Ford Super Duty (1999-2016) :: 2004 F250 - Rear Tail Lights And Front Running Lights Not Working
Apr 1, 2013
The rear tail lights on my truck have been out for a while now. I wasn't doing much driving at night so it wasn't much of a bother but the new job is getting me home a little later and having to drive with my hazards on is getting old fast.
My radio wasn't working either and I disconnected it a while back hoping maybe it had something to do with my lights shorting out but no luck. It remains disconnected. Just in the past few days my front running lights have went out as well.
I've tested all fuses multiple times (and replaced a couple of them) and checked and replaced bulbs. My brake lights, headlights, dash lights and hazards all work fine. I have the trailer light hook up on the rear bumper and disconnected it at the wiring harness as well hoping it was the problem but it wasn't.
View 3 Replies
Advertisement
The flashers and blinkers work, the taillights, brake lights and back up lamps do not.
The truck is a 2004 F250 4x4... Checked all fuses. What am I missing?
View 9 Replies
Got my 02 f350 stuck in the mud a while back and had to get a deuce and a half to pull me out (F250 couldnt do it). Anyway since then my front parking/running lights don't work.
-I have checked the voltage at the bulb socket....nada
-I have of course checked the fuse and its fine (checked ALL fuses)
-ALL other running lights are working including top clearance lights, dually fender lights, etc.
View 6 Replies
I have a 1995 Ford f250 Powerstroke and i do not have turn signals, rear running lights, brake lights or reverse lights. i checked the fuses and they seem to be good but i dont want to tear everything out to check the harness if it could be a bad ground. any insight?
View 1 Replies
I have a 07 f250 and wanted to change them to the 08-14 tail lights. Did Ford change the size or a simple switch...
View 2 Replies
I have a 2010 F250 super duty and I cannot figure out what is wrong with my 7 way for trailer lights. I have brake and turn signals but no tail lights. I have checked all fuses and relays and they are fine.
View 4 Replies
I recently got my truck back from the dealership 04 super d 4x diesel (wife put gas in).. Anyway my dash lights, running lights and brake lights are not working. I checked fuses already and I did not see any obvious problems. I also replace the switch but that didn't work. Perhaps a ground somewhere or a relay? Turn signals and headlights work.
View 1 Replies
I Have a 2002 F 250 That I recently changed the fuel pump. and now I'm having a tail light problem. when i start the truck, my tail lights and plate lights comes on (dim). if i turn my head lights on the truck stalls out. if i step on the brake or put the truck in reverse it stalls out. if i put it in drive it runs just fine. i checked my fuses and relays and the problem is still there even when the relay and fuse for the lights are out. when i turn the truck off all the light go out.
can't seem to find any info on this problem anywhere.
View 3 Replies
I have a 2001 f250 v10 lariat ext cab. i was going to get wood the other day down a muddy road. My radio went out and all my running lights. i replaced the fuse radio and now the switch. Still nothing. Could it be a bad ground? i ran a jumper wire on my old switch and they worked then just stopped again. if it is a bad ground where would it be located.
View 3 Replies
2004 f250, brake lights except 3rd brake light do not work. flashers also do not work. turn signals work on both sides. when you turn on the flashers only the right indicator on the dash lights. checked all fuses for brake lights and am at a loss. On a float trip this weekend with my toy hauler and need brake lights to get home.
View 2 Replies
I am having a problem with trailer lights and an 03 350. When the truck is in reverse the fuse for travel trailer running lights and tail lights blows immediately. Changing plugs on the truck did not work. Truck has been hooked up to 4 other trailers including another travel trailer with no problems. Our travel trailer has been hooked up to an 08 and a 2011 truck with no problems. Fuse 38 20 amp. 7 post rv plug.
View 3 Replies
I have a 2005 Ford F-250. I have checked power to the rear harness and all is good except for the tail/running lights.
Is there a fuse for the tail lights? I have checked the manual and don't see one called out. And the relays under the hood are labeled stop lights/turn signals and those are working fine.
I will see if I can trace the brown wire from the rear harness backwards, but it may be a simple fuse.
View 3 Replies
I have a 2005 ford f250 with the factory installed brake controller and towing package,until recently all was well,I tow a fairly large travel trailer and last time I hooked the trailer to the truck I noticed the running lights on the trailer were lit, I checked to make sure that I did not have the parking lights turned on or the headlights. I did find posts about the running lights not working and was surprised to find there is a relay somewhere on the central junction fuse block that was integral to the cfb and not user serviceable. Could my problem be that this relay failed in the closed position or am I not going in the right direction in my quest to find this problem. Also looking for a diagram of where this relay is located on the central junction fuse block? I would also consider doing a work around solution rather than having to replace the entire fuse block.
View 7 Replies
Just bought a 2002 F-250 Crew Cab. It has the factory style running boards with the lights at each end. None of them where working so I changed the bulbs and still nothing. I decided to follow the wiring to make sure everything was good and found that neither one of the boards are plugged into anything. They both have about a 2' loomed harness with a plug on the end of each board and it is zipped tied to the frame. But there is no wiring nearby to plug it into, I have checked everywhere. I can run extra wiring no problem if I can find out where they are supposed to plug at.
View 14 Replies
Looking for some info on wiring up some Day Lights Running Lights on a 2016 F250 with diesel engine? Thinking of adding LED lights to front of vehicle for day time use.
View 13 Replies
2012 f250, fog lights stopped working and tried fixing yesterday. I'm getting 12.8v at the plug but as soon as you plug the light in it goes to 0. Ran a new ground from frame and the hot from plug and still nothing. High beams off, truck running and switch pulled out. Bulb is fine, hooked it straight to battery and it comes on. I though it was a faulty ground but by running a separate ground and still nothing. I'm at a lose.
View 2 Replies
I have a 2012 F250 and am having a problem where the interior lights wont come on with the dash switch or when the doors are opened. I have confirmed that it is not a bad fuse, also the lights will come on when the switch on the individual lights is manually pushed, but not automatically like they are supposed to. I dont see it being a door switch issue because the door chime comes on and the stereo goes off when the doors are opened after turning the ignition switch off. I've read that the dealerships will switch out the BCM. I thought maybe the dimmer switch next to the headlight switch but there is no power to it whatsoever, which also I can't dim the instrument panel lights. What did you do to resolve?
View 1 Replies
I have a 2005 F250 that the brake lights are not working when brakes are applied. The rear blinkers and flashers are working. what could be my problem.
View 2 Replies
Just got a 2001 F-250 Super Duty (crew cab, long bed, 4x4, 7.3L turbo diesel) and have been going through and fixing a lot of little issues. The one that now has me stumped is the interior lighting circuit (which is also the bed light). Here's what I've got so far:
Map/reading lights work, but dome lights do not (neither automatically nor when turning them on via the dimmer switch). Verified all fuses in the PDC as well as the interior fuse panel (behind the driver side knee panel). The interior lighting relay was missing, so I purchased and installed it.
Relay #1 (interior lighting), fuse #4, and fuse #14 are all good - when I pull the fuse with the door open, the relay clicks (and clicks again upon reinstalling the fuse). With the doors closed, the relay clicks when activating the interior lights via the dimmer switch.
The LT GRN/YEL wire is hot, and all related accessories work (map lights, engine bay light, etc).
The BLK/LT BLU wire is not receiving power from the relay from what I can tell.
Before I start trying to pull out the fuse panel to start checking connectivity, anything else to check? The ground at the rear driver corner of the cab is good, and a visual check of the harness running down the driver side of the cab has no visible signs of damage.
Also, given that the relay is audibly actuating the way it should, I'm guessing that the GEM can be ruled out as a possible cause? My next step will be to get a pinout diagram for the relay and crimp a quick jumper to see whether or not it's simply a defective relay... But I doubt it's the case.
View 6 Replies
2002 f350 5.4L
No rear running lights or brake lights
No third brake lights
Headlights work
No signals or hazard.
I have power to the multifunction switch when I use a jumper wire to bypass the switch I can make the lights come on depending on which slot I put it in. I replaced the multifunction switch twice just to see if I got a new bad one the first time, but to no avail. I cant run my truck a night without the lights.
View 2 Replies
I installed an aluminum flatbed on m 2004 F250 5.4 and when I was wiring the lights, I accidentally shorted the marker/running lights to ground. The fuse is not blown (17), the dash lights come on. I have checked for power to the other lamps and there is nothing. I am looking for any information that would lead where to look for the cause.
View 10 Replies
