Elantra HD (2006-10) :: 2007 - Hard To Shift Into 1st / 2nd Gear
Nov 10, 2015
I got a new clutch & shift cables & fluid professionally done one year ago. I have only put 5k miles on it since. In the last two months the... gate/slot for 1st & 2nd have been getting worse n worse. All gears show sporadic rough shifting (read rough as a clunk or one tooth grind), but 1st/2nd are consistently rough & the gate seems to be getting narrower...
Environmental & operating temp, do not noticeably affect these symptoms.
View 4 Replies
Advertisement
I have a 2001 Elantra GLS, 160,000 miles. These two codes come up on ny diagnostic tool.
P0422
Main catalyst efficiency below threshold (bank 1)
No symptoms at all
P1529
Customer snapshot request
Symptoms
Car will shift hard into third gear and stay there without shifting at all regardless of speed. Shutting the car off and restarting will sometimes fix, but only temporary. When car runs normal, it runs fine and shifts good. At speeds around 40 it seems to kick back and forth between 3rd and overdrive as if it can't decide where to be. Tried replacing speed sensor, but new sensor did not fix problem.
Fuel Sys 1 CL
Fuel Sys 2 NA
Calc Load 18.4
ECT 201
STFT B1 0.0
LTFT B1 -2.3
MAP 8.6
Eng RPM 3351
Veh Speed 22
EV flashing
O flashing
View 17 Replies
I have a 2005 Hyundai Elantra with approx 155,000 miles on it(I don't know if that matters). The car started ok at first. When I put it into reverse, I noticed that it was really hard to move the gear shift(which it's normally really easy). I put it back in park and let it sit for a minute thinking it just had to warm up a bit more.
When I tried it again, it was still hard to shift, but this time when it got into gear I heard a loud clunk. This scared me, so I put it back in park and turned off the car. Now it won't start. All of my lights(headlights, dashboard lights, radio) come on, but the engine won't turn over.
I don't know if any of the following is relevant but I'm putting it out here anyway just in case it is: The battery is only a year old(and since all my lights came on, I don't think it's dead)I had an oil change on Saturday. The belts were replaced a few months ago. My check engine light is on because of an O2 sensor.
View 5 Replies
Drove to work today and all was fine. Came out at 3 and started my Elantra up, dropped it into gear and it was ROUGH. Engine ran for a few seconds before I put it in gear. The shifts up the street were hard and the downshifts were equally hard. I put the transmission in manual--same thing. After a few minutes, the shifts returned to normal. No CEL. The car has 48,700 miles on it.
View 10 Replies
I have brand new ( 800KM ) Accent with Automatic transmission and I noticed that it shifts from 1st gear into 2nd kinda rough. By this I mean that I can feel shift pretty good, and I don't feel shifts from 2 to 3 to 4. I don't rev engine high, typically shifts occur when engine revs around 2000 rpm.
I am not sure if it is a transmission defect or this is the way it shifts? May be I need to breaking my car first and it will go away?
View 16 Replies
I have a 2010 accent blue model with stick shift. been fine for 50k miles. Lately i have noticed an issue where i am in first gear and then when i push clutch in to go into second, the lever won't budge. it does eventually go in but it just isn't like it used to be. it happens say about 25% of the time. Since at higher rpms it won't do it but normal rpms it will.
Also, i just had a new short block installed, perhaps something is binding? If I sit in the car, stopped, i can shift into and out of all the gears perfectly. Maybe my 1st gear synchros are going?
View 2 Replies
My 2008 seems to be having some intermittent trouble shifting into the proper gear at a couple of speed ranges.
Occasionally I'll start it up and pull out of a parking space (or leave a stoplight) and it feels like it's stuck in 1st well after it should have switched to a higher gear (I sometimes feel the upshift at about 10* mph). If I continue accelerating and hit about 40-50 mph, once again it appears to stay in the current gear instead of shifting.
When this issue is happening, the car feels even more underpowered than usual and takes way more throttle than it should to accelerate. This results in a cruising RPM of 3.3-3.5k at 60 mph. At that speed the engine would normally be doing about 2.2k RPM. Similar power and RPM conditions exist in the lower-speed range, too.
This whole thing is usually preceded by a rough shift into gear (D or R) when I first start the car. It's always had a slight lurch in the appropriate direction as I take it out of park, but this is really noticeable.
If I stop the car and come back in an hour, it (usually) appears to have reset itself. I can drive around and the transmission control is as good as always.
This has been going on for about a month, with an episode maybe every week or two. I took it to a shop and they didn't find any problems (I told them about the weird shifting and lack of power).
Does it sound like this is what's happening (it's not getting into the right gear)? Thoughts on what I should do? I can't really remember the speeds.
View 11 Replies
I'm wondering if it is OK to shift into neutral while coasting (engine on). I've read varying arguments back and forth on whether or not it hurts it. I've done for a while in my 99 suburban and the transmission still shifts just fine. I've tried it once in the elantra just to see how it affects my fuel economy, and it boosts it about 100mpg (coming off a freeway ramp). Braking and steering controls don't seem to be affected by the lower vacuum.
I can see why its not advised while the engine is off (i.e., towing), but if the engine is on, torque converter turning, transmission fluid pumping, I can't see where it would hurt.
View 1 Replies
I have been having an issue with my 4-5 gear shift under hard acceleration and know that a rebuild is due soon but I was wondering if any high performance kit available with all the clutches and friction discs needed to rebuild.
View 6 Replies
Could my brake issue be related to my transmission problem? Neither are constant. Brake problem= sometimes the brake pedal feels hard, like there's no power brakes (I drove a car once. ..looong time ago. .. that had no power brakes or steering) but it will kick in after a short distance. Transmission prob= seemingly unrelated, is a problem shifting from 1st to 2nd gear. This has happened maybe a 1/2 dozen times, the first time and mostly when in heavy commute traffic and when going between 1st and 2nd gear because of the slow commute speed, but also at other times when not in lengthy slow commutes. When it doesn't shift, the odometer doesn't work (shows only dashes) and an engine light comes on (the sprocket/gear looking one). Usually the transmission will eventually shift and the light goes off.
I read that the brake problem might be a vacuum hose problem? Something about a booster? Is this dangerous? or is it like having a car w/ no power brakes? Going to have my transmission looked at this week. Read on another site about dropping valve seats on this year car. If there's a major transmission problem, I'm wondering if it's worth fixing? I changed, timing belt, water pump, front and rears brakes, tires. 143,000 miles.
View 1 Replies
My 2007 elantra is starting to pop out of 4th gear whilst accelerating. Is there a fix for this?
View 4 Replies
Background facts:
Tranny swapped from my 4 speed auto to a 1.8t o2j 5spd
13lb. Light flywheel
Powerflex dogbone mounts
Peloquin LSD
The problem: Very hard to get a smooth shift from gear to gear. Trust me, I know how to drive, but I can always feel the car shifting into a different gear if you know what I'm saying. On my friend's bone stock Jetta, I just let the clutch out without gas in between shifts and you don't feel a thing.
On my car, you feel EVERYTHING. People have told me the light flywheel will make the ride more uncomfortable in many ways, especially since the RPMs drop much quicker in between shifts than stock.
View 9 Replies
I have a 07 Elantra with 68,000 miles. I am having a cold start issue. When the car sits overnight and I attempt to start/place the car into gear (auto), the car will stall. This occurs whether the car is placed in forward/reverse and with the a/c on/off. The vehicle will start fine the rest of the day with no issues.
View 8 Replies
I get a hard shift into second gear, it jerks into 2nd but not all the time. I only notice it after driving on the freeway for several miles. It has 60,000 original miles. Service Engine Soon light come on after the hard shifts with a transmission fault code. I reset the Engine light and let it set 20 or so minutes and it shifts like new.
1997 CHEVROLET TRUCK S10 2WD
6 Cylinders 262 X 4.3L SFI
Automatic
View 13 Replies
I just finished the DG install yesterday. I am having a real problem with the first gear: it is really hard to shift into it (I mean hard!) - and several times I went into 3rd believing it was in 1st, while driving. I know that the DG is notchy and a little stiffer (which I like) but this does not feel right. I have to really push hard (moving slightly toward reverse) to shift into 1st. My wife would never be able to find it or shift into it (not that I let her drive my R that much...).
Note that all the other gears (2,3,4,5,6 and reverse) shift beautifully without any effort with that nice click. But not 1st.
What is it? Adjustment? I did it twice. I made sure that both cables were "all the way in" before tightening the first two bolts (and I made sure that the cables were not moving - a common problem with this install) with the engine lock on and pin in.
View 22 Replies
My wife called today after arriving at work letting me know she was having trouble shifting the car from D(drive) to P(park). I know the Gear box is set up in a stepped configuration. Sometimes its smooth shifting up to park and other times its not.
2011 Elantra Gls
Silver w/tinted windows
View 3 Replies
2011 TDi 6 Speed (Sportwagon) with problems shifting into 2nd? Mine is currently in the shop under investigation for a balky shift when cold. The tech says it's not right, but then they find another vehicle in inventory with the same issue...currently waiting on a VW engineer.
View 16 Replies
2000 ls v8 sport shifts normally exept while shifting into 2nd, it kind of pops out but then locks then shifts normally.
View 9 Replies
My 97 Taurus shifts hard going into 2nd gear only. It started as just a cold problem but now does it all the time and there are no computer codes stored.
View 2 Replies
My Santa Fe 2001 model V6 4X4 Automatic shift gears down hard from 3rd in to 2nd. I checked transmission oil and its light brown. Should I drain and refill or not worth it.
View 7 Replies
1983 Celica-Supra P-Type, 38K miles. Garage kept, never abused... I have a really hard time shifting into 4th gear. Rebuilt clutch master & slave, adjusted pedal. Buttery smooth 1st-3rd. 4th does not grind but requires a lot of force to shift. 5th shifts ok, but feels vague; hard to tell it's in gear.
View 13 Replies
