Century :: 1987 Buick - Fuel Needle Fluctuating While Car Is In Movement And Engine Stops
Apr 9, 2014
Buick Century 1987 - 2.8L
Sending unit measures: Empty 9 ohm - Full 88 ohm
Fuel pump working while engine is running or key switch in ON position (working properly).
Issue: Fuel needle fluctuates while car is in movement and the engine stops when the car is going downhill and suddenly is braked (half tank), Is normal this behaviour in this car? Is this car equipped with a 'anti-slosh module'? if yes, where it is located?
View 1 Replies
Advertisement
I have a 1987 Buick custom 3.8L that will not run or start with the EGR valve connected to the evr selenoid. How can I verify if it is the EGR valve or the vacuum solenoid? When I connect the egr to the vacuum solenoid the valve opens all the way up and the engine stalls.
View 5 Replies
I have a 1994 Buick Century Wagon with a 3100 SFI V6 engine that I can't get to fire at all. I have read many posts with the same problem but haven't been able to find a follow up fix from them. My Buick just wouldn't start one day after running fine before. I came to this site and tried some of the suggested troubleshooting and found, while testing for power to fuel pump, that if I jumped from the battery to the gray wire on the fuel pump relay the car would start and run fine. So that rules out any fuel pump problems or fuel filter problems. I then swapped fuel pump relay to a different similar relay on the car and still wouldn't start. I have read on this site about the oil pressure/ fuel pressure switch being a possible cause and I believe I have found that switch. It is in the side of the block toward the front of car and has three wires, (orange, tan and gray) going into it.
I was going to try to jumper the orange to gray but didn't want to do the wrong jump in case of negatively effecting the EMC controller, usually green/white wire? I also heard of the crank shaft sensor located on the back side of block but am not sure of which of three sensors I'm seeing back there to test. I guess first I'm looking for proper jumping procedure. I tried jumping the gray to orange in the fuel pump relay but no good. I get 12 volts at that orange and for a couple of seconds 2 to 3 volts at the green/white wires at the fuel pump relay when ignition is turned on, so when I jump the orange to gray at the relay it should start as it does when I jumper from battery to gray. I had relay apart when I jumpered the orange to gray, do I have to jumper with relay together and use a pin/needle wire jumper so rest of relay wires are connected? The same would apply for jumper testing oil pressure switch and crank shaft sensor? If it's not the switch or sensor then it looks to maybe be the EMC?
View 18 Replies
Four days into it the low tire pressure indicator lights up. Hit the reset, checked the tires, deflated some air and filled back up, etc and the indicator is still on. Even my local shop couldn't fix it. So yesterday I'm driving home and the fuel gauge suddenly stops registering, the needle drops below the red empty line. This morning I start it up and the fuel gauge is working, for about a minute, then it drops again. Same situation after stopping to get a cup of coffee. I'm taking it to a dealer today. Think the problem could be a defective speedo gauge cluster?
View 8 Replies
1994 Buick Century 3.1
Fuel pump relay is not powering the fuel pump. I was able at one point to jump the orange wire to the gray wire but it will not even do that now. I know the fuel pump works because I can jump from the battery to the gray wire and it will turn on.
I used a multimeter and tested the volts from the orange wire on the relay to the neg post on the battery and it is only reading about 1.3 volts. Is this normal?
Checked the fuel pump 15a fuse and it is ok. I am getting spark. Could it be the crank sensor? How can I test that? (It is above the start I believe). Could it be the ignition control module? How to test? Location? What else can I test with the multimeter and post back with the results to further diagnose?
View 8 Replies
I have a 1992 Buick Century with a 3.3L V6. I noticed a hissing sound under the hood with the motor running. The short vacuum hose (about 2 inches) connected at the fuel pressure regulator was loose and leaking. I shut the engine, remove the end of the hose and a little gas (about a teaspoon) came out of the vacuum pipe for awhile and then it stopped.
I tightened (but did not overtighten) the end of the hose with a nylon wire tie. There was no existing clamp on it. The vacuum leak stopped (no more hissing). Now, the car is sometimes hard to start or restart. Do I have a serious problem? Did I do the right thing? Could this be caused by a clogged fuel filter? (it was changed 42000 miles ago).
View 6 Replies
I have a 2003 Buick LeSabre Limited, and everything was going fine with it till recently. The Fuel gauge started to go haywire as in the needle would go to full, then go back down to a Quarter, then back to 3/4, then drop all the way down to Empty, this is still occurring. At first I believed it to be the fuel level sensor, but then I started to notice something else.
A warning message came on stating that the oil level was too low, but when I checked the oil level it was fine, and last night when I was driving with the air conditioner on, I hit a bump and the air conditioner stopped working. I pushed the off button, and was successfully able to make the air conditioner to come back on with out having to restart the car.
The horn has also started to go in and out, and I do not know if they are all linked together by a type of computer or if they are separate.
View 8 Replies
I have a 2001 Buick Century that started making a noise from what seems to be the engine. It sounds like a jet engine when I accelerate. The noise is still there when I cruise, but it evens out. It is loudest when going between 40 and 50mph. The car is not overheating, and other then the noise it drives fine. My husband at first thought it sounded like the catalytic converter had been stolen, but he rarely knows what he is talking about. What could it be?
View 2 Replies
I have the GM shop manual and I have gone through the flow chart for an engine which cranks but does not start. I have confirmed that there is fuel pressure and spark, but the injectors do not fire when cranking. I have gotten to the final troubleshooting step of disconnecting the crank angle sensor connector, jumping A and B terminals on the connector, and momentarily grounding the jumper with a test light. The injectors fire as confirmed using the GM injector test light (in place of an injector). The flow chart conclusion is that the crank angle sensor is bad or misadjusted or the connector is making a bad connection. I have replaced the sensor twice and adjusted it using the GM adjustment tool. The connector terminals appear clean and undamaged. 1989 Buick Century 3.3 liter ...
View 5 Replies
2000 Buick Century Custom with 140K miles: Service Engine Light came on. Re;placed gas cap, light still on. Took to dealer who replaced HO2 sensor, light still on. Took to dealer who found no problem but charged $100 for looking. Light still on. Took to dealer who said it needed two major parts. Light still on. Took to another mechanic who could find nothing wrong. Light still on. Is there hope?
View 8 Replies
The Buick Century has about 22,000 miles. The Service Engine Soon light has appeared on the dash. The instruction manual is not clear. What would you recoomend? What might cause the light to appear?
View 15 Replies
Last month I changed the oil and filter in my 1992 Buick Century with 264000 miles. I used a name brand (Citco) of the correct oil, 10W-30, API Service SN. I bought the oil on sale at a local supermarket. Now, I hear a loud tapping sound from the engine, especially when it's cold. It dosen't sound as loud after warm-up. The tapping increases in frequency when I rev up the engine. I don't intend to keep this old car much longer, but is this problem an immediate concern? Could it be a valve problem? Could it Could I have bought some bad oil with a conterfeit label? Other than this noise, the car runs okay.
View 3 Replies
I had this problem a few times in the past. Sometimes my 1992 Buick Century will shut off for no apparent reason while idling. When I restart it, the engine will race for a few seconds before slowing down to normal idle speed. Could this be caused by a glitch in the car's computer?
View 5 Replies
The car died on me the other day at a stoplight but started up again (It resisted for a sec but then caught). Now it's taking a bit to start and sounds very faint when it finally catches and the turn over is slow. I'm no mechanic but I can replace parts. I'm just wondering if it's the fuel pump or injectors, maybe low fuel pressure. I haven't had a chance to do anything to it. Where to start?
View 3 Replies
I have an 08 Hyundai Santa Fe. Check engine light comes on, fuel gauge goes from empty to full, to half, to 1/4, just all over the place. Even ran out of gas a few times on the side of the road not knowing how much fuel I have.
What exactly causes this problem? I've heard "fuel sender" I've heard "fuel pressure sensor" etc. All are different parts. Need to get this repaired asap.
View 8 Replies
I own a 1999 Park Avenue Ultra. Recently it's developed a problem where the engine just stops when I'm driving. It happens at all speeds--on the highway, on local roads, in parking lots, or just idling. Starting up the car after it stalls is not problem; it always starts right up. The car stalls at least once a day after it's all warmed up. Additional stalls can occur, but there is no quantifiable interval between additional stalls. This car has spent most of its 148,000 miles in the upper Midwest. This past winter I drove to car to Arizona, and that's when the stalling started. One mechanic looked at the car, but couldn't find anything wrong and couldn't get it to stall when he took it out for an extended drive. What the problem might be?
View 3 Replies
I recently had the radiator on my car replaced and wen I got it back the temperature and gas gauge needles are both blown past the HOT sign and past the full sign on my gas gauge and is sitting under the little black piece under the the cold side and under the empty side. it was obviously messed with and completely turned around but why is it like this? will it reset itself or should I take i.e., back to the mechanic to have it fixed by him?
2000 buick park avenue....
View 9 Replies
I have a 2000 Buick Century that I cannot get to start. While my wife was driving home it started to sputter (like running out of gas) and did a little back firing. She made it home and I put in some gas (Just to make sure) and the care cranks over but will not start. I have replaced the fuel filter, checked the spark plugs and replaced the CAM Sensor. The car still will not start.
View 5 Replies
My wife has a 2000 Buick Century with about 150,000 miles on it. It has been relatively trouble free. Recently, the "low coolant" light began to come on.She took the car into a garage where she was told there was oil in the coolant and the sensor had been compromised. The cooling system was flushed and cleaned and a new sensor installed. The "low coolant" light continued to come on. She took the car back in. She was told the wrong sensor had been installed. When she went back for the car the second time, she was told the oil in the coolant was preventing the new sensor from working and there was nothing more the garage could do. I went in and asked questions, primarily how serious was the condition, and couldn't get a straight answer.
We are due to drive to Florida in November. My wife would like to take it to a garage there. Is it save to drive it as is? What are the implications of oil mixing with coolant? What is causing it to happen?
View 4 Replies
My 03 Buick century is overheating. I changed the thermostat and the water pump. And still overheats as soon As I start driving. I am also getting when it is overheating some misfiring in cylindar 1. I am going to reflush and bleed the coolant even though it seems to be full . i dont think it is disappearing. Is it Possible i have a blown headgasket or intake manifold leak?
View 4 Replies
I am having a very tricky problem with my Buick.
For approximately the last 4 months, it has been (at least according to the heat gauge on the dash) running pretty hot. Not overheating, but getting close. And it doesn't take long for it to get there. This all seems to have begun right around the time that my father and I flushed the coolant system.
Since then, I have replaced some parts, and learned a few things in the process.
I learned that there are bleeder screws which can be opened to let air bubbles out. And I have heard that the 3.1L is especially susceptible to them.
New parts which I have installed:
- thermostat
- coolant temperature sensor
- radiator cap
- upper radiator hose
- lower radiator hose
I have checked the water pump and it seems to be perfectly fine. No leaks. No signs of bad bearings. And it circulates coolant just fine. I have not been witness to either cooling fan, primary or auxiliary, switching on in a while.
The exact symptoms are these:
The heat gauge does not take long to get to mid-way point, but will sit at that point for a bit if the vehicle remains stationary. Once the vehicle is in significant motion, the heat gauge will climb fairly quickly, especially with moderately high RPMs. It WON'T touch the red though, but will get very very close to it. The car runs fine. It does seem to be a bit underpowered, but I am comparing it to my fiance's 1996 Olds Cutlass Ciera, which I believe has a different transmission. My Buick does not seem to have lost power since this problem arose. The cooling fans no longer kick on. The oil appears fine. The coolant as well. With the radiator cap off, coolant does not bubble out or shoot out.
I made sure after changing upper and lower hoses to fill the radiator, let the car run long enough for the thermostat to open, and then slowly poured more coolant into the radiator until it was full again. And the reservoir is at proper level and the the reservoir hose s not clogged.
I am not SURE, but I don't believe the radiator is clogged. I believe that covers it, at least as well as I can.
BTW, I do not know where the fan relays are, otherwise I would test the fans to see if they still work.
What the heck is up with my Buick? Also, it has 97,xxx miles on it, and the transmission fluid is at proper level and looks normal.
View 4 Replies
