Ford F-150 (2004-2008) :: 2005 Truck Going Into 4x4 Lo By Itself
Jun 25, 2012
I've got a 2005 F-150 (5.4 triton) with about 35k miles that I rarely use in 4x4 mode. The other day, after stopping to fill up with gas, the truck 4x4 Lo light was on after starting it. The dashboard switch was still in 2H mode as I never switched it. I first thought that the dashboard light might be in error, but when I began to pull out of the gas station. the truck was in fact in 4x4 Lo. I had forgotten how to cycle it back to 2H so I slowly drove about 3 miles home at 20 mph.
Once home, I re-read the tranny sync sequence and managed to get back to 4x2. I called the dealer who never heard of a truck getting into that Lo mode w/o activating the switch and suggested that I just monitor it. I read a number of forum threads discussing the IWE and solenoid problems, but all of those threads dealt with issues of not being able to get too 4x4 mode. My biggest concern is that I leave in a month for a 2000 mile trip, towing a cargo trailer and I'd hate to inadvertently switch into 4/4 when traveling 60 mpg on a highway.
View 1 Replies
Advertisement
I'm having an issue with my 2005 f150 xlt. Its been happening for almost near a month and still cant locate the issue .
It has a vibration at 75km throughout the whole truck. Ive tried multiple things done to it by a mechanic, such as having the tires balanced and the ujoints replaced. The problem still persisted and after attempting to test out to see if press/releasing the parking break (my mechani suggested trying that out), my driveshaft fell off.
Apparently the center bearing snapped and cant simply be replaced on the 05's. So i had to get a new driveshaft installed (used, both the 3 mechanics I've gone to say its in good condition).
Even after replacing the driveshaft the issue persists - however it seems a bit softer than it was (I am guessing the old driveshaft was worn from the vibration causing it to be worse). After that I took it to another shop to see if they could locate the issue. They did a driveline inspection and engine inspection too see if a misfire could be the cause.
Again, nothing was found. The only thing they were able to find was that the issue only happens under load and slightly occurs at 40 and 100km as well (although alot softer then the one at 75) and they say they cant find anything physically and it was a mystery to them.
View 2 Replies
I have an 05 150, 5.4l, My truck idles around 600 rpm when warm, I think that may be slightly low. Not sure what to check on.
View 1 Replies
Well I have had a completely dependable truck until today. I was driving my truck on the way home, its an FX4 with only 33K miles on it that i have had since new. I went to accelerate to pass some cyclists (not a hard acceleration) and the vehicle cut off seemed like it kind of bucked a little as if it was shifting gears hard. I got a service light but what was weird was the gauges worked and the RPM still showed 1000. I did have power still though as the radio was on. The only thing that is currently wrong with the vehicle is the odometer gauge is out and needs to be replaced.
Anyway I shifted to neutral and restarted on the fly and than shifted back into drive and it drove the rest of the way home fine. After i got it to my neighborhood i ran it hard and it did not cut off again. I do not want this vehicle to cut out of me in town in the middle of traffic or while i am driving my 18 month old around and i get disabled with her in the truck. Slug of water maybe? I filled up on monday and still have around 3/4 of a tank of gas. Maybe short because of the gauge issue getting worse? I have the crazy door locks and beeps but nothing else has occurred. 05 F150 FX4 5.4 ....
View 2 Replies
what can i do to make my truck really lout? ive already cut 2 cats out and ran 2.25 strait pipes and its not even that loud would it hurt to cut the other 2 cats out??
View 10 Replies
A week and a half ago I went out to my truck to go somewhere and I got about 2 blocks away and the truck started running really rough and had a big lack of power, so I turned around and scanned it with my code reader and the codes I got were p2271, p2196, p0303, p0012, p2197, and p2272. since then I've changed all the spark plugs, boots, swapped all the coils and injectors from a great running truck, fuel filter, and the bank 1 upstream O2 sensor.
the other thing that came to mind that could of caused the problem is that a few days before the problem started. I jump started a co-workers car and he hooked the cables up backwards on his car. Could this be the cause of the problems I'm having.
The truck is an 05 F150 FX4 5.4 with 180,000 miles on it.
View 9 Replies
I have had the check engine light on for a while now with the truck shuttering and bucking along with loss of power. Feels like there is something holding back the power. Just a couple days ago I was driving on the freeway and all of a sudden it felt like I was in neutral, tried to accelerate but the engine revved but wouldn't go anywhere, I clicked the overdrive on and it went into gear and I was able to drive home. Now every time I drive it, it goes a block or two in drive then again feels like neutral, put in overdrive and it goes into gear. I just put in new ignition coils.
View 9 Replies
My truck gear shift is stuck in Park (console type). I have been reading threads that discuss potential causes such as blown fuses, bad brake switch, bad brake shift interlock actuator, and even ignition switch. All fuses are okay. Before I try to get into all the other possibilities, I have a question around what the local auto parts worker suggested. He said that there is a small plastic piece that may have slipped down interfering with gear movement. This could make sense, especially since the white manual release lever doesn't seem to be moving.
View 14 Replies
2005 ford f-150 Lariet goes into failsafe mode while driving on freeway. This is a dangerous situation happened ever.
View 2 Replies
I have a new to me 2005 F150 with 86,000 miles. When I am driving through town at a low acceleration or a constant speed at between 40 - 50 mph the truck starts to sputter and kick a bit. When I give it some gas the problem goes away. This gets worse when I pull my bass boat, and starts at around 30 mph. When I hook it up to a reader I get a P0316 code. Only code I get.
Also when I am driving through my neighborhood between 20 - 30 mph I get a noise that sounds like there is a plastic bag stuck under the truck. I have checked under the truck to see if the firewall is loose anywhere, but could not find anything. Other than those two issues the truck runs great. What these problems could be?
View 2 Replies
.Here is a run down of my truck 05 5.4L Screw has 130K on it. Sometime when going up a slight incline the truck at partial throttle will shake very very little. if I put my foot into it the shake goes away and the truck response just fine. It only does this when going uphill on the freeway and on the streets here in Dallas that have slight inclines.
The truck is not throwing any codes nor does it stall at lights. Starts right up in the morning and runs good. Nothing done to the truck except I have an Edge programmer and Magnaflow exhaust. I have pulled the programmer off and returned the truck to stock and it still does the same thing.
I bought the truck used in 07 had 40K miles on it. I'm thinking spark plugs or maybe a coil is going bad. But this doesn't happen all the time just here and there.
View 7 Replies
I have read many pages here on issue of leveling trucks.What concerns me most is the pics I see of the drive axles angles.
My question is if my stock 2005 runs a 265/70r17 tire and I level it with a 2 to 2.5" kit and change my rim and tire size to 28565r20 will this keep angles more level..
View 3 Replies
My F-150 has developed a rattle and vibration at idle that only occurs with the truck in gear and stopped (with the brake depressed.) The noise appears to be coming from the front of the truck, perhaps from the driver's side (though it's difficult to tell while sitting in the cab).
Before I go crawling around underneath with my son holding the brake while the truck is in drive--I would sure like to know where it might be best to point the flashlight.
View 6 Replies
Just got 2005 screw fx4. Seemed to run ok 115000 mi.Had exhaust leak,I put on 3" cat back on. Then I noticed tapping at front of the engine.Turns out tim. chain guides are broken. looks like very common prob after reading many forum/threads. Anyway got timing chain kit, phasers, selinoids. Truck runs and sounds great.But so far had truck back 2weeks stalled 2x at idle.What next??
View 14 Replies
My truck will not go above 30 mph - rpm's will rev high but, speed will not climb. I was able to put the truck in 2nd gear and drive home at @ 40 mph. Truck has 135K miles on it, I'm the original owner. What this might be?
View 14 Replies
My buddies truck runs fine, but when he floors it he says it dies out. Like it shuts off. Lets off the throttle n it comes back.
View 3 Replies
2004 f150, Column shift Auto...
Today I stopped the truck put it into park and shut it off, everything worked fine, when I went to go start it back up it started but I cant put it out of park, I called FORD and they said put the key into the on position press the break as hard as you can and put it into neutral, we tried that and it didn't work, then they asked if we could move the truck because it could be struck or something still nothing... We tried the little cap and hold it to override the solenoid but it didn't work I dunno if I am doing it wrong so Is there any other things I can try or can you walk me through the override button here's what I did with that.
Opened the cap with a flat head
pushed it in
And started tried to shift
Is that what you do or what do you need to do??
Is there any way I could check the solenoid how do i take apart the column to do that?
View 7 Replies
I was just wondering how do I find out if my FX4 has a locked rear? We bought it used so I have no clue.
View 14 Replies
Just got an 04 f150 STX 4.6L Regular cab.
Drove fine for a few months (she's a little rough, but she does the trick).
The other day, I went out to go to work, truck would start and run, won't come out of park. Both turn signal indicators on the dash are illuminated, turn signals, flashers, radio and Climate controls do not work.
Currently driving with the emergency shifter release pulled out and zip tied open. First thought was interlock switch, but I'm not sure if that would affect everything else.
This happened once before, and I pulled all the taillights and checked all fuses, then it just seemed to work again after flipping the rheostat for the interior/dash lights. didn't work this time around.
Dash is all torn apart - where to start looking?
View 14 Replies
I have a 2004 150 with 165,000 miles I sometimes pull a 5 by 8 trailer. when pulling trailer in overdrive and excelorating the engone will cough several times. I took it to a mechanic and he told me that there was nothing he could do that I needed a new engine. I can pull trailer out of overdrive with no problem. don't undrstand why I need new engine....
View 3 Replies
I may have to replace the starter on my truck. Have heard it is difficult especially on the top bolt. Any stickys/bulletins on how to do this.
View 1 Replies
