to go through checking the MAP sensor itself, wire harness, idle motor, is that about right?
View 7 Replies
2002 HD 2500 6.0 - Pulled into Wal-Mart, everything was fine. Came out 20 min later, started right up, but felt like it stalled, it was actually still running, (barely). Shut off, restarted, same. Used pedal to bump idle up to normal 500-600 RPM, it was smooth, no misfire or roughness. Drove home, approx 5 miles, and had to keep the idle up at every stop.
Could be IAC? How can I test it/What checks can I do in the darkness, by flashlight? No garage, but I do have tools, and basic test light, dmm, etc. First thought was fuel pressure, but it runs fine going down the road.
View 3 Replies
I have a 2000 hyundai accent and when i fill with fuel it surges like its running out of fuel and stalls when fuel is gets low it runs fine.
View 2 Replies
I have a 2002 Accent with 119,000 miles on it. Its an automatic transmission. When I am driving the car feels like it surging forward while I have the brake on...its doesn't happen all the time. But when it does it surges for half a minute, then run fine and then surges again.
View 3 Replies
I'm seeing the following symptoms in my 2001 Accent 1.6L:
1. Check Engine Light on;
2. Certain electrical functions occasionally surge. For example, headlights and dash lights will become noticeably brighter for a few seconds, and the heater fan will blow harder. The surges last for about 3 seconds, then stop. Surges happen randomly, sometimes four or five times during a 30 minute drive, sometimes not at all in an hour.
3. The speedo/tacho lights have been cutting in and out randomly for longer than this, and this does not happen at the same time as the surges above.
4. Recently, the surges became more frequent and the Air Bag light started going on, then off. Now it is permanently on.
5. The battery has leaked fluid out from the fill caps, a good few ounces of fluid.
6. There are no blown fuses.
7. The Battery is 6 months old.
8. The alternator is 6 months old, and is the third one after two previous ones failed; the original was replaced 3 years ago, and the replacement failed 2.5 years later.
9. A fried lead to the starting motor was found when the alternator was first replaced, and was repaired. Related?
View 2 Replies
I am having great difficulty trying to figure out why my truck is surging so bad in park or in gear at idle. I have to mat the brake while in drive to prevent me from ramming the car in front of me. It all started when I replaced the air filter. Everything I've read leads me to the EGR valve, but that has been bypassed.
View 14 Replies
I have a 2000 Toyota SR5 with a 6-cylinder engine. When I first start the car (cold start) in the morning it will run at high idle (1500-1800 rpm) for about 3-4 minutes. At this point, the idle will begin to drop, but then the engine starts to surge. It's a noticeable surge that bounces from around 900-1100 rpm. It almost seems like an electrical surge, but I don't believe that's the problem. After running the car for a while and it's fully warmed up to operating temperature, the surge goes away. My thoughts automatically went to the IAC (idle air control) or maybe a temp sensor?
View 3 Replies
I recently cleaned the throttle body and now it surges up and down. Not really sure what to check next. 2002 toyota camry 4 cyl.
View 3 Replies
My 2002 F150 (50,000 miles) 4.2 is surging when cold. I just got done replacing the pcv valve. I noticed it was running better so I cleared the service engine light, but now is surging when the engine is cold. I live in FL so it does not get that cold like up north. The following codes were the ones that the pcu put out, P1131, P1115, P0174 and P0171. I am leaning towards changing the IAC valve and maybe the oxygen sensors.
View 5 Replies
I was climbing up a hill on the highway, and I was aware of my issue by the time I hit the top of the hill - my car far into the red zone on the temp gauge.
I pulled over just after i got off, let it cool for a few minutes, check oil and coolant and they seemed fine (from what i could, but it was dark. Drove home because it was only a few mins away, and it had cooled a bit already, but it started sounding really weird at low rpms (1200-1500) almost a clanging noise.
Just as i was pulling into my driveway, there were a whole bunch of weird noises, and at least one of them was me losing coolant from the cap. Turned off the car and the coolant overflow box was completely full, and the radiator cap had leaked some too.
Some other things i noticed - sounded like boiling water inside the large hoses, hoses felt empty, and the coolant box emptied all of a sudden after the hoses sucks everything back up.
View 4 Replies
