My car is a 2001 honda accord v6. It sat for 3 winter months. When I go to turn it on in the morning, the car will rev while idling. Jumping between 1000 and 3000 rpms. Why this might be happening?
View 3 Replies2002 Elantra engine is revving up to 3000 rpms when in neutral or park. I changed the Throttle Position sensor and it went right back to revving up. Code read P0121. What might be causing this? Seems like I get one thing fixed and then another code shows up..
View 2 RepliesRecently I had a battery replacement and a wheel barring replaced. Once I picked up my car the speedometer started jumping. I took it back into the Sears auto place that did the work. They checked it out and then told me this was an electrical thing and that they weren't at fault. After about another day the 'check engine light' came on.
I recently moved so looked up an actual garage in TN that had good reviews and took the car in. They hooked it up to a computer and told me the speed sensor chip was bad. Since the car is a manual they said that it was ok to drive it but they wouldn't recommend that for too long while I saved money. I have seen lots of posts online about doing this yourself. I by NO means am a car person but I have seen that you can buy the speed sensor part pretty cheap online.
My questions are: Is the garage charging me an arm and a leg? Would it be a recommendation to buy the part online and then take it in to be fixed? And if so how do I know which ones are ok for my 2001 Honda accord?
I had my Honda Odyssey transmission replaced 2 years ago. The past few months, in the first mile that I drive the car on streets in our neighborhood, the car goes into high RPMs (about 3000) before it seems to drop into gear. It does this 2 or 3 times then works fine after that. The "Check engine" light is now on all the time. Sometimes, the car does one other weird thing--the high RPMs end with the drive/D4 light flashing on and off like a blinker (even if I change gears to D3. When this happens, if I turn the ignition off it comes back on and seems to function fine. I have had it back to the shop that did the work about 4-5 times to get it right. I like the guys but each time they return it to me, the problem remains. I took a 2000 mile trip with it and with the exception of this persistent problem, the van worked fine.
View 2 RepliesMy mother has a '04 Santa Fe 3.5. Her automobile makes a rattling/grinding sound when around 1000rpms/idle. However, the sound disappears when accelerating and drives like a charm. The sound returns once again around 1000rmps at idle or stop. I have changed the oil pan, replaced oil and filter and even put in a new battery. I'm not an aficionado when it comes to Hyundais (Subaru driver here).Car also has 180k miles.
View 6 RepliesI own a Ford Ranger 2003, 5spd 6 cyl. My problem is when I'm driving and the engine is revving above 3000 rom's. It begins to sputter and buck as if the engine is running out of gas. It only lasts a few seconds. It ends as quickly as it starts. It does not occur each time when driving above 3000 rpms. My mechanic took the truck for a test ride and of course he could not find anything wrong. His advise was to wait until it got worse. I would rather solve the problem now. It is difficult and dangerous when trying to pass vehicles on the road.
View 2 RepliesI have a 2000 b5 wagon with a 2.8 5spd with 200k on it .... Its slammed on coils and i get this squealing in reverse i dont know what it is i just rebuilt the front end ie control arms... also have a nasty vibration from 1000rpms to 3000 rpms could that be engine mounts/snub mount?
View 7 Replies!995 honda accord, 5 speed. Idle is fine until the engine warms up, then fluctuates between 1500 to 2500 rpms. The idle control valve was cleaned- no change. Valve was also replaced -also with no change. Put old valve back on. Computer was disconnected after cleaning and also after each valve change.Would the next step be to remove and clean the fast idle thermo sensor? Also how do you check the coolant lines coming in. Anything else I would need to check, clean or replace.
View 2 RepliesI have a 2000 accord with 2.3 v tec, parked my car last night and was working fine, started it up this morning and the car wont work over 3000 rpms, it idles and works great but when you drive it or push the gas as soon as it goes over 3000 rpms it should like the rev limiter is on, i already cleaned the iac and it woks fine a while ago,can it be a sensor, I thought it was a fuel filter like it was starving for gas but in the 2000 accords its in the gas tank, don't under stand why she runs good up to 3000 rpm then over that she misses . I took out the spark plugs and they were black and sooty, put a spare set I had in her but no change in the way the engine works.
View 4 RepliesReconditioned engine 5,000 miles ago. Last maintenance check at dealer found nothing wrong. 2000 Honda CRV.
View 4 Replies2012 SEL... Experiencing High Idle (1000 rpms) when the AC is ON. When I power the AC system OFF... the idle comes down to 700-800rpms. Then I power the AC back ON and it stays for the rest of my trip. Restart the car, and it's back to 1000 rpms with the AC on.
View 2 RepliesMy 2001 BMW 325Ci has an occasional "surging" idle problem. When coming to a stop or at idle, the engine will rev between 500 and 1000 rpm's. Sometimes it will correct the problem and idle normally, or keeps surging until it eventually stalls. When restarted it works fine. Tried fuel injector treatment, fuel stabilizer treatment, and replaced thermostat. Still surges about 50% of the time. Had it to a dealer, and computer says its running fine.
View 1 RepliesI leased a 2015 Honda CR-V AWD LX on March 11, 2015. The following day I noticed a rough vibration/shuddering/chattering that appeared to be coming from the transmission when the rpms ranged between 1,000 and 2,000. The roughness was evident at any speed (mpgs) when the tachometer reading was between the previously stated range. The service technician reported feeling the same roughness, but noted that the problem was characteristic of the CRV with a CVT transmission. On Tuesday March 17, I went back to the dealer and discussed the problem with the service manager. He also stated that he was aware of that particular problem and that it was peculiar to the 2015 CRV with the CVT transmission. He took my car for a test drive and admitted feeling the chattering. It was also evident to me as I sat in the passenger’s seat. He then took out another new CRV and it too exhibited the same characteristics.
View 18 RepliesSo I just drove my 85 to san francisco and back to Los Angles this weekend to visit my girlfriend and i had high oil pressure all the way until i blew my valve cover gasket.
So i fixed it finally today and it ran fine for a couple blocks and then my rpms shot up to about 3000 rpm and wont come down at idle speed and the car wants to keep going while in drive.
Its a 2.4l 22re EFI
I have a pretty bad flex pipe leak on my 20th. Would this leak cause a very rough idle almost stalling when I come to a complete stop. The Idle fluctuates from almost stalling to 1000rpms.
View 1 RepliesMy wifes 2008 Eddie Bauer Explorer V-6 recently started having an erratic idle and we've started noticing it while at higher RPM's. Its almost as if there is a cylinder that misfires but no engine light is coming on. The car stumbles like it is going to start to die, then the idle jumps up and smooths out. A little while later it does the same thing. The car has I think 74,000 miles on it and has never had the plugs or wires changed. I change out the fuel filter roughly every 24,000 miles and did it recently in the spring. Any places where I should start looking? Could a misfire not trigger the check engine light?
View 3 RepliesHave a 2001 CRV that is running really bad. It almost stalls when I put it in gear or even when the RPM's fall to idle. It is now throwing a p0172 code. I have a simple scan tool and verified the MAP reading and primary O2 voltages as suggested by the manual, both appeared to be normal. It seems all the symptoms point to valve clearance, however the valve were adjusted not 2000 miles ago by the dealer during the 150K service, and this issue has existed before and after that adjustment. I also cleaned the IAC screen with no changes.
View 5 Replies1992 Honda Accord with 104,000 miles automatic transmission..was my mom's car and has been consistently maintained and serviced and gently driven!!The car performs well until...about 3 weeks ago when it starting revving up and the D4 light stayed on even when I was in reverse. Idling high and Drove like the car was in high gear.
Mechanic #1 checked the gear position switch and checked connection at Trans ECM. After unplugging and re-pluging in connector system functioned properly. And it did for about one week. then we were back to the same problem and it was clear that the car was not shifting like it should.
Mechanic #2 didn't provide much feedback: he emphatically stated that it was a transmission problem and that the trans would absolutely need to be rebuilt: price quote: $3500 including labor. I'm scratching my head at this point & reaching for the aspirin..as little as I know about cars I'm wondering how a transmission needs to be rebuilt at 104k?
Oh well..as much as I like this car, I don't want to put in $3500 and hope for the best. Mechanic #3 is a Hondo maven..and he says it's not the transmission...this is what he says: checked for codes; found none. Reset Transmission computer by removing power to it resulting in the car running better and D4 light if off. He advises that we Wait & See if problem happens again.. He suspects a possible electrical problem. Car does drive better and the D4 light remains off but when I get on the freeway the car seems stressed and noisy and when I decelerate, it's noisy. I am waiting for the other foot to drop.
I have a 05 gli I just put a k04 turbo on. It runs on stock ecu but I have been told that's not the problem. When I start the car the rpm's spike to around 3 grand then slowly drop to normal idle rpm's when it gets under 1000 rpms the car starts to shake and idle hard. Idk what it is Cel is on and read misfires in 3 of 4 cylinders but checked plugs and everything they r fine. I'm thinking maybe vacuum leak or something along those lines.
View 6 RepliesI have a 2003 Ford Musang 3.8L v6 when I start my car for the first time of the day or after several hours of sitting the car idles high between 1000-1300 RPMs for approximately 15-20 seconds after that it idles down to 600-800 rpms. I changed the spark plugs wires air filter not sure what else it could be no Check engine light.
View 1 RepliesI have a 2008 Ford Focus - 4 Door Sedan SE 60300 miles.
I've gone to 3 mechanics now and no one can seem to figure out whats wrong with my car. Here's whats happening:
About 1 1/2 years ago I took my car to get an oil change at Jiffy Lube (Yeah never again). When I left, my car was idling funny... Silly me didn't take it right back and have them tell me what was wrong.. so I let it go, well about a month later it started idling even weirder. Basically it feels like my car is shaking when it gets under 1000 RPM and I notice my RPM dial start falling and bouncing back, acting like its going to stall, but never does. I notice a loss of power when this is happening (on speed up and just accelerating in general). All of this is random, I can't seem to put a pattern to it as to when it happens. One day I'll start it up and everything is perfect... Then I'll shut it off and restart it later, and it starts vibrating and puttering again... No signals as to if its hot/cold or wet/dry, no environmental variables seem to cause it to happen anymore than others. And there is no check engine light on, everything "looks" normal.
What I've had done to it so far is:
Air filter changed / reseated
3 oil changes (keep getting told it will work)
Throttle cleaned
Computer reset for idle sensor data rebuilding
Now I'm told that I need new engine mounts, and that could be the reason for the vibration. I'm thinking that the vibration caused the mounts to wear out, more so than the mounts being the cause. Mainly because I don't see how bad mounts could cause loss in power/bad idling.
What could be wrong?!? Really bugging me and don't want to keep throwing money at it for phantom solutions. Seems like mechanics I go to can't figure it out unless there is a check engine light on with some diagnosis code to tell them exactly whats wrong.