Ford Super Duty (1999-2016) :: 2007 - Mirror Swap - Wire Harness?
Nov 28, 2016
I have a 2007 F-350 SRW. I bought some mirrors of craigslist from two different sellers. They are from 2008 or later, they didn't know the exact year. I have looked in the tech folder and searched and searched. could not find wires that are the same color as mine. Yes, mirrors are OEM. I need to know what color goes to what color.
Do they match color to color? question mark represents color that doesn't line up
drivers side door colors=============== new drivers side mirror colors
green------------------------------------------------- green
black--------------------------------------------------black
green/white-------------------------------------------black/white?
blue----------------------------------------------------blue
yellow--------------------------------------------------yellow
red------------------------------------------------------red
brown---------------------------------------------------brown
passenger door colors=================new passenger mirror colors
green/purple------------------------------------------white?
black---------------------------------------------------black
white/blue---------------------------------------------black/white?
yellow--------------------------------------------------yellow
green---------------------------------------------------green
brown---------------------------------------------------brown
brown/purple-------------------------------------------purple?
Side note these are in no particular order as far as pin location.
View 5 Replies
Advertisement
Any limited number of lights the factory trailer harness on the truck can tolerate? I'm looking to add some extra running lights on my trailer, also want to put a couple of lights on each running board on the truck, they will be tied in with the trailer harness since it is not monitored by the BCM. I did a search on this a few different ways and couldn't find anything.
View 8 Replies
I have a 2006 F250 and my 7pin and 4 pin connectors are just hanging loose. I'm not sure what happened to the factory bracket. What is the part number for this bracket? Also, where does it mount to? I looked under the truck and couldnt tell where the factory one mounts.
View 4 Replies
I have a 2016 F250 XL and I want to put smaller outside rear view mirrors on her. I thought I can't be the first person to want to do this but repeated searches haven't turned up a bit of information.
I have the stock XL black plastic tow mirrors. They are manual extension and manual fold in. No heat, no lights, nothing. I want to go to a smaller, non-towing mirror like comes on stock F150's, chrome would be OK. In about 18 months I will want to go back to my trailer towing setup. I need to be narrow for a while.
View 8 Replies
I just went from 3.73 to 4.30 gears on my 2007 f250 6.0. It has the standard Sterling 10.5 rear and Dana 60 front. My mechanic friend who did the swap said the ABS light came on during his test drive but the truck drove fine. I was of the understanding that the truck would not need to be recalibrated for proper speedometer and transmission function, but what about the ABS?
View 7 Replies
I am looking at getting my new truck, my 05 F350 6.0, with factory trailer brake controller, all set up for a gooseneck. I was wondering if there was an OEM kit to add a trailer connection plug to the inside of the bed? If there is, what are the part number(s)?
View 9 Replies
I found these on my buddies truck, its on the frame rail on both sides. I have the connectors and lights to install but there is no power at the harness. Is this something the dealer has to "reflash" in the pcm to make these light up? I assume they should operate while unlocking the doors or opening, ign. on or off.
YouTube.....
View 4 Replies
I have been tracking down my ABS light and found that the left front wheel speed sensor has had the wiring harness ripped off from behind the front wheel. I have about 2ft of the harness coming off of the actual sensor.
Question is, since I cannot locate any wires that this seems to be able to be connected to, can I simply cut and splice these wires directly into the Tan/Black + Tan/Lt Green wires going straight to my ABS controller?
View 3 Replies
The pigtail from my bumper mounted 7-pin to the factory connector is all hacked up from the previous owner so I'm looking to replace that pigtail. Also wondering if there should be 2 connectors down there to add a connector for my gooseneck or do I need to splice another universal 7-pin into the bumper light pigtail? Also, is there another (preferably slightly cheaper) option besides e-trailer for such a connector?
View 3 Replies
I'm still fighting tow harness problems on my '01 F 250. I started by replacing the 7-way pig tail with a new one which didn't work. Then I undid all the butchering of the harness that was done previously. The factory harness had scotch locks all over it that were used to splice in a 6-way and a 7-way into the bed. I liquid taped all the nicks in the wires. Then I checked for power at the factory harness end where the pigtail plugs in. I have park/running lights, and one of the ports flashes for the left turn signal/flashers/stop lamps. I got rained on before I could check further up the wire. If I have no power to the wire further up is there another place to check?
View 2 Replies
Any info if the "Aux" terminal on the trailer harness wiring on '01 F250s is for reverse lighting? I'd like to put some on my stock trailer. Also, is the "12v" terminal feed switch operated or hot always?
View 2 Replies
My custom air horn setup. I have a schematic here and and need info whether my drawing is right or not. I also need some help on what gauge wiring, what amp fuse and what relays.
View 2 Replies
Installing a Pop N Lock on a 2016? What were the wire colors you tapped into?
View 3 Replies
Can I take the tranny out of a v10 and put it in my 7.3L Powerstroke?
Both are 1999 f250's.
From what I've read they should both be 4r100's.
View 6 Replies
Can an f-450 with a blown 6.4 diesel received an transplant from an f-350 V-10.
How much would need to go over from the f-350 to f-450?
View 1 Replies
I'm thinking of doing a dash swap on my 99 super duty to the 2008 super duty dash, steering wheel, etc. I know the od in my truck is mechanical and in the new one its electronical is it possible to swap without having to redue the whole electrical system and computer? Is the steering wheel going to line up and the ducting? How should i approach the wiring?
View 14 Replies
where do the wires from the cabin aux switches end up? Are any pre wired to outside of the cab (past the firewall?).
i was wanting to install a better back up light on an aux switch but don't want to deal with running thru firewall, etc.
View 2 Replies
Where is the best/easiest location to run some wires from the cab to the engine compartment?
I need to run some wires for a remote start with alarm and a backup camera.
View 13 Replies
I recently purchased a 2011 F550 Super Duty with a flatbed mounted on it. Turns out, the trailer wiring harness is totally screwed up and I am getting tons of shorts whenever it rains. Going through it front to back, we are finding multiple problems like missing fuse box covers, damaged fuses for starters. The Ford dealership in Texas that did my prepurchase inspection for me totally missed all of this, so i am stuck holding the short end.
IN the rear of the truck we detected shorts in several areas. One of them is in this adapter pictured along with this. Is this a Ford part, or does it appear aftermarket? Is it just an adapter or is it more than that? I am just now getting to l know this truck more specifically. given the date of manufacture on the label it would seem to be from Ford??? Part # is 99-004 and 71-012-A...
View 1 Replies
I recently had need of replacing my left exhaust manifold on a 2000 F250 4 x 4. I removed plastic inner fender well. Now I have a two pin harness with both white wires. One is white with red stripe, the other is white with black stripe. The harness is round with a locking square on one side. The harness is located about 10" from bottom of inner left plastic fender panel. It has 2 mounting pegs. Where the heck does this connect?
View 13 Replies
I'm trying to find out what the two connectors in the image are.. I've looked through the manual that I have and searched around on the web and find nothing.
They're on a 2015 F250. "upfitter" switches were installed from the factory.
View 12 Replies
