Symptoms:
- Longer cranking time when turning on the ignition.
- Codes P2293 - Fuel Pump Regulator 2 Performance, P0087 and P053F.
- When I get on it, the rpm would shoot up while the speed is increasing at a very slow rate.
At first, I thought it's my clutch slipping, but after watching this youtube video (not mine), I think it's the fuel pump issue.
I have a 2002 F350 7.3 with 76,000 miles (still a baby) ... about a week or 2 ago i got in my truck and went to start it like normal, except instead of whipping over and firing right up in the snap of a finger, it kinda had a slower cranking time and took a second or 2 longer than normal. My first thought was maybe the battery's, BUT there basically brand new !!! not even a year old !!! ... so i figured maybe a starter, but i just left it as is, it still ran normal after firing.... Until this morning, I went to go start it and it cranked over 3 or 4 times real slow and would crank any more, it did this to me multiple times. Its acting like dead batteries so i put a jump pack on it, no change. I am thinking maybe a starter ....
View 8 RepliesI need to locate a 12volt circuit which is switched on with key in the run position, but isn't cut off while cranking. The on/off/on that I have going to my gauges now messes up their auto zero function. I have to turn the key to run, back off, and then start for them to read correctly. I have poked around in the fuse box on the driver side of the dash, but every position looks to be either on all of the time or cuts off when cranking the engine.
View 5 RepliesI noticed that it seems as though my Mk7 takes longer to reach operating temp than my mk6 TDI did. My commute to work is plenty of time to warm up (25mi) but I feel like this car is slower to warm up (but faster to get cabin heat d/t the electric heater). I just find it strange as here in MA it hasn't even been that cold yet, so I'm wondering how the car will be wen the temps dip well below freezing.
View 7 RepliesWent out to start my car today it had a rough time cranking over and when It started had a cel and in limp mode.
View 8 RepliesMy Jetta makes a clicking/clanking noise when I turn my steering wheel from standstill. I was told it was my CV joints. So I replaced them and its still making the noise. I was told then it was my struts/shocks. Is this true? The sound is coming from the front driver side wheel. Also, when looking at this tire. I noticed that while this one does have some wear it is even throughout the tire. However, this tire has more wear than the others. The others look brand new.
View 5 RepliesSo when turning my steering wheel i get this croaking noise. At stand still and while driving. Its annoying the heck out of me. You can hear it in the car and outside. What it could be? Power steering fluid level is normal.
View 11 RepliesI've only had the car a month, and it's happened maybe three times now. I turn the key, and it takes twice as long as usual to start, about 5 full seconds of the engine cranking before it ignites. I think each time was after I had driven the car an hour or two before (when I'm heading home after an outing). Most of the time, the car starts fine. What's going on?
View 11 RepliesWhat updates were done to the 3.6 engine for 2008? So far in 100 or so miles I've noticed that the 2008 3.6 is:
Much easier to start. (06/07 requires cranking much longer to start)
idles smoother (06/07 shook a little when sitting at idle)
accelerates smoother
then the 2007.5 3.6 I had, and the 2006 3.6 in my friends Passat.
Both of those did have the OJ update done. The only visual difference is the plastic engine cover. On the 06 and 07 it has a silver colored cover. the 08 has a black cover that is different in shape.
So my 1.6 accent (140,000) decided to no longer start. Just keeps cranking but doesn't ignite. Plugged a scanner in and it's the crankshaft position sensor. How difficult is this to get to? From what I've ready its just held on one end by a 10mm bolt and the older end is just a connector, but it looks like it might be in a pain in the ass location. Does anything need to be taken off first to access? Should this take less than 30 min?
View 1 RepliesOn my 09 accent, it's been cranking slow/taking longer to start. Occasionally it won't even have the guts to spin the starter (clicking solenoid noise).
I checked the battery (<1 year old), and it has a resting voltage of 16.2 (?!) When running, it jumps to 17.4. Is this a bad alternator?
i started hearing this weird creaking noise about a month ago. When it started happening it would only occur at very low speeds and then it would stop, now it happens all the time unless i'm turning. I've heard it could be bushings but I'm not sure. What weirds me out is a lot of the time it'll stop either when I'm turning or if I shift into neutral.
[URL]
About 7 months ago my truck started cranking longer than normal to start after sitting for more than 2 hours. This went on for about 3 weeks, then it started normally again. (By longer crank time, i timed it between 5-7 seconds on average. Normal is about 2 seconds). Now it has started doing this again about 4 weeks ago. Now I'm thinking HPO slow leak. Yesterday all is good again. What should I be looking for as a starting point to fix this permanently? When it cranks longer, the icp stays at 0, the ipr goes to 77%. Then it just fires off. No slow build of pressure. You can see all my mods and updated parts in my sig. I wonder if one of the new dummy plug o-rings is starting to give up already after only 15k miles. (Batt voltage is at 13.9-14.2, ficm is at 49.5 steady).
View 5 Replies2003 Santa afe 2.7 litre: So for some reason the key ignition cylinder light no longer works, but no issues with the ignition at all. What powers the light, is there a specific part of the cylinder I need to check or replace or do I have to replace the whole cylinder. Would a another cylinder I pick up from the junk yard work?
View 11 RepliesMy daughter drives a 2005 Passat station wagon, has a small child and one on the way. She has had intermittent problems with the car just not wanting to crank. After sitting 15-20 minutes it will crank. But the wait and not knowing if it will crank is taxing me and her. Especially since she has another one on the way. She has taken it to a reputable mechanic. They kept it for 3 days, cranking it on and off without a problem, and told her they couldn't find anything.
View 3 RepliesI just bought a 2001 Dodge Ram 1500 (Magnum Series); 5.9l, 2WD, 8cyl. After 2 months the transmission went out. I bought a used transmission and had a shop install it. When I picked it up (10-3-14) the mechanic pointed out the shifter is one notch off (ie. in R position its in Park, in N position its in Reverse, etc). In addition it no longer has D1 nor D2 (putting the shift in D-D2 position results in Drive only, no power gears). The mechanic said it was something in the steering column causing the shift display to be off and had no explanation to why there were no power gears.
To make matters worse, the ignition switch no longer reverts to the Off position; the key can be removed but the switch stays On, warning alarm for key being in ignition comes On etc. I admit the ignition switch was old and the switch would sometimes not turn over before the transmission was replaced. He blamed something in the column again. So,
Q1-Is the mechanic correct there is something wrong in the column and not a misalignment he caused when he installed the replacement transmission causing the shifter to be misaligned?
Q2-Why doesn't the truck have D1-D2 gears? Do some transmissions not have these or am I missing something?
Q3-Is the most likely problem to the ignition the ignition switch or solenoid? Or could he have damaged something during the transmission installation? (I ask the latter because he took a panel off under the steering column while installing the replacement transmission.)
I have 2002 camry V6, I did a battery replacement few months ago. It gave me hard time to start, cranking but will not ru,. I did clean the throttle body and was fine. I left the car for few days, came back will not start,you hear the starter but no cranking, a neighbor mechanic kept starting and did start. He said it needs tuning. The car has 104 k miles on it.
View 1 RepliesI am having this issue if it's one. With the fuel level below last quarter, I'm having the time of starting the engine longer (cranking time). I tried several times, leaving the fuel level reach the last quarter, with same result. Reaching that level of fuel the problem appears.
Another issue is that sometimes when the day is hot and the fuel level is not necessary below quarter, the starting time is longer too. It's a Santa Fe AWD 2.4L Automatic.
Today i went to the store and my toyota camry 2002 with 4 cylinder turn on fine. i came back home and car also turned on. after 3 hours, i decided to take a short trip but this time the car was not turning on. there is no cracking, radio and headlight dont turn on. i thought it could be the battery, i used a multimeter and see that i get a 12.6 volt but still no headlight or radio.
The battery is 3 1/2 years old but the fact i get a 12.6 v make me believe is not the battery. I get a little bit of light in the dashboard and when i try to turn on the car it looks like the dashboard light get dim as well as the indicator in the dashboard such as battery indicator, abs, oil etc.
The starter was changed 2 years ago. The car turn on normally before, no sign of long cranking or anything like that. So I think it is not starter either but not sure. when the starter went bad 2 years ago, there was no cracking but the car made a click sound when try to crank. Now there is no click sound and this is why i think it is not the starter.
Occasionally my 2003 f150 takes longer to start than Id like. Lets say 2-3 seconds before it fires. It turns over plenty fast so Its not a battery crapping out. Runs great once it lights. I replaced the spark plugs but that didn't change it. Once again this just happens every now and then. 120k on the clock. Should I suspect a fuel pump showing its age? Oh, I should also note I changed the fuel filter a few months back.
View 6 RepliesI've got a 1993 Ford Aerostar XLT. Was running great until yesterday, when I turned the ignition and got nothing but a click every time the key was turned. Checked the battery (had power), bridged the relay (just got clicks but didn't turn over)....so I concluded the starter was bad.
I installed a new starter motor/starter Selinoid today. The van started right up, but next start the engine kept cranking (even while van was running and after shutting off)...I had to disconnect the battery cable for it to stop. Next start the problem didn't persist...but the time after that it happened again.
Any thoughts as to what is going on, or where to start in tackling this problem?