Ford Super Duty (1999-2016) :: Clock Spring Suffered Water Damage - Replaced But Still Fault Message
Feb 4, 2016
I have a ford f350 2014 that had some water damage, the clockspring suffered water damage so I replaced it along with the steering column module.
The clockspring was brand new from ford, already centered, I pulled out the plastic tab during install.
Cluster has SERVICE ADVANCETRAC error and IDS is shows fault with the steering angle sensor. (see picture)
Do these new sensors have to be reset and calibrated to work, or does this FAULT message on IDS indicate a wiring problem?
View 6 Replies
Advertisement
2001 F250, 5.4, Replaced the clockspring and now my steering wheel feels very tight. After cornering, it doesn't come back on it's own, like something is rubbing. The face of the clockspring is slightly different than what was there.
View 1 Replies
Adding cruise control to F350 XL I just bought. I got a steering wheel with the buttons. But I am having problems with the clock spring. Mine has an 8 wire plug with only 6 pins on the big plug and all of the clock springs I have found have only a 6 wire plug for the big one. Without changing my clock spring I have no where to plug in the cruise wiring. All have been for right year model with cruise and even tried different years but none will plug in under the dash.
View 3 Replies
We are in Montreal and are getting a "TBC Fault" message from the tow command brake controller. The owners manual is a little fuzzy about it...says may experience degradation of braking. The message displays each time I start the truck and clears if I hit the reset. I get a good connection if I hook up, and can hear the brakes activate on trailer...just have not tried to tow.
View 14 Replies
So on my way to work this morning taking off from a light on a smooth blacktop my message center lit up with "tire pressure sensor fault". is there any way to tell which sensor it is without a scan tool?
View 11 Replies
Got a 'Tire Pressure Sensor Fault' message a few times on the way back from Florida. Tire pressures were all fine. Hate that it doesn't say which monitor has the problem. Anyway... it comes on, but after a few minutes goes back off. Saw it a total of three times over the course of 1,000 miles in two days. Is this the sensor failing and requiring replacement? Or is the system itself starting to fail? Would ESP cover this?
View 6 Replies
Every time I touch the brakes I now get a very annoying beep and an error message that says "wiring fault on trailer." I don't have a trailer hooked up so not for sure what's going on. The error message on the console I can live with but that loud beeping is driving me crazy.
If you hit the brake and keep the pedal depressed, then you only get the initial beep and then it goes away. The problem for me is I live north of Dallas so if I'm in traffic then I'm constantly hitting the brakes. I called my dealer today so I'll wait to hear what they have to say.
View 14 Replies
Conversion from the dana 50 to the newer dana 60 with coil spring? My Dana 50 has called it quits so while my front end is already off the vehicle already why not make improvements. Ford used the 50 for 1999 to 2002 then upgraded to the 60, I'm guessing it was for a reason!
I've read this article on a similar project but the dana 60 had leaf springs as well: Dana 60 Conversion for F250 years 1986-1996 .: Articles I'd prefer coil spring, nothing more then personal preference with a bit of better ride quality. The donor vehicle is a 06 SRW F250 This is not what I'll be getting but just as an example of the parts I would get.
View 10 Replies
Does this look like a bulb may be burnt out?
It is dark between 5 o'clock on the speedo and 8 o'clock on the tach.
Where are the dash lights and what type are they?
View 3 Replies
Ok, I've seen a post or two about this issue of rear end chatter on the super duty But not that many so I am going to ask a question here and now......what causes/allows this to happen and what purpose does it serve? also, does it cause any damage to the gear head? or any other part of the rear end?
My truck tends to do this from time to time when I am plowing snow (only when backing up, or at least so far) and I really can't relate it to condition other than maybe the fact that pushing snow may cause the gear oil to get hotter than normal driving and thins out and causes this?
View 2 Replies
I am looking at a set of SD axles for my 92 F250. I have been looking for the last 2hrs and have found measurements for seemingly every axle in existence except for the SD D50/60.
What the center to center width is on the spring pads of the front axle. Wouldn't hurt to know the same measurement for the rear either.
Also, a bit more trivial, but still need to know, what is the size and taper of the draglink joint that goes in the pittman arm.
View 3 Replies
Where I can get or have a speed nut for the front eye bolt of the right rear leaf spring? If you do I'll gladly send you some cash for it and to cover shipping it. It's supposed to rain pretty much all week here and I really don't want to go to a junkyard. I have checked ford parts and nothing there you can get the hanger that attaches to the frame that the spring bolts to but not the speed nut or bolt only need the speed nut though. Truck is an 2004 f-250 so 1999-04 will work and 05 to 07 is setup the same in the rear but I don't know if they are the same size bolt since they made the frame heavier. I have no idea after 07 when they made the springs longer.
View 1 Replies
i went to change the time due to DST, and when i push the menu button nothing happens.
is there any other way to reset the clock?
View 14 Replies
2003 f250 6" lift on 35s. How to lift the suspension to change out spring bushings? Was thinking using two chain falls on tow hooks on the front, any easier, safe, cheaper way. I have a farm jack but need to weld a plate on bottom of it for more support...
View 5 Replies
We currently have a 2011 F250. During the day time, when you turn on the headlights all the way (not just on "auto"), the dash lights and clock shut off. Originally, I thought that they were just dimmed to the point where you couldn't see them, but the brightness is already turned all the way up on the dash lights. If I turn the brightness up any higher, the dome lights turn on, but the dash and clock remain off. If you return the headlights back to the "off" or "auto" position, the clock and dash return to their normal brightness.
View 4 Replies
I just realized my driver's side front leaf spring on my 2002 F250 has snapped. I checked the weight sticker on my truck and it weighs 5200lbs in the front. My question is the heaviest springs I found only support 2630lbs a piece, so being a 7.3 is 5200lbs a correct weight for the front of this truck? also why would Ford make springs that support only 60lbs more than the front weight? Hell I weight more than 60lbs.... Did I snap the damn thing just by climbing into the cab?!?!
View 6 Replies
My front passenger leaf spring just broke on my 2000 f-350. My front springs are T code, but I was wondering if a could replace the broken one with a code X spring as a temp fix until I get a leaf spring replacement delivered?
View 1 Replies
So I went to install a front end leveling kit in my 2003 2WD F250, looked like a simple task, except the bolt that holds the lower coil spring mount won't budge! I tried heating the nut, I soaked it with WD-40, tried a 200lb impact and a 30" breaker bar with all my weight. Is there something I am missing?
View 5 Replies
What is the width between the spring perches on leaf sprung 99-04 front axle. I searched and cant seem to find a dimension listed anywhere. i tried the dana60 bible on the pirate site as well, but it doesn't list the spring perch dimensions, only for the pre 99 styles
View 2 Replies
I have a 1991 f250 that used to have a camper on it, I recently got this truck and when I put an older heavy camper on it the back springs flattened out and the front raised about an inch or two.
My question is...I am going to put air bags on this truck to alleviate this problem, should I replace the springs as well or will the air bags be sufficient to handle a camper?
View 1 Replies
Is there some sort of reset to turn off the Check Engine light? I had replaced the TPS sensor, and after a day the engine seems to have stopped the high idle and returned to normal, and now it still has the check engine with the same error code, but the problem seems to be resolved. My previous post: [URL] .....
View 14 Replies
