I just got my timing belt replaced by my mobile mechanic thats been doing it for years. I saw him do the work and get the timing right. When he was done the car turned on and ran perfect. After about a minute the car just shuts off. Now the car won't start at all. The car turns over but no start. The car ran perfectly before I had this job done.
View 9 RepliesSo i just spent over $1700 at a vw service ctr having a sched 140k timing belt replaced with thermo and fuel filter. This was 3 days ago and when i picked it up it was slower to turn over then got worse and todsy it won't turn over at all even when jumped. It cranks and blows black smoke. Problem is i'm 160 miles from that svc center and it's sunday. There is a vw svc center 14 miles away but i feel like it needs to ho back to where the work was done because it ran great before taking it there.
View 5 RepliesI recently replaced a timing belt in a 2003 ALH TDI & since it will not start. When I took everything apart I found the belt extremely worn & the engine had actually slightly jumped timing. When I replaced the pulleys & belt & reset the timing to the way it would be from factory. When I tried to start the vehicle it turns over fine but will not catch. I double checked all the timing, fuel pump, everything - all okay. I can get it running with ether but will not start with diesel fuel. I also replaced the fuel filter, checked to make sure there was fuel at the injection pump but nothing works.
View 4 RepliesBrought my car to a garage that someone suggested to have a new timing belt put in. After I picked it up I was having problems ((I would try and start car but it would take a few trys to get it started)I called garage told them i thought the timing belt needed to be adjusted. They told me that was not the problem but i needed some censor. Well now my car wont start at all so i brought it to another garage who tells me that the timig belt was placed wrong. My question is..Now what? lol. Do I ask for my money back seeing that they didnt fix it? Do i have the same garage just fix it?(i didnt like them in the first place so really dont want to go back. If i do ask for them for money back and they give me a hard time,what can i do? or who do i call first?
View 4 RepliesA mechanic has my car and replaced my timing belt and water pump....he said he had it running and then it sputtered out and wont start..i have never had a problem with this car. Just replacing before it went out.. he is missing something.
View 19 RepliesFirst off I have a issue the Timing Belt Tensioner Stud / bolt that holds my tensioner on is stripped and came out with my tensioner. I don't want to risk putting it back into the engine because some one prior to owning my car stripped the nut that holds it in. Where I could get a new one of these bolts. I have a 2000 VW Golf GL with a 2.0l. I've searched high and low on parts sites and cannot figure out where to buy this item.
View 3 RepliesI recently purchased 2003 gti with a broken timing belt i bought a reman cylinder head did the timing belt, water pump, belt tensioner, cam chain, and cam chain tensioner. I read the service manual and many forums before setting the timing. I got it all set and back together it runs great at the low end but it feels like when it starts to build boost pressure it stops making power. Would i throw a check engine light if the timing was any off? Would it run well on the low end and then lose power if the timing was off or should i be looking in a diffrent direction? I just want to make sure timing is not an issue.
View 1 RepliesI plan to take the timing cover off tomorrow, but I wanted to post this video. You can hear the rattle immediately in the beginning of the video below and then intermittently after that. Also, is that whistling noise you hear while the engine's running normally?
View 7 Replies 2.0L 8v ....So what's my chances the valves stayed clear of the pistons?
Driving 70mph 5the gear and cruise control set. Motor just died and I pulled off.
Cars back home in the garage. Iv ordered the ecs tuning timing belt kit.
This was a belt I installed 50k miles ago, shouldn't have gotten a auto parts store belt, or maybe it was my install, but I deff didn't think the belt was going to fail that early. Is there much of a difference between different brand belts and OEM?
2.0 Jetta with AEG engine.
I've been plagued by a belt squeak for several months now that only seems to occur when I'm in motion and let off the accelerator. I'm thinking it's the timing belt so I took the top cover off to have a look. What I found is the belt is a bit off center on the top sprocket, although it doesn't look frayed and isn't hanging off the edge.
I found that the tensioner seems to wiggle slightly when I try moving it by hand. It doesn't look like it wobbles when the car is running, but I've never been able to see in the engine compartment when the squeak occurs. The belt also appears to have some shine on a line down the center. Pictures attached.
FWIW, I checked for play in pulleys on the aux belt and found none. What's everyone's opinion on the tensioner and the condition of the belt? The belt has 52,000 miles on it.
99 passat 1.8t with 5spd has 95k on it. 2 weeks ago my ex wifes car broke the timing belt and bent 12 valves so brought it to mechanics to get repaired and got it back seems to start up fine but when shes driving it stalls out on her. Mechanic says its something do with electronic throttle and nothing to do with his work. No check engine codes yet anyways .
View 1 RepliesMy friends car suddenly quit running while he was on a trip, he went through the carwash and as he pulled out the car died. He had it towed to a shop and they charged him $400 to run a few tests and replace the fuel pump relay thinking it would fix the problem, obviously didn't or i wouldn't be typing this. At this point the car cranks but won't start.
This is what the sheet from the shop says, "retest through PCM to locate problem. Ran diagnostics per flow chart. all power, grounds and G28 engine speed spensor output to ECM test good excepting pin T121/86, wire color Lilac/yellow. Signal between camshaft position sensor to ecm. No voltage signal recommend replace PCM and RETEST."
I've put a used ecm (ecu? i've read both terms used) in and the car cranks, starts, gets to idle and dies. If i give it gas after it starts it'll rev up once, then die. I'll call it progress, but i want this damn car out of my driveway.
Today I had my 2004 1.8T Passat in the shop for a few minor things. The car has only 89,000 KM's (NOT MILES~ I live in Canada) on it. They told me that my serpentine belt was needing to be replaced (which I knew) and they recommended that I to my timing belt at the same time. They told me that you can buy a kit that has the timing belt, tensioner and water pump in it. Anywhere I have read it has said to change your timing belt at 120,000 KMs.
View 2 RepliesI just had my timing belt, water pump, etc. replaced at a reputable indie VW shop. I just got the car back and it seems to idle a bit rough. The car used to purr like a kitten but now it shakes a bit in idle. Seems to run fine but the idle is rough. I'm going to bring it back to the shop on Monday. Can the timing be off a bit? Will it ever purr like a kitten again?
View 2 RepliesChanged the timing belt. Used the red mark up top and the cut in the block on the lower one to get TDC. Changed everything with new parts. Double checked the marks after the belts were on (rotated by hand through two full turns and checked to see if the marks were in the same spot). I followed the write up that was posted here by U95.
Anyway, the car won't start. It tries cranking, but won't actually start. There is fuel and the battery should be good to go. There shouldn't be any Fuel/Compression/Air issues.
I guess my question is: If the timing belt is not tightened enough, would that keep it from firing?
Also, in trying to crank it by key every thing sounds normal (no knocks or pings or valves getting bent sounds) and turning by hand gives just the little bit or normal resistance but spins nicely.
I'll probably take the battery to get it load (I used my tender to try and start it as well, didn't make a difference) tested tomorrow and then try the starter (shouldn't be bad though, only 60k on the car). Otherwise I'll have to teardown and start over.
My car has 103000 miles on it and the timing belt was replaced several hundred miles ago. After the service I noticed it had a bit of a rough idle and a very slight sputtering noise, but still no check engine light. Was the timing belt put on wrong? The engine is non-interference, by the way.
View 1 RepliesI have a 2007 Accent with 119K on it.
I wanted to replace the water pump and I was wondering if this can be replaced without removing the timing belt or the lower timing belt cover?
We recently had the timing belt replaced in our 2003 Volkswagen Passat (1.8T). Now it shakes and vibrates badly when we put it in drive and idle. It ran smoothly before we had the belt replaced. The mechanic hasn't found a solution yet.
View 2 RepliesI drive a car I am extremely reliant on. I don't have money to buy a new one and I may be a bit over protective of this car. It is in excellent shape, I bought it with 96K and whoever owned it took good care of it. I changed the battery pretty much right away, and the auto parts store guy said it looked like it was the original battery. So I suspect the timing belt is original too, (along with the clutch, which works great BTW). I don't know anything about cars short of what I have heard on CT, but it seems there is a trend towards having to change the timing belt at 80-90K And I know that a worn out timing belt can have no symptoms and essentially ruin your car if it breaks.
I took my car for the blue plate special, and it has been to the dealer a couple of times for some repairs where they also do the general service and see if they can find something to charge me for and in all cases, my car had nothing they would identify and repair. Fluids are good air filters are good etc. When I took it to the little shop on the corner I got the same report, and when I picked it up I asked, well how does the timing belt look? And he said. I can't tell you, you would have to take it apart to find out. So my questions are, as I do not know if the timing belt has been changed by previous owners. should I just go for it and have someone change the timing belt as part of my regular maintenance plan now, or is there some nifty way to find out if it needs changing without having to spend an arm and a leg?
Cracked my oil pan somehow on the way home. I didn't notice it at first because I didn't go out to start it till the following evening. I went out to let it warm up for 5 minutes that evening and it started perfectly fine. I went back in the house to grab a couple of things, and i could here a loud ticking so i run out side to shut the car off and just as i get to the car it dies. so i push it into the shop and of course i notice the huge splotch of oil on the gravel. It sat in the shop for close to a month, as I got busy with school, and what not, I didn't get a chance to replace the oil pan.
I finally replaced the oil pan on Friday night, there was no metal bits or shavings in the old oil pan. it wont start. everything turns on in the car just fine. It just wont start. Battery is at 12.6 v all the grounds are solid no corrosion. The car tries to start, but the starter will maybe turn over once or twice and then stop.
Is the Motor pooched or is there something I'm missing.
After changing my dead alternator and resulting dead battery, I am having what seems to be electrical issues with my 2.8L VR6.
Neither of my keys can unlock or lock the car remotely and when I try to start the car, all the regular lights turn on in the dash, but the engine dosn't make a sound. Inside the car there is no power apart form the gauges, no windows, no AC, no sunroof, nothing. I have checked the fuses, unplugged the battery and plugged it back in, even changed the batteries in my keys to make sure that they weren't out, and nothing works. I have also tried to reprogram both keys and neither of them unlock the doors.
I think that it might have something to do with the anti-theft system, since I didn't touch anything while changing out the alternator.