Ford 6.0L Power Stroke Diesel :: Shift Lever Sticks In Park
May 4, 2017
A few months ago I couldn't get the shift lever out of park without trying multiple times. Then it was okay for about 5 months now it is back and worse. It is not bound up because of parking on a hill or anything like that and I press very hard on the brake pedal. It take s multiple times to get it out of park trying turning the key on and off and so on. The truck only has 86,000 miles on it and the transmission has always worked perfectly.
View 6 Replies
Advertisement
I just noticed I could manually down shift transmission in D drive by tapping - on shift lever. I thought this was only possible in M manual mode.
View 3 Replies
I have a 2007 Touring Edition PT Chrysler Cruiser which was just a few days ago repaired because of damage under the front of the car. Front bumper, ouside and inside grills, all housings and connecdtions in the front area were replaced, including air conditioning mechanisms. Received car on Monday, Friday evening, it wouldn't start. Just made a tet tet tet or clicky kind of noise, no turning over of engine, then there was no noise ... just wouldn't start. Got jump, still wouldn't start until the third cycle that peddle was pressed. Now I'm finding that the longer I let the car idle, the more likely it will be to start after more than two hours of non-use. Had all electrical circuitry checked ... battery's 100 percent, alternator is working fine, but it's still not starting.
Car's gear shift button at top of lever is also sticking when I put it in park to turn the car off. Have to pull the top button up to get the key out. This was happening before car was repaired underneath front. Talked to warranty person, and he felt that maybe the ignition starter switch (if that's what's wrong) and sticking gear shift may have something to do with each other. Since car is actually starting after being run, maybe it's not the starter switch. I'd hate to get it repaired if that's not what it is. Thinking about having a Chrysler dealership do a diagnostic test on it to pinpoint exactly what is going on.
What's happening? Why is my car cutting not starting in selective situations after not having been idled for a couple hours or more?
View 3 Replies
2011, 69,000 miles. My truck is experiencing very hard shifts from park to drive or park to reverse after a cold soak. It goes away once warmed up. I can't find any excessive driveline play and my transmission fluid level appears fine and in good condition.
The last repair done on my truck was around 7,000 miles ago and it was for a transmission fluid leak around the bell housing. They just replaced the seal between the torque converter and transmission.
View 13 Replies
2003 6.0 has had hpop replaced with adrenaline hpop, updated hpop cover, new oem oil cooler and gaskets, holder premium 175/30 injectors, new lpop and front cover, new cam and crank sensors, all new pigtails, rebuilt turbo with 360 bearing and kc billet wheel, egr delete, coolant filter. New ICP and IPR, oem filters and cap. All work done by reputable shop. Truck will run fine and then just die like you turned off the ignition. Everytime IPR is stuck open. Replace IPR and truck will run fine for a short period and then problem will reoccur.
View 9 Replies
It's a few times in the past 2 weeks, the shift lever won't come out of PARK easily. Sometimes I have to wiggle the shifter for quite awhile before I can get the shifter to shift out of PARK. It also doesn't start when that happens, like everything works but it doesn't start. It's like it's locked. It finally lets go and I can start it and put it in Drive and Reverse and go on my way. But there's not set thing that I can do to make it work.
It's just luckily let me go the few times it's happened. We replaced the shift cable about 1.5-2 years ago and of course the cable is out of warranty. But even if it's the cable, it's definitely going into park because you can hear the click when you stop the truck and turn it off, and throw it into PARK. But when the shift get's stuck it won't crank or make any kind of cranking noise, it's like the battery is dead but it isn't. When it happens you can't even shift it out of PARK to try and start it in D or R.
So I was thinking something could be going on with the NSS. Is there any kind of brake pedal interlock switch on a 98 Ranger? I notice when I start it and press the brake pedal it clicks loud under the dash, which I don't remember hearing always. But maybe it always makes that click when you hit the pedal because I usually always have the radio on. What I can do if the shift gets stuck when I go to leave work? What do I need to look at to determine the problem?
View 3 Replies
My 2009 Ford Escape shift lever is stuck, not allowing me to shift out of park without using the manual override. However, when I slam my foot to the brake (rather than simply stepping on the brake), the brake switch relay, etc. all engage and I am able to shift out of park. Is this a brake switch relay problem, or is it possible that it has to do with the age of my brakes, etc?
View 3 Replies
I searched for a prior post on this without success. I have a serious problem with my '04 V-8 transmission shift lever being stuck in Park in cooler weather. Ny wife is the primary driver, and on some cooler mornings it is almost impossible for her to move the shift lever out of park. She has to let the car warm up a bit, and then move the lever around a bit with all her might before it will finally move out of park. The dealer can't figure out what is wrong. It only appens when the temperature is below about 50 degrees, and with winter approaching, frequent problems lie ahead.
View 24 Replies
I have just bought a 2001 Prius with 127,550 miles. Hybrid battery has been replaced with a used one and all systems seem to work fine except the shift lever in the "Park" position does not lock the transmission. No big problem as long as the Parking Brake works. Preliminary investigation does not reveal any easy fix.
View 6 Replies
I searched for a prior post on this without success. I have a serious problem with my '04 V-8 transmission shift lever being stuck in Park in cooler weather. Ny wife is the primary driver, and on some cooler mornings it is almost impossible for her to move the shift lever out of park. She has to let the car warm up a bit, and then move the lever around a bit with all her might before it will finally move out of park. The dealer can't figure out what is wrong. It only appens when the temperature is below about 50 degrees, and with winter approaching, frequent problems lie ahead.
View 24 Replies
I have a 2009 Santa Fe and last night, out of the blue, the engine wouldn't start. The shift lever was stuck in park and the brake pedal was very stiff and wouldn't move much. I popped the cap off the shift lock and moved it to neutral at which time the car started without a problem. I could drive but shifting was difficult and the lever didn't really click into a gear. I noticed that when shifting gears. the indicator on the dash would change from N to D and to R in reverse but when I moved up to park, the indicator went blank and the lever locked up again and had be released manually. I also noticed when I got home, since my driveway is a slope, that when the car seemed to be in park is rolled down the driveway, so I had to engage the emergency brake.
View 13 Replies
Seems like I have an issue every other week of driving my truck. Today I arrived at work and attempted to shift into park but it wouldn't go. I went to tighten the bolts and after tightening it still wouldn't work. So I tried tightening them again and the top of the top bolt broke off. So I took a nut and a lock washer and put it on the other side (was very hard) and got it tightened best I can. It looks tightened pretty good but I still can't shift into park. Maybe the bushing for that piece are bad? I have no clue where to go from here or what I need or even if putting a nut on the bolt works.
View 4 Replies
Won't shift into park, Checked the two bolts and they were tight. Ended up having a rock wedged behind shift lever on the transmission.
View 3 Replies
My Daughter owns a 2000 Camry. It has a very annoying habit of not starting when it is warm (think driving to the gas station, turning the car off to fill it and then it doesn't start again). We have tried new solenoids, a new starter and several other tweaks but nothing seems to fix the problem. Recently she discovered if she jiggles the gear shift lever (it's an automatic) it will start. So, obviously she gear shift lever is not finding Park or Neutral so that it can be in position to start. She has experimented with this concept and it appears to be the only thing that consistently solves the starting issue. What would we have to fix in the gear shift lever, or elsewhere, to fix this problem?
View 5 Replies
I have been having an issue with my 4-5 gear shift under hard acceleration and know that a rebuild is due soon but I was wondering if any high performance kit available with all the clutches and friction discs needed to rebuild.
View 6 Replies
Borrowed a buddys trailer that had wiring issues. I ended up blowing a mini fues & maxi fuse in my truck. 06 F350 CC ... Replaced both fuses in the truck and had park lights on the truck but now dont get any lights on any trailers. All factory plugs 7pin & 4 pin. I get turn signals and brake lights on the trailers but that is all. If the fuses are good were should I start looking for problems? or is there more fuses I may be missing. I have metered all the fuses under the dash aswell as under hood all check out. Where to go next ???
View 14 Replies
Get the message every time at start up and won't go away. It doesn't seem to be working when I back up near something. If one sensor goes does the whole system shut down? Also It won't let me check the "ON" box for the park aid.
View 6 Replies
OK I know it's not a 6.0 or even a diesel. I had my Ford Expedition(2005) in to have rear main bearing seal, transfer case input shaft seal, etc, which included dropping the transmission. When we picked it up I noticed that it now shakes when in Park and Neutral when at idle. The shake cycles every 2 seconds or so, shakes for 2 seconds, smooths out for 2 seconds, shakes for 2 seconds, etc. There are no codes thrown, it runs smooth in gear running at interstate speeds and in town driving. They put the scanner on it, unbolted the transmission and re torqued them, and a bunch of other stuff. They are lost. I though maybe the torque converter wasn't in balance or something but they ruled that out.
View 1 Replies
It clunks real bad at random times. Whether I have had the e-brake on or not (sometimes even with it on, so I have not put any load on the locking mechanism in the tranny).
Its a 2014... Does not matter if its inclined ground or flat.
My 08 F350 V10 it replaces never once clunked.
View 14 Replies
Wrestled with them for a while today to no avail. Can't get the big spring under the lever thingy. I hate drum brakes. I don't have the special tool to pull axles on my sterling.
View 13 Replies
Ok so I just put an egr delete and a new oil cooler in the truck. Everything went pretty well but when I was going for a test drive I'm not building any boost. I can here the turbo whistle like always but there no power and none of my gauges register boost. Also, the transmission is shifting funny I don't know how else to explain it but just not right. Now I don't see/smell any exhaust leaks and can't hear anything too wierd in that department. I checked the intake and the intercooler tubes I think their called and all good there. However, I did break my map sensor post off my intake during the install . So my map tube was just open to the atmosphere I didn't plug it or anything. Could that be the cause of my woes? Is there any thing I can do to alleviate the issues I'm having with the map? Can I just plug it until I fix it? And is there anything else to check on my turbo?
View 14 Replies
