My 03 Camry is blowing cold air on the passenger side while the heat is on. The drivers side blows hot air as it should. The coolant is full. Its a 4cyl LE and does not have dual climate control.
View 14 RepliesI started my car and noticed that something under the hood was very loud. It sounded as if there was a large fan left on high and I was right. The passenger side radiator fan doesn't come on. The drivers side does though and yet there is no overheating! Ive taken short 15 mile trips here and there but the temperature gauge stays right in the middle. If i give this radiator fan motor a good whack with a screw driver, it comes right on. What it could be? Does it need a motor replacement? Could it actually be the relay if when I give it a whack, it comes on?
View 5 RepliesJust had the truck in the dealership for a bad blend door/ heater core case. Heat would only blow out warm on the passenger side, blows cold on drivers side. Dealership replaced the case, heat works normal on both sides now. It was a little warm out yesterday so i turned on the A/C, frosty cold on passenger side, warm on drivers side, temperature does change when i select different temperatures (dual zone.)
View 1 RepliesMy 2001 F150 4.6 threw the #3 plug on the passenger side while going down the road at 65 mph. It threaded back in and tightened up to make it the last 7 miles home. I have read that Time serts are the best option but I need this truck daily at work. Has anyone tried using the Heli Coil system as a temporary fix? I am going to order the Time Set kit but since I need the truck now, I was wondering if it were possible to pick up a Heli Coil and insert it until my Time Sert kit arrives?
View 5 RepliesI have an 2004 Camry XLE which just had the coolant flushed. Now I only have heat on the driver side. It blows cold air in the rest of the car. Temperature runs normal. Antifreeze is full. I can get more heat if I recirculate from the inside rather than bring in air from outside. It is zero in NY. Car never heats up on HOT!
View 2 RepliesThe vibration on my passenger seat is at any speed I notice noises coming from the front of the car like if something is loose, I took it to the dealer and they told everything it's fine and I told them that's b.s. what can cause my passenger seat to vibrate?
View 2 RepliesI recently moved from TX to MN and it's getting cold enough to need heat in my car. Well I've turned it on and nothing but cold air comes out. I've check my coolant level and it was getting close to low, so I added more and I've checked the fuses and they look good. So, what it could be or how i can fix it?
View 14 RepliesAfter fixing a misfire on cylinder 4 (bad plug) I find two other problems on a 2005 Camry I bought recently. It has 88k miles (bought at 85k) has new plugs, air filter, and oil changed recently.
When I start the car in the morning a puff of blueish smoke comes out and doesn't come back until it gets started again after getting cold. Has a strange chemical smell. Also when it starts it shoots up to 2k RPMs and slowly goes down to a notch below 1k after a minute or two.
The other thing is that when cruising at around 40MPH and just holding that speed the car will start to vibrate intermittently. Not just the steering wheel or anything, it's felt throughout the car. I also notice that the RPMs fluctuate slightly, just a notch up and down as the vibrations come and go. If I let go of the gas it stops, if I accelerate, it stops.
I have been having a problem with my 2002 F250 Super Duty 4x4. It started about 2 months ago. I was in traffic (truck hadn't even been on for 15 minutes). The temp gauge spiked, so I pulled over and turned the truck off. I turned the ignition on and the gauge was normal so I started it and all was fine.
Fast forward a little and every so often about every 3 weeks it would overflow (coolant) but not get to the point that it would overheat. I changed the thermostat and all seemed good to go. Fast forward to yesterday morning. Got in the truck and left to go hunting, and I didn't even make it 10 minutes down the road when I turned the heat on and it blew cold.
I started to see the gauge creep up so I pulled over and shut it down. Upper hose was cold, lower is cold and both heater hoses are cold. After some time of waiting, I started it but the gauge kept creeping up and no heat, so I kept shutting it down. After about 5x of this, the heat worked and the upper hose got hot and all was right with the world. SO I drove it home. Coolant is new, flushed about a month ago and was running great since then. Thermostat is new. Do I have a blockage somewhere? Water pump bad?
Recently bought 2002 Camry 2.4 .... Engine has a cold start rattle in the top passenger side. The noise stops after the engine heats up in about 10 minutes. I've changed the intake manifold.... Did not work. Looking for the OCV VALVE FILTER but cannot find it ....
View 2 RepliesMy car has 219k miles and has been very loud and when i turn it on the rpm meter goes to 3 and gradually car quiets down and needle comes down to 1. While i drive the steering wheel vibrates too. I took it to the mechanic i was told that timing chain needs replacement as its about time. I was under the impression that timing chains do not need replacement.
The steering wheel vibrates (shakes) it makes light clicking sounds too. I have not been able to diagnose the problem by myself. I think these two things may not be related but engine is really loud. Does timing chain needs replacement? and if it does what else along with it should be replaced?
My camry won't start I got a new battery and a new starter (they are both good) and it sill wont start.
View 4 RepliesOur Camry has about 105,000 miles on it. Car is well maintained, I change the oil every 3 k or so and the air filter is clean (although it is not a factory air cleaner- it is a K&N filter). Other maint is done as specified by the warranty/maintenance book although the car is long out of factory warranty.
We occasionally pull a 800 lb pop-up tent trailer and just got back from the Sierras after driving up some pretty tall passes with it. Car ran great, got great mileage, temp gauge rock steady. I say this because it is probably the most stressful driving we do with this car. While we live in the city we are retired and the car is not exposed to constant heavy traffic, dust or snow. Mileage seems to have remained pretty steady, even with the hesitation.
Got home from the mountains and a couple days later the car began to hesitate when under load. The hesitation shows up as a slightly uneven surge when the car is going up a hill or when it is cold. About 20 mph the car seems to momentarily stop accelerating, then evens out and upwards of 40 mph I don't feel it at all. The hesitation is getting a bit worse over the last couple days in frequency, but still isn't felt on the freeway. I don't know if the hesitation is related to the recent trip to the Sierras.
I hooked up my OBD II computer to see if there are any DTCs, none shown, even left the computer on the car for a day to see if anything might pop up when the car surged, but the computer isn't seeing trouble codes.
My other thought was "got some bad gas", ran the tank out and put in new gas, fuel injector cleaner and dryer. With one new tank it hasn't worked. I haven't replaced the fuel filter yet.
Tried driving the car in 1st and 2nd gear only and found that the hesitation isn't dependent on what gear I'm in, but seems to be more about the speed and load. In neutral, slowly revving the engine, I don't detect anything that sounds or looks like a hesitation (just watching the tach).
Been reading about problems some Toyotas have had with unintended acceleration but I'm not sure that is my problem. I have to admit I didn't know that my Camry was "drive by wire" and maybe I don't understand it enough. Maybe a "reflash" might be needed?
My sense is that I should go ahead and do the next major maintenance items including plugs, but if I had a bad plug or plug coil wouldn't that show up as a Diagnostic Trouble Code item?
Could this be a bad injector or fuel filter? Wouldn't they produce a DTC? How do I break down the next steps?
I have a 2003 Solara 4cyl, some months ago it started to blow light blue smoke on start, but would go away after a few minutes. My mech, could be the valve guides. Then about a month ago it blew a head gasket, didn't overheat though, as I stopped, added water and went to the mech. So new gasket and a valve job, but it still blows smoke on start. THe mech said going to 20w50 might work, it didn't. I check the oil last week, thought it should a couple of qts low, so I added oil, but the blue smoke is still there, and I started to smell oil burning. I thought maybe I added too much, so I add another oil change w/20w50....still have the oil burning, blue smoke on start... The mech thinks might be leaking in the rings...ugh....probably could/ve bought a new engine by now...... The check engine light had been intermittent, the mech said it the catalytic converter....it finally went off by itself four days ago....maybe it burned out..........
View 5 Replies2003 Camry 2.4L 4cyl
I noticed my engine light turned on. I went to Autozone to hook the car up to the computer. The computer printed out the code P0420. My coolant temp is normal. What can this code mean. The car has over 126,000 miles.
My wife drives a 2010 Hyundai Elantra with a 5speed manual trans with about 40K mi on it . We purchased the service maintenance package that covers all scheduled major and regular maintenance. A year ago they replaced the head gasket because they discovered a small oil seep. Well a couple of weeks ago I noticed that the heat is fine on the drivers side and blows cool on the passenger side. This is a problem particularly when defrosting the windshield.
When she brought it in for the next scheduled service a couple of days ago I asked that she mention this problem to the service people. Their response was "we need to do a cooling system flush which would not be covered by the service contract" to the tune of a couple a hundred bucks. The coolant is the transparent green it should be due to it being changed one year ago so I have my doubts about it being the heater core.
[URL] ....
So my beloved 03'Camry was developing a bulge for sometime and now the bulge has cracked open around the passenger side airbag. I am taking the car to stealership next week, but I would rather hear from you guys from TN.
How bad is this crack, rather rapture around the edges of airbag and the dash?Should I be alarmed?
Heat on HIGH
Drivers side dash vent and defrost will blow fairly warm air, but no where near the 120 it should be on high
Pass side vents ( all ) blow cold air.
Car heats up fine according to the dash gauge and doesn't overhear.
I've run VCDS and there are no fault codes pulling up, so I am at a loss. With the temp being -15 with the wind-chill, it's a damn chilly drive into work. At first I thought it might be the heater core, but that wouldn't explain the split dash issue.
I have a 2002 Dodge Durango and the rear passenger air blows cold only - was fine last winter. Neither the passenger or the driver controls will get warm air to the rear via the overhead vents. Warm air comes out under the front seats to the rear only.
View 1 RepliesI have A 2012 Chrysler T&C purchased new Sept. 2012. At times heat comes from one side and cold from the other. Varies which side is cold or hot. Had problem from start and Chrysler said was working on solution. Had back to dealer many times with no fix. Warm weather came, no problem. Cold weather now here and same problem. Chrysler's fix was turn heat control all the way up then back down.
View 3 RepliesThe first time installing my hid without a relay harness was a fail. One side keep coming on and off and I gave up went back to stock after it blew out my fuse. This time I tried using using the same kit with a relay harness and it was good for about 10-15 mins and then it starts flickering then both side went off. Pulled over and realized my fuse blew out again. I am having real bad luck with hid, or is it a bad kit?? I love hid but it's really causing me a headache. Can my 2014 Camry not handle HID or what? New kit?? Car can't handle hid?? Why does my fuse keep blowing?!! My kit is opt7 by the way.
View 14 Replies