Lexus IS 2014+ :: Grinding Noise And The Hub Became Difficult To Turn
May 10, 2016
I am replacing the rear passenger hub assembly and as soon as i put a significant amount of torque to the axle nut...i get a crazy grinding noise and the hub becomes very difficult to turn. When I disassembled the old assembly it took very little effort to push the axle freely in the splines of the hub after i took the 32mm nut off. Now when i start to get the grinding, i remove the axle nut and it take some serious whacks with a larger hammer and brass drift to free the axle spline in the hub.
Ive dug around online and found someone that had to slip a couple pieces of wood in between the sheet metal dust shield and the end of the axle to fully seat it.
View 2 Replies
Advertisement
Experience a grinding noise at around 1500-1800 rpm when driving?
The noise sounds like the 2nd gen valve spring start up but not as loud.
The dealer was able to replicate the noise on my car but they don't know what is causing it.
They called the regional guy to come look at it but he doesn't have a clue where or what is causing the noise.
2015 350fpsort
30k miles
Noise starts at around 10K-15k miles and dealer couldn't replicate it then but I hear it everyday.
Update with video : [URL] ....
View 2 Replies
My girlfriend has a 2007, v6, Honda Accord. She had difficulty turning the steering wheel, accompanied with a loud noise. She took it to a local garage and they diagnosed it as a leak in the power steering hose which she had replaced for about $400. When she used the car the following day, the problem was still there and seemed to be a little worse. She called the garage and they said for her to bring the car back which we'll be doing tomorrow. Also, coincidentally, we saw that Honda issued a recall for this. [URL] ...... As a result, we have the following questions:
-Is there any recourse for full or partial reimbursement from Honday? After all, if we took it to Honda, then Honda dealer would bill Honda Manufacturer anway.
-Should garages be familiar with recalls?
-Assuming the local garage fixes the problem, do you recommend that we still take it to the dealership?
View 4 Replies
So I'm new to the all time awd car thing. I came from a 4x4 truck which 4x4 was never engaged on pavement or in tight cornering. When maneuvering my is250 awd in tight spots ie. parking lots and the front wheels are at full lock in either forward or reverse there is a slight binding/grinding feeling or faint noise. Is this normal on an awd car or Lexus specific??? Did a quick search and didn't find much about this issue. I'm pretty sure its not tire rub.....stock set up.
View 10 Replies
You can hear the clunky, groaning noise around 8 and 11 seconds when I turn the steering wheel, making a tight u-turn in an alley way.
What can it be..? I hope it has something to do with my tires since I'm getting new ones today. The current ones are pretty bald.
Quick video clip of noise...
View 7 Replies
I have a 2014 Prius C and for the last month or so it's sometimes difficult to shift from P. I always park car with handbrake. It's specially difficult if I push down hand brake before stepping on the brakes and car shifts a little while on park. Car has 35,000km.
View 9 Replies
I have cleaned the fuel injectors, put in new spark plugs and new spark plug wires. What else I can do. The only time it starts easily is when it's very hot. If I leave it off for just 5 minutes, it will start up quickly. And a few times, when it is dead cold it will start on the first turn. All other times I have to crank it for what seems like minutes. I'm killing batteries and starters on a regular basis.
View 2 Replies
I have a 2003 Subaru outback and sometimes when I go to back into a parking space or straighten out after pulling into a parking space my steering wheel becomes incredibly difficult to turn. It used to only do this when I was backing into a space but now it has started doing it when I pull forward into a space as well. This happens most often when I am driving to multiple places and have to park several times over a period of a few hours. I've monitored my power steering fluid and the power steering pump was replaced not too long ago. What's causing this?
View 1 Replies
I was recently experiencing problems with my front brakes. It sounded like it was grinding on something (it doesn't screech) whenever the speed reaches below 15 mph. I called up my dealer to take a look and upon investigation they told me that i needed to do the front brakes job but they could save the rotor (they charged me around $300). Is this common ? It is a daily driven car and i mostly drive on highways. I drive the 2014 RWD IS-350 F-sport model and just recently hit 17.8K miles.
View 14 Replies
When I start my car (usually a cold start) I hear a TERRIBLE grinding-like noise. Other times it sounds like a shuffling noise. And then other times it's like its over-exerting itself trying to start up. I've taken it to the dealer many times as it's a 2014 Corolla. They have no answers. The claim it's just a characteristic of the car. I call bull. This isn't normal for any car. My car has a CVT transmission by the way. Could it be the starter? Spark plugs? Note: the noise is about 1000x worse in winter. Audio is attached in separate comment.
View 19 Replies
I have a 2010 XLT, 85K, just started having a horrible grinding noise at start up for about 2-3 seconds, then gone. Going to dealer tmrrw. Multiple people said, possible oil pump hydraulics, ??????. Whatever it is, they say its expensive!!!!!
View 3 Replies
There is a grinding noise when i make a turn,when i straighten out it's fine,when i bought the truck in 09 i had a shudder problem but that was repaired by greasing the spline in the drive shaft. Truck has 59,000 and is coming up on the 60,000....
View 1 Replies
Recently had a coworker point out that my truck was making funny noises while it was backing up. It is a 2013 f150. It almost sounds like metal grinding to me. It does not do it while going forward either.
Have been underneath and can't notice anything out of place, although I'm not sure I'd notice if there was.
View 4 Replies
It was having trouble turning over for a few weeks, getting progressively worse, but we just didn't have time to look it over. Well, it finally died--now if I turn the key a couple times we got a grinding noise but mostly just nothing at all. The lights, radio, etc all turn on though so we were sure it wasn't the battery. Thinking it was the starter, we pulled that out and took it down to Advanced Auto Parts, but they ran a test on it and said it was still good. So we put that back in the car and brought them the battery instead--they tested it and said it was charging and holding voltage but not amperage, and that, that would mean the lights and things could come on but it wouldn't have enough kick to actually start the car.
So, we bought a new battery, went home, and popped it in. Still, nothing. My friend says it's not the alternator because with a fully charged battery the car would start even if the alternator wasn't right (and would just die in a couple days, at which point you'd know you needed to replace the alternator) and my car's still not starting. The last thing we tried before we gave up for the moment last night was checking fuses in the driver's side of the car and also under the hood, the handful we thought could be related to the starter, alternator, and/or battery, but they all looked good.
The only other thing I read about online with Infinitis was that if the security system was activated it wouldn't start, however, while I noticed the light for it is flashing which I'm not sure if that was normal before or not, I THINK if it is activated it would be solid red, and at any rate, I tried what I read online to unlock it (put key forward for 5 seconds, then off, repeat 2 more times, then try to start) and that didn't do anything either.
View 14 Replies
Just got a 2010 lariat supercrew...I put 1900 miles on it so far. When slowly letting off the accelerator (doing between 20-30 mph and between 1000-1500 rpm) there is a distinct rubbing sound for about 1-2 seconds...it is now sounding more like grinding now...took it to the shop today...(they couldn't duplicate (because service rep documented 60 mph instead of the 20-30 mph...went back at the end of the day to ride with the tech, and i was able to duplicate so now they have something to work with....also the noise happens mostly when the path of travel is either level road or slight to great incline..it has not happened on a down slope....
View 14 Replies
I have a 2013 XLT Scab that has been in twice now for a low speed to stop brake rubbing or grinding noise. The first visit they turned the front rotors and scuffed the pads, which seemed t fix the problem for about a month. The second visit they repeated the same process on the rear and the problem was good for about two months. Today while driving I noticed the noise, probably worse than I have ever heard. It seems like after about 20 stops the noise gets quieter. I am taking it back for the third time and I am hoping they will fix the problem for real this time. I am tired of burning my gas to get to the dealer and then having to ask my salesman for a loaner car. Other than this issue I love the truck.
View 6 Replies
Wife's 2010 F150 4x4 85000 KMs makes grinding / ratcheting noise in LH front axle when in 2 wheel drive. Mostly when turning left some times when traveling straight never when turning right. Never makes the noise when in four wheel drive. I am suspecting the auto hub is the issue but wonder if others have had this trouble ?
View 5 Replies
First off I have a 2009 F150 4wd 4.6L truck...we have noticed a grinding noise on the front driver side wheel...we have replaced the auto locking hub acuator and the hub assembly but the noise is still there....it has us puzzled now not sure what it could be. I have read many different threads on this issue an it seems that it might be something to do with the vacuum. The noise is only on the driver side and only in 2wd, when its in 4wd it doesn't make the noise at all. Also while in 2wd the noise seems to go away when we let off the gas.
View 5 Replies
Just installed new actuator and wheel hub assembly on my 2009 f150,truck still had grinding noise in front passenger wheel , New solenoid and vacuum hose kit installed when test drove noise still there until you put the truck in 4 wheel drive it disappears . The noise returns as soon as you take it out of 4 wheel drive. Also mechanic said steering was tight,installed new shaft same thing, could this be the rack and pinion.
View 5 Replies
I have 35k on my 2009 camry, (past warranty). All of a sudden in the last few days when I make a sharp left turn (like into a parking spot) I hear a grinding noise from my car. Not really a full on grinding, but like a quiet fart can muffler noise. No issues with alignment, driving straight, or sharp right turns.
View 5 Replies
Coming to a left turn signal I was anticipating it turning red on me, and I drove into the turn lane briskly 30mph and then applied brakes as I made a u-turn. It sounded like a cross between dragging the front air dam and metal on metal brake grinding as I made the turn. Stopped immediately and did not scrap the air dam and all front end components checked out, okay. Car is driving just fine now, has only done this once.
View 18 Replies
