Ford F-150 - 1997-2003 :: Cruise Control Not Working After Clutch Changed
Apr 7, 2016
A few years ago I had the clutch changed on my 1997 F150. Afterwards the cruise control wasn't working. When I brought the truck back to the repair shop I heard the manager tell the mechanic to "attach the clip by the pedal" and that fixed it.
I just had some work done, had to replace the oil pan, and the mechanic had to remove the transmission. Now the cruise control doesn't work. I changed the Pressure switch but it didn't fix the cruise control. What that clip might be that fixed the cruise control last time?
View 3 Replies
Advertisement
I have an '02 F150 Lariat CC 5.4L. The truck is new to me and neither the cruise control nor the horn works. i have checked all (known) fuses and relays. I have tried the cc diagnostic, and the dash light DOES NOT illuminate. Should I assume that the dash light is not burned out? Is there a way to test the clock spring connections for continuity? and how do I access the connection
i checked the cc brake pressure switch and have continuity there.
View 2 Replies
I did the diagnosis,on my non working cruise control on my 2000 f250. The cruise light came on when, I, depressed the off switch and turned key on. I depressed on switch,cruise light came on.
I then depressed the resume, coast, and set switch, as described in the diagnostic procedure,suggested,and no light came on. Do the switches for the cruise control are bad.
I have checked the fuses at the power distribution box under the hood and checked the fuses under dash,all are fine. I just replaced the switch at master cylinder, as it was leaking and it had the recall switch replacement, too.
View 8 Replies
I am having trouble with all sorts of functions on my 2002 F150 4x4, 4wd not working, cluster module illumination not working, horn not working, reving up and down at idle and sometimes dyin, cruise control quit working. I have been reading it is the GEM module that causes these issues. My question is I ordered a new one from Ford, when it arrives I was told I can just install it and It should be pre programmed. but one ford house tells me that they have to install it and program it. Which it right? I have seen several sites on u tube where people replace the module and then start their truck right up without any issue.
View 2 Replies
My AC clutch, radio, cruise control, and turn signals are not working. I have checked all fuses and relays that I can find, all good. From what I have read, these are not part of the GEM function. What I need to check next!
View 7 Replies
My 1997 Aerostar's cruise control is not working. Horn is functional however. I've checked fuses and they seem to be ok. What could my problem be?
View 10 Replies
I have an 02 f150 5.4 and since I got it it hasn't had cruse control. I went to a local ford dealership and they ran the vin and didn't find any recall on it. Under the hood on the master cylinder there is brake fluid coming out of the brake control switch. Would I have to do something with the harness too?
View 9 Replies
I have a issue with my cruise control not working. The Ford dealer in my home town has had my truck for 3 days now and cannot figure out what the problem is. I finally went by the dealer and wanted to know what the deal is and how can this take so long to figure out when they have to of seen issue like this in the past. The tech that is working on my truck said he has traced wires,etc and think it has something to do with the after market JVC touch screen DVD/backup camera. My question is would this affect the cruise? I cannot find anything on the net that may point in that direction. The steering wheel controls work for the fan and temp controls but not the radio as its aftermarket. Radio adapter for the controls?
View 14 Replies
I recently bought a 1997 Park Avenue and have a couple of repair questions.1) The car is in need of struts/shocks. The rear has air shocks. Before I purchase new air shocks, how do I test the compressor to make sure there is no problem? If the compressor is bad, is it possible to install conversion shocks and do away with the compressor/ air shocks?2) The previous owner says the cruise control does not work. On rare occasions it will work for a brief time during the winter. What things can I check out? Someone suggested checking the brake light switch.
View 5 Replies
2003 X limited 2wd 6.0L ... My cruise control was working intermittently. Could it be the buttons on the steering wheel itself? there is a cluster that I see. Does it pop off to expose the connectors/switches? Can these go bad? Can I buy new switches for the steering wheel?
View 2 Replies
Ok replaced the front brakes, tie rod ends, and all ball joints today. Also flushed old brake fluid and replaced with new. Now my cruise control does not work. Light on the dash momentarily flashes when I try to set the speed. I have checked all the fuses and the connections and everything appears normal.
2001 Ford F150 5.4L 4x4 off road pkg stock height and tire size.
View 7 Replies
2000 F 150, 4.2 v6, M5OD-2 Manual Transmission, LX, reg cab .. Cruise Control passed all static and dynamic self test. All fuses inside and under hood checked good and still cruse control will not engage. All other functions work: brake lights, turn signals, etc. Green cruise light is operational, checked pin #10 on wiring harness at servo,amplifier unit under hood and have good ground. The Cruise ON button will not turn on cruise control system and will not light green cruse light.
View 4 Replies
Just bought the 03 listed in my signature line, and I just found out that the cruise control isn't working, so started trying to troubleshoot anything obvious.
When I switch it on, I get no cluster light that the manual shows to be to the right of the brake light. When I turn the key to run, it never lights up, so am guessing the bulb is bad.
Can't see how a bad bulb would keep the system from activating, so am thinking I have bigger issues. I pulled the fuse panel, but the manual does not have a listing for speed control. Which fuse it is combined into?
Also need the skinny on how to change the bulb. Can I reach my hand behind there? does the cluster have to come out?
Last question. What is the most likely culprit for non functioning cruise? A module? Perhaps the switch in the steering wheel?
View 14 Replies
Cruise just stopped working. The fuses all check out ok. What would be the next simplest thing that I could check before turning the problem over to a mechanic?
View 14 Replies
All, i have an issue ( or at least i think its an issue) with my 99 f150 5.4. When i use my cruise control, i notice when i put on the brakes slightly to slow down, it feels like its not coasting because you can feel the engine still engaged and wont coast. I think this happens even without the cruise on. What this could be? I have the latest update on the cruise control harness. I believe that was for power always to it even in off, causing fires.
View 3 Replies
While driving on the highway, the cruise control shuts off and the speedometer stops working. Check engine light comes on. Car continues to run fine.
Five days later, I start the car and the following do not work: clock, intermittent wipers, neutral safety switch, tachometer, temperature gauge, gear indicator lights, rear defrost, windows, and I believe that is all. Car runs and drives fine. Other electrical items working. I check all fuses and only find one burned out - (#1, inside, labeled 'back up lights' meter lights) I replace the fuse and it blows when I start the car again. Take the car to AutoZone and they put it on their computer and it shows one code - P0501 - CVT speed sensor.
Two days later, the car will not start. Turns over strong, but will not start. I have checked the grounds on the transmission and body and they appear to be fine. Battery cables, also.
View 4 Replies
I am stymied by a weird Cruise Control problem on a 2001 F150 Lariat SuperCrew with 5.4L V8 engine that I just purchased. Long story short, the cruise control does not work. That is, when I push the "On" button at any time while the engine is running (even when traveling at highway speed), the dashboard CRUISE light does not come on.
I ran the cruise control "self check" procedure. The first time I ran it, we failed with 3 flashes. So I checked the cutout switch on the brake master cylinder, and it was indeed leaking brake fluid. So I purchased a new switch and cable (Motorcraft SW-6350 Speed Sensor Switch Repair Kit) and installed them.
With the new cutout switch, we seem to pass the self test. That is, after pressing all the buttons in order , I see all the quick flashes of the CRUISE light
(1. On (flash), 2. Resume (flash) 3. Coast (flash), 4. Set/ accel (flash)). Then the accelerator pedal is pulled away from my foot.
However, unfortunately, the cruise control still does not work. That is, when I push the "On' button at any time while the engine is running (even when traveling at highway speed), the dashboard CRUISE light does not come on. What to look at next? I note that horn works, in case that's useful info.
View 14 Replies
I have a Ford F150, 2003. I replaced the switch above the master brake cylinder just a few months ago soon after I bought the truck. I put 17" rims and new tires on my truck and now my cruise control works intermittently. It worked fine before then.
Can there be a connection between the intermittent failure of the Cruise and the larger rims and tires? I know my speedometer is off by about 4 MPH at 55 but I expected that.
View 4 Replies
I have a 2003 F250 Super Duty 5.4 crew cab. Cruise light comes on when engaged but does not work. I did some research on why its not working checked wiring at the throttle body it seemed ok, Fuse is ok. Also did the self test and everything passed with just one flash but cruise still does not work. I read about many problems with the brake pressure switch but would it pass the self test if that pressure switch was bad? Also what should a switch cost. Local dealer wanted $125.00 for a new one and I have read where they cost around $15.00 - $20.00.
View 12 Replies
I have a 2003 F150. My horn and cruise both stopped working. All fuses are OK. Cruise controls are on steering wheel (as is horn). Why both would stop working???
View 2 Replies
I just discovered my cruise won't "SET" (light goes out after 1/2 second) anymore after having the brake light switch done yesterday.
View 2 Replies
