When I'm driving and the clutch is slipping a bit ( i.e. starting from a stop) I feel very noticeable vibration. Is that a sign the clutch is starting to do? I feel like a year ago it was smoother action, and I barely had to give it gas to get started ( could start with clutch action mostly).
View 9 RepliesYesterday I was driving my car on the highway, and stepped on it in, and the rpm's fluttered, felt like something was slipping. What this could be?? Could this be my clutch slipping?
View 7 RepliesSo after replacing my shift forks in my 20th, installing a new clutchmasters fx100 clutch kit with a LWFW I've become a victim of the typical clutch disengagement issue.
In a nut shell car doesn't go into gear while the car is running. System is fully bled with no leaks and a brand new slave installed supplied by CM.
My understanding is the early FML code o2ms in the 20ths can not make use of the NLS shim kit and a stainless line is not a 100% fix.
Who's solved their disengagement issues and how?
My clutch has been feeling very strange lately, and has had a mind of its own. I have looked underneath myself, and have even taken it in to two transmission speacialists and they can't figure it out. The master cylinder isn't leaking, and the slave cylinder is fine as well.
Here's what is going on with my clutch...
- I will push in the pedal, and there will be ZERO resistance until about 1 inch from hitting the floor, then all the pressure is there, and I am able to shift. However, sometimes I won't even be able to put it into gear because the clutch won't engage.
- Then I will pump the pedal, and slowly I will gain a little more room on the draw of the clutch, and it will feel fine. All the way to the point where a few days later it will be driving like new.
- Then it will start feeling funky again a few days later and the cycle starts over.
I drive a 2003 GTI 20th AE.
I have a 2003 20th anniversary edition GTI. Yesterday I noticed my car started shaking when I was driving on the highway. The only thing I can think of that I did was run into a snow bank during the snowstorm. What is causing my car to shake?
View 2 RepliesI have an 03 20th ani gti golf... It has been stuttering when idling and driving... Almost sounds like a subaru... I have changed the plugs/coilpacks but still does the same thing... My check engine light comes on and blinks.. Got the codes ran and it came up... Cylinder 2 misfire and catalytic convertor threshold....
View 7 RepliesI have an automatic gti/337 , on friday my transmission started slipping , while I would be driving on D the rpm would rev like crazy as if it was on N, I had to decelerate then accelerate in order for it to work. anyways i changed the transmission fluid and still having the same problem.
Ill be taking it to a mechanic tomorrow, but what to expect tomorrow? Its a 2002 two doors gti/337 ...
I just got my 2003 passat 1.8T 5 speed. i noticed that every time i come up to 1500 to 3000 rmp in 3rd gear the clutch or what ever that is hesitates to spin. I am wondering what could it be? and the other day when i was driving in the freeway i noticed that when ever i get to 78-80mph i feel or the car starts to vibrate. does my car needs alignment?
View 1 RepliesI recently got the GTI 1.8L 337 with 64,000 on it. It had been sitting, with daily start-ups, for about 8 months until the ALT was replaced. I've been driving it for a month with no problems until last week. At first I noticed the clutch pedal would pause on the way up for a split second then tap the bottom of my shoe. I thought maybe it needed adjustment but nothing serious. A few days ago the pedal would stick at 3/4 of the way up, and stay there most of the time unless I raised it with my foot, till the car warmed up a bit. Yesterday and today the pedal started to stick 1/4 of the way up, unless raised with my foot, at the morning start-up and will only come up 3/4 when warm. It also wont go into reverse at initial start-up until it gets really warmed up, shifting into other gears is fine. I've had no problems or real sounds shifting into any other gears, though out of 1st has been a little jumpy.
View 3 RepliesToday I went to start my car and let it warm up and everything worked fine and it started regularly but when I went to go drive the car and put the clutch in the pedal didn't return and I could not put it into gear, need to identify the problem.
View 4 RepliesMy wife was driving home and was exiting the freeway, downshifted and then no response from the clutch or gearbox. It would move left to right but not go into any gear with the car on. No real pressure in the clutch pedal either. With the car off you are able to find all the gears but when you start the car in gear with the clutch down it just jumps forward and dies. No smoke or burning smells either way and the pedal does come up by itself. Pushed the car into the driveway and its goin to the shop tomorrow morning.
With the search button so far: master/ slave cylinder, full clutch problem, air in brake/clutch lines, shifter linkage bracket
I don't think it's the slave cylinder as the pedal is NOT stuck to the floor, but I am not handy with cars, only motorcycles. First thing I checked was the linkage bracket, which seemed to be fine and as I stated, I was able to get in gear while car was off. Brake fluid was almost full but i know that doesnt rule out air in the lines.
We were headed home the clutch pedal went soft... Ok, I thought it's either the clutch master or slave. I get it home and replace the master and after bleeding I had good pedal feel.
Great I thought, I got lucky and it was only the master. Drive it around for a bit and get on the highway and just as I was about to downshift the pedal went flat to the floor again.
Well after pumping the pedal until it had good feel again I got it home and bleed it a couple more times just to make sure I got all the air out. Drove it again. Same thing, after a little while the pedal gets soft again.
Now before I go and replace the slave is it possible I have a faulty master? Having issues after replacing the master?
So I am pretty sure its my clutch that is the problem, here's what happens: When I go into second gear, it doesn't really grind.. but its tough to get it into gear and its only with second gear. sometimes it will go right in and others i have to double clutch. when i double clutch it goes in smooth every time. now I don't think it would be syncros because I am pretty sure if it was that it would do it every time I shift? It only does it while its cold or hasn't been drove in awhile.. but after i drive it around its fine so I am pretty sure its the clutch. Second thing, what is an upgraded clutch that is good for these 6 speed transmissions?
View 2 RepliesNoticed recently that my clutch is starting to slip. It only seems to happen when I'm cruising in 6th and floor it. When the boost spikes, the revs will shoot up ~750 rpm and then settle back down before the car starts to pull. It is chipped Unitronic Stage 2 with some other bolt-ons.
What I'm wondering is, should I just drive it like this until it really starts to go, or should I replace it now? And what are my options for a new clutch? I don't want to big turbo this car, so the most it could get is a few more bolt-ons. I'd like a stock feeling clutch.
I just put a stage 1 clutch in my 20th anniversary. When i was taking the transmission out, i dropped the hydraulic clutch line and all of the fluid spilled out. I got the whole thing done, and bled the clutch line and topped off the reservoir. I started the car and the clutch pedal had, what felt like the right amount of pressure. More than the stock, but not significantly. When i went to put it in gear, its like there is no clutch, just grinding and it doesn't go in to anywhere. I can cycle through the gears with the car off and like i said, the clutch has the right pressure and everything.
View 10 RepliesNoticed the other day my clutch pedal trim is coming off... What did you do to fix it?
View 8 RepliesI just bought a 2005 GLI and when i test drove it the Clutch was extremely light when I shifted, I have never drove a gli before. Now after researching and further driving i think the clutch is going out. am i right? if so, should i bother putting in a new stock clutch kit or should i go stage one etc...
View 3 RepliesI recently was driving home from a buddy's house, when at the light i go to put the car in 1st gear and it was way harder than normal. I kept driving just to try and get home but it was so bad that i never went past 3rd gear.. I'm pretty sure the clutch went out, since it was extremely hard to get the clutch to engage to get it from gear to gear, and i basically have to turn the car off to get it to stop so.....
I'm pretty new too the vw game, and don't know of any good companies as far as clutch kits. Im looking to buy somethings either oem like or a little better but with the same feel. also, just a Pressure plate and clutch. I doubt the flywheel is damaged.
I keep finding air every time i bleed my clutch. I am not losing fluid but i can not figure out whats causing my problems. The pedal is soft at first and then gets harder and it sometimes needs pumped before i change gears or to even get into gear. I am afraid its the slave but i also just may have air in the system.
View 8 RepliesI just replaced my clutch and have put everything back together, and bled my clutch line, but I have absolutely no pressure still in my pedal. I read that u need to make sure your brake fluid reservoir is filled to the max, but following the clutch line, I dont see it going to the reservoir? I also read that the master cylinder is behind the clutch pedal, does the master cylinder hold any fluid that maybe I lost during the bleeding? I'm at a loss right now.
View 12 RepliesJust got in my car and the clutch went to the floor and stayed there when I stepped on it. What are the steps to diagnose this problem? I'm assuming my slave cylinder went kaput!
View 11 Replies