Grand Prix :: Code P0410 After Air Pump Replacement Several Times
Apr 24, 2015
I bought my 2001 Grand Prix with a 3.8 liter (non supercharged) earlier this year. Within the first month, the check engine light came on with a P0410 code. Took it to the shop here at the auction that I work at to get repaired. He ran the diagnostics on it and found that the air pump wasn't working. He pulled it out and it was full of water, due to the air inlet being so low. So, he replaced the air pump and re routed the air inlet so that it was higher up into the engine compartment. That same night, the light came back on, so I brought it back in the next day. The relay failed and popped the fuse. Replaced both, and the light was off for a full day.
Got ready to take it in for its emissions test today, and the light came back on again. The air pump is not working, again. Turns out that the previous owner had replaced the air pump twice (once with aftermarket, and once with an OEM unit) because of the water build up and freezing the first time. I am not aware of any GM service bulletins, but there has to be something that is taking out these pumps. The only things not replaced on the secondary air system is the lower check valve and solenoid. So, what could be causing the pumps to fail prematurely?
View 4 Replies
Advertisement
I have a 98 Grand Prix 3.8 with about 170,000 miles on it. Yesterday I tried to start it, and it would crank but not start. Let me provide some background info . . . We had received cold temps and snow recently and the vehicle is parked outside. The car ran fine the day before in colder temps. Yesterday morning I was scooping the snow next to the car and I bumped into it causing the alarm to go off. The horn honked 4 or 5 times and then stopped. Later when I tried to start it, it would just crank. At first I thought it was the fuel pump since I could not hear it. The fuse was fine. I then noticed the DIC was flashing 0 on all modes.
On another thread I saw that is often due to a loss of data between the DCI and PCM. I thought perhaps I tripped the security system when I bumped into it which is preventing it from getting fuel, and perhaps was also causing the DIC to show 0. A GM service tech said to put the key in the run position for 10 minutes then turn it off, and then do this two more times and that should clear the security system and the car should start. I tried it and it did not work. I am starting to think it may be a bad PCM. Stopped at my local Oreillys to check out their code reader, but they no longer check them out to take home. It must be used there.
View 2 Replies
I have a 2004 grand prix gt, within the last couple of days, it seems to loose power on acceleration and the motor completely dies at times. After waiting 10 seconds or so it will crank but may die again or just feel like it is loping. The problem is getting worse quickly. I have replaced the fuel filter. This did not stop the problem. I thinking it may be the fuel pump. If it is the fuel pump is there any way to verify this to be sure it is the problem before replacing it?
View 3 Replies
Radio is fine, all gauges and such seem to be normal. The climate control unit displays 75 degrees, the fan is blowing, but none of the controls do a darn thing. I can't turn it off, up, down, or anything. Where to start looking?
View 1 Replies
Having an issue with my car blowing fuel pump fuses every once in a while under heavy to moderate acceleration. Have replaced inline fuel filter and the fuel pump resister(white ceramic part). Runs fine with normal driving, but when I want to get some horses out of it, it will cut out and stall and once i replace blown fuse it will start back up again, and I'm off and running again.
View 2 Replies
My son had the car and put the window down and it would not go back up. Had to drive 13 miles in below zero temperatures to get home. After searching online and doing some checking on the vehicle we found that the Driver's PW switch was dead. Went and got a used switch and replaced it and the window works find. SO, the husband goes to start it and the battery is dead so he put a charger on it and it did start but it stalls right away. It will stay running if you have your foot on the gas but as soon as you let off it stalls. If it idles at all before it dies it it does so erratically.
View 10 Replies
I have a 97 grand prix GTP that I am replacing the ignition switch on. I am having trouble locating the small hole on the key cylinder that I put an allen wrench into to release the key cylinder.
View 2 Replies
1997 Grand Prix GT N/A. 175,000. I keep getting this code about once every two weeks. I'll clear it and doesn't come back until then. I've had passengers in the back seat smell gas so I'm suspecting the vapor canister. Would a leaking canister set this code off? I checked all the vacuum lines to the purge solenoid and seem fine. Is the canister in the drivers side rear wheel well? I need to get in there and check if it's leaking. I'm having no driving issues however my gas consumption seems to be a bit more than usual. I checked the FPR and no fuel contamination.
View 2 Replies
2000 Grand Prix GTP has code P1629, car will run for 3 sec with black master key and then die. Security light in dash is flashing when this happens. Tried the 30 minute relearn for PK3 with no luck. It will start and stay running with the grey Valet key which is perplexing to me. As of right now I am siding with replacing cylinder and ignition switch after everything I've read on the subject.
View 13 Replies
About a month ago I had my SES light go on and I took it to the auto parts store and they said it was a small emissions leak. I am not sure of the code though. I took my car to the shop and they said that a sensor that had something to do with the exhaust was bad or unplugged.
My SES light came back on about about a week ago and I had it tested and it said the same thing. "Small emissions leak" This time I got the code and its P0442. The shop is closed today and tomarrow so what and where the sensor is located? Or if its the same thing?
View 7 Replies
1997 Grand Prix 3.8 N/A 181,000 ... I have been getting a misfire only on cylinder 4 which has become more frequent. It "only" happens after the car has warmed up and I turn it off for a few minutes, for instance going in to pay for gas. When I start, it immediately starts to miss but as soon as I hit the accelerator it evens out and runs great, every time. I replaced plugs and wires two years ago with stock.
Upper and lower intake manifold gaskets were replaced around 110,000. All three coil packs have been replaced with original GM packs. I replaced my EGR valve last year due to the original was sticking. My throttle body was cleaned about four years ago. I've seafoamed through brake booster and the rest in gas tank.
I'm stumped that it corrects itself right away by giving it gas. The SES light always come on but goes off on it's own after a few cycles.
View 4 Replies
My Check engine Light comes on with a P0410 Code. It used to come on every 6 months and I would get it cleared. Now it is coming on about every month. I can't find much about it. Is this something I should get fixed right away. where is it located?
View 4 Replies
I just bought a new 2001 Grand Prix. I am not completely car savvy, but I know a few things for a lady.
The battery won't hold a charge.
and the computer diagnostic tester thing says the Headlamp Relay is malfunctioning.
View 2 Replies
I have a 95 Grand Prix 3.1L and I can't turn my key. You can put it in and take it out, but it won't turn whatsoever. It's stuck in my driveway and I've tried just about everything to get it to turn.
View 1 Replies
I'm pulling the engine to overhaul. I've borrowed a hoist and think I'm ready to lift the engine out, but I don't know how to strap the engine to the hoist. I first thought of using the brackets with the eyelets bolted to each head and bought chain and hooks. But I had to remove the rear bracket so I could remove the rear exhaust manifold so I could remove that darn rear engine-transaxle bolt. (That really bites because I want to have the exhaust manifolds on when dropping it back in.)
Are those brackets intended for lifting the engine? If so, I could reinstall the back bracket and give it a go.
Searched the internet for info but didn't find much. Did find a 3800 being lifted with two straps completely under the engine.
Also, the engine-transaxle joint hasn't cracked open yet. I'm guessing it's because they're stuck after 198k miles and will eventually separate. But I did not find one of the engine-transaxle bolts mentioned in the 98 FSM: front lower (#1). I don't see how I could have missed it ; maybe the 99 doesn't have it?
View 4 Replies
Thought my transmission was slipping. So I changed the tanny. been driving it for a few days and now it doing the same thing. Is it possible that it a different problem with the same symptoms?
View 4 Replies
When I turn the car off the key only goes to acc. If I wait a few minutes I can hear a clicking sound coming from the steering column I think. Then I can turn it off all the way.Whats causing this? and how do i fix it. My car is a pontiac Grand Prix 2002.
View 2 Replies
I have a 2000 Grand Prix with a 3.8L engine that will not start. When I turn the key to the run position, the headlights and the dash lights come on, but when I turn the key to the start position, the lights go dim and nothing happens. No sound from the starter. I checked the battery and the starter and they are good. I installed a new positive battery cable. Still works the same. Not sure what else to check.
View 13 Replies
When you are accelerating anywhere from half to full throttle it may cut out at any given time. The RPM will drop down, it may bounce up and down for a bit and recover, or it will drop all the way down and stall. If you let off the gas it may or may not recover. If it stalls so far from the tests I have done if you never shut the key off it will never restart again. If you shut the key off and wait from 5 to 10 minutes it will all of a sudden restart normally like nothing ever happened. If you try to restart it immediately even if you shut the key off and back on it will not start.
When it does not start when I am attempting to start: Fuel pressure according to my gauge is between 55 and 60 psi. Inline spark tester shows that it is getting a spark. Engine sounds normal while cranking so in other words compression sounds normal. I have an LED test light rigged up showing when an injector fires, and it does show electrical activity going to the injector when it opens (flashes). Only clue is that it SEEMS dimmer when it wont start, but I have no clue if thats how it normally is on start up. Its only a slight difference from the brightness of a normal idle brightness. I have a snap on scanner hooked up, nothing that I know of looks abnormal in the data and it will not throw codes when this happens.
Parts I have changed or cleaned so far: Changed the fuel filter, crank sensor, cam sensor, ignition module, and MAF sensor. Cleaned the throttle body. When the car is working normally it runs strong, good power, smooth. Starts great normally.
View 8 Replies
What may be causing my car to harshly shift fron 1st to 2nd and then from 2nd the 3rd. One solution some one had was to replace the:
"TPS (throttle position sensor). The other reason for hard shift is a worn Boost valve and will need to be replaced, or a faulty transmission fluid EPC (electronic pressures control valve). Both Boost valve and EPC are located in the Valve Body and can be replaced with out dropping the valve body, but have to drop the transmission pan".
I did just recently top off the tranny fluid because it was running a bit low but there is no leak....
View 7 Replies
Last year my a/c worked off and on. so far now its not working at all. Compressor isn't kicking on. i bought a bottle of the EZchill refrigerant to recharge the system. I took the relay out and added 12+ to the pin to kick on the compressor. Even with the compressor running the gauges are in the blue range which is the normal operating range. With the compressor running, the air is cold but when i stick the relay back in the compressor wont kick back on. I tested the relay and its fine. Also the compressor is rattling.
View 8 Replies
