Ford - Explorer :: 1993 - Stuck In Forward Gear
Dec 28, 2015
A friend of mine at work has a 93 4wd explorer. A4ld transmission. Reverse quit working, and no matter what gear you put it in, reverse, neutral, or park, it will stay in drive. Park holds itself, but if you give it gas, it tries to pull. He says when it's in reverse, it's almost like it's stuck in reverse and forward, it wants to rock. He pulled the pan, no metal shavings, and pulled the valve body. He said the screws holding the valve body were finger tight. The gasket underneath had a small tear in it, he doesn't know if he did this pulling it out or not. He replaced those gaskets and retorqued the valve body. When he put it in reverse and topped off fluid, reverse worked. He put it in drive and it worked, but when he put it back in reverse, it stayed in drive and is staying in drive in all gear selections again. He bought this explorer new, and the transmission had never been into before.
View 3 Replies
Advertisement
I just got myself a 1993 ford explorer and the damn thing won't drive forward but it will drive in reverse. What could be the problem?? I've already drained the Transmission Fluid out & refilled it. My friend told me it is most likely the Neutral Safety Switch but I have no clue where it is located. I will be honest I have absolutely no clue about vehicles.
View 1 Replies
I have a 93 explorer it ran fine then when I drove it today it stalled put it in park it started but wont go into gear when shifted?
View 1 Replies
Have a 99 Ranger XLT, 4 cyl, manual transmission with 191K miles. Was running good as ever last night but went to start it this morning and throttle's stuck open, causing truck to move forward when in 1st gear. Even with clutch in, near impossible to get vehicle in or out of gear. Managed to get it into reverse, but truck was having none of it. What is the cause or causes of my trouble? Or how much the repairs might cost? I'm on the road so no chance of doing this myself.
View 2 Replies
'98 XLT 4.0 SOHC.
First of all overdrive started to play up, the engine would flare as it went into OD and often would have several goes at it until it engaged OD. Finally it wouldn't go into OD.
Still driving it around for awhile then it went into limp home mode - stuck in 3rd gear. What it might be?
View 12 Replies
I was pulling into my driveway. I put the car in park, but when i went to get out of the car, it started to roll forward. When I finally got it stopped, I tried to shift it, and it wouldn't shift to any spot. Then it became stuck in between Park and Reverse. I can't move the gear shift.
View 1 Replies
Last night while driving, my transmission made a pretty severe clunk, but then appeared to act normal. However, a check engine light came on so I pulled over immediately as I was literally at the entrance to a gas station.
I looked under the vehicle, under the hood, saw nothing leaking, nothing obviously broken etc. So got back in and started the engine, went to shift into reverse and the transmission clunks, same going from N into D.
I limped it home, but while driving noticed that it was not shifting but stuck in one gear.
This morning I scanned for codes and the only one showing is P0770 Shift Solenoid. I searched this forum though and get 0 results on that code, searching Google is also surprisingly vague. I believe (could be wrong though) that I have the 6R60 Transmission, it is a 2008 Explorer with the 4.6L V8.
Where to check first? When I get time I am going to check the fluid level, but could not last night as there is no dipstick!
View 3 Replies
Tranny started acting funny recently...shifting hard into reverse at first, then last night it was like it was stuck in high gear or slipping on the way home. Limped it home and took the following codes:
P0743 TORQUE CONVERTER CIRCUIT ELECTRICAL
P0750 SHIFT SOLENOID A MALFUNCTION
P0755 SHIFT SOLENOID B MALFUNCTION
P0760 SHIFT SOLENOID C MALFUNCTION
P0765 SHIFT SOLENOID D MALFUNCTION
P0962 PRESSURE CONTROL SOLENOID A CONTROL CIRCUIT LOW
P0966 PRESSURE CONTROL SOLENOID B CONTROL CIRCUIT LOW
P0970 PRESSURE CONTROL SOLENOID C CONTROL CIRCTUT LOW
View 1 Replies
My emergency brake works fine when I am parked nose down; it prevents my truck from rolling forward. When I'm parked nose up, the e brake doesn't stop the truck from rolling backwards. 2.3L 1993 ford ranger manual trans.
View 3 Replies
I am doing an sas on my 93 f150 short bed. my issue is that I've made coil spacers out of 1/2" thick by 3" tall by 4" in dia.... as you can see strength is not an issue here. i bought 6" lift coils for a 93' then decided to just say f it and throw a d44 straight axle under it. the springs on a 78' d44 are the same dia. top to bottom. 93' springs get smaller at the bottom so i made this spacer for two reasons.... 1 to have smaller seat for the bottom of the coil.. and 2 so i could make up the spring length difference between the two springs. The spacers are leaning forward due to the 7 degree c bushings on the radius arms.
View 1 Replies
I have a 1997 Mercury Mountaineer with a 4R70W trans behind a 5.0 liter. Vehicle sat for about 5 months. Went out to put it back on the road, and now the trans seems to be stuck in a forward gear no matter what the selector is in, park, reverse, neutral. Dropped the pan and replaced the filter and replaced what fluid was drained. no difference,.
View 3 Replies
My 93 ford explorer has a factory alarm. It went off this morning, 2am! in the rain. I tried the remote, nothing, tried the second remote, nothing. Honking and lights flashing, I disconnected the battery to calm the neighbors and hopefully reset everything. I also disconnected the horn. After reconnecting the battery, and waiting a few minutes, the alarm again triggered.
View 6 Replies
I have a 96 explorer (Eddie Bower Edition) with automatic trans ( not sure which one at this moment)....
Today getting on the freeway as I was getting up to speed I heard what sounded like a click then no longer had any forward gears. After rolling to a stop I tried every gear and nothing I did fell like it wanted to go but it would not move.
The trans fluid did not smell burnt and at most I might have been maybe 1/2 quart low. Where to start and what to check?
View 8 Replies
My wife has a 2008 Eddie Bauer 4x4 explorer and when you are backing up or pulling forward with the wheel turned, it feels like the automatic 4wd wants to engage. The Ford dealership mechanic told me this is normal but it does not do it all the time. Is there anything I can look at to try and figure out why this does it sometimes or if this is even supposed to do this at all?
View 7 Replies
2003 Explorer with a slipping transmission...codes are P0731, P0732, P0733... Just had a new solenoid pack installed last week when O/D light came on and truck was clunking into reverse. Now, after new pack was installed the forward gears are slipping all over the place!
View 5 Replies
I bought my wife a 2010 Explorer a couple years ago, nice car but when it gets to 0 or -0 it wont move. After idling for an hour and some persuasion with the throttle it will lunge forward and then there is no issue until it is shut off and cooled down again. I'm wondering if there could be water in the tranny and its freezing but there is no way to check it.
View 4 Replies
Okay so my dads 93 explorer seems like its starving for gas, it cuts out almost like its going to stall, hasn't stalled yet, but it seems like its not getting enough gas, new fuel filter and still having the same problem, fuel pump isn't that old either, just started doing it maybe thursday. We haven't really looked much into it yet, but what it could be?
View 6 Replies
My brother in law has a 93 explorer which developed a serious transmission leak and had to be towed home. We suspected a blown front seal, which we replaced. We also replaced the transmission filter and pan gasket. When we started it up, it seemed like it was stuck in gear and wanted to move forward no matter what gear it was set to. Even wanted to go in park and neutral. We topped off the fluid, and finally got park to work, but all other gears including reverse want to go forward and it seems as though it is not shifting at all. Could we have forgotten a connection of some sort, of could something internal been damaged when the fluid was lost?
View 6 Replies
Have a '93 Aerostar that had something roll up against inside sliding side door and must have nudged it out of alignment. Broke off outside door handle, took off inside panel and tried prying, pushing, kicking and pulling rods, handle, linkage and anything I could get at. Any way to get it open, so I can re-align the catch mechanism??? I have tried everything I could to "muscle it" open....
View 14 Replies
I have a problem with the serpentine belt tensioner, on a 1993 Splash; 4cyl motor. The tensioner spring is frozen/stuck, so it is set to where it is. Tried to 'exercise' to free it up, that did not work, and sorta' rounded out the 3/8 square hole doing that. So, ordered an new tensioner assembly. I felt around the tensioner mount at bottom, do not feel a bolt head. So it must be flat head allen or torx bolt, correct ?
View 9 Replies
I took my 1993 Ford Explorer for an oil change they told me I also needed a rear differential service and a transmission service, so I told them to go ahead (this was on a wednesday). On friday the car broke down leaking transmission fluid (reddish oil). The clutch was making a sound when pushed in and we were not able to shift. I towed it back to the place where the oil was changed the gentelman open something under the car and he said that it had transmission fluid. He got on the car turned on and push the clutch when he did that a lot of fluid began coming out (reddish oil). He said it was the clutch that went out. We think they messed up the transmission. I towed the truck to a garage and the guy mentioned something about a plug related to the transmission. Could the oil people have done something wrong to the transmission that made the car break down???
View 4 Replies
