My check engine light has came on and I received these error codes
PO441 : Evaporative emissions control system incorrect purge flow.
PO 455 : Evaporative emissions control system pressure leak-large leak.
PO 446 : Evaporative emissions control system vent control circuit fault.
Also only my driver side fan is working, may be separate issue?
I got a Ford f150 and getting the error code P0446 Evaporative Emission Control System Vent Control. My truck has burnt up 3 of these things already in the last 8 months. Why my truck keeps killing them?
View 2 RepliesWe are selling the girlfriends 01 Passat. I pulled the codes tonight for a long standing check engine light knowing it had one of the 02 sensors bad. Here are the three codes I received from the scanner:
P0130 - 02 Sensor Circuit Malfunction (Bank I Sensor 1)
P0455 - Evaporative emission control leak detected (large)
P0441 Evaporative Emission Control System Incorrect Purge Flow
So is it one thing causing all three or are there common things to look at. We can't really afford to go replacing all the emission system sensors and hoses etc. in hopes of finding the right piece. Gas cap is screwed on tight and codes were cleared a couple times to make sure.
I have some codes on my ranger 2000 here goes
P0141: o2 sensor heater circuit malfonction (bank 2 sensor 2 )
P0455: evaporative emission control system detected (large leak)
Now I will need to get that fixed cause I don't know where to look and what to look for ... For the leak I know there is a big crack on the plastic where the gas lid is could that be it ?
What can be done regarding these faults? P0037 and P0057
Description:
Oxygen Sensor Heater Control Circuit Low (Bank 1, Sensor 2)
Oxygen Sensor Heater Control Circuit Low (Bank 2, Sensor 2)
The catalytic converters have been removed but the fault was present before that anyway. All I want is the VSC function to work again and the lights to go off. I have heard you can put dummy sensors in.
Got an engine light on today and had it checked at Advance Auto. It is P0442, "small leak in Evaporative emission control system". One article I read said to remove and retighten the gas cap, clear the code then see if it occurs again. If it does then replace the gas cap with a new OEM cap, and try clearing the code again to see what happens, as a first step in the troubleshooting process. I retightened the gas cap, but don't know how to clear the code and turn off the engine light.
View 3 RepliesThe check engine light on my 99 Camry went on at about 180,000 miles. My mechanic checked the code and turned up an EVAPORATIVE EMISSION CONTROL SYSTEM INCORRECT PURGE FLOW He said this could be any number of things,including the need for a gas cannister or some type of valve. What does this mean? How do you determine exactly what the cause of the problem is? What are the likely fixes? Will Toyota be able to better determine the cause than my personal mechanic? What are the best options?
View 5 RepliesI'm not too knowledgeable about wiring and electrical systems. I'm getting a P1451 code (EVAP Control System Canister Vent Solenoid Circuit Malfunction) on my 99 4.2. I've read that it could be a bad solenoid, bad wiring, or a blown fuse. So far I've;
- checked (and changed) the related fuse
- checked the wiring for damage at the connector
- checked voltage at the connector (12 volts)
- checked the resistance at the solenoid (around 60 ohms)
- actuated the solenoid with a 9V battery (can hear it opening and closing)
I haven't had a chance to check the wiring all the way back up the frame to yet, but I noticed that the ground at the trailer wiring harness has broken off the frame. Would this potentially cause a fault in the upstream wiring? I'm going to slap a new connector on and bolt it back down anyway, but as it's Labour (Labor) Day I'll have to wait for the stores to be open tomorrow.
I bought my truck 2 month ago. I use it for commuting, only short trips now ( 10 min ). After about 2 weeks the Check Engine light came on. The truck is running fine, no problems I believe, starts easy. After another 2 weeks, the CEL disappeared. Another week, and the CEL came back on and it`s there since. I have a code reader, these are the codes and meanings according the manual:
P0299 - Turbocharger "A" underboost condition
P2286 - Injector control pressure sensor circuit high
P2287 - Injector control pressure sensor circuit intermittent
P0299 Pending - same as first but with "pending" status
This is my first diesel and my first turbo charged engine. Is this a common problem? How serious? It`s a bit strange that the error came up before but disappeared. Can that happen just because of the short trips I`m making? I`m planning a long trip soon with towing my trailer, so I want to make sure the truck will not break down during the ride.
I am getting error code po457 Evaporative emissions error, I am told the canister purge valve could be bad.
View 4 RepliesI have an emissions test coming up. I have 3 P codes that I'd like to eliminate before then. I don't want to "fix" the issues they are telling me about. Just make the codes go away. I know why they're there I just need to get rid of them.
What I have coming up is:
P0475 Exhaust Pressure Circuit Valve (result of EBPV delete)
P0541 Intake air heater A circuit low (result of aih delete)
P0640 Intake air heater control circuit (also result of aih delete)
What resistors I'll need and where to put them in?
I have been smelling gas and noticing that I am using a lot of gas. I checked the codes. I got P0442, Evaporative Emissions System Leak Detected(small leak) and P0446, Evaportative EMission System Vent Control Circuit. Where do I check for the leak and what is a vent control circuit?
View 1 RepliesI've got a '99 Passat wagon with the 1.8T. My check engine light came on the other day. i had a friend check it w/ his OBD 2 code reader. I got 2 codes: 1300 & 1136. "boost calibration fault" & "fan circuit control malfunction" , respectively. are either of these worthy of a trip to the shop, or can i handle this on my own?
View 3 RepliesI own a 98 f-150 5.4 with 70,000 miles. I get a check engine light (code p0455-large leak detected in evaporative emission control system).
Replaced the gas cap with an after market 'stant' ( I believe was the manufacturer) brand. The check engine light went away for 4 days then came on again.
No obvious vacuum line leaks.... Puzzled.
Is it possible to take an 'throttle emissions control solenoid" off a 2150 Carburetor and swap it with a different solenoid, say something like an idle swap?? I can't find a new throttle emissions control solenoid, but I see plenty of idle stops.
View 3 RepliesSo mad today. Check engine light came on, plugged in my scanner, got P0441 EVAP Emission Control system Purge Flow Fault and P0455 EVAP Emission Control System Leak (Large).
8-month old '13 TCH XLE is getting a check engine light already.
The check engine light came on yesterday. 2004 with 115K. Auto Zone read the codes and they are as follows:
Definition:
Idle Air Control Valve control circuit.
Probable Cause:
Open or short circuit condition.
Poor Electrical Connection
Failed IAC motor
This is the third time this has happend in a week I used my torque app but it says no fault codes but the warning lights are clearly lit and wont turn off unless I shut down the car. Its a 2012 with 8,000 mile?
View 6 RepliesThe first is a trans control system malfunction and the 2nd code(0740) is tcc circuit malfunction- but what exactly do these codes mean? and the o2 sensor needs to be replaced, it said bank 1 sensor 1- does that mean the one BEFORE the catalytic converter?
View 4 RepliesMy 2.5L is throwing a check engine light with only 5000ish miles?!
P2407 - Powertrain - Auxiliary Emission Controls - "Evaporative Emission System Leak Detection Pump Sense Circuit Intermittent/Erratic"
I did a quick google search and apparently it MAY be due to a loose gas filler cap. I tightened it and drove around the block. Still on...
And (from the google search), this code isn't common with VWs.. (in fact, couldn't find a single VW with this code?).
I have just replaced the abs ecu and have cleared the codes, thought all was gonna be good but now two code are still coming up they are:
01044 Transmission control module - incorrectly coded
00778 Steering angle sensor-G85