just picked up this 99 Jetta with about 150,000 miles and while driving all of a sudden i had extreme power loss, shaking and shuddering, and the engine light came on. My code reader found multiple random misfires cylinder 1 and 4 codes P0300, P0301, and P0304.
View 7 RepliesIt all started a few months ago.... I started my car, and it started noticeably misfiring, CEL flashing and everything. I scanned it with my vagcom and it came up Cylinder 1 Misfire and Random Multiple misfire. I popped the hood, made sure everything was seated correctly, and shrugged.
Ordered some new wires for it, since it had 80k miles on it with original wires, I figured why not. The misfire didn't come back.
A few weeks later, same thing happened. Misfires, flashing CEL, same codes. I ended up driving it the 5 minutes to work anyways and figured I'd look at it later after I got off.
8 hours later I started it up again, ran like a champ, no CEL on. The problem didn't come up again for 3-4 weeks.
So now, without fail, every month or so, I'll get the same issue. It doesn't matter if it's raining or sunny or cold or warm. But if I let it sit for a few hours, it'll act like it never happened.
Now, I haven't replaced the coil pack yet, simply because it doesn't sound like a coil problem, but I might do it just for the hell of it. New plugs and wires have already been done.
So I picked up this 24v vr6 in florida and it has the folowing codes:
p2181 malfunction in cooling system
p0303 misfire in cylinder 3
p0305 misfire in cylinder 5
p0300 random multiple misfires detected
p1570 engine control module disabled
I am thinking the ecu is fried? otherwise why else would that last code pop up. misfire codes im assuming are related to the ecu because theres new COP on each cylinder, newer starter, newer alternator, new spark plugs. Cooling system malfunction im thinking could be the ECT sensor, apparently the water pump was replaced a little while back.
If the ecu is fried can I buy a new one chipped from like APR or do they need the existing ecu and then they modify it?
I have a mk4 1.8t Gti. Recently I have been having issues with idle and boost. I read the codes and multiple random misfires in all 4 cylinders came up, idle control and the crank, knock, and o2 sensor came up. Shows that system is running to lean as well. I changed the spark plugs and wires, check the coil packs they where done about 1k miles so I expect them to be perfectly fine. When I clear the codes it idles below 9-8k rpms. I also noticed the breather hose coming out of the valve cover into the EGT has a hole melted into it, could this cause any of my issues?
View 2 RepliesMy 99 v10 is having a random multiple misfire, it showed an 0300 a few weeks ago. since then i have replaced plugs, 2-cops/boots,dpfe,egr, did a vacuum check,fuel pressure at 28, and i'm sure i'm forgetting something. I drove down to napa today for some sea foam (15 miles) and it drove like new, when i started it up to come home it started missing again, it starts easily and i can press the gas and go, but i can still feel the misfire...
View 1 Replies97 Accord Lx - 215k miles - 4 cyl. - regular maintenance. It's been my daily driver for over 5 years and been running perfectly.
Yesterday I drove the 35 miles from work back to my town but before going home stopped to visit someone for about an hour. When I came out to leave I noticed a larger than normal amount of fluid in the drive. I just thought it was condensation from the AC and that it was more because it was extremely hot yesterday (100+).
When I got within 2 miles of the house the 1st thing was that the AC was not blowing as cold. I turned it off. Then the engine seemed to "pulse" with loss of power, and the temperature gauge was maxed out. As I pulled into the driveway the engine light and oil pressure light came on.
After it cooled down I checked and the coolant was a little low, so I topped it off. The oil was really low and I added three quarts to bring it to full.
This morning I started it up and let it idle while I finished getting ready (5-10 minutes) and the temp gauge was about 1/3rd of the way up (where it normally is). It sounded, felt, and drove as normal but after a mile or so the gauge was climbing extremely fast so I turned around and took it back home.
What it might be? Water pump?
I have spent alot of time looking through threads about v10's misfiring and have not been able to resolve my issue. I recently purchased a 2000 v10 f250 with about 220000 miles on it I bought it knowing it had one miss fire but now I have a total of three. Te truck has no problems accelerating but at a little over 40 mph the engine shakes quite noticeably and after 60 i5 seems to smooth out. After alot of reading I replaced all of my plugs and ignition coils, ran a can of sea foam through my gas tank and my intake with no change to the miss fires. I have started my trials with the fuel injectors by switching them from miss firing cylinders to ones that aren't. Some other information is my truck has no egr on my intake.
View 4 RepliesToday i come here for a AC/Compressor trouble: The AC on my Jetta 2000 2.0 works very well, however it seems that the engine loses a lot of power when the AC is on (the acceleration becomes very slow), and at the moment of turn on the compressor, the engine revolutions down to 400 rpm for a couple of seconds (after back to normality, 800rpm on idle).
I know that the power loss on engine is "normal" with the AC, but in mi case, seems excessive, and the fuel consumption, when the AC is on is vey high too. I think that maybe the compressor is stuck, but I'm not sure about that.
As additional information, i scanned the engine codes an throws P0422 (related to oxygen sensor)
I bought a 2000 jetta gls vr6 5-speed. Only had the car about 4 weeks, already I am in, ball joints, struts, brakes, core leaks and my half shaft fell off at the transmission. Now, driveabilty issue.
Severe loss of power, sputtering bad. when i shift, the car revs a bit. installed new O2 sensor due to a rich code and a out of range code. Now the EPC light is on with an implausible brake switch signal. Replaced switch still comes back on. Still running like poop. Changed the plugs also about 1k back. I just ordered a MAF.
I have a 04.5 GLI 1.8t, performance mods include, cone filter on the end of my maf, silicone TIP, Forge splitter, 3in custom tbe and unitronics stage 2
I started noticing this problem on the day I got the car tuned, I hadn't noticed it before hand. I replaced the spark plugs and it worked a little, but it continues to do it.
The problem: When I get on it at WOT under full boost, around 2500 rpms, the car loses all torque, misfires spits and sputters throughout the rpm range until about 5300 rpms then it all of a sudden has torque and pulls great.
I don't have any boost leaks that I know of along with vaccum leaks. There is no flashing cel or misfire code for my coil packs. Can this be a faulty n75 valve? if so what could fix it?
My car has been throwing a code P2178
P2187 System Too Lean at Idle (Bank 1) DTC.
Checked the intake, checked maf, checked injectors.
Today after leaving show n go. Stopped at a gas station (never turned off the car) leaving the gas station the car was loosing power, I thought I was in 3rd instead of first. No, I was in 1st. Driving and car was sputtering and wasn't getting any power. After a few blocks it sounded like its gonna shut off. Pulled over to the side. Car died, doesn't wanna start again. Got spark, got fuel to the injectors, discoed the sensor to maf, still cranks but doesn't start. Got it towed to NY from NJ. Still no start. Few people said crankshaft sensor, starter, clogged cat or fuel filter. Car isn't throwing any codes now (probably cuz the motor didn't start) any clues on what it can be?
Started my car (02 with a 2.0) this morning and as I pulled away the EPC light came on and the car lost power, almost stalling. I kept on going, and then the check engine light came on.
Got to a stop sign and it died on me. Battery light came on at this time as well. Started back up no problem but idled rough and kept dying. Just kept restarting and moving bit by bit until I could get home. EPC and check engine stayed on through all of this.
I also noticed that it would buck like crazy around 3000 rpm and not increase past that point. What could be going on here? I'm going to pull codes when I get home.
2005 prius. the car is pulling three codes misfire cyl1, misfire cyl2, and multiple misfires. The car has over 450000 miles on it and runs like a dream. I just replaced they spark plugs and the coil packs in each cylinder. The cel codes are still there after clearing them. I am willing to replace the fuel injectors but just seems weird that two of them would go out like that together.
View 4 RepliesI have a 2005 jetta 2.0 Once it gets under half a tank I lose power, it acts like it's running out of gas. It only does it in warmer weather (this started in march when we took it to Florida, once it got back in the cold weather it didn't do it again until 2 days ago when it was in the 70's). I took it to he mechanic I've used since I got the car (he works exclusively on vw and audis). It didn't do it to him in the two weeks he had it, he couldn't find anything wrong that would cause the issue.
He did do a complete tune up, replaced both of my fans and coolant. I ended up replacing the coolant temp sensor myself since that decided to go bad after I got it back. It lost power after getting the car back again warm weather and just under half a tank of gas. Prior to the Florida trip the water pump, timing belt and starter were replaced. I had my fuel pump replaced in 2014. It is an automatic with 157k miles on it.
I know the ignition coil are a big thing but I'm going to be buying this car this week and so I need to see how much less to offer the guy because of this issue. Is there anything other then the ignition coil that it could be? What's worst case scenario? And also would it be ok to drive it home about 60 or so miles with this going on? I'm guessing it's doing the misfires at idle.
View 6 RepliesThe past couple days when driving to school in the morning i've been noticing that my car starts to rattle and struggles to accelerate once I pull out of my driveway. Once i get to the next stop sign to take off the car runs fine like nothing ever happened. My check engine light doesn't come on though. I usually let the car sit for about 30 seconds to a minute before i start to move the car. Mods I have are Unitronic stage 2, Forge 007p DV with yellow spring, and 3" downpipe.
View 1 RepliesLast weekend, I was riding my Golf 2.0L when it started losing power, then a thick blueish white smoke started coming out from the engine all the way through the exhaust. Stopped the car on the side of the road and had it towed back home. I've looked for loss of any oil or coolant but the levels are ok. No mixed fluids from sight. I've had a check engine light for oxygen sensor for a year or so, but I've been told that would not be the problem. I started the car a few hours after it was towed home, it was now cool so the smoke wasn't as thick. The smoke doesn't smell like coolant fluid. I took out a spark plug and there was a bit of oil onto it too. My engine runs normally. People have been telling me to look for head gasket, valve cover gasket, engine head, etc. A week later, I still can't find what it could be.
View 1 RepliesWhen i got my 2000 jetta vr6 it has a CEL for misfires. Searched this board and google already. Im thinking injectors (havent checked yet) I noticed something weird the other day. At a light i get the CEL flashing. Then after a bit it will come on and stay on. I plugged in my generic reader and deleted the codes. When the CEL is on I get loss of power and hesitation. When its deleted the car runs better. I get my power back. I looked in the coolant tank and see no bubbles. Could this be the ECM? Im still going to get injectors but want to buy the gasket and anything else I am going to need to put it back together. I already cleaned the MAF, replaced some vac lines, coil pack, wires and checked plugs (gapped at .28) ...
View 4 RepliesI want to start by saying I'm new and don't really fully know how to search vortex, I'm sure there's probably a bunch of things about this. I have an 04.5 gli, my temp gauge reads 190 all of the time but according to vag com I'm running at about 220 some times higher. I've heard my fan kick in once in the year I've owned it. Also I get a decent amount of power loss after driving for about 20 to 30 minutes. Idk if that's related, but just hard wire the fan with a switch? I don't have a lot of money so I'm not really trying to play a guessing game replacing stuff.
View 6 RepliesWhere to begin, I've checked things i thought could be the issue but aren't. I am having a constant e-brake light on which as you know emits the loud and annoying beep sound. What I've checked and done:
I checked the brake fluid, its fully topped off. I also removed the ebrake switch (the thing under it that when depressed pushes the button and turns the light off) and just crossed the wires to complete the circuit (this does the same as the button essentially) before buying a new one to see if that was the issue, which is doesn't seem to be. I had my buddy run vagcom which turned up no codes that SHOULD make this issue occur. I even popped in a new brake light switch which didn't work.
At the same time of this happening my car is making ZERO boost at all. Is it a coincidence? I don't know... it's just weird they would both happen at the same exact time. Again, no codes are showing up. Checked lines and didn't see any potential boost leaks. What to do.
So I took a trip from Dallas to Florida, and on the way back my check engine light came on. The car shakes at idle, almost like it wants to take off. I drove it back to Dallas like that since the car runs normal on the high way. I got it scanned at autozone and the code said it had multiple random misfires. I'll be taking to the dealer in the morning, but what it could be? The car jumped over 50K during the trip hopefully the dealer will be nice and cover it.
View 4 Replies