Ford Transmission :: 4R55E - Truck Starting In Third / Downshifts During Deceleration
Apr 24, 2012
I bought a 95 Explorer with a known bad transmission, rebuilt it (broken band and chipped intermediate apply piston), put it back in, and now it's acting odd.
It wants to start in third. I can manually start it in second (first rarely works), shift it to drive at about 30, and it's fine. It shifts into OD, locks the TC, and when given a bit of gas kicks down to second. It downshifts during deceleration, but once I come to a complete stop, it'll try to start in third again. The only transmission code it's giving is for incorrect first gear ratio, there is an off and on engine code for the EGR pressure sensor as well.
View 5 Replies
Advertisement
If I understand correctly my 2004 Expedition has the 4R75E transmission. We are experiencing a clunk upon acceleration when the truck downshifts from 4th to 2nd. I had the fluid & filter changed, flushed the transmission with cleaner. It still does it but not all the time. I turned OD off and I didn't notice the problem when shifting from 3 to 2.
View 1 Replies
2013 CCLB, 33,500 miles, stock emissions
While towing a 9000 pound trailer at interstate speeds (75 to 80 in Wyoming), when pulling a hill, the truck downshifts to 4th gear, boost is about 18psi, eng and transmission temps in the 230F range, EGTs around 500C or 935F. RPM increases normally to 3000 then the turbo gets very loud and boost drops to about 10psi. The truck shifts to 5th gear, noise decreases but is still present, shifts to 6th and noise goes to normal after a couple seconds and boost builds normally.
This just started today. I have about 8000 miles towing this trailer and never had this before. I have about 350 miles until I'm home so I'm headed back out. Will play around with manual mode and see what it does. I also took a video of the gauges while this happens. Audio is difficult to discern. I will try to get better audio and post when I get home.
View 5 Replies
2001 expedition, 198,000 miles. Got p0781 code ,1-2 shift error. replaced the accumulator valve with a factory tech valve body. Pan was clean, some gray material on the magnet but not bad. 1-2 worked fine after vacuum swap, but when trying to shift from 2nd to 3rd gear, the transmission downshifts hard all the way to a stop, like the brakes are on.
I can manually drive in 1st and and 2nd but when I put it in drive it will downshift/brake instead of shifting from 2nd to 3rd. pulled the main valve body and 2-3 and 3-4 shift valves seem good, no sticking. 3 other valves were sticking. i think they are the Solenoid regulator valve , and coast clutch shift valve, and low/rev modulator. Could they be causing the hard downshift/braking?
View 8 Replies
I was on highway doing 75 with cruise on. All of sudden the truck downshifts and continued to do this while on highway but not surface streets. Is it tran auto relay switch or solenoid (I have no leaking). 1996 s10 4.3l v6...
View 2 Replies
I have a 1994 4x2 shortbed standard cab Ranger XLT. It has the 4.0 OHV engine, A4LD Automatic transmission, and 195,000 miles.
Under average driving conditions, it operates fine. It shifts up through the gears much like it always has, although the shifts may not be quite as firm as they used to be.
If I'm at cruising speed and step harder on the accelerator, it downshifts, RPMs increase, and it upshifts rather poorly, & then I feel a thump, (maybe the torque converter locking up when it shouldn't be?), and I'm in the higher gear. This seems to happen when it upshifts from 3rd to 4th gears for sure, maybe from 2nd to 3rd, but I'm not sure. Again, it only seems to happen when I attempt to speed up from cruising speed, not from a stand-still.
The transmission fluid and filter have been changed at regular intervals, and the truck has never been abused. The fluid is red in color, doesn't smell burnt, and the level is correct. I don't want to get rid of this truck if I can avoid it. It has been super-reliable and mostly trouble-free for the 16 years I've owned it.
View 1 Replies
I had some vibration occurring during deceleration and though it was either the slip joint or the rear u-joint because I could sense some movement back there.
After I replaced the u-joints and properly serviced the slip joint I still had the issue (although it was a little better). I now see that there is a little bit of play in the pinion shaft. I can't really shake it back and forth, but if I hit it hard upward it clearly has play.
What should I do next? I have read a bunch, but would like to get an expert to chime in.
View 1 Replies
Having downshift problems? The dealer has "flashed" the software 3 times and the hesitation still occurs.
View 11 Replies
I am getting to the point with this car that I can't stand driving it This thing where the transmission downshifts as I slow down and come to a red light is the most obnoxious feeling I've ever experienced in a car. What's worse, is when I go to speed up again and it's in the middle of one of its downshifts and hick up so bad it feels like it's can fall out of the bottom of the car. I'm done trying to deal with Toyota dealerships, all they do is tell me that Toyotas don't have transmission problems and that my car is fine unless it kicks on a light.
I feel like if this transmission was reprogrammed to act more like a normal transmission Like the electronically controlled transmission that was in the 1995 Alexis that I sold a few months ago, or my wife's 2006 solara or the 2008 I asked to 50 I used to have, the car would be fine. But this thing is neurotic, jerky, and unpredictable.
View 10 Replies
We have a 2007 Limited that we love everything about except the way the transmission downshifts to first gear when it seems to me it should stay in second. My inlaws have a 2007 XLS and it doesn't do this. This is our third Avalon and the only one to do this. The dealer we bought from says this is normal but I strongly disagree. Is there a service bulletin on this or what else can be done.
View 2 Replies
I've noticed lately in auto mode (not in sport mode) when I'm going downhill on a section (doing maybe 45-50 mph) of road and apply the brakes, the transmission wants to downshift automatically to 5th gear. I know in Sport mode if you are not using paddle shifters this seems normal. I don't think this is normal in just auto mode, non sport.
I don't think mine is normal as I don't remember it downshifting this much in auto mode. I'm thinking fluid level needs to be checked. I know there is a sensor in the transmission that senses the angle of the car so not sure if it's being overly aggressive or not.
View 12 Replies
My 2011 toyota tacoma auto transmission downshifts on any slight decline, even to the point of losing traction in the rear end if I am on slippery pavement. How can I disable the electronic engine brake?
View 5 Replies
I bought a 2003 Jetta with a 5 speed automatic transmission (09A tiptronic) but it upshifts and downshifts really bad, it doesn't matter if it's cold or warm. After reading a lot of posts in here I thought that what was wrong with the car was the valve body on it, so I bough a re-manufactured valve body and replaced the old one. When it was in the shop I was told the wiring harness was burnt/fried so they replaced the harness too. I got the car back and it still does the exact same thing, so I don't know if the transmission is bad or maybe it can be a bad TCM. What could be wrong with it?
View 3 Replies
My 2004 VW jetta has 139k on it. Whenever I come to a hard-ish stop or almost-stop, the transmission downshifts to 1st and won't get out of it unless i play with the tiptronic mode selector and coax it to upshift. it shifts well and works well in gingerly driving other than in this circumstance. i took it to a shop and they say (as they always do) it needs a new tranny. I'm wondering out loud if there is some kind of mounting instability issue that could explain this. This is definitely a case of needing a new transmission. I have read a bunch about solenoids being the culprit in general shifting problems, but not this exact set of symptoms and circumstances.
View 1 Replies
2012 2.5 SE Auto 53,000 miles ... A few days ago I started getting very hard downshifts and long upshifts. The downshifts were hard enough that the person at the dealer didn't make it out of the parking lot on the test drive. Most noticeable from 3-2 and 2-1. 1-2 is hard and 2-3, 3-4 and 4-5 take a few seconds to happen. No lights or limp mode.
In recent months I was getting a thump about a second or two after coming to a stop. Enough of a thump that the car would move forward if I didn't have my foot firmly on the brake. They flashed something(the ECU?) claiming there was a TSB for my complaint but it didn't seem to make a difference. I bought the car with 40,000 and the trans never felt right to me. I had them change the fluid just before 50,000 so they couldn't deny a claimed based on failure to maintain.
View 4 Replies
I've noticed that when I'm coasting to a stop and my speed gets to about 27 MPH, the transmission downshifts (RPMs increase) until I reach about 22 MPH. I'm not applying the brakes at the time.
It's a bit annoying as it sometimes bleeds off just enough speed that I need to accelerate to reach the point I was planning to stop at. Is this normal?
View 6 Replies
Car is a 2001 Accent 1.6L 4 door automatic with about 130,000 miles on it.
Transmission shifts correctly into reverse, drive, neutral as well as manually shifting into 2nd and 1st. When in drive I will accelerate perfectly through 1st gear, shifts smoothly into 2nd gear then the problem arises. The car will shift ok into 3rd, but if I let off the gas to coast to a light or a corner, etc, the transmission physically downshifts or locks up in 3rd (like driving a stick, ie the car has drag like the converter is locked instead of freely coasting). It feels like 3rd gear but could be 2nd. When I go to accelerate again without coming to a stop the car has this same feeling of drag with no power and speeds up very slowly (almost like i am pulling something behind the car or am in a gear that is too high). If I give it enough gas to force a downshift it really slams that downshift. While the car accelerates through the rpm range after this downshift it will rev past the normal up-shift rpm until it finally slams into the higher gear. Or if i hold the gas steady at the higher rpm the car will suddenly slam into the higher gear. after all of this nonsense the car drives perfect through to OD. The problem is much worse going uphill and is consistent every time it is driven.
Also, sometimes the car would shake and vibrate when hitting the gas during this "drag feeling" until i let go and did it again. This is pretty random compared to the main problem but also seems to happen while the car is in 2nd or 3rd. This has been happening for about 5 months now and as far as i know was sudden. And on another note it suddenly was shifting fine the other day while driving it. I haven't driven it since then but this completely stumped me, as most problems will do when they magically disappear.
There is no check engine light, OD works fine and the car does not go into the safety mode where it will shift to 3rd gear on the highway. It's city driving that is the real headache (2nd and 3rd gear difficulties). Would the pulse generators cause this? bad TCM? i haven't scanned anything yet but will be within the next few days(at pep boys or similar) as well as ohming out pga and pgb. i have found resistance readings for pgb but nothing for pga, what should pga read? fluid is also within acceptable amount and color.
My initial thoughts were dirty or stuck solenoids/valves in the valve body and i was going to do a filter and fluid change with a quick valve body cleaning and check. But after researching on here I am starting to think it may be electrical. The only reason I put my scenario up is because it seems that everybody else who is having a similar problem is also having the "no reverse" or "shifting into 3rd on the highway" problems while i am not. On a random note, for my own piece of mind, how do the pulse generators work? Are they just reading ticks on a gear cog in the tranny or something? fluid flow?
View 1 Replies
I have a 2006 Chryler Town & Country with the 3.8L engine. The car has 170K miles on it and I change the fluids/filters as recommended. I have never changed the plugs and wires though, or the fuel filter. The car starts and idles normally, and no issues driving in-town or on the highway.
Recently I have noticed a loss of power when I give it more gas and the transmission downshifts. The engine revs up but the power doesn't really increase and it makes a low growling kind of sound. The engine also starts to hesitate at around 3000 RPM if I rev it in neutral. I am thinking it could be the plugs/wires, fuel filter or air filter (even though the air filter is less was installed at 163K miles.
View 4 Replies
My beloved Treg is marooned at the dealer again, having been towed there this morning. Transmission is all over the place...shifts into 5th and stays there, or extremely jerky shifts - especially downshifts. Gear position indicator is highlighted in red and no longer indicates which gear I'm in. Check engine light is on; no message in MFI...
Incidentally, it appears that the dealer and/or VWOA is starting to understand how to treat luxury vehicle buyers. Roadside assistance was very responsive and courteous. Dealer set me up with a rental from Budget...made a point to have me pick something similar to the Treg (not a POS econobox). I'm driving a Ford Exploder...a far cry from the Treg, but at least it's an SUV and has similar seating and hauling capacity.
View 15 Replies
I have a 2005 Sante Fe 2.7 4WD with 168K miles. Last week I'm driving at 45 mph with cruise control on and it just downshifted to 3rd and then back to 4th in about 3 seconds.
It did this on the highway at 55 as well. I used the manual shift option and it works perfectly. It still shifts smoothly in auto mode but around every 5 minutes or so it will downshift and back again.
Here's what I know.
1. Using automatic mode in Drive it shifts smoothly from a stop to speed but then downshifts and back occasionally. It does this with Cruise Control on and off.
2. Using the manual mode and shifting on my own works perfectly. Even when the cruise control is on it doesn't skip or downshift.
What it could be?
View 3 Replies
2002 Hyundai Accent with automatic transmission. This problem happens only if I floor the gas gas on the highway (trying to pass somebody or get out of the way in a hurry) or if I apply too much gas after coasting around a sharp turn. My car will then downshift with a jerk and an audible THUNK!. Right now I just avoid those situations and it shifts through all its gears fine, it only happens when I cause a sudden downshift. Transmission fluid level and color fine.
View 1 Replies
