Three weeks ago: clutch started slipping
Two weeks ago: pulled the glovebox handle off just by opening it
Yesterday: curbed one of my barely 4 months since fresh powdercoat BBS RC's
And I've been developing a lovely "What the ark is getting ready to fall off in the front suspension?!" noise for the past few weeks, too.
Well the clutch started slipping finally, not sure if it was the weather change on the drive from here to PA but I slip 5 and 6th wot 4-5k rpms. Have some coin set away because I knew it was going to happen sooner or later did some searching and I'm curious to here the verdict on the RSR clutch how many miles and how its holding up as well as whatever else you are running. Will probably keep the car 2+ for quite a while so not really worried about 3+ power.
View 24 RepliesI'm a new owner of a 04 gti 1.8t. The car has been modified with a ko5 turbo @ 20psi, apr tune, 3" turbo back exhaust, hks bov, and a FMIC. The car is amazing, but with my luck after only a few days of owning the car the clutch started slipping.
View 2 RepliesI have a 2012 gti with a short ram intake, downpipe, and apr stage 1+ tune. I got the tune first and, as expected apparently, the clutch started slipping at lower rpm when I start to get on it. I'm ready to do my clutch. That being said, would it be in my best interest to change the flywheel or can I run the stock DM flywheel?
View 2 RepliesThe car is a 2011 GTI 2dr w/6 speed, 12,000miles, cat back exhaust and that's it. Recently when I get into my car in the morning when it is cold (social not that cold) and either put it in reverse or just take off from first the clutch makes a really loud whining noise. Generally, it will go away after a few minutes but sometimes it doesn't go away even after the car is warmed up.
The thing that is weird to me is the clutch isn't slipping at all, even on a hard pull. I know that VW's clutches don't have reputation for lasting that long but I would be pissed if they said it was my fault seeing I drive it nice 9 times out of 10. On another note, I had my leaking water pump replaced a couple weeks ago, ever since then after the car warms up something is making a loud noise that sounds exactly like when your ears are ringing. I popped the hood and it sounds like it coming from the rear of the engine bay but its really to hard to pinpoint exactly where.
My son bought a 2008 Fit new. At about 16K miles, the clutch suddenly started slipping. He barely made it to a dealer and it was replaced at no charge. Recently, the clutch suddenly started slipping again at ~32K miles. Before you say he's hard on a clutch, he drive a 95 Civic with no clutch troubles for over 140K before selling it to buy the Fit. He took the Fit to another dealer (he's in a different state now) and was told the clutch is OK, they drained some fluid out. Would excess fluid cause a problem -- after 16K miles?
View 4 RepliesHaving problem with 5R110W direct clutch. My nephew had his 2005 SD f 250 6.0 be told that 5R110W direct clutch problems. He was towing a trailer in tow mode and it started slipping in and out, so he took it to a dealer and they said that it was the direct clutch that was causing the problem and needed to be rebuilt, he only has 40000 miles on it but they said that it is out of warranty. What do you guys think that he should do?
View 12 RepliesI have weird noise and from just a quick inspection of the car, I don't even know where to start to inspect...
Current setup:
30,000 km
stock clutch
stage 1+ Unitronic @ 5000km (1 track day)
stage 2 w/ hpfp Unitronic @ 27000km (1 recent track day, drove it hard but not prolonged, perhaps 20-25km on a 1km course over 2 hours at max)
VW v2 (~15000km)
drivetrain taken out to install DP @ 25000km.
H&R Rear Sway (setting: stiff)
I feel a weird 'clink' as I turn, and via multiple observations here are the only times I've found it semi-repeatable.
- heavy hard turns (only had a few instances where i could try this out and not 100% repeatable)
- slowly pulling out of a parking spot (turn radius on the steering wheel is more than 50% of a turn) - usually turning left (repeated a couple of times now)
- turning into a driveway (mini bump) @ less than 20km/h
- usually right turn more often then left does this appear
Also, its the noise is coming from the driver side wheel and sometimes right above the drivetrain. this can also be felt if my clutch is semi-engaged (or when i have my foot on the pedal). I have hoisted up my car to do a quick visual inspection (sadly didn't pay attention to the drive train /shaft). but found nothing suspicious (keep in mind it was relatively quick as the shop was closing). one thing i found that was loose and thought was the culprit was a plastic arm with a metallic tube that came off on the driver's side rear control arm .
I'll start out by stating that I failed to get new transmission fluid, which definitely caused the issue. So let's go back to December 26th. Check engine light came on, and I assumed it was for the oil (which has never happened before, suspicious). So I changed the oil, and took it for a test spin. Well, a mile later, I was going up a hill, and the clutch started slipping. Yes, I know, it's an auto, but I know the feeling of a clutch slipping... no power, engine revving up, jolting forward when slip stops. At this point, I drive it home without much incident, a few slips and I part it but don't drive it again. Checked the engine, and transmission fluid was out. Filled it back up, seemed to take care of the problem of slipping, but now there's a new problem...
The new problem is the following. Every once in a while, going uphill or applying full power in first gear, the clutch will slip. Also, this happens 99% of the time, first gear to second gear is a bit of a jolt, not much more than normal, but it's noticeable. And the transmission is kind of loud too, first gear sometimes sounds like there's a marble in there. Is this a rebuild? Will it work itself out?
I just had a new clutch installed yesterday. Bully stg3 with flywheel. My 2012 R has 22k. I had to change it since my stock clutch was slipping at 3000rpm with the Unitronic stg1+.
The second I start the car and stay on neutral, give a little gas I hear a super loud grinding noise. It stop when I press the clutch. On idle I don`t hear nothing and when I drive everything is fine until I release the clutch and when I don`t press the gas.
The shop said they never heard anything that loud and they confirm that everything was installed correctly. Other then the noise the clutch is fine and works very well.
So i have a 05 1.8t gti... just bought it about 3 months ago and it has a stage 2 south bend clutch... the car has only 68k on it and the clutch is slipping already... it was driving fine then about a week ago all hell broke loose and it's slipping bad... now for my question what performance clutch is recommended? I have a giac tune and its pushing about 21 boost... . would a 2.0 performance clutch work on the 1.8t?..
View 12 RepliesMy wife was driving my Stage 1 R last night (by herself) and she ran into an issue where when she tried to leave from a red light, the clutch was slipping through the first three gears and she could barely get up any speed. She pulled over, let the car sit for a few minutes and then started going again with no issues.
She drove home about 5 miles and told me about what happened. The car smelled like burning clutch, but when I took it out for a quick test drive, everything seemed fine.
I am at around 5000 miles and have never had any issues before and I don't ever do high-rpm launches. So, could this have been a fluke or a sign of the clutch/pressure plate issues people have been having?
Well I was hoping it was just a fluke the one time it slipped about a month ago, but my clutch is now officially toast. If I'm between 3-4k RPM and punch it in just about any gear I'm getting slip. Trying to pass a car on the highway, and I'm getting slip. I do not launch my car, I simply like to play in the 3-4k rpm powerband as I love the torque. Apparently spirited driving while remaining in the peak torque range of the engine will kill the stock clutch. God only knows how long the OEM clutches will last with people that drive their R like a racekar... 3200 Miles, Stage 1+ ....
View 24 RepliesI have an issue that I thought was a slipping clutch, but my dealer says it isn't. If I'm cruising at highway speed (stg1 gti)say around 65 and I get on to pass the revs will surge, but there will be no apparent acceleration to go with it. The dealer said it isn't the clutch because there is a standard test they do where it would be jerky in 2nd. Could this be a DV or something?
View 24 RepliesI went stg.1 at 1000 miles & stg.2 around 6000
miles, then K04 I'm at a little over 6400 miles & my clutch slips in 4th & 5th gear. I never got the chance to install my APR inner cooler. I really hope the Southbend stg.2 endurance setup works well so I can move on to the suspension. This hobby can get expensive but the car is a blast to drive! It never fails to put a smile on my face & has definitely taken the smile off other drivers faces when they realize they can't get by me.
So I have a stage 2 endurance clutch and light weight flywheel on my car. I had not really gotten on it of late until yesterday. I was getting on the highway and really got on it. When I hit third gear it felt like my clutch was slipping. I have only had it on the car for like six months and about 10,000 miles. It could be worn out all ready? And after the incident yesterday I pushed the clutch in and held it to let it cool down a bit after it did it held fine even in higher Rpms didn't feel like any kind of slipping. Pulled very strong. This morning after having all night to cool off (and I mite just still be freaked out a bit) but it seemed to feel different, like a possible slip at 3,000 Rpms but again I mite just be freaking out about nothing. What does a master cylinder or slave cylinder going out feel like?
View 1 RepliesSo my clutch started to slip in 4th when I first got my apr stage 1 tune at 24k miles. now 600 miles later it's slipping in 3rd. put it back to stock mode and it doesn't slip in any gear.
My question, if I replace my clutch with an OEM sachs what are the chances of it slipping again? From what I understand the golf R uses the same clutch disk and pressure plate as the gti so why is mine slipping so early? luck of the draw?
I prefer oem because it is a lot quieter and I do not plan to mod any further than stage 1. I'm still running the stock airbox.
I am trying to find origin of clunking noise, but it is difficult to do as there is no visual signs and no excessive movements in any components.
Little bit of details and video. Noise occurs when moving rapidly steering wheel on stationary car with running engine. Not noticeable when at speed. Wheel is not vibrating and cv joints not clicking. Very tiny free movement in steering wheel about 1mm, but I am not sure if that is related maybe a completely different issue there. Mot tester make an advisory note that steering system slightly rough, but its not that useful to find an issue.
[URL] ....
So I've recently dropped the car with ST coils and during the install, I had the mechanic installed NEW strut mounts and strut bearings because I've heard people having noises if they only do the coils.
However, even with the new strut bearings/mounts, I would hear clicking noises at low speed going in a out the parking spot or parallel parking (not every time but getting close). Therefore, my questions are:
1. If strut bearings/mounts are new and put in at the same time as the coils, what other reasons could there be that's causing this clicking noise?
2. If the noise doesn't bother me and I can live with it, would there be any negative effects for not having this issue taking care of?
I know some of us drag race our cars from time to time. I have a fair bit of bolt ons and I was just wondering what I would run so I had her out 3x yesterday. Impressed with my trap speed of almost 100mph on an 85-degree day w a stock intercooler but not my times, so much so that I don't even want to say them.
I was shifting a little after redline as quick as possible and leaving at like 3000-4000 rpm.
Is my clutch slipping or where am I going wrong?
the suspension is mostly stock as are mounts. I am sure I will get better with practice but this was a really sticky track so I really cant blame my tires
So I got my stage one flash yesterday and I noticed 5th gear slipping already. I don't plan on getting a k04 upgrade, maybe stage 2 down the road. so I am looking into the drop in clutches, preferably this one [URL] .... I am just trying to find out some reviews from people who are currently running drop in clutches and the issues that they have come across.
View 8 Replies