Ford F-150 - 1997-2003 :: 1998 - A/C Blowing Cold Via Floor Or Defrost Vents?
Jun 9, 2016
1998 F150 XLT 4.6l automatic,,,
Drove the truck on a trip the other day, about 650 miles with a loaded 5x8 trailer in tow. A/C started acting weird. When the truck was on level ground, or going down hill, the A/C was fine. Cold air coming out the correct dash vents. As soon as I started up hill, or put the truck under strain of acceleration, the A/C would stop blowing out the dash vents and would start coming out the floor or defrost vents, or just not come out anywhere.
When I turned the A/C off and just used the vent setting, it would do the same thing with the fresh air. I guessing this has something to do with my vacuum lines, somewhere. What I should be looking for and where?
View 6 Replies
Advertisement
My A/C is blowing cold but only thru the defrost vents. First it was blowing normally from the dash but during acceleration or under load, the a/c would randomly blow from any vent, from the floor, dash, defrost. Now that stopped and it only blows from the defrost vents above the dash-board.
1997 F-150 XLT, 4.2 Liter, V6, manual transmission.
View 14 Replies
2001 F150 5.4 4wd - AC not working but when I turn the temperature dial to the blue side and turn on the fan, super hot air comes out of the vents or wherever I direct the fan to blow (Floor, defrost, etc) I know it shouldn't blow ice cold especially since my AC doesn't work but.....shouldn't I feel a temp change coming from the vents when I move temp dial from the red area to the blue? It's max heat wherever I have it set.
View 6 Replies
The floor and defrost vents work. It just stays on defrost when you try to use the dash vents. The actuator seems to be working fine. I can watch the arm move through all the motions. and I cant find ANY vacuum leaks. Yes I looked at the hubs and under the hood. May be moving to alaska and kind of need my heater to work properly. . . .
View 5 Replies
As the title implies, that is my problem. Can't get the AC to come out of anywhere other than the windshield defrost vents. Y'all ever encountered this before?
View 4 Replies
My 97 e350 club wagon is doing something weird. Front AC wont go to Max Air, the blend door wont function. Can hear vacuum trying to work. Rear Unit is on Heat even though Front is on AC and blows hot air out the rear floor vents. Hit some high water going too fast about a year ago. Next day, this started happening. Rigged up blend door so air flows through vents.
View 2 Replies
I have a 2010 f-150. Started having issues with the blend door actuator located behind the radio so replaced that a couple months ago and fixed issue. Now the a/c will only blow through the defrost and floor vents. I replaced the lower blend door actuator thinking that might be the culprit, but did not fix the problem. What the solution might be.
View 3 Replies
Every thing was working great then the AC quit. I ran through the air selector and all I can get is panel and defrost with no heat. I checked the vacuum line on the passenger side engine compartment and it looks good. Oh I also took the control apart and 3 of the five holes had vacuum to them.
View 2 Replies
The front a/c on my ex on the highest blower motor speed blows out the vents like its on low, but I can hear the motor blowing at full speed. It's not blowing out of defrost or floor unless I switch it. On lower settings I can barely feel any air at all. Only does this rarely. Could it be my vacuum pump?
View 4 Replies
No matter what I do with the settings for my heater in my lariat air only blows out of the dash vents. Defrost and floor vents don't work it still blows hot air out of the dash vents. I'm not sure what the deal is maybe the vacuum system? I did a search and all I could find was people having trouble with air ONLY blowing out of the defroster and my case is just the opposite.
View 8 Replies
This has been on going for the past year. The blend works fine. Fan speed works correctly. The selection for ac, max ac, etc., will only allow air through defrost vents. Vacuum leak?
1998 4.6 auto super cab
View 4 Replies
My 02 V-10 Ex seems to be blowing Air from the front vents up to the Defrost unless it go through a series of events-- Hit Auto then forward Air then the fan has to be a 4 only. It will blow forward vents then go back and forth from theirr to the defrost. Also the Temp seems to be much hotter then it should.
Took a interstate trip this weekend though and it seems to blow much colder and do a little bit better staying in the front vents however still goes back and forth. Im in FL and its HOT!!!! The only thing I know is that its a vacuum system.. and that again its HOT in the truck as a daily driver.
View 1 Replies
I have a 2008 F350 and there is nothing blowing out of the vents or defrost for AC or heat. It doesn't matter what fan speed is set. Would this indicate a blower motor? Where exactly is it located and how to change?
View 8 Replies
I have a 2001 Mercury Grand Marquis and the A/C will not blow out of the vents. It is blowing cold air, but will only blow from the floor and defrost.
View 3 Replies
I have a ford f150 supercab XLT with the 4.6L triton. It starts and idles absolutely fine but when i push the gas to fast(when in park) it bogs down. I just changed the fuel filter aslo...No change.
If I floor it it Bogs then goes up to about 3000rpm (about halfway) and has trouble moving over that RPM or halfway. like theres a restriction of some sort.
If I gradually push the gas, it will go up in rpms and i can get it to about 2000 rpms then I can tack the rpm gauge out if I wanted. but never do.
Also when driving, it seems as if its lacking power..and just to add it does all this stuff while in gear also..
When running It smells of an exhaust leak. but I cant find one. And I cant smell it in the cab.
So there it is. If I think of anything else, or do anything. I will keep posting.
View 7 Replies
my AC is only blowing through the defrost and the floor - It's a cool 101 degrees here today!!
We have changed out the battery, the actuator on the passenger AND driver side, as well as pulling the HVAC fuse from the fuse box under the rear seat - none of this has worked!
View 4 Replies
I am having problems with the blower on my truck. I can feel the air coming from vents no matter what setting on it. I think it maybe the blower itself as it was working and just quit. Is there a fuse for the blower that I can check? And I have the V6 4.2L 2 wheel drive
View 8 Replies
02 F250 with 7.3. When I activate the 4WD, my light comes on, the A/C quits blowing out of the forward vents and goes into defrost and no 4WD. If I sit and wait a bit, the air again blows out the front vents and the 4WD engages. I figure I have a vacuum leak somewhere in the 4WD system. Is there a common place for this to happen or do I need to trace the whole system down? Also my manual hubs has never been turned and of course they won't. I know better than use a wrench so is there a easy way to free them up or just go ahead and disassemble and clean?
View 3 Replies
The AC works, but just not well enough on a really hot day. On a day in the 90s I have to put it on Max AC and even then it does not cool down for a while and the air out of the vents is not ice cold.
So, it works, but I cannot tell if there is something wrong or not. I recently put in a can of AC Pro and it did not change anything.
View 6 Replies
My 06 F250 crew with the 6.0 starting blowing the cold AC out the defrost vent and will not switch to the dash vents. It's goning to hit 108 today and stay around 105 for the rest of the week.
View 14 Replies
98 F150 2wd 5.4 -even though VIN says its "W" 4.6; it has a 5.4 with 4.6 timing setup-found. But that's a whole other story...
So, Replaced heater core. did the blend door too.
A week later it overheated and blew a heater hose off the core at the firewall (several times). Temp was up and down, forced me into cylinder head protect mode, so i called my mechanic.
Mechanic used a sniffer (blue liquid turns yellow) in my overflow tank and there was exhaust gas in it... so we replaced head gaskets, intake, timing, water pump, radiator and the rotted out rad support.
Got it done and back on the road, but a few weeks later and the heater hose quick disconnect blew off again, spewing coolant all over (again). This was what we thought was part of the original problem- head gasket allowing cylinder compression into the coolant passages. the little rubber hose that comes from the back of the intake and goes up into the heater core builds enough pressure to pop the disconnect right off and I dont know why. Like I said- I thought it was the head gasket blowing pressure into it but that's all been replaced. Why the pressure would be so high at that point, and how do I correct this?
This is my daily driver, so for now I've bypassed the heater core, but I'm afraid that pressure is gonna burst a hose and/or fitting again.
View 4 Replies
