Lexus RX 2004-09 :: Misfiring And Check Engine Light Codes
Apr 25, 2015
The car was misfiring and the check engine light codes were all sensor coils were bad. Lexus told me that it was coil6 bad and they fixed it. I should have had no problems, I got a whole 2 miles and I misfired and engine light back on. I drove for a while and light went off and then misfired again. Before I bring it back in I was looking for some insight. I can't understand how it wasn't fixed right the first time but I don't want to go back and get a few thousand bill either. Could fixing one coil cause another to go bad.
View 1 Replies
Advertisement
It all started after I refueled at Mobil after a rainstorm a month ago. Could be coincidence, but right after that the car started jerking wildly and making a howling wind noise from the front. Thought it was the transmission. Brought to Lexus dealership, they told me nothing was wrong as I had low mileage on the car. There are NO Check Engine lights on the dashboard. Car "quieted down" after that, but the noise remains EXCEPT at high speed when it's quiet.
In addition to that, the jerking / misfiring continues at stops, reversing, and slower speeds on occasion only.
I tried Techron FI cleaner, but it has not made a difference. Filled up several times since then.
What's wrong?
View 14 Replies
My 2004 f150 has always been great to me. all the way till now at 255k miles. My truck is misfiring really bad. Here are the codes I have :
P0506 low idle (because of the misfire)
P0356 ignition coil F (6) primary/ secondary circuit
P0308 Cylinder 8 misfire
P0174 system too lean (Bank 2, right side of engine)
p0316 misfire detected on startup
This problem happened 2 days ago. I reset the codes and they all come back together in 10 minutes. the misfire is very bad. I wonder why coil 6 has a fault code but number 8 has the misfire code.
View 1 Replies
I have a Lexus es300 1995 and lately its been acting crazy. It all started when I had to push the pedal all the way down just to get to 60 mph and when i took my foot off the pedal the car almost stopped completely, would not coast well. Then the check engine light came on. Took it to dealer got codes p0500 and p0720..they said get a new ecm and dash cluster. Got both used from a junkyard. Car drove fine, then check engine light came on again and drove crazy again.
I was told the ecm needed no programming just plug and play ..is this right? Did I get a bad ecm? Coud it be another problem?
View 8 Replies
I have 2007 ES350. I was driving then check engine light and VSC popped on. I went to autozone then they said p0776 & P0746. The car is still driveable. I can still drive it on the expressway. The shifting from 1-3 isn't smooth. I'm going to take it to a transmission shop.
View 3 Replies
I have a 2005 Prius with 131k miles. The check engine light came on. I had my mechanic check for codes, he had 3different scanners. There were no codes posted. Next day light went off. It has been off for a week. Now it has returned.
View 5 Replies
I have a 2008 Prius that I purchased used last year. It has just shy of 139,000 miles on it. Recently the check engine light came on, and I dropped by AutoZone to have them pull the codes. They are as follows:
C1241
P1121
P3193
I haven't been able to find a full explanation of the codes online, so I need to know what they mean, how much it would cost to fix, and how urgent the repair is. I will be going on a 5 1/2 hour road trip next week, so I want to make sure I'm not going to break my car (or myself!) by doing so with the engine light on.
View 6 Replies
My check engine light comes on intermittently, fuel consumption normal. I have not had any noticeable performance issues. I took it to O'Rielly's for a scan but they could not establish a connection to get a readout. Is there a special scan tool needed? The on board Lan Monitor shows EMV codes below, are they meaningful in any way?
Code Sub-code
01-DC 190-38-5
01-D5 190-52-F
01-D8 190-35-1
01-DB 190-11-F
01-DB 110-21-2
View 5 Replies
Just last week I bought a 2007 prius from a local dealership in Houston. The check engine light recently turned on and had it checked out by an auto parts store. The codes they read were the p1116 and p1121 (issues with the coolant valve). I know it would cost much to replace the valve, and I am not wanting to pay that much, especially since i just bought the car. I'd also be willing to fix it myself if i had some guide or step by step instructions...
View 3 Replies
My 2004 Cadillac CTS 3.6L started running rough, check engine light flashed on and off. Codes P0300 and P0303. The car has about 119000 miles. Could this just be the plugs? The car has been running fine up to today.
View 2 Replies
Alright, so I was driving along and everything was fine, I had no error lights and the car was running perfectly. I accidentally went over a lip of this parking lot a little too fast and all of a sudden the check engine light came on!!! I took it to Jiffy Lube and the codes I got were : c1253, c1311, p0011, and p0012. Is my car safe to drive tomarrow? Are these super expensive to fix? Could they have been set off from the curb?
View 2 Replies
I have an 05 F-150 Lariat 5.4 and it has been going haywire today. While driving if I hit a hard bump the power will cut off (radio, a/c) and even sometimes the truck. Check engine light came on and I pulled codes P2160 & P0506. Also, when it completely cuts off and I start it back up it says "engine in failsafe mode".
View 1 Replies
Yesterday out of no where my rio started to misfire so i immediately took it into autozone to have it checked. when doing so the check engine light was on, but solid.
The tests came back with P0300, P0301, and P0302 or 3. I cant find the papers, but its 3 cyns that are misfiring. The guy at autozone suggested i try changing out the plugs first since its cheaper and has been known to fix this issue.
The second I bought the plugs I went home and changed them out. once finished i started up the car and not only was the car still misfiring, but the check engine light is now flashing... I did notice one thing when changing the plugs.
If facing the engine the second coil from the left had a bit of what looked to be rust. i was able to wipe it off with ease. What my next move should be?
View 9 Replies
I recently bought a 2003 nissan maxima 134k and i bought it with the p0300 check engine light on a looked at the engine and though it was an air box problem because they had previously installed a K&n filter so I went to the junk yard and got a 2000 nissan maxima air box and new filter i changed the oil and checked the spark plugs they look new and the dates on the coils are 2012 and 2013 and still its misfiring. i bought it to a mechanic and he discovered a vacuum tank had previously broke and they glued back together so i replace that with a factory one today same problem still misfiring but it got better but now its a p0306 then i erased the code and p0304 came back i erased it then p0302 came back then i change the cam sensors, and the crankshaft sensor and now it get a p0300.
Symptoms:
*when sitting for a long time HARD TO START ( takes multiple cranks to start it ) but once i leave it off for short time like 30 min it starts right up no problem
* when stop at a stop light in drive i can feel small little explosions sounds like my car is beat boxing
*performance is strong good acceleration no problem on that i just don't want it misfiring
View 14 Replies
i have a 2008 santa fe with a 2.7 61,000 miles 2nd owner ,out of warranty. It started missing and the check engine light came on. I took it to a local parts store who put an analyzer on it an it showed the #3 spark plug was misfiring. I am hoping its the plug. I do my own work but havn`t been able to find a correct sequence to replace the plugs.
View 3 Replies
To start off with I am not car smart! I have a 2008 Santa Fe 3.3L V6. Last year about this time (December) I had problems with the vehicle upon start up would be miss firing and the check engine light would come on. I would turn the vehicle off and restart and it would be fine and not happen again sometimes for a week and sometimes for months. I hooked it up to the computer and found that it was missing on the #6 cylinder. I had the coil pack replaced and that seemed to fix the problem (replaced spring 2011). About a week ago it started doing the same thing (December 1). Upon initial start up when the car is cold and the outside air is very cold it started missing again and having a rough idle. Would turn of the car and restart and would run fine but check engine light would come on.
Hooked it up to the computer once again and it read random misfire. This has happened twice now in two weeks with the same reading each time. Always when it is cold (engine and outside temp) and seems to reset itself when turned off.
I spoke with a mechanic who recently had this same issue with a different vehicle and after trying many things replaced the engine coolant temp sensor and that did the trick. He said it was a cheap start therefore i bought the part and now am looking to replace it. The only problem being i am car dumb and cant find it. I have done many searches and the diagrams i have found don't do me any justice. The past posts on here have given pictures of older models that dont match what i am looking at. It probably is right in front of my face. Any picture of a 2008 that will show the correct area I should be looking at? The vehicle only has about 57,000 miles on it.
View 9 Replies
While driving up a long hill on the highway, one of the cylinders quit firing causing a bad engine vibration and check engine light. I turned around and drove home, pulled the plugs, and found the plug closest to the passenger side had bridged. I'm not sure why; it almost looked like it melted or had some sort of physical damage. This was on a 2013 Sonata Limited 2.0t with 45000 km / 28500 miles.
Pictures here: Spark plug failure - Album on Imgur
View 6 Replies
I have a 1996 ford taurus lx v6 3.0 dohm..my check engine light flashing. then it stop flashing..i did replace spark plug,wires,coil pack..when it start to flash i put it gear the car start to shake and sputter.i really don't know why its doing that the car has about 150000 miles on it..i do get a code p0302 Cylinder #2 Misfire..the new plugs and wires and coil pack is about 2 weeks old..
View 11 Replies
08 RX350 with ~100K miles. Two weeks ago the Check Engine/TRAC light were on, VSC light blinks, so I tightened the gas cap, and pull the negative and cleared the code. Hoping this is just a gas cap issue.
2 weeks later all those lights are back again, so my mechanic pulled the code and came up with P0128. He told me it should be the problem with the Coolant Temperature Sensor. The water pump, thermostat was replaced last year and coolant level is OK. No issue with coolant temperature and the car drives like normal. My mechanic cleared the code and told me to drive it again until the lights come back and he will pull the code again.
08 RX350 AWD
08 Avalon Touring
View 5 Replies
Just got the car last week and now my check engine light is on and VSC lights are on and wont go off? 2006 w/ 75k miles on it...
View 13 Replies
My 2004 Lexus RX 330 with 116,000 miles has a check engine light on. The code was P2198, the problem: Bank2 Sensor1. I replaced the O2 sensor myself, easy, at $180. I erased the code and the check engine was back on the next day. Not sure what to do next.
View 9 Replies
