I put new ball joints on a few months ago and now the truck is starting the death wobbles felling even around slight bends in the road.I jacked it up and the passenger side tire will move 1" side to side scarey.Not sure what I need to replace.
View 9 Replies1999 F-350 7.3 Dually 2wd Front End issues. I think I may have several things going on so here goes. Truck has about 130,000 miles on it . Bought it with 60,000 miles in 2009.
It's always worn the front tires weird but it's gotten a lot worse and it's happening in about 10-15 thousand miles now. It's wearing the tires on both sidewalls like under-inflation but I run 70 lbs in them. I've noticed for several years now that it makes a knocking sound and I feel it in the floorboard, shakes in the steering wheel when I turn to the left only in a corner at speed. (65-70) ...
Now it's started intermittently going into the death wobble at slow speeds like the caster is to negative on it. I'm sure it could use some shocks but I just rotated the tires and I felt no play anywhere. I know when we used to get that bumping in the floor board on older Fords it was a bad radius arm bushing but that couldn't be all of what's going on here. I've done searches on this and it has happened to others but I haven't found a resolution from any yet.
I purchased the truck from a used car lot about 3 months ago and after driving for a few thousand miles I am feeling a slight wobble after hitting a bump in the road. Here is my truck set up:
- 2011 Ford Lariat F250 4X4 FX4 6.7 ltr
- 67400 miles
- Tires stock and great tread
- Rancho steering stabilizer kit
- Rancho Shocks
- Rear air bags
It does appear one of the rancho stabilizer dampers is leaking slightly. Why would the previous owner install a rancho stabilizer kit? Is it because of the rear air bags?
It seems that my 2010 F250 truck has come down with the dreaded death wobble. My truck is stock and has 63k miles. I was driving home today on a 2 lane side road and hit a few bumps that almost put me into the oncoming traffic. That sure did get my attention! I've been ready a lot on this site and wanted some opinions if replacing the stock steering stabilizer would fix my problem.
View 14 RepliesMy 05 F20 CC LB 6.0 4WD has the alternator light on for a few miles then goes out also sometimes goes away when you accelerate hard, is my alternator going, or is this some common glitch in the light hopefully?? Also every once in a while got the death wobble, installed tie rod ends and center link, but if I hit a bump just right it does it.
View 2 RepliesSo I've got a 2000 F350 7.3. Just replaced all the ball joints, sway bar end links, carrier bearing, balanced the tires... a bunch of stuff to try and eradicate this weird wobble I have and I just can't seem to figure out what it is.
The wobble happens at and around 35mph, and then once I break 70mpis on the speedo (I have a 4" lift and am running 35's so it's not actually 70). I've experienced death wobble before in a jeep I had, and it is nothing like that, and I can't see it being driveline related but I could be wrong.
My truck is a 2002 F350 CC dually longbox 4x4 7.3 auto that I bought last fall. On the street it is very well behaved although I suspect it is not giving me as much power as it should be, as compared to my previous 95 powerstroke.
Off road, slow crawling, the throttle is very jerky. Under acceleration it is smooth, but if I try holding a low throttle position, the rpm rises and falls. I am certain this is a bad TPS, and may also be contributing to my perceived low power on the street.
I have googled my brains out and it seems there is a cheap replacement TPS for earlier trucks but the 2002 has the 5 wire combined TPS and IVS, which reportedly is not replaceable without replacing the whole pedal assembly. To complicate matters I have the adjustable pedal assembly
So are there any options other than buying a complete pedal assembly from ford? Can I save some bux and retrofit a non-adjustable pedal assembly? I saw a youtube video where a guy put a newer 6.0 pedal assembly in but he was short on specifics about what exactly he gained doing this.
2000 F350. 4x4, V10. 153,xxx miles. Here's the story. Whenever I hit a little bump in the road, I get a vibration directly under my feet and in the gas pedal, NOT in the steering. It will go away pretty quick or when I hit another bump. It only happens when the front driveshaft is not spinning. Hubs locked in in 2WD, it doesn't vibrate. Hubs unlocked and in 4x4 High it doesn't vibrate.
View 8 RepliesI am installing a set on a '12 F350 for a customer. I already had to go buy an additional hardware in order to get the back bumper on correctly...and now I'm looking at the front bumper and I swear I don't have the parts I need to install it. It appears to be missing some brackets. There were NO instructions with them (apparently a chronic problem with Road Armor) and I can't possibly imagine it bolting to the flimsy brackets that hold the factory bumper (fairing would be a better word for it) in place.
View 6 RepliesI have a 1997 f-350 crew cab 4x4 w/ off road package and 7.5 fuel muncher power package. My engine stalls going down the road w/ no warning. Sometimes it will start back up immediately, and other times not until i cycle the ignition 6 times or so.it seems to be getting worse as time goes by. Since it started i replaced tps, cap, rotor, plugs and wires. I also replaced fuel tank and pump and filter about 1.5 years ago. Some other issues to clear up, but concerned w/ current problem.
View 2 RepliesI have a 2005 king ranch and have a clunk coming from the back over bumps/heaves in the road. It doesn't happen all the time but often enough. I just replaced the shocks, that worked a little but didn't solve the problem. Now thinking rear sway bar end links? Anything I can check/inspect?
View 1 RepliesHave a 06 f350 just rebuilt the engine. Started up ran it down the road a couple miles and lost low side oil pressure. Got back to the house and will not start again so put a gauge on and it only has 3 lbs after cranking for 10-15 sec. Pulled the balancer and lpop cover and front cover had some deeper scoring then before. No noticeable stuff in the pan or filter. Changed out the front cover and lpop. Still has only about 5 psi.
View 3 RepliesOn a 2000 F-350 with 5.4 engine, where does the vacuum line enter the cab? I got a truck in with no vacuum signal to the heat controls, and it has a slight miss at idle. Both of these are signs of a vacuum leak, but i can not find the line going into the cab.
View 5 RepliesI have a '15 Ford F-350 w/ 6.7 - 34k miles. Most of my driving is towing a 30'RV trailer. Today, without any trailer, I was on a local interstate and at around 65 mph on a bumpy stretch of highway the death wobble started. Had it come and go 3 times in a few miles requiring me to slow to about 45 or so to stop it. Never had any such happening prior.
View 14 RepliesI'm getting a nasty wobble from about 45mph - 60mph. I'm guessing it's time to start replacing front end components. So far, the only thing I've ever replaced in the front end are the sway bar bushings. I have a new steering gear / box to install; I plan to replace wheel bearings, ball joints and tie rod ends. Is there anything else I should replace while I'm in there?
1999 F350 4x4 7.3L auto trans, 150,000 miles....
I recently bought some used rockstar 1s off a buddy, installed new tires, balanced, put tapered lug nuts on and I'm still getting a slight vibration above 40mph. Do I need hub centric rings? XD says no, I think I do.
View 2 RepliesMy truck has developed a wobble in the steering wheel. I don't mean when you are driving down the road, but the steering wheel wobbles around. It wobbles in any position that the Till shaft is set to. How to repair.
View 10 RepliesIve had this 2009 F250 4x4 Super Crew, 6.4 for 2 years now. Bought it the way it sits with a 6" ProComp lift and 37" Yokohama Open Countrys. Recently, once I get up to 40-45 mph, the rear end starts vibrating violently until I speed up or slow down. There isn't any clanking noise and it's silent. I look in the mirrors to see if it's the tires but they appear to be rotating smoothly. It's never done this before. It's like a tire is out of balance but it shakes much harder than that should be at that speed. It rides smooth as can be at any other speed all the way up to 80 mph which is the faster than i drive. What this could be? I've done searches but can only find info on the front end death wobble which is not the case here.
View 4 RepliesI have an 09 F350 (116,000 miles) that I have only owned for about 3 months. I got it pretty cheap but it did have a front end issue. Drives fine most of the time but hit a bump just wrong at highway speed and it goes into a shake and wobble that feels like you just blew a front tire. Took it into my shop, not the dealer and was told I pretty much need a front end rebuild. Kinda what I figured I would hear.
View 4 RepliesGot the death wobble, had everything replaced. Wobble was worse, upgraded track bar. Then no wobble but bad bump steer. Put on new OEM track bar.
Ok but still if I hit a hole on the interstate I get death wobble and little mini wobbles on any bump. What is the permanent fix for this other than selling the truck?
2011 6.7L FWD Lariat, upgraded exhaust and Def removed.
Brake issues on 2005 F250. About 3 years ago during vehicle inspection the garage stated I need all for rotors on my F250. I had @40,000 miles at the time. Garage said rotors are a onetime use, no recutting them. So I got all new rotors. Prior to then I never even felt a wobble indicating they were warped. Anyhow now with 15,000 miles on them I have a huge wobble when I get on the brakes and it's 5x pronounced when pulling a trailer. I assume more warped rotors. If so, why? I pull a camper or car trailer maybe 7-10 times a year.
Now currently I am assuming its warped rotors because I have not had it "professionally" checked. I did have one occasion last August pulling the camper where I smelled the brakes being hot. The pedal got soft. After cooling it seemed ok and I flushed the old fluid and put in new. I have about 4100 miles since then and the warped feel just started about a month ago. I hate the thought of new rotors as I paid for new Ford rotors 3 years ago. Didn't want the Chinese crap from the box stores. I can't imagine how these would warp this bad after less than 15,000 miles, they are massive. Why they would so quickly?