Hyundai - Elantra :: 2007 - Brakes Make A Grinding Sound When Tried To Stop In Icy Conditions
Feb 16, 2012
The brakes on my 2007 Hyundai Elantra make a grinding sound (almost like finger nails on wood) when I have tried to stop in icy conditions. It's also hard to get the car to stop and I end up pumping the brake. A Hyundai dealer replaced the front brakes over a year ago and Adirondack tire replaced back brake pads in the summer. Is the noise part of the anti-lock feature or does it sound like a problem?
View 10 Replies
Advertisement
My 2006 Hyundai Elantra has developed an intermittent starting short that seems to only occur in damp conditions. The intermittent starting short/fault seems to only occur in the mornings when the car has sat overnight outside. When I put the key in the ignition all the regular lights and bells will ding as normal, but when the key is then turned from "on" to "start" the entire electrical system cuts off. No interior lights, gauges, dash lights, nothing. However, if I pop the hood and then drop it, electrical power will be restored. I have been doing this for the past two weeks while I tried to determine the conditions of the fault. This morning however, this "fix" wouldn't restore electrical power but the short occurred again in a cycle and the car never did start, despite trying the hood pop/drop method 10 times.
I had it towed to a shop this morning. When the car and I arrived, it started normally without issue. (of course!) I'm wondering if riding on the back of a tow truck dried out something or if that was immaterial. The person who looked at my car noticed a loose negative battery pole attachment and replaced the negative battery clamp. (His advice was to start small before needlessly pulling things off trying to find the fault.)
So, what could cause this or what course of action to pursue? The car has 94,000 miles and this is the first real issue it has had.
View 6 Replies
Just purchased a 2010 ls with 20,000 miles on it. Brakes make a popping noise when coming to a stop. Not all the time, seem to get worse as brakes get hot. Have had to dealer twice they have resurfaced rotor, bled system put new pads. Still have noise my service manager opened a trouble in the lexus system and called Atlanta. They said this is characteristic of this car. I drove a couple of other ls cars and did not hear the noise. Not sure where this is going to end up. I saw where the brake actuators where changed on the 07,08 and 09.
View 14 Replies
2004 Chevrolet Silverado 1500 4WD.... Rear brakes make strange winding sound when coming to a full stop, noise only apparent under 5MPH. They have been completely done over. Rear end issue? Changes gears fine, brakes work ok.
View 1 Replies
I have fairly new brakes on my 97 Chevy Tahoe with 202,000+ miles. For the last several months when I come to a stop, sometimes the brakes make a grinding sound (or 'boy-yoi-yong' sound- it's hard to tell) and the brake pedal feels like it 'slips' although the brakes do always stop the car. The brake don't always do this but it happens at least once or twice a day. Sometimes the problems is very mild, other times it's very noticeable. have it checked by two mechanics and they can't get the brakes to misbehave so they can't find the problem. All they did was flush the brake fluid twice and tell me it MIGHT be the master cylinder or the ABS system. My husband got laid off from his job and I am disabled. We can't afford to start fixing everything the mechanics THINK might be wrong with the brakes.
View 3 Replies
I noticed yesterday a sound, like a grinding sound, *sometimes* as I apply the brakes to stop. I'm at 68k. The noise only happens when the brakes are applied so I suspect there is an issue with my brakes again.
Some BACKGROUND info: At around 60k (or 8 months ago roughly), the front pads were replaced after the brakes were squealing and a pulsating brake pedal when stopping. The pads were replaced by a dealer. In addition, both front/rear rotors were turned at the same time. Rear pads had 40% at the time and were not replaced.
Some weeks later the pulsation came back and I went back again and they machined them again. For this current issue I was thinking about taking the car to someplace local (not a dealer) and getting a free brake evaluation of what is going on.
I'm also concerned that all this machining the dealer did to eliminate the pulsation may have decreased the life of the rotors and perhaps they need replacement now.
View 3 Replies
So, last week I got my transmission replaced and they also had to replace the CV axle because it was damaged beyond repair when the Transmission self-distructed. They drove it after all the repairs and said it was driving fine, just that it had a belt squeak.
On my way home (30 min drive) about 10 minutes in, still in the city, my brakes start making a grinding noise and sort of a thump thump thump when I brake which sounds like its coming from the passenger side front, it makes me really nervous. It doesn't sound like any brake grindy noise Ive ever heard before and it wasn't making any brake noises before it broke down. (On a side note: it also made a weird noise maybe the first 3 times I drove it after getting it back and I turned the wheel hard to back out of a parking space, that used to be when I heard the belt squeak but I haven't made it squeak since I got the car back.)
Everyone I talked to said it sounded like it needed new pads so tonight I bought new brake pads and rotors for the front and got everything taken apart. The rotors didn't look bad at all, just some light surface scratches, nothing deep, no warping I could see, and the brake pads look almost brand new. I did notice that the inside brake pad on the passenger side was missing its little metal plate that is usually between the caliper and the pad, so I went ahead and replaced all of the brake pads hoping this lost metal plate was the issue.
I also turned the rotor by hand on each side while the brake pads were off and the only difference I could notice was when turning the passenger side one it made a little more noise almost like it was loose.
I got everything put back together and drove around the neighborhood with my boyfriend in the car to listen, the grinding noise was gone and it seemed to brake really well (never got above 30 mph.) However, on my way to return the rotors to advanced auto (45-50 mph) it started making the thump thump thump noise but without the grinding, still on the passenger side. I can feel it in the gas pedal and now it not only happens when I'm braking, but also any time I let my foot off the gas pedal. The only time I dont feel/hear it is when I'm accelerating.
View 3 Replies
2004 Santa Fe, after starting car the brakes make a grinding noise, the nthe ABS, ESC and 4 wheel drive light come on. After the initial grinding the noise stops and the brakes work fine. Just the lights stay on.
View 4 Replies
My car came back from the shop yesterday with new brakes and pads and seems to be making some odd noises, both at low speeds and while breaking. I called the shop this morning and they said that this sound was normal for awhile but to come back in a week if it persists. Is this sound advice, or should I be driving my car right back to the shop?
2005 Hyundai Tucson 122,000 miles
View 6 Replies
There is this incessant squealing and grinding coming from my brakes. I have taken my 2010 Hyundai Accent to FOUR different mechanics and none of them have been able to figure out what is wrong with my brakes. I have replaced all of them and each mechanic has cleaned and adjusted them. But THREE days after, every time without fail, it is back as bad as it was before. It is only the rear right brake drum that is doing it still and I have no clue what to do. Something is definitely wrong with this car.
View 3 Replies
I recently had an issue with my transfer case that caused me to have to replace it with a rebuilt one. I did so and am now having a different issue. I have a switch on my dash that shows Auto, 4 High, and 4 Low. Whenever I shift that switch over to 4 High from Auto the light changes and I hear a click sound. When I shift the switch from 4 High to 4 Low I get nothing. So, I took off the transfer case motor and switched things over by hand. When I shift the transfer case (manually by hand) over to LOW setting on the transfer case; it seems to run ok as if it is in 4 low, BUT, when I shift the transfer case (manually by hand) over to HIGH setting I can shift into every gear but seemingly have no reverse. Reverse seems to make a whirring grinding sound.
View 2 Replies
My 2007 Hyundai Elantra SE (Automatic, 69,400 miles) makes a grinding noise when I start to accelerate from 40 mph. I sometimes hear a noise that sounds like an airplane wheel being activated when I'm driving at lower speeds driving around town. Could this be the transmission? Who should I take the car to?
View 7 Replies
I'm having 4WD problems with my Yukon, but the dealer keeps telling me there's nothing wrong with it (this has been going on for 2 winters now), which is either code for, "let's wait until it's extended warranty expires, so we don't have to pay for it," or "the computer says nothing is wrong, so that's all we're going to look at." When it's in 4WD, anytime I make a sharp turn or even turn a corner there's a grinding noise in the front, if I try to back up, it will only go as far as one revolution of the tires then stop (I have to take it out of 4WD to backup), eventually the "Service 4WD" light comes on, but apparently nothing gets recorded on the computer. It has 32,000 miles on it.
View 6 Replies
My 2003 Jetta GLI was making a terrible grinding/knocking noise when i would turn and occasionally make this "Bong" sound especially when reversing. I took it to my local shop and they say my spring in the front left is "either broken or unattached" and that i need spings/struts. I have like 150k miles on this car so the timing is probably right. So my question is, how much should they charge for this? Also, what should i have them order and install? Im not trying to lower or anything like that, OEM or a slight upgrade is what im looking for....
View 9 Replies
So about 6 months ago I got new brakes on my car (2009 Hyundai Elantra). It was done by a independent repair shop. A few weeks later the brakes started making really weird noises, so I took it back to the shop and they took a look at them and they said everything seemed to be fine. So the next couple weeks there was no noise, but after a month or so the same thing happened again, I took them back to the shop they said everything looked fine and the noise stopped once again, but after a couple months later this happened again! and its been frustrating.
So when I took it to the dealership for oil change, I asked the guy to check the brakes for me and he said everything looked good, but if I had them changed in an independent repair shop they probably put generic ones which don't have some kind of lubricant that keeps them from making noises, that this happens sometimes, and if I wanted to fix it, new brakes had to be installed and they need to be the dealership brand which is for Hyundai cars. How true is this? I'm very naive when it comes to cars so I don't know whats going on.
View 11 Replies
I recently crossed 21 K miles in my Saturn. The brakes make a squeaky sound every time I press them. Is this a sign that the brakes need to be replaced?
View 5 Replies
Ive got a 2011 Sonata GLS with 111k miles. I purchased the car new. For the past several months the brakes make a crunch or creaking sound when the pedal is being pressed OR released. The funny thing is it only happens when driving forward. When I apply the brakes while reversing, the brakes are silent. I did a pad slap at 68k and have taken everything apart, cleaned and re-lubed to no avail. The sound can be heard at the front wheels when someone else works the pedal while the car is parked. Pads have about 50% thickness. Pads? Calipers, master cylinder?
View 27 Replies
Just bought my new ride last week and already noticed strange clunk sound when braking. It doesn't happen all the time but seems to happen when I make full stop, like at a stop sign or stop before turning.
View 1 Replies
Just to start off im new to the camry family.I have a 2007 camry se. Well the the problem I am having is when i make a sharp turn or hit on the brakes hard my oil light flashes. Didn't know if this is a big problem or something small. the light flashes and goes rite back off.
View 14 Replies
I have a 2011 Hyundai Elantra GLS... Few months back I refueled my tank with degraded fuel (of course i did not know about it and some refueling stations in our country mix oils) and the problems started to arise with my car.. initially it all started with jerks and cracking sounds from the engine.. I then took it to the dealership and cleaned everything except the injectors but the jerking and cracking problem was solved.. but it still had a pickup problem.. whenever i tried to accelerate from 40km/h to above, the transmission seems to give a jolt make a clicking sound when downshifting.. and the acceleration compared to before has degraded.. I took it to the dealership again and their answer was drive it for 300 km more everything will b fine.. but i have driven the car for 1000 km more but the problem is not solving.. I don't know.. my warranty period is over.. in our country they only provide for 12000 km or 1 yr warranty.. now i have checked online and it seems Elantra transmission has bugged a lot of ppl..
View 19 Replies
My 2003 Hyundai Elantra makes this creaking noise when I come to a stop. It seems to make it when the weight is shifting back from a stop. It's not a brake noise. I've checked my brakes and they're fine. It's not even close to a brake noise. I was thinking it was the shocks or springs since it only does it after I've stopped. It makes this noise also while I am stopped and if I shake the car a little. Not too sure what this noise could be. I'm also hearing a new noise in the front. It a loud squeaking type noise that only happens it seems when I am stopping going down a hill or on hard turns. It gets very loud and I kind of feel a grinding in the pedal when it happens.
View 5 Replies
