I have replaced my cv axle and seal, and now I have transmission fluid leaking from the axle seal. What could be the cause of this? The seal is brand new as is the cv axle. Could it be that it the seal isn't seated correctly? What could possibly went wrong to cause this?
View 3 RepliesI get my oil change at the Toyota dealership instead of Lexus and save quite a bit of money for my 2013 ES350. At the 30k service, Toyota technician said he noticed transmission fluid leaking at the axle seal." I was gonna show Lexus this at some point, or maybe get an oil change there at the 40k service.
View 3 RepliesI have a 2006 sonata 3.3 with auto trans I'm having trouble with fluid leaking from the passenger side axle seal. I have already replaced the seal with a Hyundai seal and it is still leaking. Not as bad as before but it leaks onto the exhaust and smells really bad. The transmission is not overfull...
View 2 RepliesWhen I took my Saturn L300 to the dealer recently for its regular oil change I was told that my right front axel seal was leaking and it will cost me $580 to replace. This seems awfully high to me. Am I getting fleeced by the GM dealer?
View 1 RepliesFirst of all this is also my first camry and I noticed that there is only 1 reservoir for the slave and the brakes - which is unique to cars Ive owned in the past. My question is when I remove my slave cylinder from the trans and unhook the hard lines from it would this introduce air into the brake lines since they share the same reservoir? Should I remove the brake fluid from the reservoir before I disconnect the slave? I am wondering because If i just disconnect the lines brake fluid will leak from them between the time I disconnect the old slavecyl and hook the new one up.
Also regarding the trans fluid. my le has 80,000 miles on it and I am not sure whether or not the previous owner ever changed it before. I am having a hard time finding information about how much fluid and exactly which fluid to use. All I know is that gl-4 is the safest choice, butis it ok to use red line mt-90 or amsoil MTF? I dont want to ruin the trans by putting in the wrong fluid and/or wrong quantity.
Passenger differential axle seal is leaking again. It was replaced twice already. My mechanic checked the seal...its not damaged. Its not a excessive leak. Both times, the seal were replaced with OEM. I don't want to buy another one and replace it.
Its a 1995 Celica, 5SFE, 5-speed MT. 98k miles.
So I have a 2004 Hyundai Elantra 5 speed. The driver side cv axle seal started leaking a few months ago and I finally got around to repairing it. Everything went relatively smooth until I got to replacing the seal...
The problem is, it will NOT fit over the cv axle. It just won't. When the seal is installed, not matter how much force I put on the axle it will not go in. Also, I even pulled the seal back out and tried to put it onto the axle out of the car and there is no way it is going on. This is the third seal (done the rounds to through the big name parts stores) and no go.
Now, some quick car back story, I generally do all of my own repairs, but over the winter in the midst of a family tragedy I had a friend (professional mechanic with a shop) do a bunch of work to the car. He replaced the boot and joint that goes into the transmission (he did not replace the entire cv axle assembly for some reason). What I am beginning to think is that he replaced it with the wrong part.
Now, what I am wondering, is this even possible? Is it possible that it could fit and work perfectly yet be wrong? This also appears to be what broke the original seal. The inner portion of the seal was totally blown out in a circle, but perfectly, like it was crushed or cut out, and I am wondering if this happened due to having extreme force applied to it (possibly when he reinstalled it?)
That, or is it just extremely difficult / next to impossible to get these seals on? Even with both parts out of the car, stretching and pushing down on the seal (oiled it up as well to see if that would work) with all my might yields no results.
The leak was not there for the first month or so that I got the car back and then showed up. I have put about 5k miles on the car since I got it back. With Monday quickly approaching, I am wondering if I should just blow the crap out of my budget and pick up a new cv axle? I could at least have them pull one and let me see if the seal fits, I suppose.
I have a 2000 Chevy Monte Carlo that has me stumped as to why it leaks. The driver side axle seal leaks fluid only after a drive. I have replaced the axle twice and seal 6 times and it still leaks. I am stumped on this one. Unless I got a bad axle twice that the diameter of the sealing surface is too small but didn't seem like it as the seal hugs the shaft.
View 4 RepliesI have an 02 camry and the transmission appears to be leaking fluid around the transmission pan. The tranny shifts fine and I wiped the pan noticed the leak to get a little worse since the last time I was under to change the engine oil. Does that pan have a gasket or does it seal with just hi-temp sealer?
View 6 Replies2005 4wd excursion. I have a leaking rear seal on passenger side.
I have the hub assembly off. I'm down to the spindle. My old seal came out in pieces. There's either a piece of the old seal or another seal on the back of the spindle.
Are there two seals? This what looks like a seal still on the spindle against the plate on the back...
I noticed the other day after my truck was parked on a bit of a angle there was diff oil from the passenger side on the ground. reading a bit on here i learned the axle seals are way in the front housing close to the front diff. and yesterday driving a heavy load around my front brake driver side got stuck on a bit and over heated and was smoking, couldn't even touch the rim it was so hot. anyway about this axle seal i got the hub off right now but cant seem to pull out the axle assembly through the knuckle but i see i have to pry and most likely wreck that seal. Looking for a link of piuctures or how to replace the axle seals in the housing.
View 11 RepliesI took the front axle shafts out a couple months back and remember NOT seeing any differential fluid in the axle shaft housing. But then when I took the tire off tonight.. I noticed diff fluid leaking from from the axle shaft dust seal ?
1. I didn't think diff fluid flowed up near those front dust seals ?
2. That's a brand new dust seal so I'm guessing some debri must be in the connection causing the leak ?
99, F250, 4X4, V10, 72,000 miles. I have had the front axle seals replaced three times in the past 3000 miles, and the right continues to leak. My mechanic screwed up three times?
View 6 RepliesWhile diagnosing an issue with my ebrakes I found the drivers rear axle seal was leaking coating the ebrakes in gear oil, replaced the seal. Decided to pull the differential fill plug and check to make sure it was full - drained a good bit out pulling the hub to replace the seal. To my horror this is what I find when I pull the plug. First photo is as it came out on the magnet - second is after a clean up. What is it? I am almost afraid to drop the cover....
View 14 RepliesAbout 2000 miles ago, I had the transmission on my liberty serviced. I had the pan dropped, the fluid drained / refilled, and the filter replaced. The work was done by a jeep dealer. The jeep ran fine with no rough shifting or error codes - in fact, I drove it 500 miles this weekend without incident. This morning, I backed out of my garage and found a big puddle of red fluid on the ground.
I warmed the vehicle up, and checked the transmission fluid level. It appeared to be low, so I added some (about 1/3 a quart). I then looked underneath the jeep and observed red fluid leaking from the transmission pan area. I ran my finger around the bottom of the pan and ended up with more fluid on my hand.
The fluid is clean - no discoloration or burnt odor. What might my problem be? Could it be an improperly sealed trans. pan? Something else?
The jeep is an '03 and the transmission is original to the vehicle. Bought it with 83K and have done fluid / filter changes at 90K, 120K, and 153K. Currently at 155K.
I took my gs350 for a drain and fill today. Before They did anything, The service advisor called and told me the pan gasket is leaking along with a seal? I am aware of the gasket on the pan but wasn't able to get any info on the seal. Is it a seal that is replaced regardless of leak or not if they drop the pan?
Got quoted 700+tax for pan drop, replace gasket and said seal with fill of fluid.
I noticed pool of oil yesterday morning, felt engine oil has leaked. Did oil change as it was due, the mechanic said the leak doesn't seem big enough, still overnight there was again lot of oil leaked, I kept a pan below to capture it. Checked it at auto shop near me and they said it is transmission fluid leak and probably due to driver side axle seal leak. I am going to take it again tomorrow to fix. How much do you think it will cost to fix if this is right diagnosis? This is 2005 4 cyl Ford escape with 150k on it. As per them if it is axle leak it will probably more of labor (2 hrs) than seal price.
View 11 RepliesHow do you replace the rear axle seal in a 1995 F150?
View 14 RepliesThis is a photo of my '79 F250 4x4 rear axle (Dana 60 full floater) this seal will leak in a few miles ..what I need is the part number of a replacement seal made like the one in the lower photo ..it seems that Ford no longer has this seal.
Notice the increased distance from the bearing to the sealing lip in this photo ..the sealing lip on the new seal in the upper photo lies almost on the bearing, this one just barely engages the seal surface on the axle stub. I can machine the bearing pocket deeper to cause the seal to move farther onto the sealing surface, but that would also cause the bearings to be closer together, and may cause problems there.
I have a 2003 4 cylinder Camry XLE. I was just about to get off the highway on my way home from work today when I heard a pop sound come from the passenger side of the car. The oil light also came on at the same time and stayed on. When I got home I saw that there was fluid running down onto the front passenger side wheel.
View 6 RepliesMy transmission on my 2002 7.3 4x4 is pouring fluid from somewhere above the rear of the pan. I thought it was the pan at first. I pulled it off and replaced the filter. After adding fluid while it was running for 4 or 5 minutes it started pouring again. It's not the pan. It's coming from above the pan somewhere. It won't leak unless it's running. Is there a place it can leak on top??
View 7 Replies