Ford Escape / Hybrid :: Replacing Power Steering Pump Pressure Line


Jan 30, 2015

I need to replace my pressure line on my 02 Escape 3.0L. Looking for a DIY for doing this same job?

View 1 Replies

Advertisement

Ford Escape / Hybrid :: 2005 - Power Steering Pump Replacement

We are a 2 Escape family. We have an '03 and an '05 - both 4WD and 3.0 V6. My college freshman son purchased the '05 this summer to get to and from his summer job. It has a little over 173K on the clock and it has a power steering leak, so I decided to try to tackle this one.

There is a fairly good video on YouTube on replacement of the power steering pump on an '03 - but apparently on the '05 Ford decided to relocate the pump from under the upper right engine mount to a lower location closer to the front bumper so the video is not of much use in this case.

I have searched the web and this site but cannot find any tips or instructions to replace the power steering pump on the '05. The Chilton Manual I have does not acknowledge the difference in the power steering pump location on the '05 and only provides the procedure for those Escapes where the pump is located under the upper engine mount.

I think I may be able to get better access by removing the inner fender plastic and perhaps the front bumper cover, but would really like to know the accepted procedure before I start tearing into this one.

One interesting bit of info regarding power steering fluid on these vehicles. Ford designed them to use automatic transmission fluid (Mercon) instead of power steering fluid. Initially, when I saw the leak, I thought it was a tranny line leak. Then I traced it to the front of the engine which is totally on the opposite side of the vehicle from the tranny lines.

View 14 Replies

Ford Escape / Hybrid :: 2003 V6 - No Key On Prime / Zero Line Pressure

No key on prime. Inertia switch OK. Zero line pressure when filter removed & changed. Tries to start with ether. Front 3 coils are for sure firing. Swapped the pump relay with fan relay, no change, no prime.

I'm working with an 03 factory hard copy manual & I'm just not seeing a testing procedure, but I'm bat blind sometimes. What I'm missing? The patient had run fine all day, stopped for an hour. Got back in, started badly, shook somewhat, died, no start since.

View 13 Replies

Honda - Accord :: 1993 - Replacing High Pressure Steering Line?

So, I just found out that the noise my car has been making is related to the power steering. The mechanic said I need to replace the pump, two belts and the high pressure line. The car is a 1993 Honda Accord LX. I can't afford to have the mechanic fix it, so I'm going to have to do it myself. My questions are:1) how long should it take me? I'm not experienced at all. I was thinking of just doing the high pressure line as a 'warm up' to start. Is half a day wishful thinking? Any tips?

2) The mechanic said the hose is leaking all over the belts. He said it was "squirting and pouring out". I tried to duplicate the squirting by turning the wheel all the way and revving the engine. What I saw was a very small leak at the joint. So small it wasn't falling, but I'm sure it would if I waited long enough. The belts appeared dry to me, but I'm not really sure what they are supposed to look like. The mechanic said that they are getting soaked in fluid and that I might throw a belt. Anyway, so my question is how can I tell if the belts are "soaked in" steering fluid.

3) I've been told that if the belts are getting steering fluid on them they might be responsible for the loud squealing noise when turning. If I clean the belts with degreaser, and the noise stops, does this mean that replacing the leaking hose would be sufficient?

I'm making a long road trip in about a week (ca to wa). I'd prefer to deal with the replacement when I get to wa, but I also don't want to make things worse.

View 1 Replies

Ford 7.3L Power Stroke (1999-2003) :: High Pressure Power Steering Line Blown?

I just replaced my 3rd HP power steering line last night( 3rd in 300K, always blows the same point....fitting comes apart where it attaches to the pump.

I'll start, mine have gone about 100K plus or minus 10K, almost thinking about making it a 100K maintenance item.

View 14 Replies

Ford Escape / Hybrid :: 2009 - Power Steering Losing Power

Our escape recently started loosing its power steering, once the engine is shut off the power steering is ok. Also some times you can feel a pulsing in the steering wheel. I've been doing some googling and it looks like the dealers are replacing the steering columns to fix the problem.

My question : is this the only fix or if something like some contacts being cleaned or maybe replacing a steering sensor of some kind is the fix.

View 5 Replies

Ford Escape / Hybrid :: Power Steering Wheel Jerks When Turning Left

Have an 03 Escape / 3.0 and the steering catches when turning left. Steering wheel jerks. Replaced the pump about 2 mo. ago and seemed to work, but now it is back. Is there something else I should look at?

View 3 Replies

Ford Ranger / B-Series :: Power Steering Leak / Sensor On High Pressure Line?

I think I've tracked my power steering leak to some type of sensor on the pressure line, close to where it connects to the steering box:

I assume this is a pressure sensor? I got no CEL or anything like that when the fluid had leaked down to the level that the pump started whining pretty badly though. As far as I can tell by looking at pictures, the parts store replacement pressure lines do not have this sensor, or any provision to connect a sensor to it: Advance Auto Parts: Power Steering Pressure Hose by Powercraft - Part 71878

I may just put a replacement line on there and leave the sensor plug hanging and see what happens...

View 11 Replies

Ford Escape / Hybrid :: 2001 - Replacing Main Bearings?

Is it possible to replace the main bearings in a 2001 Escape 3.0 with the engine in the vehicle?

View 1 Replies

Ford Escape / Hybrid :: 2002 V6 - Check Engine And Low Oil Lights Come On And Power Steering Lost

Ive got an 02 2wd escape with the v6. Its been an excellent truck until here recently. The wife has had a weird problem twice now, that I have been unable to reproduce. She says the check engine light and low oil light come on and she loses power steering. Shutting it off and restarting fixes the issue.

Took a 400 mile road trip with it last weekend and never had an issue. Only thing I noticed , the readiness meters never went ready. Even after that trip, It still shows a systems not ready code.

Tonight the wife had the issue again. Shutdown and restart fixed it. Battery cables are clean and tight, several grounds were freshly cleaned a couple months ago.

View 1 Replies

Ford Escape / Hybrid :: 2005 - Replacing Alternator - 3 Pin Connector Clip Broken?

The 3 pin connector that connects to the alternator, I broke the clip. Do the local auto stores sell that connector in a pigtail form so I can just cut the broken one off and solder the new one in? I'm sure someone has broken that clip before.

View 6 Replies

Passat (B5) :: Power Steering High Pressure Line Replacement?

How do you get the line back on to the rack? There is absolutely no room and I have experimented with a variety of tools with no luck. What's the trick?

View 1 Replies

Caravan/Voyager :: Power Steering Pump Not In Line 2000 Grand 3.3?

I had a VERY bad leak, to the point where I would fill it, an hour later it all leaked out. I had a mechanic work on it, and he rebuilt the PS pump, BUT the pulley was cracked, they DON'T make that size anymore. He put a bigger one on, only to find out, it was rubbing on my brake lines so I couldn't drive it! SO I had another grease monkey work on it, went through a few new pulley's FINALLY found one! BUT went through 4 Serpentine belts!!

After 3 months with NO VEHICLE, we finally got it all back together. BUT now it is not all lining up we couldn't tell until we had the belt on. it is about a 1/4 of an inch to much to the right.

I'm thinking maybe washers or spacers would work?

View 4 Replies

Ford - Suspension :: Pressure In Fill Line Keeps Shutting Off Gas Pump

I have 2002 Ford Explorer and I have trouble filling it with gas. The pressure in the fill line keeps shutting off the gas pump. I have to slowly drizzle the gas in to fill the tank. Sometimes the problem is better, sometimes worse.

View 4 Replies

Accent LC (2000-05) :: 2003 - All Metal High Pressure Power Steering Line Has A Leak

I have an 03 Accent. The all metal high pressure power steering line had a leak. So I bought a new one for around 70 dollars from Hyundai. This part has a curved shape and fits around the radiator. The old one was difficult to get off, but the new one is proving impossible to get on. I cant get it into place.

View 2 Replies

Ford Escape / Hybrid :: 2005 - Fuel Pump Not Turning On

A friend has 2005 escape 3l. He called me yesterday saying that he needed replacing his fuel pump.

Before I got to his place he had already replaced the fuel filter...

We got the pump replaced, and when we went to start the vehicle, it still wouldn't start.

We double checked to make sure everything was connected and plugged in and it was. We checked all fuses, and they were all good.

This morning I am going to try jumping the relay and see if that does anything. What else to check?

View 3 Replies

Ford Escape / Hybrid :: Oil Pressure Light Was Blinking / Now Constant

I'm having an issue with my ford again. Escape, V6, 123k miles. Recent work done: Replaced all spark plugs, coils, and intake manifold gaskets. Replaced all four O2 sensors. Oil change switching from the 5w-20 to 5w-30 due to it getting cold, (probably a month ago?).

Now for my current problem. Two days ago on a 20* morning, after it sat outside all night, I drove about 3 miles and then noticed the oil pressure light was blinking intermittently. When I came to a complete stop, it stayed lit. I pulled into a parking lot and starting shutting stuff down. I noticed when I turned the heater blower off, the light went out. Turning it on to High, I noticed the RPMS on the tach dropped to around the 500 mark, and the oil pressure light came back on. I turned it off and let it sit for about 45 minutes. Oil is showing good on the dipstick. I then drove it the last two days without the light coming on.

Now this morning, driving it again in 20* weather, after it sat outside, the light came on again, in almost the exact same place away from home. Both times the motor had reached operating temp, with the temp gauge being in the middle between "C" and "H". This time, even with turning the blower off, it came on every time it was at idle. I let it sit another 45 minutes, but this time when I drove it, the light was more intermittent and then was constant.
Again, the oil level is good on the dipstick, and the motor seems to be running smooth. I'm wondering if this could have anything to do with changing over to a different oil and with it being so cold in the mornings?

I have it written down at home, but I can't remember when I did the actual oil change, but its probably been a little over a month. I went from 5w-20 Pennzoil, to 5w-30; wix filter. I'm planning on doing another oil change tomorrow when I get home and go back to the original 5w-20. Also, I'm ordering a new oil pressure sensor, and I'll try that also. I've also looked into an oil pressure tester....

View 14 Replies

Ford Escape / Hybrid :: 2008 - Oil Pressure Light Comes On When Stopped?

2008 Escape V6

Got the oil changed at Walmart and they told us there was oil in the air filter and we should replace the pcv valve. Before we changed it the oil pressure light had started coming on when the car is stopped, either in gear or park. Once the gas is hit it goes off, even at something like 1 mph. Well I changed the pcv valve but the oil pressure light is still doing the same thing. What should be my next step?

View 2 Replies

Ford Escape / Hybrid :: 2008 V6 - How To Change Belt On Water Pump

How to change belt on water pump on my 08 V6 the hayness says there is a tensioner on the v6 well i am stumped cant find it so ....... Belt is tight I see no way to get slack in belt to change it .top pulley and pump pulley is all i see...

View 11 Replies

Camry :: 2007 - Power Steering Hard To Turn After Replacing High Pressure Hose

I have an 07 Camry with a hard to turn steering wheel. I had to replace the high pressure hose from the rack due to a leak. After that I basically bled the system as one would do under normal circumstances. With the cars front wheels off the ground I turned the wheel hard left and right. The wheel did give a bit but not to the point of perfection. After many turns I put the vehicle on the ground and repeated the process. The fluid no longer leaked but the stiffness was still there.

The hose was replaced at 110,000 miles. It's currently at 112,000 miles

View 14 Replies

Ford Escape / Hybrid :: 2008 - How To Disable Low Tire Pressure Light

With winter on its way I have installed winter tires and steel rims w/o pressure sensors on my 08 Escape. Is there a way to disable the dash warning light for low tire air pressure?

View 14 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved