Elantra HD (2006-10) :: 2008 - Steering Wheel Makes A Binding Noise When Turning
May 13, 2012
I have a 2008 Elantra with 59,000 miles. When it is warm out (70 F+), the sterering wheel makes a binding noise (squeeking noise - it is hard to describe) when turning. It doesn't do this all the time and it is much more noticeable when it is warm out. The temps are usually mild. This is a recent problem as I haven't noticed it before.
Should I be concerned about this? I want to get it checked before the 60,000 mile mark in case this is a serious issue such as rack and pinion steering problems.
View 4 Replies
Advertisement
I bought an '08 Elantra about a month ago. A few weeks after buying it i noticed a creaking noise while turning the steering wheel to the left. It happens at low speeds or when stopped, but I haven't heard anything at high speeds. I can't tell for sure but it sounds closer to the inside of the car than the outside and will happen the entire time the steering wheel is turning to the left. No sound turning it to the right.
My brother liked my car so we test drove 3 other Elantras, 2 '08s and an '09. Two of them made the exact same noise. He ended up liking the one that didn't but after a while his started making the EXACT same noise too. I'm thinking this must be a common problem with the '07-'10 Elantras as all 4 cars had the same noise, but I can't find anything about it.
My right strut is bad and I'm having both front struts replaced Monday, so if it's something that can be done while he's doing the struts I'd like to find out before he takes everything apart so he doesn't have to do it twice.
View 1 Replies
I have a 2007 elantra. I drove it for a while, then my ma needed a car (her tercel was a little unsafe) so I traded her. She loves the car, but as sometimes is the case, her dealer is not very nice. She has a severe side to side knocking noise in the steering- can be easily duplicated by sitting with the car idling and turning the wheel back and forth, even a little. Doesn't correspond with driving over bumps unless the wheel is inadvertently turned by the bump. If the suspension is unloaded (front wheels off the ground), noise disappears. No EPS lights, no codes in any system.
Listened with a stethoscope inside the car- not that loud through column within car. Inner and outer tie rods are tight, noise is not heard loudly with stethoscope through struts, upper mounts, lower arms. Under the car with loaded suspension (rhino ramps), noise is deafening in the rack, with a stethoscope. Dealer told her it needs a steering rack, I definitely understand why they would say that as the noise is clearly audible through the aluminum housing directly below the entrance of the column shaft into the rack. Only TSB I found was for a worm shaft flexible coupling, but the TSB says this is bump related.
View 7 Replies
I've recently replaced the power steering pulleys and belts. Now when i turn car, it makes a clunking /clicking noise and sometimes the power steering tugs back a bit. 2010 camry.
View 3 Replies
I have some big time slop in my steering wheel, and what started as a type of binding when turning sometimes, is now really sloppy - almost dangerous
Is this the intermediate steering shaft? I just want to be 100% sure that I get the right thing before I buy it, as it's a dealer only part.
View 2 Replies
I'm having an issue with my 2004 Elantra.
When I turn the ignition in my car, it makes a very loud noise at the front of the car. This goes away after about 3 seconds, but when I turn the wheel to either side, it makes a very high screeching sound. This persists until I've been driving for a few minutes then it goes away.
I hesitate to say the following, but it also feels as if my steering wheel is a bit "harder" to turn, but maybe it is my imagination. What it could be? I checked power steering fluid and it is at normal levels.
View 2 Replies
I have a 2008 F-450 Lariat 6.4 4x4. I recently started noticing the front driver side wheel (best I can tell) wheel makes a noise as though it's binding uo when turning either direction, and I can feel it as well. 4wd is not activated and the hubs are in auto. When the front end is off the ground, I rotated the wheels and they spun independently unless the hubs were locked. I noticed what appear to be seals on both the driver and passenger side hanging loose (see pics). What this might be? I recently used the 4wd when we visited White Sands National Monument while pulling a 5th wheel RV.
View 9 Replies
My 2009 Impreza 2.5i manual transmission makes a clunking binding when I turn. What the issue is it goes away and comes back.
View 1 Replies
I recently picked up a cpo rx 350 and my steering wheel makes a squishy rubber-rubber friction kinda noise when I turn - especially when I am reversing. Is it common and does it go away?
View 14 Replies
I bought an 09 Accent and love the car, good mileage and actually quiet. I have developed a noise when I turn my steering wheel. It is not there when the car is cold, but after a few moments, when I turn a corner, I hear sort of rubber on rubber sound as I turn the steering wheel.
View 2 Replies
I have an 08 F-150 5.4. When sitting still or moving, and turning the steering wheel to the right and only the right past center, there is a popping type noise somewhat like a screw driver down a washboard (for those who'll know what that is). I replaced the ball joints because I saw a slight amount of play, but the noise is still there.
View 12 Replies
My Elantra has been making a click noise every time I turn the steering wheel. The noise comes from somewhere in the area behind the wheel, not from the engine apartment.
If I turn the steering without turning on engine, the noise could still be heard. So I am quite sure its' not a power steering problem.
So far there is no effect on driving, I could turn normally and the power steering works well.
Doesn't seem to be a problem with the indicator light switch as they still work as normal.
View 7 Replies
When I am sitting at a dead standstill and I turn the wheel lock to lock, left or right, I hear a clicking sound. The clicking is louder inside the car, but I can't tell if it's coming from the steering column or the various linkages in the suspension or drive systems.
If I drive in circles, with the wheel at a constant (or changing) angle, there are no clicks, so I don't think this is a CV joint issue.
What could be causing this noise? I really don't want to take off my lowering springs and restore this thing to the original configuration for a warranty repair visit to the dealership.
If I do, you may see a fire sale of H&R 20mm wheel adapters and B&G lowering springs in the near future.
View 3 Replies
Changing wheel bearing on mk4. makes noise when i turn to the right. what side is bad? i like working on my own car but this might be out of my hands.
View 12 Replies
2007 Hyundai Elantra, gets this noise/squeak when around freeway speeds.
I took this short video, squeaking starts around half way in: Video - TinyPic - Free Image Hosting, Photo Sharing & Video Hosting
This is a really annoying noise .
View 3 Replies
On my xl-7 upon turning left it makes a poppping noise, its real bad at complete stops,its almost like a cv axle noise. Ive taken it to the dealer at least 8 times and they replaced struts , but it still makes this noise.I also called the main Suzuki customer office and complained. They told me its just one of the characteristics of the new Xl7.
View 4 Replies
I have a power steering pump that makes a moaning noise when turning. Normally this means your fluid is low, but mine is full. Is it possible the reservoir is clogged not allowing fluid into the pump? When you take the cover off the reservoir the fluid is frothy so you know the pump is cavitating.
View 4 Replies
Here's my problem, I have a B5.5 1.8 5speed and my power steering makes a whining noise when Im turning. I checked the fluid and it's full. A few years ago on a roadtrip from CA to NM, my PS cooler hard pipe had a leak and drained all the fluid. It's was 11pm and still had 30 miles to get home and all I could get was Pennzoil PS fluid from Walgreens. So for the past 3 years I've been using Pennzoil PS fluid. Just recently it started making this noise. Luckily I picked up a 98 AEB parts car for $300 and my question is,
Would a power steering pump from my B5 fit my B5.5??? And, If the problem isn't my pump, would the PS rack fit also??
View 3 Replies
I have a 01 Chrysler Sebring 4D Sedan. I have been working on cars many years, never done tie rods. This my first attempt, I messed something up I believe. I replaced both inner tie rods and outer ends. I followed what I thought was correct procedure., counted turns on ends coming off. Installed new ones the same amount of turns. Before I did this the steering was fine. Now when I turn sharp to the right or left, like turning in to a driveway, I get an awful binding grinding noise, and I can feel it shimmy in the wheel. It will even stop the car going hard right. I can see evidence of rubbing on the CV boot closest to the wheel on the pass side. I assume I messed up somewhere with setting the steering when I installed the Tie rod ends to the wheel hubs.
View 19 Replies
I have a clicking binding noise while at idle, with the clutch out it goes away, when depressed its there. So, is this a bad throw out bearing? Clutches and flywheels?
View 12 Replies
My car makes a trouble sound when turning the wheel. It has been to the shop and new steering wheel fluids and a few other adjustments were done. I have a friend his daughters car just started making the same sound. My car has been doing this for months. We both have the same make and year car.
View 4 Replies
