Ford F-150 (2009-2014) :: 2001 - Power Steering Line Leaking At 45k Miles?
Dec 22, 2014
Brought my 2011 Limited (6.2 so old school hydraulic power steering) in for its 45K service, and they found a weeping high pressure line. $100 special order part + 3 hours labor. This seems a little soon (to me) for PS components to be failing already, or is this a common repair? They said I could leave it alone for now and monitor it but could lose power steering while driving (safety risk).
Any history of high pressure power steering line leaks at such low mileage/age before? Does 3 hours labor sound about right?
View 5 Replies
Advertisement
2010, 5.4L... Noticed a small oil spot under the truck this morning. Took it into the shop after work, we lifted it up, and ran it for 15 min to see where the leak was coming from, and the truck did not leak a drop... until we turned it off. The oil would slowly leak near the power steering pump pulley. But only when the engine was not running ...
View 1 Replies
I have 2002 F150 5.4L gas 4X4 Lariat FX4. Last winter when it got to -30C here in Manitoba one of the lines near the power steering cooler began to leak. I had just bought this truck and upon investigating found that the original line had been replaced and reattached with hose clamps. I had this "farmer fix" redone but then this winter when it hit -30C it blew apart. Obviously something happened to this line before I got it, so I am curious if there is an issue with these power steering cooler lines when it gets really cold. Should I just get factory lines installed and hope for the best?
View 3 Replies
I picked up this 2004 Chevy Venture for my daughter and it has a power steering fluid leak coming out of the power steering cooler line that runs along the frame in front. I know that the procedure to replace this line calls for disconnecting the intermediate shaft of the steering and lowering the subframe to gain access to the line connections on the rack. My question is, is it possible to replace that line without lowering the subframe? I ordered the new line and it's on its way. I wanna do the job right.
View 3 Replies
Someone stopped by the shop today with a problem with the power steering leaking. I checked it out and the return line from the rack to the pump is rusted through and needs to be replaced. The pressure line looks just as bad and will develop a leak soon too, if not replaced. While chatting the customer revealed that while stuck with no power steering, he put motor oil into the reserve tank because that's all he had. It did get him home. My plan is to replace the pressure line first, then cut the return line below the car (where it can be accessed better). Then use my evacuator.
hooked to the return line from the rack. Start the siphoning and fill the reserve tank with the proper fluid to flush everything out. I figured that it would flush the reserve tank, pump, pressure line, and rack. Then replace the return line and top off the tank. Will I have to have the engine running while I flush, and do I need to work the steering wheel left and right too.
View 2 Replies
I have a 2003 Santa Fe that had a corroded leaking power steering return line. I want to replace both the high pressure and the low pressure lines coming from the steering box. The high pressure removed quite easily. I cannot get the low pressure out. Everything is broken free. Is there a trick to this? I want to see how it comes out so I can put the new one in same way.
View 3 Replies
Looking for the instructions on how to remove the lower power steering belt and replace it. We recently discovered the leak and I can't find any information on it.
View 1 Replies
Started a while back and comes and goes. Only commonality I have found is the truck needs to be warmed up for it to happen and usually after a few hours of driving. The downshift from 5th or 6th into fourth, at times, produces anywhere from a light to violent clunk, feels like a typical tranny slip. It will do it while in cruise and it will do it if I don't have the cruise on. Can't figure out if it is going to be a tune issue or hardware.
It does it only downshifting into 4th from 5th or 6th, no other downshifting is a problem and usually the 6th to 4th produces the worst results. At highway speeds that is usually a shift from around 2Krpm to just over 3K rpm (6th to 4th) if it is from 5th it is about 2500 to 3K. Start from a stop and go WOT and there are no issues.
Having it in Tow/Haul or not makes no difference as far as I can tell. IT can do it on one hill and the next time be just fine or do it 2-3 hills in a row. After this last trip it will do it at 9K feet or at 60 feet elevation, didn't make a difference there either.
Another issue that may be hurting the computer is the truck originally came with the 235 tires, it now has 285's and the rear is only 3.31. I plan on going with 265's and maybe still a gear change to 3.73's in the future. I usually only notice this on long trips, first was a 1500mile hauling an ATV, second was last week during a 2500 mile empty. Although I have had it do it a few times locally. I figure those bigger tires can't be good especially with that high of a rear for the management system.
View 3 Replies
My 2002 Elantra (about 276,000km) had some kind of leak in a power steering return line. A mechanic looked at it, said I needed to order the replacement part from Hyundai. Got the part, the mechanic (not Hyundai) took 2 hours and fixed the line.
Driving away from the mechanic, I noticed the front right turn signal was blinking abnormally rapidly. Left turn signal is fine. I call the mechanic, tell him what's happening, and ask if it might be related to the power steering line fix (after all, they're both in the right front side of the vehicle). He swears up and down he touched nothing having to do with the turn signal.
Okay, maybe it's just a coincidence. I buy a new signal light and put it in. Same thing with the front right turn signal blinking too rapidly. While driving back from replacing the bulb, a car cut in front of me and I went to lay on the horn....nothing happened!! No sound. To top it off, for a while now, the dashboard lighting has been dimming slightly at certain times.
What could be causing all this? The alternator is fine, someone tested it.
View 4 Replies
My 2010 F-150 Lariat 5.4L 2WD Ext Cab with 76,000 miles is leaking power steering fluid. I traced it down to the cooling coil in between the radiator and the transmission cooler. It does not look easy or cheap to get out of there. Stop leak scares me a bit...
View 14 Replies
I have a 2010 f150 XL. 4.6L The power steering would work one day and not the next and work again and so on. But now it just stopped. How can you tell if the pump or the rack and pinion is bad. My reservoir full of fluid. When I start the truck turn the wheels there's no whining sound. Should the fluid in the reservoir be flowing?
View 1 Replies
Is there any way to check your level of the power steering fluid on a 2013 xlt 5.0,
View 4 Replies
I noticed that the power steering fluid is leaking bad from a weird spot under the car, it looks like it is coming directly under the drivers seat but I can see any lines. It's an 02 Santa fe ....
View 8 Replies
I purchased a 2014 Passat 1.8tsi - had 4 miles when I test drove it.
Now a week later and 100 miles later I noticed a trail of red fluid when I had parked in car port. Leaking transmission fluid. I can see fluid drops on all the bolts underneath the car. I feel like dealer should give me a different car - 100 miles and a problem like this - feel like I have a lemon. Not sure if I should even drive it to them or they should tow it? Why its leaking? -
View 4 Replies
I have a 2010 F150 4.6 3V... The power steering reservoir is constantly losing fluid. I've purchased the truck,used, a few months ago, bought a warranty. The dealership has had it multiple times now and can't find the leak. They just keep replacing hoses and the problem keeps occurring. Also worth noting, the truck has 6" lift with 35s. I've have also pulled the radiator cap and found a decent amount of what looks to be sludge/oil inside. Dealership says it's probably just bad coolant.
View 1 Replies
I'm having some strange action in the turn where sometimes it "sticks" and also I sometimes get a loud whining sound for 10 seconds or so and I believe it's coming from the power steering but I could be wrong.
I know my ecoboost has an electronic power steering system but that's the extent of my knowledge on it. Does it have a pump anywhere in the system that could be making this whining noise?
124,+++ miles, no real issues, runs like a champ.
View 4 Replies
We have a 2001 VW Golf w/100K+ miles and the power steering fluid's leaking. Mechanic says a new rack/pinion and steering gear is needed. The estimate is $1K which troubles us because of the market value of the car isn't great. So, in the meantime, I tried "Lucas Stop Leak" and it seems to work (when the fluid was completely empty, it was making that loud screeching noise). Seeing that this is a 2nd "back-up" car, my questions are these:
1) Is it a bad idea to use Lucas (topping it off w/VW-approved steering fluid)? We rather donate the car than than to pay for the repairs. Some internet searches indicate that a lot of people drive around with a bottle of Lucas in their trunk. That is, that they avoid the repairs by using Lucas
2) Is it dangerous to drive the car? I notice the alignment is off and that re-alignment is part of the repair job. Can I have the re-alignment done?
View 4 Replies
OK so my 2001 F250 was leaking power steering fluid from the lower portion of the gearbox (where the pitman arm attaches).
I found a thread on this forum where it showed how you could change the seals out WITHOUT taking the gearbox out.
So I got the pitman arm off with a heavy duty puller. Then I scraped out the 1st rubber seal hoping to reveal a snap ring behind it. Well, the seal is 99% scraped off, but there is not evidence of a snap ring. It does seem like there is some metallic ring holding another rubber seal in behind it. But again, I can't find the little open spots that you put your snap ring pliers in to get snap rings out.
How do I get this metallic thingy out???? I already broke a small drill bit trying to drill it out. It just doesn't seem like the best way to go about it.
View 1 Replies
Couple of years ago I installed a fuel pressure gauge. I wrapped the fittings with teflon tape. Well within about a year it started leaking. So I shopped around and used Permatex Permashield fuel resistant sealant on the fittings. It says diesel resistant on the package. Couple months later leaking again. So I take it apart again, clean every fitting and follow the instructions to the letter. Well its leaking again. What will resist diesel fuel under 55 psi pressure. All the fittings seem to be pipe thread.
View 7 Replies
2.7 Power Steering Fluid boiling/foaming leaking out a reservoir cap!
1) Recently had Timing Belt/Water Pump and spark plugs/wires replaced.
2) Issue started immediately after.
3) Removed most of old PS fluid, cleaned out reservoir w/brake cleaner. NOTE: nothing appeared to be clogging reservoir. Refilled with new PS fluid. Repeated these steps a second time. This appeared to immediately resolve the issues for several weeks.
4) Now the power steering is getting rough and noisy again. Also, the PS reservoir is leaking out of the cap worse than before. It looks like the fluid may be "boiling", but it is definitely foaming up pretty badly.
What my issue(s) may be?
View 4 Replies
New to me early 99 (4/98) f350 7.3 6 speed. Truck started acting up a few days after I bought it. Return line at fuel bowl was leaking, so started there and found a bad seal on the Fpr (unrelated to the fuel leak due to disentegrated compression sleeve). Fast forward through a bunch of parts swapping that still resulted in miserable lift pump pressure readings, I pull the sending unit out of the tank, expecting to find a plugged screen.
Well, there was in fact a plugged screen... Attached to the bottom of an in-tank pump. How did that get there?!? Everything I've read says there should only be a pickup tube??? Should I get a new sending unit from a junkyard and do the hutch mod or???
View 9 Replies
