Ford - Explorer :: 2008 XLT - Power Steering - Check Charging System Warning Comes On The Dash
May 31, 2017
My 2008 2wd 4.0l XLT is having a strange power steering issue. When I start the truck and back out of my driveway it feels like I have no power steering. Within about ten seconds of putting the truck in reverse the "check charging system" warning comes on the dash. As long as it is on I have no power steering. That warning stays on for about 15-20 seconds and then goes away. As soon as it goes away power steering is restored.
I have checked my battery and it is good, it is also pretty new. The power steering fluid level is good. Based on another thread that seemed to have a similar issue I replaced the serpentine belt, the idler pulley and the belt tensioner. No changes at all to the issue. My next step is to replace the power steering pump....
View 11 Replies
Advertisement
Less than 30 days ago, replaced the Timing Belt, Water Pump, Front Arm Bushings, and Power Steering High Pressure Hose on my 2007 Honda Odyssey.
Today, my wife noticed the engine was noisier than usual, then suddenly became stranded on the roadside when the power steering went out; at the same time a "Check Charging System" error displayed on the panel. The van was within walking distance of home. I got it home and checked the engine, finding the Power Steering Fluid Reservoir to be nearly empty (far lower than the minimum line).
My questions - am I right to think Honda blew it? Does the above scenario sound like they simply forgot to refill the fluid after their repair? Or other? If negligence, what sort of damage may have resulted that I should be on the lookout for? Finally, why is the "Check Charging System" light coming on as a result of this?
View 14 Replies
Check Charging System message, battery-shaped idiot light, and audible beep has happened a few times over the past month or so. Yesterday it happened while my wife was driving so I had to bring it to the dealer, not to mention I drove it last night and there was constant beeping for about a minute which was pretty annoying.
But first I had the battery checked, which turned out to be OK. Also we got a new alternator 5 months ago, installed by the dealer.
Today they said they "updated the computer" whatever that means, and otherwise couldn't find anything wrong. $99.85 plus tax.
Needless to say I'm not confident that "updating the computer" has fixed it. What are the odds we get the warning again in a couple of weeks? Short of disconnecting the sensor, is there anything that can be done?
View 2 Replies
Three weeks ago I replaced my battery and serpentine belt as general maintenance before heading out on a prolonged trip. The next day I started receiving 'check charging system' whenever I turned the a/c on and the truck is at idle. Power steering becomes very hard to turn and engine feels like it is going to quit.
This is not a problem at highway speeds. Looking at the engine when the a/c is engaged, a slow down of the belt/pulley is obvious. The alternator has been removed and checked, battery checked good, and the belt is the right size/length. What could be causing this? Again it started behaving like this after a belt and battery change. There is no issue if the a/c is off...
View 12 Replies
I have a 2004 Explorer with 167,000 miles that has begun to display erractic messages such as, check charging system, low tire pressure, AvTrac off and about everything there is. Reset and everything looks good then messages start again. I am thinking computer module.
View 3 Replies
I have a 2003 mercury mountaineer 4.6L AWD. The other day it died at the grocery store and now won't start. All it has is the check charging system warning light on. Changed Alternator, battery and starter already and still nothing. It does start sometimes but i need to give it gas to keep it running.
View 7 Replies
1997 3.2 2WD 299,000 miles original alternator
3 times in the last month when I start up first thing in the morning dash warning lights are lit up and the electrical system is not charging. AC doesn't work and windows operate very slowly. A simple rev of the engine has resolved the problem. However, the belt is very tight (and I mean very) and there is no indication of it slipping.
This morning, a rev didn't solve the problem. I only work a few miles from home and my mechanic is also very close so I just figured to head that direction. About 1/4 mile later charging kicked in and everything worked just fine.
I hate Intermittent electrical problems Where to start.
View 2 Replies
New Interstate battery, new alternator (x2, 1st was Napa (DOA), 2nd Motor Craft) and 1 new Napa idler wheel. The battery test at 12.5 and when the truck idles it shoot to 15.14. It holds a charge fine, but the check charging system keeps popping up which concerns me, not only because its annoying. Also why such a spike when started...?
View 1 Replies
I installed some 5K HID's with 35W ballasts and a relay on my 15 toyota camry SE. When I start the system, it says check charging system and once the engine starts it goes away. I initially had 50W ballasts installed but I changed it to 35W as the 50W caused the HIDs to be too bright for my taste.
View 4 Replies
I have an '04 F-150 4 x 4 Supercrew Lariat w/ the 5.4 V-8. It has 105,832 miles on it. No issues until a week ago. Battery light and "Check Charging System" message appear 30 seconds after cranking the engine. I have replaced the battery (Ford Motorcraft), belt and alternator (Motorcraft 130 Amp). Still getting battery light and error message. I've read some post that indicate it could be a short in the fuse box.
View 2 Replies
I just got a new-to-me 2007 4.0L Explorer . When I turn the ignition to the on position, I get a message that says "Check charging system"...
Once I start the engine it goes away. Is this normal?
My battery reads 12.6 with the engine off and 13.8 with it on.
View 2 Replies
I have a 2008 f350 6.4 (105,000 miles) and I am randomly getting the check charging system the batterys have a standing voltage of 13.8 and 13.9-14v (read from the ecu with scanner) both at idle and under a load. I also checked the alternator and its making 13.8-14 all the batteries are tight and there is no corrosion.
View 1 Replies
I have a "check system" warning on my dash, does it mean that my tire sensors are bad?
View 7 Replies
2007 ls 460 l - Warning light on dash: Check VSC system. Happens intermittently. When it is on, the cruise control does not work and the break-hold is off.
View 2 Replies
2003 explorer 4.0.. I have no charging from the alternator at all. battery dash light on all the time. exciter wire from PCM to alternator, green/white is right around 11.6-11.9v when running. when key on engine off its 0.the other wire for the regulator is battery voltage all the time. voltage drop from large post to + battery terminal is 0.4v. I tried 2 different new alternators so far from napa and same issue. belt is not slipping and tension is good. this vehicle sat for about 6 months and has been on the road for only a week or 2. maybe 100 miles so far until this. I might try a ford alternator, what to do.
View 2 Replies
My Prius yesterday while driving slowly (under 10 mph) all the dash warning lights came on(triangle, cel, trac control, brake). the gas engine started and the message came on that says: "check hybrid system". Today when I went out to check there only two warning lights on (triangle and cel) with the same message displayed. My question is can the vehicle operate without damaging anything if I drive it as is? I have read on several threads that the engine will not start if the hybrid motor(s) are not working. Since my engine starts and runs I have to believe the motor(s) are working.
View 19 Replies
I had my alternator and battery die on me in Dec 2015 and replaced both. Vehicle ran perfectly fine until this Sept 2016. First thing to happen was the battery light came on and then the System Charging Failure message and the tone came on and off intermittently. I took it to my garage and they tested and said the alternator was defective that they replaced in Dec 2015. It was showing 9V.
So they replaced it again free of charge with another rebuilt alternator. Within 30 min leaving the garage the system charging failure light was back on and again i lost charge to the point where everything was shutting down to the point i even lost the gauge cluster. Took it back to the garage and they checked the plug at the alternator and said it was fine. Then they said the belt was loose.
So they replaced the belt, the belt tentioner, and a pulley. Within 20 min the lights were all back on again and I was losing charge and all the things started to shutdown again. Where I picked up the car at 5PM on a Friday they had left and wont be back till Monday. So I am asking here....what is going on??? What else is there to look at or replace to fix this charging error???
View 3 Replies
Noticed the warning indicator on dash, linage of a battery, this morning. Thought maybe battery needed to be replaced? So got replacement battery and installed it, but warning light still on.
View 14 Replies
I have 2007 PRIUS with 187,OOO miles, I just replaced one bad cell today and the master warning,vsc,charging system warning light went off then come back on but it's charging .
All bars are green. Blue light is ON.
View 2 Replies
A few days ago my charging system warning light came on in the middle of my trip home from work.
I popped the battery out and took it to Advanced (in my other car) and they tested the battery, it was fully charged and was in good condition. So I popped it back in my car and when I started the car I didn't get the warning light on my way back to Advanced.
They tested my battery again, along with my starter and charging system. Everything looked good, except one of the terminals on the battery was a little loose so we tightened it. Next time I started my car the light was back on.
Also, I looked at the belt and it didn't appear to be cracked, but I'm not completely sure how to verify if it's in good shape.
View 11 Replies
I have a 2008 Camry Hybrid and recently got a "Check VSC System" warning light. A diagnostic resulted in a C0210 error code. The code is for a right rear speed sensor malfunction.
I had a local shop look at it and he replaced the hub accembly including the speed sensor. It didnt work. He and I took a ride and on his diagnostic tool, the speed reading for the right rear wheel was all over the place.
The next day he replaced it thinking that the new sensor was bad. This worked, however only for a day. Now the light had come on again with the same error.
View 2 Replies
