Passat (B6) :: Headlamp Bulbs Replacement In 2006 VW
Aug 15, 2010
My front dipped headlamps both burnt out within days of each other and I replaced them with H7 Sylvanias. Pretty easy to get out, but they are too dim. I believe I do not have them installed properly.
Looking for PDF for this replacement procedure and/or give a description of how this is done???? It is kind of a bugger to get inside that housing. I am a mechanical novice with cars, but a competent M1/M14 gunsmith. I really can't justify paying VW $50 to install a few bulbs. I like fixing things for myself.
View 23 Replies
Advertisement
Is there a DIY on how to change the headlamp bulbs, DRL and turn bulbs? Do i need to remove the bumper cover and/or headlamp from the car or can i change the bulbs with the headlamp in place?
View 3 Replies
I know the instructions are somewhere, but I am having trouble figuring out how to change the headlamp bulbs (high & low beams) on the easy side-driver side. Do I need to loosen the headlamp assembly or can I just go into the headlamp assembly without removing it?
View 3 Replies
Just replaced my bulbs with the Garax 6000k and they look good but now my check engine light and VSC light is on. Problem started after changing bulbs? My pops said it should go away but we're not sure. Is there a way to reset it and get rid of the lights?
View 3 Replies
I need detailed instructions for how to replace the right (passenger's side) rear turn signal bulb socket and the subassembly that holds the remaining bulbs and inserts into the tail light assembly. I've done this once before successfully but now can't seem to make it work now.
Without the subassembly inserted and locked into place with its locking tabs, the turn signal bulb locks into place in its socket, and that socket in turn easily inserts and locks into place in the hole in the outboard corner of the lens through the rear of the lens assembly. However, I can't seem to install both the turn signal bulb in its socket and the subassembly that holds the rest of the bulbs. The two contacts on the underside of the rim of the turn signal bulb socket would indicate that that the socket installs after the subassembly, but then it has nothing to plug into. When it's installed first, I don't see how the bulb would be energized.
The owner's manual of course says to have the dealer handle maintenance in this area.
View 1 Replies
How to replace the side marker light in the headlamp?? Without taking of the grill and the whole head light assembly? I don't want to go through all that work for that little bulb.
View 1 Replies
I tried doing a search on how to replace the License plate LED bulbs...
Looking for pictures or instructions on how to replace them...
View 2 Replies
Just discovered moisture on the inside of my front left headlamp housing. I called the dealer and asked if warranty would cover it. The dealer said yes as long as there are no cracks in the housing, of which there is not. Have other members had the lens seals leak on their Accents? While the car is in the shop, I'm also having them check the pulleys, as theres quite a bit of movement side to side at idle. I also noticed alot more vibration at idle, enough to vibrate the front plate and the radiator trembles like crazy at idle. Does the main pulley also act as a counterbalance? If so, is there a pattern of those going bad?
View 5 Replies
So I noticed the other night that one of my LED's on my headlamp flickered while they were on, with the key in ignition. As of today, the driver's side LED light went out. Where to to tap into to make an attempt to figure this out. Wires and connector seem to be all in tact.
View 5 Replies
I am looking into replacing my cab light bulbs with amber led's. What ones do you recommend? There are so many available out there. I don't want some cheap crap! Also, what is the bulb type in are in the mirrors for the parking light and turn signal?
View 2 Replies
My driver side door has not been working for about a month now. It started gradually opening after a million tried but now it just wont open. Tonight one of my lamps stopped working when I was trying to install HID's. I suspect the fuse is burned out but cant get to it cause the door wont open. How can I get my door open. Need headlights as I get out of work late night and dont want to get pulled over for a headlamp being out.
View 8 Replies
How to change the timing belt and water pump on a 2006 2.0t passat?
View 3 Replies
I tried to convert the bulbs in my dashboard with LED bulbs..and it worked for about a month and stop working..then about a week after not having any dash lights. They came back on...but like a strobe, but not all the time..... And then it'll be fine? I'm also looking Into doing a taillight conversion to LEDs.
View 2 Replies
Having trouble finding h7 xenon bulbs anymore. Most say discontinued and the ebay crap burns out right away.
View 1 Replies
I recently tried to install some LED bulbs in my ride. And they all worked except the map lights in the front. I removed them all and now no lights work when I open my doors except my foot wells.. Any one know whats up?
View 7 Replies
Is this any easier in my 2004 VW Passat than it was in my 2001 VW Jetta? In the Jetta, I had to disconnect the battery and dislocate my elbow and wrist in order to get my hand in the awkwardly placed compartment. Also, is it worth stepping up the original OEM to high intensity bulbs?
View 11 Replies
I just replaced the interior bulbs with LED's (3 Chip SMD's). The bulbs in the glove compartment and overhead rear lights remain on but the ones under the dash (driver and passenger courtesy lights) turn off within a few seconds. What could be going on.
View 8 Replies
Any tricks that will make this job easier? They seem buried and when I reach I am only guessing as to what I am pulling out. For example, I pulled out a round cover, but what was it covering up? Must the bulb be twisted and then pulled or just pulled?
View 7 Replies
I have a 2006 VW Passat which has been eating low beam bulbs. I've probably replaced this one 4 times in the last 12 months. The last time I replaced was 2 days ago with a Sylvania bulb. Yesterday on my way to work it burnt out. Then on my way home last night I was pulled over by a cop for it. That really annoyed me.
Having issue with Passat burning through headlight bulbs? Do I need to have the wiring assembly checked or possibly replace the entire headlight assembly? I'm getting really tired of changing these bulbs so often.
View 7 Replies
I ordered a set (to go into the headlight housings, the little corner one). They don't work and I have the headlight out on my dash. I assume it needs to be VAG Com'd? If so, what are the settings?
View 5 Replies
I recently had my ignition cylinder replaced at the dealer. Immediately after this repair, I noticed that several lights were out - lower left radio, lower left dashboard, lower left steering wheel control, some light controls, and drivers side daytime running light. I brought it back to the dealer, and they told me that it was a coincidence that all these bulbs burned out at once (and all on the lower left side) and is not related to their repair. I'm not convinced.
View 2 Replies
