Lexus LS 2007+ :: Error Messages After Replacing A Battery
Apr 11, 2016
I put a new battery in my 2007 LS460 and it lit up all kinds of vsc, brake, abs, pcs, stop the vehicle immediately, etc. A 30 minute freeway trip, then 1 hr turned off has not changed anything.
Background: no warnings before the dead battery, but the rear window would reverse when it got part way. I was monkeying with it, and found the weather seal crimped right there. I left the ignition on by mistake. 8 hours later, the 1 year old battery was dead. I hooked up a good charger and it nearly cranked 20 minutes later with the charger connected so I left it until the charger said it was done and unhooked it. There were no dash lights and my voltmeter read something like 3 volts.
I pulled it out and replaced it, which cranked right up and runs great, but has all these errors. I'm having trouble walking right now, but when I get a chance, I'll check the voltage on the new battery in case the car isn't charging, but I would have expected the two long drives yesterday to kill the battery again if it wasn't. I also have a ScanGaugeE which I may use to read and reset the codes.
View 4 Replies
Advertisement
My wife suddenly had error messages today, Check AWD System, check engine, traction. Carista reports P0138 O2 sensor high circuit voltage bank 1 sensor 2and also C1241 ABS low battery positive voltage. I get the O2 sensor or wires could be bad, but the C1241 could be expensive ECU. Think both could happen at same time or just a thrown code? Reset turned warnings off but Carista reports permanent for P0138.
View 5 Replies
At the time of starting the engine up, there is a warning "OIL MAINT. REQD SOON" but it goes away after when the motor is running. How to turn it off?
View 6 Replies
I left the lights on last night in our Santa Fe, and drained the battery.
Took the battery out and up to O'Reilly and they recharged it for me on their charger. When re-installing the battery the car alarm goes off as soon as I attach both battery cables. Turning the key in the ignition doesn't kill the alarm.
How do I reset the alarm and shut it up?
View 5 Replies
2010 GTI. Just got back from a business trip, hasn't been started for a week. Turn key, just clicks at me. Dash flashes and threw up half a dozen error messages from ESP to ABS to AFS/headlight. Battery seems fine. I, unfortunately, do not have a windows laptop handy currently so cannot hook up vag-com. Does this sound like a starter? ECU? I do have APR stage I and I was NOT able to access via the cruise control set function which has me worried that somehow it has engaged lock out mode? At this point, I appear to be headed for flatbed, dealer and major wallet damage.
View 3 Replies
Read previous post about the clock and battery. But I've replaced the car battery and the clock still isn't working. It gets stuck at whatever time I set it to. And I've also noticed the colons do not blink on the clock.
View 4 Replies
I posted recently because my '05 Touareg had been in twice for a "coolant overheating" error when the car was driven less than three minutes after a long cold start. They replaced the main computer and I had it back for a week and everything was fine. This morning, the same error occured. We took it in. When my husband drove it to the dealer, the warning went away after several minutes. They said that the error never logged on the computer and there's nothing wrong.
One person had responded last time with the sensor issue but got it resolved. I am really concerned about the possible problem that they can't seem to fix. They seem to be ok with it.
View 1 Replies
My F250 is displaying error messages for the hill descent/advance trac yet again. My truck was in the shop over 7 times about 6 months ago when my instrument cluster would go crazy. Every warning possible on the display, and once you killed the engine it wouldn't start until the dealer cleared the codes...once they flew in an engineer he fixed it within a couple hour timeframe, and I thought that nightmare was over.
View 2 Replies
My truck is back in the shop for a third time for the same problem and the dealer is really clueless about anything. Here are the alarms I get when trying to start( Low Oil Pressure, Service AdvanceTrac, Engine Overtemp, Wrench Icon and Starting System Fault.)
When trying remote start nothing happens then the horns honks after a couple of minutes.
Below is the timeline and a video.
July 21, 2015 - Vehicle would not start, multiple alarms going off and dashboard has all icons showing. Towed vehicle in around 0700. Truck stayed in the shop overnight. Resolutions was told that the codes was reset and battery cable was tighten. I ask why the battery was loose when it was just in the shop for routine maintenance and it was signed off that it was good to go. I also told the service representative that I felt this didn't not solve my problem as it was just a quick fix.
Sept 4, 2015 - Problem is back, same symptoms, truck not starting, alarms going off, dashboard has all icons showing. Towed vehicle in around 1700. Vehicle stay in the shop for a week and was picked up around 1800 on Sept 11, 2015. Service representative stated they replaced the PCM and reprogrammed the keys.
Sept 12, 2015 - Yep you guess it, same problem and not even a full 24 hours from when the vehicle was towed to the dealership again. Truck wont start, same symptoms, alarms going off, all icons showing. Towed vehicle in around 0900. Vehicle would start now but check engine light is on. I have an inclination that all that will be done is to reset the codes.
2014 F250 6.7 Starting issues - YouTube
View 14 Replies
Just bought a 2012 F350 6.7 4x4 in the beginning of March. After about 500 miles the "Exhaust Fluid System Fault - In 50 miles, speed limited to 50 mph" message displayed. So first thing that occurred to me was maybe it was low on DEF, so I added approximate 1.5 gallons as it had some already in there. I also called the dealer who said "well it just needs to be driven on the highway" hmmm, that sounded weird but I did it anyways. After that I started the truck and the message was gone. I thought that fixed it. - Nope, at about 1480 miles I got the same error message again.
So after getting the message again I just kept driving and the message went away. I thought ok. Yeah right! Now in the past few weeks I have been noticing that the truck almost wants to stall and begins to shudder when going over a slight incline and shifting from 5th to 6th at about 45mph. When I accelerate it makes a knocking noise. If I let off the accelerator, let it slow down, it downshifts into 5th and I then accelerate and it goes away.
And today... I decided to go for a nice ride. After about 10 minutes of driving I get the ole "Exhaust Fluid System Fault" error again. Crap! Again, I keep driving and after another 15min - I get that shutter and knocking noise. Anyway I drove until the the truck displayed "Speed limited to 50mph on next restart. I just kept driving and the error message mysteriously disappeared again.
View 6 Replies
One of the LED lights in the front overhead panel appears to be burned out. How do I replace this? These are the lights up next to the sunroof controls. One switch controls three of these LED's. I'm hoping this is an easy repair.
2007 ES 350.
View 1 Replies
Replacing or cleaning speaker grills. Previous owner has alot of marks on mine and was considering replacing the fabric or cleaning them. The marks are scuff marks so I am not sure that the will come off easy.
View 4 Replies
I need to replace the original driver side HID bulb on my '07 ES350. I intend on doing this myself. I found the thread that listed detailed steps which I'm sure will be very useful.
Any tips as far as getting to the actual bulb? It looks pretty cramped in that area.
I have the adaptive headlights that turn with the steering wheel. Any special steps needed for this headlight?
View 4 Replies
Just picked up a Ctek 3300 battery charger for my 2008 LS460L since we only drive it a few days a week. Is it safe to connect directly to the battery under the hood?
Where is the ideal spot to jump start on an LS? Reason I ask is that my BMW 6series have the battery at the back trunk but for any charging or jump starts it must be done under the hood where there is a terminal that goes to the battery.
View 8 Replies
The clear cover on the directional signal on the right rear view mirror was smashed in a parking lot. I have purchased the replacement part but am looking for instructions as to how to replace it.
2010 es350
View 3 Replies
I wanna know if I can take a regular car battery 500-600 cca to replace the old aux battery.
View 9 Replies
I drove the car yesterday night for about 30 mins and parked it at home and after one hour went back to start the car but it wont start. All the lights working fine it gave me an error saying check VSC system and whenever i start the car it gives me sound zzzzzzzzzzzzzzzzz and ends with a fan sound but wont start ...
View 14 Replies
Suddenly got the "check tire pressure system" error (not the tire pressure one) so I tried the only procedure I could find, turning ignition on and holding reset tpms button below steering colum. Got the tpms resetting message but the previous message came back. How can I fix that issue? Never had that before.
View 14 Replies
1. I think my battery is getting weak.... when i cranked it, it didnt sound strong and the original battery eye says to add distilled water. I am thinking about getting a replacement battery at Costco.
2. so right after it started, the message of "Check Brake System" shows up. Tried to restart but no go. Drove about 15 miles and all seems fine but message is still there.
* is it OK to replace with a Costco brand battery (they have a great returns policy) and is there anything i need to do before or after replacement?
* could the Check Brake System be due to the weak battery? How can I reset it?
* Anything else that can cause this error message?
View 3 Replies
So I just bought a used 2007 ES 350. One week into ownership the check engine light, vehicle stability light (car with swerving tire tracks) and check vsc lights all come on.
I got the codes read and they are C1201 P0057 and P0161.
The last two I believe are oxygen sensors and the first is a vague engine control problem?
The lights come on for a few days, then go away for a few days.
The non-Lexus dealer who sold me the car sent me to a mechanic who says the lights will likely go away all together if we just replace the correct O2 sensors.
The car also vibrates when moderately applying the brakes at speeds higher than 60 mph- is that normal?
View 3 Replies
I have a 2007 GS 430, 126,000 miles. Initially I had one faulty headlight that would not work but after turning the switch off/on, it would work again. Eventually both headlights started malfunctioning. After reading other forums, we elected to change the headlight bulbs. So far that has worked. However, after changing the bulbs, the VSC (Vehicle Stability Control) and check engine lights came on. After running the headlights and using the car to go to/from work with about 4 stops and restarts, the car reset itself and the warning lights turned off. Scared me at first because I had also just had suspension work done. However, the Headlamp Level Control System is part of the VSC system, which makes sense, just wasn't prepared for the warning lights.
View 1 Replies
