Golf IV / Jetta IV :: Shake In Steering Wheel In Acceleration Mainly But More Often At Higher Speeds
Dec 3, 2014
So I just got my first alignment done on my gli since I lowered it. Before I got the alignment it had a shake in the steering wheel in acceleration mainly but more often at higher speeds. I was hoping that it would ride like butter but it's still shaking. The alignment was pretty bad before I took it to the shop today but what could the shake be coming from now? BTW I installed Ecs tuning rear wheel centering plates last night and I'm about to install their adjustable sway bar end links because I noticed last week that the sway bar had been rubbing the axle some.
View 14 Replies
Advertisement
I've had my 07 HD F150 into the dealer a few times for this issue and they have not been able to repair it. When I use the brakes especially at higher speeds you can feel them turning like a warped rotor, sometimes it will make the steering wheel shake. It does it with both my summer tires (22") and my winter tires (17"). Even at slow speeds you can feel it.
The dealer keeps checking and says that the fronts are fine, last time they machined the rear rotors and said it was fixed. To me the fronts look pretty grooved but they keep saying they are fine. Which didn't make sense to me. The truck stops well and has good feel and power but I get this warped rotor feeling. Is the dealer missing something?
View 13 Replies
I have a bad wheel bearing but on the highway my steering wheel shakes. It is only on the highway not down residential streets. I'm pretty sure it is the driver's side wheel bearing. I already balanced my wheels and everything.
View 5 Replies
VWVortex, so I've had some issues with my MK4 recently (go figure). It started with steering wheel getting intermittent and random jerks to the right after driving for about 20 minutes on the highway at any speed any gear but only at around 1/6 throttle. I needed to do front end maintenance anyway, so I replaced both complete LCA's with ECS Tuning's ply ones, went stage 2 BFI engine mounts, stage 2 BFI dogbone mount, both ball joints, both tie rods ends, both axles, and an alignment.
Now I'm getting a shimmy in the steering wheel starting at ~80mph. I know my wheels are slightly bent and are being replaced in the summer when the weather is warmer, but it wasn't doing this same shimmy prior to all this. Just the jerking. Could it be they messed up on the alignment? Its really getting on my nerves considering I've dumped a lot of money trying to fix this problem just to have something else pop up.
View 4 Replies
Well I've been noticing that when I'm slowing down from higher speeds (50 mph or so) my steering wheel is shimmying a bit. Also I just started to hear my front passenger brake squeal a little. Well when I went to visually check the brakes, the pads seem VERY thick! Is it normal for them to start to go bad even with such thick pads? They are like 1cm thick. Also the rotors did seem used for sure, maybe 1mm worn down or so from the outer lip which is raised (I hope you understand what I mean), but they weren't scoured or anything. I suppose they could still be warped? I figured with such big brakes I wouldn't run into that problem. The car has 70k on it and the pads have been replaced once and rotors turned at 25k by the previous owner.
View 6 Replies
Car: 2003 Jetta GLS 1.8T
The car is starting to produce a heavy shake in the steering wheel when above 45mph up through highway speeds. The kicker is that the shake only occurs on-center, because turning the wheel just a few degrees off creates a relatively smooth result.
Checked the wheels for balance, tire wear [which is good, no cupping], lower control arm (LCA) bushings, and complete a lock-to-lock steering test on the ground to confirm steering rack mounting bolts are tight. What's the next pieces of hardware I'm needing to verify?
View 2 Replies
Ok so we all know it's usually warped rotors or possibly a caliber problem. But let's say u have new of both. And still I'm getting a wobble, not only when I brake at higher speeds, but when I'm on certain roads. Only certain roads. Say about 20% of other roads while driving I get a slight wobble. Not too bad, but a very annoying wobble. I bought this CTS at 35k and now has 45k on it. And again I bought this car for my long commute and a smooth drive. Which I'm not getting. I can't take it anymore! I've got to figure this out. Getting a wobble in the steering while on super smooth roads. And I know it's the car because I have a Chevy Cavalier and a Dodge truck in the family that don't wobble on the same roads.
View 16 Replies
I've got 66,000 miles on my R32 and I notice that on certain highway surfaces my steering wheel is beginning to vibrate at around 70mph.
View 8 Replies
I noticed my Hyundai steering wheel was off centre about 20 degrees to the left so I took it in for an alignment. The toe was out and the inside left front tire was worn. The alignment is now spot on and I rotated the tires putting the slightly worn to the rear. When I accelerate now the steering wheel turns to the right. If I try to straighten the steering wheel while accelerating the vehicle veers sharply to the left. Odd is while accelerating it drives straight even-though the wheel is approximately 20 deg to the right now. When I let go of the gas and maintain constant speed the wheel straightens out by itself. When I first let go of the gas the vehicle will jerk to the right even though the wheel is straightening.
After this driving is ok - no pulling and drives straight. Only during harder acceleration does the wheel turn. I've had the Sante Fe since new and this is really off now. Has 170K km (100K mi). I know it is torgue steer due to some worn part or bushing but have not been able to diagnose easily. I replaced the lower tie-rod ends. Steering feels tighter but the bad torgue steer is still there. I am inclined to replace the lower control arm vertical and horizontal bushings. Ball joints seem ok when testing with pry-bar. I brought it back to the alignment shop and they verified the alignment was ok, everything was tight and could not identify any obvious issues with the suspension or steering components.
View 3 Replies
2003 Jetta. She has worn out front 225/45-17's on right now. From what I can tell, these would still work but I want to make sure on here. Not really worried about a slight speedometer speed change or slightly more sidewall compared to rear, just don't want any rubbing issues.
View 3 Replies
I have just over 11K miles on my 2011 and now notice steering wheel vibration & slight shake at 70 mph. The passenger can also feel it.
View 14 Replies
Started to hear noise from passenger side front wheel at higher speeds and will disappear when turning wheel to right.
From what I have been reading this sounds like it the wheel bearing.
Is this a easy repair or is more work than it sounds.
Autozone shows wheel bearing and hub as separate pieces.
when removing the parts from the car do they come out as assembly or in parts
View 1 Replies
When I accelerate at 70+, I get a very noticeable vibration that is felt into the steering wheel and throughout the cabin. I have 14,000 miles on the car, so I seriously doubt that it's the CV joint. Could it be possible that I lost some wheel weights, and it's become imbalanced?
View 2 Replies
My '01 VR6 GTI with new struts, A-arms, ball joints, wheel bearings, tie-rods and ends, etc. has started to get a shimmy through the steering only under acceleration. Half-shafts?
View 2 Replies
I know there has been much talk about steering wheel shake between 70-80mph. I have the shakes at 70mph. But, I'm wondering why my service department (Boucher VW in WI) can't drive my car up to 70mph so they can feel the shake. The service manager said they absolutely cannot go over 65mph. So ofcourse they can't verify the shake and in turn won't balance my new front tires properly (VW replacements). Am I losing my mind here -- I can't have a car that doesn't shake at highway speeds? How to get them properly balanced through VW service?
View 4 Replies
2014, IS350 F-Sport owner. Noticed the steering become resistive at higher speeds?
When I drive at freeway speeds (70-80mph) for, say, >10 minutes, I get a very large increase in the resistance in the steering. This is combined with a complete lack of caster response, resulting in very difficult control.
This occurs in all modes, and once it happens I have to come to a complete stop before the steering once again feels normal and the caster response returns.
I've had it in the service dept. since day 4 of owning the car, but no "error code = nothing wrong". They're now trying to convince me that it's supposed to work this way because of VGRS, but I'm calling B.S. on that. The car's handling and performance are decreased at higher speeds; definitely NOT what an F-Sport car is designed to do...
View 14 Replies
I have a 2003 Jetta Wagon with 49000 miles on it. I noticed that when turning at slow speeds (like taking turns in a parking lot) I hear a klunk coming from the area of the left front wheel, and I think I feel it through the steering wheel. Yesterday I was going around a hairpin turn at a shopping mall and heard two clunks. Driving straight it doesn't happen.
View 8 Replies
We purchase a left over 2005 V8 and upon driving home I notice the steering wheel shook at about 63mph and throgh 75mph. A tell tail sign of the front tires being out of balance. Hard to believe at 150 miles.
So when I brought it in for a dead battery and to fix some issues it had when we picked it up (so much for Perfect Delivery) of course they gave me crap about not being able to go that fast and typical BS.
I told them it wasn't normal and I'm not an idiot. Plus the speed limit is 70pmh in lots of places out here. Taking a ride with the tech of course they see it happen, and try some BS about it being common in 4WD, typical response instead of being upfront.
So they are going to re-balance all the tires, but my GF noticed a slight pull to the right so I'm going to have them align it too (love how dealers think I enjoy bringing it back in) but is there any issue with the Truck, something beyond the simple fix I think it is?
There's no way a wheel should shake like that, even though they said it was slight. My Z has 25,000 miles and I can't feel any shake, and I've never felt another AWD truck do that. I just want to make sure I couldn't find any balljoint issues or something.
View 2 Replies
But I have noticed over the past week of driving, whenever the RPMs are around 1000-2000, it is very hard for me to pick up speed, and I can feel a little bit of a rumble/vibration through the steering wheel. So...
If I feather the gas, the RPM increases slightly and you can hear/feel the engine rumble/vibrate. The speed doesn't really increase...
If I hit the gas more than 1/2 way down, turbo kicks in and the car shoots forward.
Is this normal? I find it very hard to add a little bit of acceleration if I feather it, the engine seems to be resisting it, if I hit it any harder, the turbo kicks in around 2500 RPMs. It almost feels as if it is in too high of a gear and the engine has a hard time accelerating a little bit...This is around ~40-60KM/hr
View 4 Replies
I have an 09 Subaru Impreza Outback Sport with 70k miles. I recently had new rotors and new tires replaced, an alignment and recently brought it into the dealer for its standard 60k tune up. I now feel a shimmy in my steering wheel at about 65-70 mph. It tends to come and go but I do a lot of highway driving and I feel it quite a bit. I already had the tires rebalanced 3 times and when that didn't fix the problem the shop replaced the tires with a brand new set. I still fill the shimmy. Is this a common problem with Subaru?
View 12 Replies
So I lowered my car sometime last year and ever since then when i make a right turn above 20mph it caused my car to shake pretty violently. i figured it might have been my Left outer cv joint so I changed the axle, solved my problem temporarily but didn't really make it any better. Recently its gotten way worse and now shakes on any sort of acceleration, and at the slightest turn of the wheel towards the right side. If I left off the gas, put it in neutral, engage the clutch, or turn the wheel to the left it goes away. Could this be the right side inner CV joint or something else? Car shakes under acceleration or right turns, is it my axle?
View 8 Replies
