Golf IV / Jetta IV :: 2000 - Sudden Boost Surge To Almost 20 Psi
Aug 25, 2014
I have a 2000 Jetta 1.8t. I am having a sudden boost surge problem. It seems no matter what gear I am in if I get on the gas when getting on the highway or whatever to just get up to speed in a reasonable amount of time, the boost just increases like crazy. I do have Gonzo Tune and know I should have a faster response but I have been in higher built mk4's and they don't do this.
I have done the following to try and fix problem and some cause it was just time to replace:
New MAF
New N75
Fixed Leaks
New Plugs
New coil packs
New Fuel Filter
I do have a boost gauge and when cruising my vac is steady. The sudden surge of boost goes to almost 20 psi. I have thought of replacing my wastegate actuator since I have heard that can be a problem?
View 1 Replies
Advertisement
Replaced my coil packs/sparks, and just got around to changing my N75 valve today. The rough idle issue is gone but now when I go WOT it boosts but goes from 15psi-12-13-12-14-12...etc. I've checked and there are no boost leaks. I do have a CEL saying I need a new bank 1 sensor 1 Oxygen sensor. If it is that, why did this problem arise as soon as I changed the N75 valve and wasn't present earlier?
View 1 Replies
2000 jetta 1.8t ... Yesterday driving home from work (1.5 hr drive and it was 25+ degrees) my car died on the highway just before I made it home. Just lost power all of a sudden with no warning signs before and no overheating. No lights came on I just felt sudden loss of power and pulled over and turned the ignition off and it wouldn't start again. Just makes a high pitched whining noise and won't crank over. I just found out the other day that both O2 sensors need replacing but I can't see that being the reason.
View 5 Replies
My boost gauge is bouncing around during the flutter at peak psi? I have a apr stg 2 evoms intake and full tbe exhaust 42dd...
Here is a exact video of the flutter i am talking about [URL] ....
View 13 Replies
I installed a brand new "A line" 007 last night. Now I have ridiculous boost surge (15psi then to 5psi, then holds 11 hard) I did a N75 race valve last year (ECS), so I have my doubts that it is the N75. So what gives? The car wasnt that bad with a blown stock DV compared to this. I have minor mods: CAI, exhaust, Forge TIP, APR stage 1.
View 24 Replies
So my buddy was driving my truck and boat through Amarillo and suddeny had a buck/surge accompanied with black smoke. I left my torque app with him. Its throwing codes: P2287,2285, and P????(fault log got erased and I'm going from memory) concerning #8 cyl. I got there today and we noticed coolant leak on left side. Its small and I cant tell the source, but it is wetting the exhaust manifold on left side. Also now its blowing white, black, grey smoke. At idle its more white/ grey. Under load it mixes a little blck in. I only had time to check the ICP on torque and at idle its bouncing from 0.9 to 1.1. Unplugged ICP ran about the same. Still started and idled fine with white smoke. No oil in ICP or connector.
So I'm no expert but I think ive got a bad icp and something else going on. I didn't pull the egr valve and look so no idea on the cooler ,yup syill have the cooler. Degas has a small amount of white residue directly under the cap but no puking. Degas is just below the max line (on the sticker).
One other note only code originally was the 2287 last night. Now this am there was the other codes ref'd above.
View 14 Replies
What is making this noise? car fired up fine this morning, drove it to work and once i exited the highway, idle started bouncing slightly and it seemed like the car was trying to compensate for something. every once in a while it will jump to 1000 rpm then try to settle but still the idle is choppy. and then there is this noise. Does not seem to the be the belts and to be honest I cant really pinpoint its location i think its loudest under the intake manifold. it sounds like a bad bearing to me but from where? O and I checked codes, nothing accept my regular emissions delete codes. I don't have immediate access to VAG-COM so that's out for the time being. also another detail, if i rev the car the noise does not seem to get any louder in fact it disappears mostly.
View 1 Replies
The past few days ive been having some boost problems. Boost will surge to 15psi then drop to 0psi and continues on acceleration. Coming from work today I was unable to get past 5psi accelerating
Then on WOT the boost would spike to 23psi then down to zero. Checked all hoses i could see and reach to make sure they were connected.
Mods:
Forge 007 DV
ECS Race N75 Valve
Turboback Exhaust
Chipped
Short Ram Intake
View 3 Replies
So I was driving down the road today and my car just shut off. No turning back at all. It is still trying to start. Battery is fine, terminals are fine, it acts like it wants to start but won't start. It's been running fine for a long time now. I think it may be the fuel pump. I'm going to take the fuel line out when I get home and see if it's getting fuel.
Door doesn't make the buzzing sound when you open the door. The car is also on air ride...
View 24 Replies
I've got a slight surge that's very noticeable cold and not so much after warmed, I can hear the turbo surging and feel a slight power increase on and off, checked with forscan the normal values, alls inline, I did not ck fuel pressure yet but will, I noticed vgt, boost fluctuates when this happens, icp ipr readings inline, this is a 04 with throttle plate inside the air elbow area, can this cause a surge and how to test this, I am not familiar with this setup as my 05 does not have it.
View 6 Replies
my car into VAG COM and since then it hasn't boosted past 4 lbs. it has Revo stg 2, K04, aftermarket side mount, full exhaust and a couple other bolt ons. Before the car was spiking at around 23/24 lbs. after pressure testing the system I found that the turbo inlet pipe was lose, so I tightened it. Still no change. I tried holding the battery terminals together for 10 minutes to reset the ecu and I also tried clearing the codes through a handheld code reader. No codes even come up anyways for this. The car is a 1.8T.
View 4 Replies
I am having a overheating issue with my 1.8t AWP gti, it goes as fallows, start the car, engine warms up go for a drive (short 5-8 mi), park the car and temp gauge starts to rise, (turns off car)... I began to check some things with the system, I checked both rad hoses bottom is hot top is a bit hotter and fans work when ac is on; here is where it gets interesting i took off the coolant return hose on the reservoir (cold start) and nothing was flowing ...water pump?... So i turned the heat on and air full blast and all of a sudden coolant starts to flow.
It also seems like air is being spat out as well. Soon after the flow beginning my coolant in the reservoir starts to fluctuate (rising and dropping) with air bubbles and beginnings to over flow so i shut the car off. Now I know what the possible issues are its either the water pump, air in the system or bad autozone thermostat. Here is some history of the car TB was replaced at 70,000 by Previous owner, i bought the car had the belt inspected and was told it was good, about 2 months ago i had a coolant leak and had it misdiagnosed as a thermostat housing leak; it turns out it was a coolant bypass hose that was leaking so i ended up fixing it. I lost a lot of coolant but topped it off with g12+. My mechanic doesn't think its the water pump and recommended changing the thermostat for an VW one another mechanic recommended to bleed air of the system.
View 7 Replies
So my 2001 1.8t Golf is having some issues holding boost. I have a Gonzo stage 2 tune, CTS FMIC, Forge 008 Diverter, Silicone inlet and MagnaFlow Exhaust. I've also done the whole Evap, SAI delete and installed a catch can.
Starting in 2nd or 3rd at WOT the car spikes up to 18psi and then progressively loses boost throughout the rev range. Close to redline the boost drops to 5 psi or so. It seems to be dependent on the revs. In fifth gear the car holds 18 psi much longer as the revs don't increase as fast.
There are no CELs. I've done multiple leak tests starting at the air box and plugging the pcv/catch can system as well as at the compressor side of the turbo. None of the tests revealed a leak anywhere in the intake system. However, when I stuck my ear very close to the valve cover I could hear what sounded like a very small air leak coming from inside the valve cover. I took a look at the wastegate actuator and it seemed fine, no play in the rod, no loose bolts and to move it just requires enough force to compress the spring and it returned to its original position.
My thoughts are that it could be a fueling issue or turbo in the process of dying maybe.
View 9 Replies
Just noticed today that I have a slight drop in boost. Normal boost is 1.5 bar but today it is running slightly lower boost and does not have the same pull through all the gears.
2001 mk4 1.9 tdi golf
View 4 Replies
I just recently notice a whistling noise when I hit boost. I'm not sure but it sounds like it is coming from my gauge. I'm not losing boost pressure. I do have a glow shift gauge. The most recent install was the TIP which I clamped on to the turbo but I'm wondering if it isn't on tight enough.
View 2 Replies
I was riding along today everything running fine then I came to a stop sign and when I pulled off my car wouldn't run 10 psi of boost it was only running 5 psi so I when to a buddys checked everything over and all my piping looked fine so I went up the road and everything was fine so when I started going home it did the same thing pulled of shut the car off pulled off and it was fine again.
View 5 Replies
I think my stock DV is going bad, my car makes a weird noise under boost?
1. Only happens when first starting the car after it has been sitting for an hour or a few. (not overnight)
2. Does NOT happen when first start in morning.
3. Goes away after like 5 minutes every time and the normal WHIIISHH sound comes back like it should when I step on the gas.
4. It does not make the sound at idle.
This recording I made was of my car being revved up after it sat for one hour.
[URL] ...
View 12 Replies
I just installed a boost gauge and drove the car a little and this is the readings I get. It starts off with 20 inHg and to normal street driving it goes up to 0 and down. However when I pushed it a little, the maximum reading I got was 11-13PSI (High RMP-almost redline). I am a noob in this boost department so Is this readings really accurate or is there something wrong? Recently i had some transmission work done. And since then the gas pedal feels heavier. I was convinced that it is from the new bushings but I feel like this is boost related. Because at 4000 RPM sometimes It suddenly looses the boost (Kick).
View 5 Replies
Yesterday driving on the highway, i hear a sudden "clank" and out of the corner of my eye i see my key turn itself to the off position. which i think is really strange... my rpms went to 0 and everything died.
I pulled over, put it in park. I tried to start it but the key wouldn't turn cause it locked. So I took it out and tried again. It started just fine.
View 24 Replies
I was having an issue with my car not going into boost so I plugged my code reader in and it had 2 codes 1 was p1200 n249 malfunction and the other was diverter valve malfunction so I did the quick easy one and got a new factory diverter valve but it still doesn't go into boost and still reads p1200 n249 what do I need to replace or should I do the n249 bypass it's a bone stock jetta 5 speed.
View 5 Replies
I just got done with a complete engine rebuild on my 02 1.8t jetta, had everything hooked back up and went to start it for the first time and it wouldn't. I went back looking for loose connections, nothing. Worked and banged my head for a day or two, I had fuel and spark but couldn't get it to fire. Finally I "choked" the intake to see if it was getting too much air and it fired right up. I unplugged my map sensor giggles and it starts up perfectly. I then hooked everything back up and what do you know it starts up and runs fine, but if I plug the sensor back in it kills the motor after about 10 seconds of running and won't start until I unplug the map again.
Car runs and drives but wont boost over wg pressure but that's probably because sensor itself is unplugged. I just wanna know what could cause it besides the sensor itself being bad. I ordered a new one waiting for it to get here (hoping it fixes the problem).. And I'm talking map (manifold absolute pressure) not maf (mass air flow), just in case people are confused.
View 4 Replies
