Impreza :: 2010 2.5i - Clunking Noise When Slowly Drive Away
Oct 8, 2009
Every time I turn on my 2010 impreza and slowly drive away i hear a clunking sound coming from somewhere in the front. it happens almost every time i start it up, even if it is warmed up.
Went to the dealer (car is 4 weeks old) did a test drive and it only did it once for them of course even though we tried almost 10 times. What it could be and will take it in for a full day to let it get cold.
Also, a slight rumbling when the car is cold and the blue cold engine light is on? I know the car being cold explain that but you'd think that a brand new car would be free from things like that.
View 11 Replies
Advertisement
The car is under 25k miles. I have owned for less then 2 years. Recently, I notice a noise coming from the rear every time backing out the drive way. The sounds louder in the winter**. I have gone to 3 different dealers and non of them offered a remedy. Some say they cant reduplicate the issue so I scheduled a test drive with a tech. Was able to duplicate the issue, however the tech says its normal ( pad shift over time) and told me a lot of the newer carmy has the issue. I'm exhausted from going dealer to dealer and no remedy issue. They all said the same thing "its normal & there's nothing they can do".
View 2 Replies
Ive had a weird annoying clunking noise coming from the front of my car going very slowly you can hear it or just by sitting still turning the wheel. It also appears while braking a clunking noise as the weight shifts.I replaced all control arm bushing, cv joints, and ball joints. The only other thing I could imagine is tie rods so I got under the car and had my gf turn the wheel its not coming from the outer tie rod ends but towards the middle? I am curious if maybe its some time of bushing towards the middle.
View 6 Replies
I have an 02 Avalanche 1500 4wd z71. It has 173000 miles. Noticed a clunking noise under driver side when slowly taking off. If I floor it there is no sound at all. This only happens when vehicle is on 2wd mode. If I put it on auto 4wd there is no more clunking. The noise sound like two pcs of bare metal are hitting each other. What this could be.
View 6 Replies
2004 Santa Fe, clunking noise in drive or reverse. checked brakes and cv joints, replaced drivers front and still making the noise. Transfer case was a little low on fluid but not much. Put up on stands and turn wheels with no noise. Put in drive or reverse while in the air and rear wheels sit still. It is a 4wd so I would think that all 4 tires would be turning. While in the air the front both turn and no noise is made.
View 18 Replies
When I drive over bumps or dips my car makes this clunking noise in the front passenger side. I just had the front brake assembly replaced as well as the engine mounts but the noise is still occurring. what could this be and would it affect my new brakes in any way?
View 6 Replies
Alright so a friend of mine has a Ford Explore with the little switch on the dash for auto 4 wheel, high 4 wheel, and low 4 wheel. When it is in Auto it has no issues drives fine and good. As soon as you turn it to 4 wheels high and start to go all you get is a loud clunking noise constantly. Another friend had a similair issue with an AWD explorer that we just pulled the front drive shaft and it seemed to solve the issue. How would I test the driveshaft to see if that's the issue.
View 2 Replies
My 2009 Impreza 2.5i manual transmission makes a clunking binding when I turn. What the issue is it goes away and comes back.
View 1 Replies
So I have a 06 350 and I'm getting clunking from drive to reverse and now with drive too, I know my rear diff is on it's last days but I am wondering if that could cause the clunking and now my truck around 90km shakes likes crazy and same thing wana know if that's the diff. And if I was to fix diff myself would it not just be easier for me to just swap axles if I wanted to be cheap??
View 12 Replies
I bought (in November 2012) a 2009 Subaru Impreza. On a couple of occasions, when I put the car in Drive, it started going in reverse (in a flat parking lot). Each time, I put the car back in Park, turned the ignition off, started up again and it seemed fine - till yesterday. I was in a parking lot again, tried putting the car in drive and it went in reverse! A few times in a row, till I got so close to the vehicle behind me that I had to call roadside assistance... What's going on??
View 4 Replies
The front struts n my 2010 camry se with about 51k on it and it makes a horrible clunk and pop noise when going slowly on uneven roads and over speed bumps. I got out to check the cause and found it to be he top of the strut coming through the strut mount is making the popping sound and seems like it has more than normal movement... does this happen to many? is it a common issue...
View 2 Replies
When I'm driving slowly and turning over a dip or bump, like driving out of a driveway while turning, I always hear something in my steering assembly clunking. Is it something I can tighten up, like a bushing? I know it's not the usual the abs system clunk, and it's a different sound from the echo inside the tires one may hear at low speeds.
View 1 Replies
I had a problem with the CV Axle and the Wheel Bearings. I replaced them already and I ran into another issue with the Wheel Studs and the Ball Joint, so I ended up replacing them as well. Yesterday I put everything back together after replacing all the parts mentioned before and I made sure everything was bolted down and tightened, and then the tire back on and lowered the jack. I started up my car expecting it to drive just fine and it was harder to get into gear than before and it wouldn't move in reverse, neutral, or drive. I called a Monroe Muffler around here and they told me that the CV Joint is probably not seated all the way inside the Transfer Case.
So later the same day I took everything back apart and made sure that I put the CV Joint back into the Transfer Case and I put the pin back in and made sure that both CV Axles would turn at the same time, which they did. I figured it was good so I put it all back together again and went through the same process as before, making sure everything was tightened down, all the bolts and nuts and pins were where they needed to be. Everything seemed to be good. I put the tire back on again, lowered the jack, started the car and attempted to drive it again. It still won't move. Why this is happening.
View 1 Replies
Brought mine to the dealership they can't find the knocking noise. I asked the technician to Test drove it but still can't find the problem. Technician on the passenger side and we test drove it. He was able to hear it, but can't confirm if its coming from the pads or rotors. Its pretty anoying when driving at night when the roads are quiet. You can hear it even with windows close.
View 4 Replies
We're having problem with our Prius where car suddenly started to make weird clunking noise from the engine (28k miles, 2011 Prius). Car sounds unsafe to drive around, so I left it parked in the drive way. I did check engine oil level and it was at F level.
View 4 Replies
My concern is I have some intermittent clicking/clunking noise. What causes it is if I start out whether fwd or rev. Or if I am going slow in 1st gear and I let off the gas to slow down or press the gas to speed up (btw 1000rpms and 2000rpms) I was told this noise is the clutch engaging or disengaging, which doesn't make sense because when it happens the clutch is fully engaged.
I have had this noise before 2X and there were things that were loose, which were tightened up and the noise went away. This time local dealer told me sound is normal and to keep an eye on it. To me it doesn't sound right cause its noises I didn't notice before.
View 42 Replies
For the last few weeks (about a month) I have been experiencing a clunking noise/ knock on acceleration coming from either in front of my feet or below my feet (drivers side) ONLY on acceleration and only then from a full stop. I can also feel the clunk as well which leads me to believe it is a transmission mount.....maybe an engine mount. I am taking her to the dealer after work today. we had some very cold weather and I was hoping it was just ice but yesterday and today were well above zero and it is still there and it is EVERY time I accelerate. Which is a somewhat good thing since I will be able to replicate the problem for Hyundai.....
View 17 Replies
Yesterday I started my 2011 Prius, about 3 seconds later (Im guessing here) I pushed the A/C button, the engine started (at the same time), and I got this horrible grinding, clunking, bucking noise from under the hood. It lasted for about 5 seconds then stopped and everything was fine. Engine ran smooth, A/C was running. I turned off the A/C thinking that might be it and started it again, again everything ran smoothly. I pushed the start button the shut down the car, waited about 15 seconds, pushed it again, all normal, again with the A/C on. I put into drive and moved forward, allowed the engine to start, no problems. Smooth operation, everything normal.
I gather it'd be a good idea to take it in, but want to know how many "on-off cycles" until a problem is erased from memory. I did drive it last night (everything ran just fine) and went through 3 "cycles". What this could be? Bad fuel?? I have a 2011, with about 38k miles on it. This is the second Prius I've owned and have never had a problem before, let alone something like this.
View 2 Replies
I have been frustrated with my Elantra's handling from the time I purchased. I feel that the car is setup poorly and has design/OEM part issues.
I have improved the rear-end "hop" issue by replacing the OEM rear shocks with the KYB Gas-A-Just's -- a big improvement in handling the bumps. But the rear-end solid axle on such a light car is just crap...
I have developed quite a bit of 'clunking' noise in the front suspension.
I am considering replacing the front-end shock-strut assemblies with KYBs -- I'd love to hear if it made a big difference. Also wondering if I should change-out the 'sway bar link' while replacing the shock/struts.
I'm just so frustrated with the way this car handles (I've driven Subaru's, Honda's, and VW's) compared to other cars. I feel it's a combination of low-quality OEM suspension parts, rear solid axle, light weight, crappy electric steering settings, and tires that are too wide and too low-profile for such a light car. (I have the limited with 17 wheels).
View 2 Replies
Driving 2012 Elantra with 29K on the Meter in AZ with temps at 105 degrees. I am getting a clicking clunking noise. Dealership said Strut mounts and replaced them. Drove it off the lot and the noise was still there. Wont go back to that dealership. Creaking clunking noise more frequently now and has shifted from the passenger side to the driver side predominantly. End links? Axles? Brake assembly, Hub? I first heard it when I went over a speed bump at 3-5 mph. Now it can be heard upon acceleration-deceleration, deceleration in neutral with brake only gets the loudest clunk on the Driver side. Ultimately its now constant on turns, bumps, rough roads & even smooth roads while changing lanes. What is causing this.
View 5 Replies
Have had some issues with some intermittent clunking when I shift or let off the gas. It only clunks when shifting from 1-2 or 2-3 or when I am btw 1500-2500 rpms and let off the gas to coast a bit. There are times when it won't clunk at all or it does it all the time, I can shift fast or slow doesn't matter. The dealership I bought the car from couldn't find anything wrong on my last service. Also when I put the clutch in sometimes I hear a bit of a clunk as well. Also I notice moving the shifter from gear to gear when shifting feels very notchy, but most of the times its smooth.
View 8 Replies
