Ford 6.7L Power Stroke Diesel :: When Safe Stop And Shut Off Engine Immediately Message After Buzzer
Mar 13, 2013
Having that flash on the dash? Truck was running fine and the buzzer when off and dash said I think -- when safe stop and shut off engine immediately. Scared the scr-p out of me so not sure if that was word for word. Jump on the binders and got it off the road and called a wrecker. Now it's at the dealer waiting for them in the morning. Checked oil and don't see any leaks. Now I have lost my confidence in the truck. 42000 miles on it.
View 14 Replies
Advertisement
On a 2012 ford f350. We put on a tommylift gate and took off bumper with sensors. We added sensors to tommylift, now constant beeping in reverse because of location of sensors. Is there any way to permanently disable the revese buzzer??
View 5 Replies
I have a 2011 F-250 with about 5000 miles. Sunday night, I was driving home and first got the CEL. Then less than 5 miles later, I got the red "Stop Safely Now". Pulled over and the thing just died. Checked the message center and nothing out of the ordinary other than the SSN message. Had to wait about 45 minutes for the tow truck and thought it might cool down. I tried to start it while waiting but got nothing. Battery was good and all electronics worked. Waiting to hear a diagnosis from the dealer.
View 14 Replies
Luckily I was sitting in the driveway. Pulled the truck out of the garage. It started fine, idled fine, did not make as much noise as I was expecting but was warmer in the garage than outside. Stopped in front of the garage door to grab a couple things in the garage, jumped back in and it quit before I could get it in gear and roll out. Weird. This is the first time I've ever had to get a tow.
View 14 Replies
2011 6.7L company truck that I drive. Couple days ago, got the Stop Safely Now message and CEL. There was noticeable loss in power as well. 10-15 seconds after SSN message, power came back and message went away. I'm assuming the loss of power was limp mode. It happened 2 more times today. Got to the dealer and they wouldn't read the code to tell me whether it was safe to drive, they were just too busy to take 3 minutes and read a code! Got codes read at O'Reilly and came up with the P2033 and P200C. I see where the P2033 may be a failing sensor, and that should be easy enough to confirm. My question specifically is regarding the P200C, Diesel Particulate filter Over Temp. Could this be a bad sensor as well, or could it be plugged causing the P2033?
View 3 Replies
I have had my truck for about 4 years bought it used. I've replaced the motor due to #1 cylinder blowing up. So after I replaced the motor, it wouldn't start. Replaced O rings on HPOP (High Pressure Oil Pump) and started. When moving back to Colorado where I am stationed. It started getting harder and harder to start.
Then it got to the point where it wouldn't start so I would have to wait until I could start it or use a shot of starting fluid and yes I hate that. But I don't have a choice. I've bought new O rings replaced them and my IPR with upgraded screen. It fixed it for a week then the hard start came back. Tried unplugging ICP Sensor still hard start problem. ICP was reading 85%. When the truck is cold it fires right up no problems till it gets hot! Then driving down the high and hitting an off ramp it will shut off. When I try revers it will also shut off. The truck only has 111,252 miles.
View 14 Replies
On cruise control, engine went dead immediately after passing gear kicked in. After 2 days on the side of the road got a pull to the house. Then after having a charger on it over night the electric seems to be messed up. Switched on, the dash lights light full strength for a fraction of a second before appearing as thought the battery is real low. Also the doorlocks act crazy. I think maybe I blew out the BB on the high oil pressure pump.
View 6 Replies
I have seen this pop up on the truck I think 3 times now over the first 4000 miles on the truck.
Usually it's when I'm on the highway around 70mph or so.
It comes on for a few seconds, then goes away. I do have an exhaust / tune on the car.
View 8 Replies
I haven't had any issues with this truck before but last night I pulled out onto the highway and my check engine light came on and a message saying engine power reduced I finally got it to reset after 4 times of shutting the truck off, was wondering what this may be without knowing the code. I tried plugging my edge cts into it from my 6.0 but it wouldn't communicate guess it needs a update trucks a 15 f350 with only 30000km.....
View 2 Replies
My low fuel light came on tonight. I drove about 2 miles, stopped and shut the truck off. When I restarted it and began to drive off to the fuel station a notice came on that isaid power reduced then a check engine light came on. I was about a mile or less from the fuel station so I filled up. I cycled the key but the engine light is still on. No low power message tho. The power is fine.
I came home and drained the water drain on the filter, didn't see any water but hoped it would solve the problem. I cycled the key a few times and started the truck but the light is still on. My truck is a 2013 f350 6.7 and has 211500 ish miles on it. I bought it a month ago with 18500 miles and haven't had any issue until tonight. My only thought is maybe the fuel filters need changed. I don't know if or when the previous owner changed them.
View 10 Replies
So I just went on a vacation pulling my horse trailer (first time leaving the state with this truck) and at about 5 hrs into the trip I had a message Reduced Engine Power and went from 70 on the interstate to 10 miles an hour and slowing rather quickly. I ended up shutting it off and restarting and it came back just like normal. I found the nearest ford dealer and they put the computer on it and it showed absolutely nothing, no codes and nothing wrong. The mechanic reset some things and we went on our way.
Then I ended up getting a check engine light saturday. I found someone to read the code and it came up with P164A which is an O2 sensor, he was able to clear it and I put on probably 50 miles today and no check engine light. I have about a 10 hour drive back home. Still debating if I take it to ford near here if they will do anything now that it doesn't show a light?? I hate to chance getting broke down on the highway with a truck that will basically shut down like that?? It just doesn't make sense to me.
View 7 Replies
I have a 2011 Ford F250 6.7 Powerstroke. It has 107,000 miles on it.
The other day I was driving it down the highway and it got a Reduced Engine Power message on the dash. It lost power and I got off the highway to the service road. Then it died on me.
Had to get it pushed to a station then towed home. It wouldn't start. The starter cranks over for a few seconds but engine won't start. Checked all the fluid levels and batteries. My DEF fluid was only a half gallon low.
What I have noticed is that the DEF level indicator hasn't reminded me that it was low for over 4-5 months now. I had been putting in about 2-3 gallons every 3 months or so. But it hasn't reminded me lately and I just forgot. This is my first diesel.
View 5 Replies
2015 F350 6.7L, 43,000miles
My family and I were driving into West Virginia this morning when the reduced engine power message came up on the dash and the truck died. I coasted off to the side of the road as best I could and got out. Immediately I smell diesel fuel. I look under the truck and there is fuel all over the passengers side frame and when I keyed it back up fuel started spraying down by the right front wheel.
Pulled the fender liner back and saw a small rubber hose that looks like it came off of a tee fitting down by the egr components. I tried to get it back on but wasn't able to get it seated 100% and when I tried to restart it blew off again. Truck is completely stock and ran perfect right up until it died.
View 3 Replies
Ok, It was -17 this morning. I had my truck plugged in and got in this morning and it started rite up. BUT, there was a warning light on, in the dash. The light that looks like a engine block. So, I drive by the dealer and ask him what it is. Hes tells me that the Def is frozen and when it thaws out the warning light will go off. So, I drive around pretty much all day today, but the temps didn't get above 5 degrees all day. Got home and the warning lights was still on. Another thing, when I went to put her into reverse the buzzer came on and stayed on. Guess it frozen too. You colder area guys have this same problem?
View 14 Replies
I replaced all my shock and the last one front passenger side gave me fits. The lower mounting bolt stripped and I am unable to secure the shock. My question is..is it safe to drive around without the front shock to get over to the parts house? I plan to use back roads and low speeds. 20 mile round trip.
View 6 Replies
I am working on a 2007 F350 ambulance for a volunteer fire department. It run great, even with the key turned off sometimes. This is an intermittent problem. About every 10 times it is used the engine will not shut off when you turn the key off. The instrument cluster turns on and off as normal. The other odd part is if you leave the key in the off position when the engine does not turn off the RPM starts going up. I have not left it in off long enough to see how high it would go. It does not have a remote start and never has.
View 6 Replies
My 6.7 makes a humming noise when i shut down my engine. Starts a little loud and gets softer at the end. it last maybe for a minute. But here's the catch if i stick the key back in the ignition it stops and as soon as i pull it out it starts again.
View 4 Replies
Ok this may be the norm, but I'm hearing something like a motor running after i kill my engine? It sounds like a fuel pump or something!!! O ya I have a 2011 6.7. I've had the truck for several months but just now hearing this....
View 11 Replies
I do not think, I have seen anything about the engine shutting down descending a steep grade. first it threw the "wrench" warning and than that the engine was going on limp mode. luckily no one was on the road with me, coming or going. i pulled off on the shoulder with part of the pickup and 5er on the road. no steering or brakes used the 5er brakes to stop. turned the key off and restarted it again and no code or warnings. like nothing happened. it happened twice today between yellowstone park and great falls, mt. the second time the engine light stayed on and i had to stop and turn it off and restart it and it went away.
View 14 Replies
The EMS service in the county next to ours lost one of it's new trucks for a few days on Tuesday. While going on a call, the engine made a tapping sound for only a few seconds, then a loud pop and shut off. Ford dealer went and picked it up and took it in for evaluation. VERDICT: Broken rod and cracked block. I have to say, this is the first I've heard of a 6.7L having a problem like this in our area.
Ford was really interested in this engine, as a new one is already on the way and the old one is to be shipped back for complete breakdown. So far, the Director and County Manager have been impressed with Ford's response to this problem. Dealer has told them the truck should be ready by the middle to end of next week. If I hear anything else, I will let you know. Any engine can break at any time, I'm just glad they are moving quickly to rectify the situation.
View 14 Replies
2005 6.0L F250 Lariat. I picked up a couple weeks ago. The message center in the gauge cluster will only show my mileage (kilometres) and engine hours but nothing else.
Also the three buttons/controls to the right of the steering column don't do anything. I checked the wiring behind the dash and it's all plugged in... The other problem is the SRS light will flash on and off while driving.
View 2 Replies
