Camry 2012+ :: Center Console Moving When Apply Pressure To It
Jun 6, 2014
I just noticed yesterday that the center console is moving a bit when I apply pressure to it. Seems like a screw or something is loose. Luckily there is no vibrating while driving yet, so it's livable for now but I would like to fix it.
Here's a video showing the movement when I lightly push on the piece:
It's even worse when I put my entire weight on it, like when reaching for something on the passenger side floor. I don't want to rip the entire thing out one day
View 2 Replies
Advertisement
Can't upload the pic but I just opened the cc box. Don't see any extra plug?
View 2 Replies
I would like to make one or both of the 12v charging ports in the center console supplied by constant power, instead of accessory fed.
I haven't torn too deep into this car yet, so is there an easier way to do this besides running a lead from the battery? An empty spot in the fuse block perhaps?
View 4 Replies
To those who owns a 2013 Camry SE, when you're looking at the center console and below the A/C unit, there's a compartment with leather trimming around it, do you have a "gap" between the leather and the compartment?
View 10 Replies
As some of you may be aware, I swapped out my OEM HU recently for an aftermarket one -- I show it in post 486 here -- and for various reasons, I decided to go back to stock. I got a pair of 70-1761 & 71-1761 wiring harnesses (because I have a 4-channel aftermarket amplifier) and in a lapse of judgement I tapped the dimming wire into the illumination wire.
Later that night, I noticed when driving with my headlights or parking lights on, the center console buttons don't light up. Specifically, the radio, home & other buttons don't light up and all & the climate control dial knobs are very dim. The ventilation buttons buttons of the HVAC all light up fine & my hazard & passenger seat belt light up fine.
I already check the instrument cluster dash light control & I notice the dial knobs react to it but are still very dim. The brightness of the instrument cluster doesn't match their brightness at all.
I went ahead an looked at my fuse box under the steering wheel column and checked the 10 amp PANEL fuse & it's not blown. For good measure, I swapped it out but the buttons still don't light up. I then checked EVERY fuse under the steering wheel column & non are blown.
In addition to that, I checked every 10 amp fuse in the engine bay fuse box & non of them are blown.
View 4 Replies
I have a camry se and I am currently adding accent lighting to my car. I am trying to take the area around the shifter and the cupholders out so I can hide some wires and mount the led lights controller. How to get this out?
View 4 Replies
I bought a 2015 Camry LE, with manual AC.
I just noticed that every time I turn the temperature knob, there is a small buzz/hiss noise come from the center console. the more you turn the knob, the noise last longer, however, the sound disappear soon once you stop turning the knob.I tested this when the car is parked with power on but engine is not running, this noise is also noticeable in City drive if you audio is off.
I did some research and know that it is from the Heat blend door actuator/Air mix door motor. When you change the temperature, the motor is going to change the direction of the heat blend door.
My questions is : Is this noise noticeable on every Camry?
View 2 Replies
i just picked up a Black 2010 camry le yesterday, 20K Miles for 15$.Tints are getting done today, spoiler ordered, window rain guards ordered, next is fog lights.. are our cars pre-wired for fog lights or no? can i just get a fog lights from ebay and install them?URL....also does the inserts in the bumper just pop-out? no screws right?
View 1 Replies
It rattles when i drive, idk if its the clip or lid itself.. i remember another user saying they used felt or something to pad the lid or clip to stop the rattle, where its rattling?
View 13 Replies
Tonight I was moving some stuff in my car around and placed my work badge in the console area behind the shifter of my 2011 Camry LE. It's the area with the aux plug in. I will attach picture. Anyways the badge somehow became stuck between the door and the back side. How to remove the lid?
View 6 Replies
I am trying to remove the center console on my 2004 Camry. Removed the obvious bolts and screws but there seems to be more to it than pulling a few screws.
View 8 Replies
So I have the center console apart trying to get access to remove the 12v power outlet, and I have it all apart but I can't for the life of me figure out how the power outlet comes out of its mount. Does it slide out of the top, or come down through the bottom?
View 2 Replies
2005 Camry... I have tried and failed to find how to remove the center console. No bolts in sight.
View 2 Replies
I am having this same problem shown in the video is there any easy maybe cheap fixes that i can do? [URL] ......
View 3 Replies
I'm trying to get to the shifter light for a 12v power source. I know how to take the left panel off, but how do I get the cup holders out to drill a hole for some led's?
Also, without a multimeter, how would one know which lead is positive and which is ground?
View 4 Replies
How to remove the console center right under the radio head unit. I could not find any screws. But it did not pop out if I pull it.
View 2 Replies
How do you remove the armrest storage part of the center console? Ive undone the two screws by the shifter and the whole thing shakes but it doesn't come out...
2011 se by the way.
View 1 Replies
When applying brake in a traffic at low speed, I found there is a jerking movement forward of the car. I need to apply harder so the car can stop completely. No problem at high speed on highway though.
View 14 Replies
how to bypass the navigation lockout on the 2015 Toyota Camry XLE
View 5 Replies
My lighting on the shift console (P,N,R, D) is really dim.
Can it be replaced with low wattage LEDS?
AND, is that part of the console difficult to R&R, or a major disassembly?
View 1 Replies
My headlights seem to be off. The beams are spread too far apart, leaving a dark spot right in the middle. It is a 2016 and I just noticed it tonight. I have been trying to find the horizontal adjustment. Is this it? I have tried to turn it but did not notice any difference. Which way am I suppose to turn the left and right one to have the beams move closer to each other?
View 7 Replies
