I have an '02 Tracker and I've noticed if I have several accessories running, that my engine will start to sputter and come to the verge of stalling when I come to a stop. It happens if I have the heat/air and radio or charging my phone on together. What is the cause and/or remedy for this? I've changed the alternator a few yrs. back, but it still continued.
View 2 RepliesThe problem started several months ago. At first it would only happen once in a while and would only last about 5 mins. The first time it happened I had it towed to my shop and it ran fine when it got there. Go figure. They told me they couldn't diagnose it if it wasn't acting up while they had it. Makes sense. But it never does it when I'm there for routine maintenance. Now it's doing it for twenty minutes at a crack. It's usually fine around town unless I get stuck in stop and go traffic. When it usually acts up is when I get on the road between work and home.
Every time I stop for gas I have to wait for it to decide it wants to start again. All of this is putting heavy wear on my starter. I changed the oxygen sensor (position no. 01), because that was the only error code that showed up. That didn't fix it. My mechanic says he thinks the next best step might be the cam and/or crank sensor. If not that, then he thinks we should change out the brain. Somebody else said it might be the fuel pump goin out. because I travel too far for work and I can't afford to fix things that probably won't solve the problem.
I have a 98 Chevy Tracker 1.6 auto. My OBD reader shows engine load @ 25% in park at idle. What would cause this.
View 5 Replies2004 Trailblazer 6cy. 2WD - has been experiencing a very rough idle, engine shudders - no matter how long it's been warmed up. Wants to stall off red lights and at very low speeds. Not throwing any lights yet - but the speedo is out ( a cam shift typical problem for this car) so I don't trust the console for lights. Worse when the heat or air is on. Rides fine with more gas/higher speeds. Definitely worse in colder temps but continues even after 40-50 mins of driving. I've heard a number of things, but can't afford to fix them all. I've heard plugs, dirty throttle camshaft, sensors, cam actuator solenoid, etc. All seem to have people who said it fixed and didn't fix the issue. Worried I'm going to stall pulling off a stop and rear end someone any day now. Where do I start!?
View 2 Replies2003 Chevy Tracker 4 cylinder. Engine rebuilt and cannot get lifters to quiet down. Replaced 3 times. Bent valves on first install.
View 3 RepliesMy 2002 Windstar SEL has been giving me a fit and I`m not getting any codes as to why. Here`s the 2 main issues. Clicking when i go to start up in a.m. if it`s below 50 degrees. ( Battery has been checked and all is o.k. or so I was informed). As long as it`s warm it starts fine every time. Also,it seems like the least bit of wet on the underside will cause it to spit and sputter and the check engine light will start blinking until it sits and dries for a while. (A very shallow puddle less than 6 inches deep at low speed or even the automatic car wash that sprays the undercarriage).
View 2 RepliesI have an interesting issue that happened today after filling up on the way home from work. I have a 2011 Accent; 5 speed manual with 3900 miles. I filled up my tank and then topped off a little extra (which I now know is a no no) after the pump shut off. I put the cap back on, and after getting a cup of coffee, cranked her up and started on my way home. I drove maybe 20 feet and after coming to a stop, the car stalled. I wasn't sure at this point if maybe I let off the clutch a little too much. I started right back up and drove another 20 feet to a stop sign, and she stalled out on me again.
This time, after starting right back up, I noticed the check engine light was on, and if the car idled, it stalled. This is where it gets a little interesting. I was maybe 5 miles from the dealership where I bought my car. So I made a quick trip to the dealership to see if they could get the codes to determine the problem. After parking at the dealership, I turned off the car, removed the key from the ignition for about 10 seconds, and then started up again for giggles. The check engine light is now gone, and the car doesn't stall when idle. I have an appointment to get my oil changed, and am wondering if the codes can still be pulled?
I drive a '99 Chevy Tracker with the 2Liter engine, a 5 speed manual transmission and 110K mi. on it. When I lift my foot from the throttle pedal in preparing to shift gears the engine takes a very long time to reduce it's RPM. This is a problem, when up shifting, as the transmission is spinning too fast for smooth gear engagement.
The engine idles normally under all other circumstances. It is only slow to decelerate whenever I lift my foot from the throttle pedal. This makes up shifting very slow and/or causes the gears to sometimes grind slightly.
I was driving my Chevrolet Silverado 1500 4 wheel drive single cab when it sputtered a couple of times I came to a stop light and the car stopped I tried starting it to no avail. I also noticed I did not hear the fuel pump run as normal when truck is in accessory position . When my buddy showed up I had him try and start the truck as I banged on the gas tank and it would run when I stopped so did the truck...
View 2 RepliesI changed my plugs a few days ago on my 96' Taurus GL 3.0LI checked under my hood to check the recommended gap size and it said .42 to .46.. I went with .46. after putting them in i started the car up just fine, but later in the day i noticed when I came to a stop at a red light my car would sputter and my check engine light would start blinking. When I'd accelerate and drive it again everything would clear up and the light would stop blinking. I didn't change the wires, just the plugs in case you were wondering but I am unsure of how much that would influence my problem. Today after work i had a little trouble starting my car. After a few tries it started and my exhaust smelt rich in gasoline. Did i gap them too much? Should i get new plugs again and regap them? should i buy new wires also?Is my ignition coil going bad?
View 19 Replies1994 Geo Tracker 1.6L 16V engine won't start, but cranks. I have spark, compression is good, fuel (good fuel), new spark plugs, the crankshaft and camshaft are timed, the distributor is timed, there are no error codes but the ECU is fine.
I've put in new spark plugs and wires, new fuel injectors, new timing belt, new air filter. All sensors are hooked up and working. It cranks, but doesn't start. It keeps burning fuel, I can hear it and feel it in the engine, but it won't start and run.
One thing which I've noticed is weird is the crankshaft is very difficult to turn when it hits certain points. I try to turn it and it will go about a third or a turn pretty easily, but then it gets stuck and I have to turn the key to get it past that point. Then I try to turn it by hand again and it has the same problem in a different spot. It hasn't started in a month at this point, I'm planning on taking the distributor out and realigning it tomorrow, but I'm running out of things to test.
I have recently picked up this 2002 Ram 1500 quad cab and had the engine rebuilt because it was running rough. 2 weeks later After I'm driving for a bit, the engine starts shaking and feels like it losses compression and dies. It will not start for about 30 minutes and then it starts back up and I can drive for a few miles and it dies again. the longer it sits, the further I can drive. The head shop checked their work on the engine and could find nothing wrong with block or heads. they said the O2 sensors were clogged and replaced those for me. they also looked at the fuel filter and didn't see anything wrong with it.
I needed to know what direction to go from here.. Catalytic converter? Battery? Fuel Pump? I took the truck to the Service Dept at a Dodge Dealership... They checked it out and replaced the after-market O2 sensors with Factory O2 sensors and said it was running fine... As soon as We picked it up, it shut off again not 5 miles from the shop.. The service advisor tells me that his techs are scratching their heads on what could be the cause of this problem. I'm feeling that the problem lies in the fuel system somewhere, but not feeling confident in the dealer service to find my problem...
I have a 1996 Chevy Cavalier, which I purchased used Two years ago, and lately I've been having a problem with it. I live in the area where Temps rub pretty high here. Recently, with three digit weather, my car stalls when I'm in stop and go traffic. I would have to turn off the car and restart it. The car temp gauge in car doesn't show the car overheating. What is the possible cause of the car stalling?
View 1 RepliesI have a 2002 Chevy Impala driving it in the city of Chicago. It's recently had the oil changed, and the transmission fluid flushed and filter replaced. This car was mine before I went off to school, and I meticulously maintained it for three years, and then my step sister inherited it. She drove it for two years, and then it sat in the driveway for a year and a half. It's got about 175,000 miles on it.
Problem: Every time I start to accelerate past 25mph and get around 2000rpms, the car starts to give out, sputter and jerk. It starts to drop off right when it should be shifting to second gear. When on the highway, even if I floor the gas peddle, it won't accelerate normally, but instead just crawls slowly to higher speeds.
It will eventually reach the higher speeds, but it takes about 5-10 minutes for it climb up from 25mph. I don't know enough about this level of car trouble to make a diagnosis myself, and would like an estimate of the cost for repairs. Also the car is getting around 19mpg on the highway, which I need to improve if I'm going to survive the $4.50/gal of Chicago gas. I'm hoping that fixing this problem will take care of that as well.
My 2000 Chevy Tracker will not go into reverse. Had tranmission drained and cleaned. Still won't go into reverse. Does this model have a separate reverse cable?
View 1 RepliesA few weeks ago I took my 03 Caravan to a shop and they said my alternator was fine, but the Wal*Mart battery (which I assume is a piece of rubbish) reads a bit low. When the temperatures are about 25 Fahrenheit or below the engine will sputter a bit usually at stop lights and the headlights will dim then go back to normal brightness a few times.
Now that the temperatures are in the 40s-50s I am still having this problem, but not as pronounced and sometimes it happens rather randomly. There is now another problem to go along with it. If I have the steering wheel turned hard while backing up and am not pressing the accelerator I have almost had Edward (my name for the Caravan) stall on me instead of just sputtering. Sometimes I feel like the engine is surging a wee bit as I drive down the road if I have just let off the accelerator. In general the RPM seems a bit erratic at times.
The fuel economy is the same as ever, the belts are all new over the past year, spark plugs, and all that. Recently replaced the vacuum plugs where the cruise control would go as well.
my 2002 Chevy Tracker has run faithfully for the last 5-6 years. a few things have come up recently that have needed to be replaced, but nothing huge. after my AC compressor was replaced, my car started powering off in the middle of driving (not while revving engine standing still). mostly on cold starts, but now more frequently. mechanic swears it has nothing to do with AC compressor.
But he is checking drive train today. He has changed the tranny fluid, fuel filter, cleaned the gas tank, cleaned the throttle body (IAC motor), cleaned the mass airflow filter sensor, checked the battery voltage in case of an alternator problem. he has scanned the vehicle while driving and sitting still several times and no codes come up.
I have owned this 96 k1500 5.7L Vortex Suburban for 3 years.
Problem: Intermittent stalling upon coming to a stop. When it stalls and I try to restart the engine, the starter can barely spin the motor. The timing is thrown so far advanced that it will literally fire the engine backward and grind the starter gear on the flywheel. I have killed about six starters so far. I took it to the dealership and after two weeks they are clueless.
So far we have replaced: TPS, Ignition Module, Cam sensor, Crank sensor, ECM, and perhaps a few other things I don't recall at this time. If it would stall and simply restart, I could cope with it. The only way I have found to get it to start is when it stalls, pop hood, unplug the power source to the ignition coil, turn key and spin engine over for a few seconds, replug the power source to the ignition coil, and attempt a restart. Usually I don't have to do this more than once or twice.
Last Thursday I was coming home from work and the first time I came to a stop the R32 began to buck just as I gave it a little gas. Tried stopping and starting it but it continued to do it the rest of the trip home. Fast forward to this morning (first time we've driven it since) and it completely stalled on my wife on her way to work. She managed to get it started and get it home. I drove it around the block and sure enough when it comes to a stop after moving it stalls. I was able to consistently get it to stall just by getting it moving and then coming to a stop. I scanned it for codes last night and got a couple of different codes. Ignore the photo-sensor one - I am fixing that just need to find what I did with it.
Note the address 17 stuff - 2 codes to do with failure of the fuel sending unit. Could this possibly cause the car to stall out?
Also, address 16 (steering wheel) - RossTech seems to think these codes mean a faulty ignition switch.
I've never done data logging before but I was able to capture one of the stalls with VCDS. What columns would be useful to see and troubleshoot?
Here's the link to the log
01-Engine -- Status: OK 0000
02-Auto Trans -- Status: OK 0000
03-ABS Brakes -- Status: OK 0000
04-Steering Angle -- Status: OK 0000
08-Auto HVAC -- Status: Malfunction 0010
[Code] ....
I have a 2002 2500HD duramax that is stalling out when accelerating heavily ( as when passing ) I replaced the fuel filter, this seemed to solve the problem for a day or two. The problem returned after two days of driving. I took the new filter off and cleaned the lower float valve,replaced it & it seemed to drive fine until I took it for a test drive and "gassed it" and the problem returned.
View 1 RepliesMy 2002 Chevy Tracker recently has been running poorly after consuming a 1/4 tank of gas. The check engine light comes on the scan tool reports P0171 and P0174 bank 1 and 2 lean(it's a 2.5 liter V-6). If I remove and replace the gas cap it runs better but not perfect. Once I use another 1/4 tank the symptoms return. I have noticed the cap is hard to remove lately. This has been going on for two weeks It's been to 2 garages one of them told me my catalytic converters are plugged up and wanted 2500 to fix .
View 8 Replies