Had to replace the ignition switch. after I went to crank it after switching it out, there was a buzzing around the relay control module. Thought that maybe somehow the ignition tripped something in it so bought a new one. IT is still buzzing and car won't turn over. everything lights up on dash. tried to see if there were any codes and the scanner just reads "fail".
View 5 RepliesI've got a problem with my 93 ford escort. About a month ago things in it began to stop working. 1st the wipers and then the heater. and now the ignition won't start my car. It will allow it to turn over but it doesn't turn on the engine light before it starts to kick in. Bad key assembly or the whole switch? Or a relay ?
View 2 RepliesI just bought a 2001 Dodge Ram 1500 (Magnum Series); 5.9l, 2WD, 8cyl. After 2 months the transmission went out. I bought a used transmission and had a shop install it. When I picked it up (10-3-14) the mechanic pointed out the shifter is one notch off (ie. in R position its in Park, in N position its in Reverse, etc). In addition it no longer has D1 nor D2 (putting the shift in D-D2 position results in Drive only, no power gears). The mechanic said it was something in the steering column causing the shift display to be off and had no explanation to why there were no power gears.
To make matters worse, the ignition switch no longer reverts to the Off position; the key can be removed but the switch stays On, warning alarm for key being in ignition comes On etc. I admit the ignition switch was old and the switch would sometimes not turn over before the transmission was replaced. He blamed something in the column again. So,
Q1-Is the mechanic correct there is something wrong in the column and not a misalignment he caused when he installed the replacement transmission causing the shifter to be misaligned?
Q2-Why doesn't the truck have D1-D2 gears? Do some transmissions not have these or am I missing something?
Q3-Is the most likely problem to the ignition the ignition switch or solenoid? Or could he have damaged something during the transmission installation? (I ask the latter because he took a panel off under the steering column while installing the replacement transmission.)
I was having all the tell tale signs of the almighty ignition switch. No lights, wipers, heater fan. But I didn't have time to change it. The other day went to start it and nothing. I changed the switch I have headlights wipers blower fan now which is sweet. But the car still wont turn over.
View 2 RepliesWhen I put my key in the ignition, I cannot turn the key. I tried putting a small amount of WD40 in the ignition and turning the wheel back and forth while trying to start, but all that did was make my key greasy and my wheel lock up. I've tried getting a new key made from Lowes and Home Depot, but their keys are too wide and will not fit in the keyholes. The only thing I am down to is replacing the ignition switch completely but I'd rather do that as a last resort because my car has had a big problem every week (alternator gone, new wheels, new master cylinder, new rotors/brakes). I haven't explored yet? And also, if it comes down to replacing the ignition switch, how would I do that without being able to turn the key?
View 2 RepliesI put my LS 430 key in my RX330 yesterday, I realized as soon as the ignition would not turn. I put the RX key in, and ignition will not turn. I'm assuming that the pins may be locked so I tried a few options.
- I wiggled the key.
- I lubricated the lock.
- I tried rocking the car while trying to turn the ignition.
- I tapped the ignition lightly with a screw driver and hammer, but no luck.
- I turn the steering wheel while turning ignition to make sure its not locked.
I really don't want to get the car towed to the stealer/dealer.
I have a problem with turning my key. It will not turn at all. I have taken the upper and lower part of the cover off to expose the switch and removed one screw from the ignition housing, but the internal part of the ignition switch will not come out. How do I completely remove this ignition switch. I have already removed the negative battery cable. It seems this is a continual problem with focuses. Oh, do I need a releasing tool to release the ignition switch.
View 7 RepliesI have a 2000 Staturn LW2 auto, 6cyl. When I try to turn on the car, sometimes the engine does not turn, doesn't make a sound, nothing. When I move the steering wheel, it turns on fine, it has to be in a certain position. Does that mean, the ignition switch is faulty or is it the pin? Is there a test I can do?
View 7 RepliesI am having a little issue with the ignition in my car. I had the typical no headlights/wipers/heater etc. so I ordered up a new ignition switch and when I went to replace it, the switch fit perfectly and had the correct part number but when I put my key in to try and start the car I couldn't even turn the key but when I put the old switch back in it would turn just fine. Also when I removed the old switch I noticed the red wire going to the switch was slightly burnt right at the terminal.
Here is the basic procedure I did:
-Unhook negative battery cable
-remove lower dash/ center console
-remove switch
-install new switch
Whats this little metal piece? I did not see that when I did mine...
I'm having a problem with my ignition switch. It won't turn and I have to turn the steering wheel for it to finally work.
View 4 RepliesI have recently been having problems getting the ignition switch to turn. There seems to be a negative correlation to warmer weather (the warmer the weather, the more likely I will have a negative experience --- and I will get the switch to turn only with some difficulty). When I have such a failure (in which the switch does not turn), I take the key out, wipe it off with my hand, flip it over and shove it back in. Sometimes this works with one try. Sometimes it takes multiple tries. My fear, of course, is that one of these times it will never work, and I will be stranded. I should add that I do have another key, and that I have had the same experience with this key. I don't really want to spend hundreds of dollars on a new ignition switch... and I especially don't if that is really not the problem.
View 2 Replies97 Toyota Camry 2.2l motor.
Sometimes, when I turn the ignition on I don't hear a sound and all the power dies in the car (the radio ejects the CD and all the presets are erased when I turn it out of start). This can happen once or twice in a row then generally the car starts up normally.
The battery is brand new (1 month) and is fully charged. My hope is that it's the starter drawing too much power when it tries to start? It's entirely possible it has the factory starter still on the car.
In the mornings when I turn the ignition switch to on right before starting, I don't hear the fuel pump wining. I notice the wining on almost every other car that Ive drove. I don't know if its because of this I get a rough start. It usually happens only in the mornings especially on cold days. During the rest of the day I can hear it clear and it turns on right away with no problem. I have tried to turn the ignition switch on then off then back on to see if the pump would turn on but nothing. Also sometimes I have to keep the gas pedal down about half ways for it to turn on and not stall. Tomorrow I am going to check to see if any fuel lines are clogged.
Car is a 2000 accent gs 1.5l 12sohc ... With about 87500 miles on it ...
Anything I should replace with these many miles ... Planning to replace spark plugs and timing belt myself ...
'04 RX330: Starting about a year ago, occasionally when inserting the ignition key it wouldn't turn to start. Take key out try again and it would start. Progressively, it seems to be requiring more and more in/out cycles to get the key to turn. It's like the transponder is not recognizing the key FOB. I have two keys, one is a master and other is a sub key, both have the problem. What has to be done to correct it? I'm afraid the dealer will just change some expensive ignition part when there's an easier fix.
View 14 RepliesI'm trying to get friend's 04 F150 4x4 started. I think it might be the ignition switch. Here's what I've done. Turn the Key and nothing happens. Not even a clicking sound from the battery.
-verified the battery had a good charge and that terminals were clean, connections were tight.
-checked the fuses in the passenger side kick panel, none were blown
-Determined there was power to the primary Pos wire going to the starter , but no power being sent to the smaller wire that goes to solenoid at the starter.
-Hooked a jumper wire to the starter solenoid and engine did crank (so starter is good and battery is making good connection)
This is why I'm thinking its the ignition switch.
1) Where is the ignition switch located?
2)How can I test the ignition switch?
3)Could it be the "cylinder lock and keys" that is faulty?
I have a 1999 ford escort that is slow turning over and now does not turn over at all. I have replaced the battery, starter, alternator and neutral safety switch.
View 3 RepliesI have a 1992 ford escort lx that I just got and it is a great car cheap on gas a great work car but the only thing is the av doesn't work. I can turn on the air to cool but when I turn on the ac my car stalls out. So my question : what the problem is?
View 6 RepliesI have a windstar 1998 model got into it not reversing was told range switch faulty because its drives and parks. Had that replaced still not reversing though reverse light comes on.
View 5 RepliesSo I recently (within the last month) replaced my DV for a Forge 007 and my stock air box for an EVOMS v-flow. My cel came on after the DV switch and was throwing the P0420 code at me. Then I swapped the intake and it has been good but I felt like I was running a bit rich and pulled my codes and it now has P0030 in addition to P0420. Why this is? I have 88K miles. Spoke to a mechanic and he says he thinks it is my cat dying. I'm a bit confused since I have a turbo back exhaust.
View 6 RepliesMy radiator cooling fan is on all the time. This is a 93 escort wagon with the 1.9 L engine and A/C. Even when the engine is stone cold the radiator cooling fan is always on. I might note that the A/C switch is OFF and as you might guess, the A/C compressor is off as it should be. On most vehicles and I presume this escort is the same, when the A/C is activated the radiator cooling fan will be activated as well. Do you know of a few things I should check that would cause the radiator cooling fan to be activated as soon as I turn the key to start, then run, even though the engine is stone cold?
View 8 Repliesmy car stopped starting. when you turn the key i hear a buzzing noise from dash, but nothing else. tried replacing ignition switch, no result. removed starter had it tested, passed. checked battery, passed. Don't know what to try next.
View 3 Replies