I am a newbie Golf owner and have little trouble. I am not sure where is the map sensor located in my 1.8 tsi engine. I've been googling and have not found pic or technical drawing to be 100% proof which one is it.
View 2 RepliesWhere the Coolant Temperature Sensor is located in the R32? Need to replace it. I searched but luck so far.
View 23 RepliesI dont see anything attached to the manifold....
View 10 Repliesi need to know what locations are these sensors at bank 1 sensor 1 and bank 2 sensor 1 what i`m asking is it at the front of the engine or the rear its a 2.7 liter engine.
View 1 RepliesWhere the ambient temp sensor is located on my 02 Golf 2.0.
View 5 RepliesIs the TPMS system in our cars capable of learning or being programmed to know which tire sensor is where? I know with my Vag-com I can separately see each sensor that is talking to the module.
Do we have the ability to do anything so the MFD is able to tell you which tire is low?
I have an 04 gx with a check engine light on I had the code read at auto zone. That tells me o2 sensor bank 2 sensor 1. I have already changed the sensor they said it was and still have the code. What is the correct location of this sensor?
View 2 RepliesI took the car out for a little spin about 8 miles. We where about .5 of a mile from the house and there is a section where you have to stop on a little bit of a hill. I stalled the car due to the new Dm clutch then headed to the house and the car started to run like crap. I hooked up VAGCOM and had this code:
17748.P1340 camshaft position sensor-G40/ Engine speed sensor-G28: incorrect allocation(#1)
I swapped out the 2 cam position sensors and cleared the code and started the car and it still ran like crap. I just happen to have a new Cam position sensor(hall sensor) so I swapped it out in both cam positions one at a time and cleared the code and the car still runs like crap.
Is there a way to check(test) with vagcom to see if its one of the engine speed sensors?
I recently picked up a 2000 jetta vr6 for a very good price its a glx I have owned a vr6 before and done timing chains myself on it this one is a glx , I am having 5 fault engine codes on my vagcom they are cam position sensor , knock sensor, secondary injection pump, and mass air flow it ran fine 100 miles yesterday this morning the epc came on then went off and ran bad can these codes all be related or do I have to replace each sensor individually..
View 9 RepliesI need figuring out the speed sensor on my 96 ,k1500 series,5.7,4*4,automatic.. Where is it located...
View 1 RepliesAre these easily accessible? I have to replace both sensors in my 04 4.2 and was curious if they are easy to replace. I could not find and detailed info. Also any tips when replacing these and purchasing 2 sensors?
View 3 RepliesWhere is the MAP sensor located on a 1997 toyota tacoma.
View 2 RepliesI have a 2007 Camry Hybrid with ~150k miles, 4-cyl engine and last week the water temp gauge starting fluctuating erratically...going from extremely hot to cold and vice versa. It eventually tripped the check engine light and autozone said it was p0117 - Engine Coolant Temperature (ECT) Circuit Low Input. At one point the engine was really shaking the whole car. I haven't driven the car as a result.
I have ordered a new ECT sensor and it should arrive this week. the problem is I can't find where the sensor is located... I have looked all over this forum, google, the internet, nothing. I have looked in a Chilton's manual but it doesn't have a diagram.
Where is the ambiant outside air temp sensor located on the Phaeton? I know it is located under the outside left or right mirror (based on model year) on a Volvo but not sure where it is on the Phaeton. No problems, just curious.
View 6 RepliesWhere it is?? Body shop didn't connect it after repairing my bumper and I would rather not have to take it off again..
View 3 RepliesLooking for the location of the coolant sensor.
I'm pretty sure I have a faulting coolant sensor. Light comes on with a message in the MFI indicating coolant is low, but when I check, its at the maximum line on the overflow reservoir. So I assume the sensor is not accurate/faulting.
Spoke to my service advisor who said the sensor is attached to the reservoir and you buy it all as one item, sensor and reservoir combined.
I've also seen threads that indicate it's a stand alone sensor toward the back of the engine compartment.
Need to confirm either of these as being accurate locations for the sensor? Is there more than one?
Trying to replace the post cat O2 but not sure if I have the right location. Looking for a diagram?
View 9 RepliesWhere is the cam sensor on a 2000 chevy metro 4 cyl. ?
View 1 RepliesDon't know the location of the MAP sensor for a 2008 Elantra 4-dr (HD)? I'm reading a DTC P1100, which indicates a manifold absolute pressure (MAP) sensor malfunction. The Haynes manual refers to this only being necessary for the previous model Elantra.
View 3 RepliesI need to change the knock sensor of 2011 Accent, don't know where it is.
View 7 RepliesI am trying to replace the coolant temperature sensor for the electric fan on a 2007 Hyundai Santa Fe with a 3.3 engine but can't find it on the engine.
View 2 Replies