Avalon 2005-12 :: Check Engine Light Remains On With Code P0327
Feb 14, 2015
I replaced the water pump. Huge problem. I will get rid of the car before I replace that again. But, it is replaced and the car is functioning.
Unfortunately, the check engine light remains on and I still get p0327(knock sensor) code and car has a slight ruff run.I have the Actron code reader(fairly cheap, but effective) and it will clear the vsc but not the check engine. Upon restart, the check engine light reappears in 7 seconds followed by the vsc symbol. This has been for a week now. So I have been dreading tackling this project next. But I figure if I'm doing this, I better change the rear plugs and maybe the rear coil packs as well.
Don't want to do this, but whether I do it or send it to the dealership, once is all I'm gonna do. I say all of this and yesterday, the check engine light goes away on its own and full power is back and ruff run gone.
I still plan to go into the engine this year because my car just hit 120,000 miles and i have to change my plugs. If it recurs, I will change it all. I will just wait. Only going in once.
View 3 Replies
Advertisement
So, I have my check engine light and the code is p0327 (knock sensor). Clear cose but it returns. Going on for 3 days now. I was suspicious that something else is going on. I also remembered I've been using a little more antifreeze in the reservoir. So, today I needed to watch the coolant. I ran the car for an hr and I found a lot. Red coolant on my belt, the back passenger side of my engine and it was caked on with coolant. I think the water pump is going up.
I was concerned that coolant was also leaking from the intake manifold but it's only the right side, so I'm pretty sure the coolant is being slung around from the belt. I rinsed the engine down and the knock sensor code went away. Temporarily, until more coolant got back there. Do you think I will need to replace the knock sensor along with the water pump or should the sensor work ok after some intense cleaning after the water pump replacement?
View 5 Replies
It came on yesterday and went out on it's own today then came back on later. The code is PO354. the manual says the "D" ignition coil primary is open or has a problem. I don't believe it because the engine runs fine. Opinions?
View 14 Replies
I have a CEL on my 2007 Avalon so I decided to take it to Autozone to get a scan. Error code P0015 was returned. This code has to do with B Camshaft Position, Timing Over Retarded (Bank 1). I've done a little research and I've read that this could possibly from a dirty screen on the Oil Control Valve, the OCV itself, or the Cam Position Sensor. Before replacing parts, what I would like to do first is to check/clean the screen on the OCV. Secondly, I would like to swap the Cam Position Sensor to a different bank and see if the other bank throws an error. If the other bank throws an error, then I know the sensor is bad and needs to be replaced. With this said, I am having trouble locating the OCV and CPS. Where the valve and sensor is located. A diagram would be useful.
View 14 Replies
My car just turned 85k miles. The day it turned 85k, I recieved a message from dealer saying their records indicate car is due for 85k service. Coincidence? Note: I do not have my service done at the local toyota shop. They have not seen car since last warranty work probably 2+ years ago.
Also at about this same time, the service engine light came on, (oil change needed). Since I only use mobil 1 in the car with genuine Toyota filters, I am not to concerned if the car gets another 500 miles on it while scheduling a service. However, this time, returning from a short trip on Sunday, the VSR (traction control) and the check engine light came on. Only Code is p0015 left bank. Monday, warning lights are gone, and oil change is scheduled for Wednesday.
Is the VSR and the P0015 related.
View 4 Replies
Check engine and VSC lights came on wife's car, took to dealer, they hooked up computer and now stating that the Evap system has a leak. They want to replace the Charcoal Canister and they are quoting $900.00.
View 5 Replies
I have a 2009 Avalon that is displaying a Check Engine Light and a VSC light. Is it possible it is doing so because I have two different brand tires on the front hankook and the back Michelin?
View 2 Replies
MY 06 Avalon has acquired a check engine light that goes on and off sporadically..mechanic states it was a misfire cleared the codes but now it has come back and then turned itself off only to come back again. Car 80k miles..needs tuneup ?
View 14 Replies
Do the check engine lights when you put the switch in the start position or as I know if working properly. I have a 2008 toyota avalon XL,
View 14 Replies
Took my 07 Avalon Touring to the dealer because of a check engine light. They replaced coil and plugs, but also told me unbalanced wheels had caused the computer to throw a code. As Click and Clack would say, this sounds bogus. I'm feeling no vibration and the wheels were balanced about 3 months ago.
View 3 Replies
My check engine light came on in my 06 toyota avalon. i had the code read at pepboys and they said it was something like 0300 misfire. i took it a few days later to my personal mechanic and he said nothing popped up when he tested the code. i notice the car (engine) is running a little rough though. What is the firing pattern as i want to try and fix by putting new plugs and coils.
View 1 Replies
My Avalon has 55,000 miles on it. when it is idling the motor seems to be very noisy. to me this isn't normal my service rep says there should be no problems if there is no check engine light on.
Should not be as noisy with such low mileage. dealers says if there is no problem and that is the way it is they will charge me for the diagnostic fee. seems like it's not right the way it sounds so what is everybody's opinion on this issue. Oil level is up and very good so just wondering if it could be very variable valve timing solenoid making noise.
View 4 Replies
I try to do my own maintenance. I have a 2006 Avalon Limited. This has happened twice recently, using cruise it has kicked off and gives me the VSC light and the check engine light and cruise error, when running codes I get the following P0138 & P2195 both have to do with the O2 sensor on bank 1, and P1578 & P1201 which are brake malfunction. I have been searching the Internet for any information on what could be causing my issue with no luck. I have a 3000 mile trip and need to figure this out soon.
View 14 Replies
I have an '05 I bought 3 years ago and any time it sits outside and gets rained on, the VSC/check engine light comes on when I start it and it doesn't go away for 2-3 days at a time. The frustrating part is that any time this happens, I get the E3 error with the cruise control even though there's not a drop of water to be found anywhere.
View 6 Replies
Weekend trip in the 09 Avalon and after stopping for fuel i end up with a check engine light and two codes P0014 and P0015, camshaft over advance bank 1. Cleared the codes but came back hours later. What am i looking at to correct this problem?
View 14 Replies
So I was on my way to work and i noticed my check engine came on. i get out of work and its still there. i go to the movies to watch friday the 13th (ok movie, worth watching in my opinion)...still on. i drive to my friends crib after to chill...still on.
View 2 Replies
I am having a hard time getting the low EGR flow check engine code to clear. The EGR valve and tube from the exhaust manifold were replaced, the wiring harness verified, the passage channel between the EGR valve and the intake manifold cleaned out...but the check engine light remains... what to try next?
View 12 Replies
I was going to look into getting a replacement EGR valve from AutoZone, which I did. After installing the valve and on my way to reset the check engine light, it went away and has not come back.
View 1 Replies
I bought a 2005 Volvo V70 with 75,500 miles on Nov. 13. On Nov. 15, the check engine light went on, and I returned to the dealership for a solenoid replacement. The check engine light went on again on Nov. 17, oil pan replaced. On Nov. 19, the light went on again, timing belt replaced. On Nov. 22, the light went on again. Each time the code was the same--sometimes in conjunction with other codes--but one code was consistent. We returned the car on Nov. 22 and asked for a refund in keeping with the Massachusetts lemon law (an attempt at repair 3+ times). The dealer refused, saying the check engine light and computer code were not the same as an attempted repair. He took the car and said he was going to call Volvo Tech in. However, he says the light "went off" and never came back on even though his staff has test driven it 170 miles in the past three days. He's "releasing our car" to us, even though he has made no repair. Tell me--is trying to address the same computer code considered a "repair"?
View 13 Replies
where best place to start looking for what's causing p0442 code on my 2005 rx330? and its not the gas cap... also have a "c" code identified for the VSC light, states that its wheel speed sensor. evidently wrote the wrong code down, i had it listed as a c1290 but in looking them up i couldn't find that one.
View 6 Replies
My 2005 Camry check engine light is on. The trouble code is P0138, bank 1 sensor 2 oxygen sensor. Engine is the 2AF-ZE. Not a California emission car. Car is Japan built. It has two O2 sensors. What is the correct OEM part #? I believe it would be a Denso?
View 2 Replies
