Elantra MD (2010-15) :: 2016 - Washer Fluid Pump Location?
Jan 25, 2017
Got a problem with my wifes 2016 Elantra... The washer fluid pump stopped working.
The wipers work, and their is no blockage in the fluid lines from the tank to the nozzles. I used my compressor to blow out the lines in both directions. I've done some research, and someone said if the wipers work its not a fuse issue.
I saw a video on you tube for an older Elantra, that showed the pump behind the headlight... Does that hold true for the 2016? And if so, how do I get the headlight assembly out?
View 5 Replies
Advertisement
Looking for info from Bentley manual which relay is for the blower motor, washer fluid pump and 12v outlets? They all went out on my brother's Passat. I'm thinking it must be the relay as we have tested each fuse and they all test fine.
View 1 Replies
I have a 2005 F-250 6.0 Powerstroke.
My washer fluid pump is not working, it was a few weeks ago but now it is broken. The Owner's Manual only has the listing fuse 33 for "cluster, 4x4, wipers". It looks like some of the older models have an actual fuse for the "washer fluid pump". I checked fuse 33 under the dash and it is ok. What fuse controls the washer fluid pump?
The pump does not make noise when activated, so I'm starting at the fuse but I don't know what the hell is going on.
View 5 Replies
I own an Elantra GLS 2012, and starting a week ago, I noticed my windshield washer was coming out through the nozzles with low pressure (1/2 of the windshield). Yesterday one stopped working and the left nozzle is "spitting" (1/3 of the windshield).
I thought they are clogged and today I tried to unclog them using computer air cleaner, but air was coming out through the left nozzle with pressure and nothing through the right nozzle. When I tried to wash my windshield, no pressure on my right nozzle and low pressure on my left nozzle. Same as before.
I plugged off the tube from the hose connector under the hood, and if I pull back the control bar, I have a stream of washer liquid over 3m (10ft) long, but if I put my finger on the hose, I don't have pressure on the windshield washer.
My question is: the nozzles are clogged or the pump is dead?
I know the clogged nozzles are not under warranty, but what about the pump?
View 15 Replies
Where to find the headlight washer pump fuse. My owners manual does not list it for some strange reason.
The washer heads both extend OK using the service button, but when I pull the washer stalk only one (RHS) pops out and no fluid comes out, so I am guessing the washer pump has stopped working.
View 9 Replies
So recently I decided to add some fluid to the windshield washer tank, but when I added some, a clump of slime fell right in. Needless to say I couldn't do much about it. Now I have no fluid running through the system. What could I do to purge the junk out of the system? And where is the pump that drives the system?
I figured out I would have to remove the bumper to get to this part. In theory I could take it up to the dealership ...
View 32 Replies
A friend of mine almost crashed his 2014 Santa Fe during a snow storm, his washer fluid pump stopped working and he could not see in front of him on a bridge, he could not stop on a bridge. He has been scared to death. The dealer found out that the pump was completely rusted inside and out. It should be made of stainless. not steel. The dealer told him he was not the first to report this problem.
View 5 Replies
I know I need to remove the reservoir to replace the pump but I can't get it out. I removed the storage compartment, then the bolt connecting the translucent top portion of the reservoir that connects to the front and the side bolt that connects the reservoir to the side of the truck. It is loose but I still cannot get the reservoir out.
View 1 Replies
On our '06 Avalon Limited, my wife had parked the car was parked in the driveway and about 30 min later I walked by and heard that the wiper fluid pump motor was running non-stop. The only way I could get it to shut off was to loosen the fender liner and reach in and un-plug it. I'm thinking relay, but would it be that, the switch, the motor itself, where should I start and how can I tell or diagnose short of replacing them?
View 3 Replies
Okay, So my rear washer is not pushing out the nozzle. Pump works, line from res checks okay, nothing frozen at this point. What route the line goes through the body, or what the diag steps are or the process to service it?
View 10 Replies
I have a 2003 Explorer Sport and the windshield washer pump is not getting power. Owners manual does not show fuse or relay locations.
View 2 Replies
I am a new owner of a 2006 F 250 6.0.
I need to install a new washer fluid pump. My question is what is the best way to get the old one off and the new one on? Should I go from under the wheel well? Or is there another easier way to get to it? The truck didn't come with an owners Manuel and I cant find anything about how to do this.
View 2 Replies
I have a 2005 Elantra and the fluid will not spray onto the windshield. The washer motor is good and the switch is new. What is the problem? Wipers work fine.
View 3 Replies
My 1999 Jeep Grand Cherokee sprays a very weak stream of windshield fluid for the front and back windows. Fluid reservoir is full. Where are the fluid pumps for the front and back windows? Is it hard to replace or is it a job for the professionals?
View 5 Replies
Noticed that the windshield washer fluid level is ALWAYS low, needing significant amount to refill, even when not used? I'm not talking weeks or months, so that evaporation could be the cause, but rather DAYS. No evidence of leaks under vehicle, either. What could do this?
View 18 Replies
2012 Elantra GLS ... The windshield washer spray pattern is too low. The nozzles on the Elantra appear to be entirely plastic unlike the conventional ball which I can poke a needle in to adjust it. I ran the hand under the cowl cover and could not feel any kind of adjustment mechanism. How to adjust the nozzles to aim higher.
View 27 Replies
1989 Shorty - 3.0
problem with washer fluid - the motor seems to work, but nothing comes out of the tubes...
I know the motor works, cuz there is water all over the engine compartment (near the battery) and down... soaked there...
so, my guess is that the rubber has come off the pump? where is the pump first off, and second, how do I get to all that? - just remove the cowl?
any diagrams or photos would be great!
View 14 Replies
I have a 2010 V-6 Camry that has been sitting for a couple years, changed the oil (what a system that is !) and was wondering the location of the fuse or the relay for the fuel pump is so I can crank the car over awhile to build up some oil pressure before I start it .
View 4 Replies
Elantra 2011 1.8 engine ... Where is the PCV valve located?
View 1 Replies
2004 super duty crew long bed 2wd, v10 auto SLT.
Manual says not in fuse block.
Looked behind radio, nothing, not even a space or the blue one there.
There are some on the firewall, driver side not marked. No pink wire.
Where else??
View 2 Replies
I have a 2013 Elantra with 145,000 miles. The A/C isn't working--just blows out warm air. I checked and the compressor turns on when I hit the A/C button. I'd like to try refilling it. I can't find the low pressure valve location (only high). No luck on Google.
View 4 Replies
