Ford - Explorer :: 2003 XLT - Steering Wheel And Whole Front End Jerks When Turn A Curve To The Right
Feb 4, 2016
While driving whenever we turn a curve to the right the steering wheel jerks and the whole front end jerks and will either quit when we slow down or come back straight. It seems the faster we go the worse it is also starting yesterday day we have noticed that the front end is beginning to make a popping or thumping sound while turning a curve or sometime will pop or thump randomly. It's starting to get pretty scary.
Just some info, tires are fine, no wear, all correct pressure. Had to recently use 4x4 in the snow but didn't have any problems with it. Did however hit a ditch pretty hard on the driver side and quickly came back out on the road from sliding off in the snow. Has a bad leak from the power steering reservoir to the pump (the line is bad but can't change it on my own and top off reservoir daily). Truck has 227k miles on body and 157 k on newish motor that was just put on in September.
View 2 Replies
Advertisement
Just started noticing that whenever i turn right the passenger side front wheel vibrates. 2003 ford explorer xlt 4x4. i asked a friend and he said cv axle.
View 1 Replies
VWVortex, so I've had some issues with my MK4 recently (go figure). It started with steering wheel getting intermittent and random jerks to the right after driving for about 20 minutes on the highway at any speed any gear but only at around 1/6 throttle. I needed to do front end maintenance anyway, so I replaced both complete LCA's with ECS Tuning's ply ones, went stage 2 BFI engine mounts, stage 2 BFI dogbone mount, both ball joints, both tie rods ends, both axles, and an alignment.
Now I'm getting a shimmy in the steering wheel starting at ~80mph. I know my wheels are slightly bent and are being replaced in the summer when the weather is warmer, but it wasn't doing this same shimmy prior to all this. Just the jerking. Could it be they messed up on the alignment? Its really getting on my nerves considering I've dumped a lot of money trying to fix this problem just to have something else pop up.
View 4 Replies
So today out of nowhere the truck starts acting up with the steering. It got tuff to turn the wheel and then would "release" and steer ok. I drained the fluid (brownish and stinky) and added new.......
Crawled under the truck and the rack was damp....... The old fluid (likely original with 120k) had small metallic piec s in it.......Is the rack toast? Or shall I look somewhere else too?
View 8 Replies
I'm buying a 2003 Ford Explorer, XLS Sport Utility 4D. She's got 150k miles on an automatic transmission (pretty sure this model only came in auto anyhow).I'm mostly concerned about the rear axle, as the title prompted. The rear wheel seems awfully close to the front of the wheel well. Is this normal? I google searched some images of this model and seems to be the norm in some cases, and in other cases not.
Attached is a photo of the concerning placement. Is the rear axle bent? Is this suggesting that the rear end is on it's way to crapping itself?
View 2 Replies
Seems that after a sharp right turn, for instance turning right at a stop sign I'll get a loud pop that I can feel in the floor pan under my feet.
After the pop the steering wheel and whole front of the truck will shift left and right like someone is grabbing the wheel, sometimes violently. If I drive slowly it will cure itself and sometimes not do it again for several days. I've check ball joints and hubs and they are in great shape. I pulled the hubs and greased the needle bearings about 6 months ago. I checked all steering components and the linkage that attached to the steering arm had some play so I replaced it. Then I found that some idiot took the steel sleeve out of the bushing in one end of the steering stabilizer. I bought a new stabilizer and cured a pop I'd had since I got the truck, but the other issues were not solved.
Alignment has been checked too.
View 14 Replies
Have an 03 Escape / 3.0 and the steering catches when turning left. Steering wheel jerks. Replaced the pump about 2 mo. ago and seemed to work, but now it is back. Is there something else I should look at?
View 3 Replies
I just recently bought a 2000 Explorer, 4.0 OHV, 4x4 with about 150,000 miles.
I've had the vehicle for about a month, and ever since I bought it, it's had a grinding sound (sounded like wheel bearing) coming from the front right side. I replaced both right and left bearing/hub assemblies, and took it out for a drive. The initial sound that I thought was bearing noise is still there, and at about 65mph I started to get a little bit of steering wheel shake. I took my foot off the gas and it stopped. I accelerated up to about 70mph and it seemed ok.
I hit a VERY small bump in the road and the steering wheel started shaking like hell. So bad that I almost lost control. I slammed the brakes and the shake stopped instantly. I took it home and put it up in the air, half expecting to see something loose or broken, and everything looks perfect. I re-torqued everything that I had taken apart for the initial hub/bearing replacement, and took it out again. Same issues.
I never had ANY of these problems before I replaced the hub/bearing assemblies, so I'm completely confused. I was thinking CV joints, but I have no clicking at all when turning, in forward or reverse, everything is smooth. Outer tie rods were done about 6 weeks ago..
View 1 Replies
my turn signals only work with the steering wheel tilted all the way up. It works for me, but my wife drives the truck mostly because we live a mile from her work. The dealer said it was a "peanut connector." And can someone walk me through the steps to fixing it?
View 8 Replies
Working on my bosses 97 Econoline conversion van. The steering wheel was flopping in the breeze, gear indicator was off and some of the time it would be in reverse when you thought it was in park. Checked the torx on the shift cable plate and they are tight. Replaced the 2 bushings on the shift column. They tightened up the steering wheel flopping around. I checked the shift cable and it appears to be in good shape.
It would start sometimes if you worked the shifter in park or moved it to neutral. Now it will not turn over. Shift lock actuator does not appear to be working. Does not lock it park. No continuity between any of the three pins with the actuator pushed in or out. If you turn the key you can take it out of park without pushing on the brake. Really do not know the series of events that have to occur to make it turn over. How to trouble shoot the problem?
View 1 Replies
Got my new truck last week and the steering is awful. Loose as a goose. Every bump that you hit jerks the steering wheel around. I changed the tires from the factory 80psi down to 60 for the front and 65 for the rear, didn't work much. On some big bumps it acts like I am losing control. It reminds me of the death wobble on my old 05 F250 which was 4wd. I thought that the 2wd independent suspension would be smoother.
It's got a sway bar up front can I add a steering stabilizer? If so who makes one? Everything else about the truck is great. The new 6.7 is quiet as a mouse and powerful. So far fuel economy is the same as my ecoboost. Haven't got to tow with it yet.
View 5 Replies
What causes a whirring sound in the front of the car when I turn the steering wheel? It happens first thing when I start in the morning but goes away.
View 3 Replies
I took my truck to work and needed a pitman arm. So took it home put a new one on and the steering wheel was crooked which didn't bother me. but after in cranking the torsion bars I noticed how Badly I needed an alignment. So took it back in for an alignment and I cant turn the steering wheel back to center because the tie rods are maxed out. I tried to take the pitman arm back off center the wheel and everything but the key ways just line up the same way. Any chance the after market pitman arm is off or any clues?
View 11 Replies
I recently bought a 1998 f-250, regular cab, long bed, 4x4, 5.4l triton, automatic. The truck was involved in a wreck by the previous owner and I am trying to repair the damage. He hit some ice, slid off the road, and collided with a log cabin.
The visible damage was done to the driver side front. The bumper, grill/surround, header panel, headlight, turn signal, fender, and hood all need to be replaced. When you drive the truck there is a shimmy coming from the front that can be felt in the steering wheel. When going straight and releasing the steering wheel it pulls to the passenger side. The driver side front rim might be bent? Which might prove interesting if I have to replace it (7x150mm).
This is my first Ford truck. I was willing to take the gamble on fixing it up. I hope that it works out and I am able to do so. What years/models can I source these parts from?
View 8 Replies
Whenever I brake hard the steering wheel jerks to the right and the car follows. And it'll stay to the right until I got about third gear or if I shake the wheel back and forth. Not sure what it is. What could cause this? 01 jetta wolfsburg.....
View 8 Replies
You can hear the clunky, groaning noise around 8 and 11 seconds when I turn the steering wheel, making a tight u-turn in an alley way.
What can it be..? I hope it has something to do with my tires since I'm getting new ones today. The current ones are pretty bald.
Quick video clip of noise...
View 7 Replies
Ok, so I leave the fire station this morning headed home and my steering felt weird. About 1/2 mile from home I hit a bump and my drivers side front wheel started making a screeching noise. I stopped and looked out the window and it appeared fine. I limped home and as I pull in the driveway, I lost all my steering. I look under the truck and this is what I found.
Not sure what to do. This is my daily driver and neither of my 2 mechanic friends will answer their phones.
View 14 Replies
I have a 03 1.8t jetta if i turn the steering wheel all the way to either side a epc light comes on and cuts power a lot what could this be....
View 2 Replies
Having trouble turning my wheel both ways on my trail blazer. Just replaced wheel bearings on truck not sure what would causing this. Also tries are wearing down..
View 6 Replies
I have a 2003 Subaru outback and sometimes when I go to back into a parking space or straighten out after pulling into a parking space my steering wheel becomes incredibly difficult to turn. It used to only do this when I was backing into a space but now it has started doing it when I pull forward into a space as well. This happens most often when I am driving to multiple places and have to park several times over a period of a few hours. I've monitored my power steering fluid and the power steering pump was replaced not too long ago. What's causing this?
View 1 Replies
I have a 2003 Saturn Vue, been a pretty car, bought used. It has been making this obnoxious moaning sound when I turn the steering wheel. Had one mechanic say he thought it was some bearings? But I would have to bring back (was having something else fixed at the time). I am financially challenged at the moment, and I am concerned this is going to be costly. The sound doesn't seem to be affecting the mechanics of the car, it is just annoying.
View 5 Replies
