My V10's steering column has lost the ability to adjust up and down. In and out is still fine though and the position memory works, just for in and out too. I was thinking that a fuse may have gone but I can't see a fuse dedicated to this in the manual. No doubt it'll be something much more complicated than that though.
View 7 RepliesMy 2008 250 suddenly lost ability to adjust temp control of heat and A/C. I can adjust the fan speed and the defrost/dash vents/foot heater position controls, but no matter how far I turn the cold/hot dial left or right, the temp is the same. Even in the Max and Norm A/C setting, it's the same temp, which is stuck in the hot range.
View 10 RepliesI picked up a golf mk4 with low miles on it and have been working out the bugs - so far I changed out the dreaded power steering rack starter crank position sensor - dam theses cars are tough to work on but I actually enjoy it and could not have been successful without vwvortexx guiding me through- got a ton of suspension parts waiting for me to put in but I have this problem that's dogging me - searched like crazy couldn't find anything ...
When I adjust the steering column the engine "skips" and when I push the wheel in and out (as opposed to up and down) I can actually get the engine to cut out completely. (I should also mention that according to dealership receipts the PRNDL switch has been replaced along with repairs of wiring harness)...
My W12 Steering wheel seems to no longer adjust in the up/down range when I use the button on the side of the steering column. It does move in/out. Is there a way to reinitialize or calibrate the steering wheel.
View 1 RepliesBeen monitoring this excellent forum for a while, having taken the plunge last year. The car is stunning, although I have been waiting for a gremlin or two for a while now and it finally seems to have happened.
Having set up the driving position using the excellent forum guide, all was well. Last week, however, the steering column failed to move out from the dash to the memorized position. I have tried manually, to no avail. All other motion - up, down and away appear to be normal, just the switch or motor that moves the column towards the driver.
Looks like I've got the classic electric steering column failure. It still works in and out but won't go up or down. I think it won't go up as the column is at the top of it's travel. I can hear a click from within the column when I press the up button but nothing when I press down. So I've done a quick search but I can't find the post which shows the replacement of the wiring. It's probably me being stupid and it's starring me in the face. Also I've got no warning come up on the dash is this a good thing? I haven't plugged the VCDS in yet I'm not expecting it to show anything.
View 6 RepliesI was driving yesterday evening when my car started to cut out, it kept restarting as I was doing 70 on the motorway. So I decided to pull over.
I restated the engine and all seemed fine. Until another few miles down the road To my driveway where it again cut out.
As it stands now it will start but cuts out after a minute or so and will not re start unless I take the key out and keep trying.
I had the car scanned by a mobile mechanic who told me my steering column was the only thing that scanned up. Which made sense because a few days ago an airbag warning came up and stayed up.
I have read up a bit about the steering column on the passats which have the exact same symptoms of cutting out the engine. Could this be the same with the phaeton?
The car is a petrol 3.2 litre that also has an lpg conversion. I don't know if this makes any difference?
My 2003 made a sharp mechanical noise one day, next thing I knew it lost the ability to shift out of 2nd gear....Now, it can still shift into 2nd gear when cold, but only after holding rpm for a bit and then suddenly jerking into 2nd gear. Once it's warmed up for a few minutes though, after dropping out of 2nd gear, that's it! Then it's stuck in 1st gear the rest of the time. Reverse doesn't work anymore at any time, and it gave me code P0732 to P0734 which should be gears 2 - 4. Is it possible that not being to get out of 1st means 2nd gear is broken, but the other 2 are okay and it just can't get shift past 2nd? Or might all 3 have problems after all?
View 1 RepliesMy 2001 Santa Fe 2,4l - Have suddenly lost the abillity to shift gear. Its stuck in 2 and the shift stick is very loose in the "front to back and back to front" motion.. in other words there are resistance sideways.
I suspect it to be a broken shift cable. So my question is : changing shift cable on a santa fe easy? Is the best approach to start from inside the vehicle or from transmission side?
Just the other day the radio in my 06 Subaru Outback lost the ability to pick up an AM stations. Is this going to be expensive?
View 8 RepliesI have a 99 F250 5.4l 4x4 Super Duty that just all of a sudden stopped going over 30mph. I was traveling down the highway at 70mph and all of a sudden the truck acted as if it were in neutral and started revving up. i let off the gas and the problem stopped. i went to pass someone and it occurred again. I slowed down to 65mph and a couple minutes later it did it again. I wasn't too far from home so i drove it there. By the time i got around the corner I had the truck in second gear to prevent me from going over 25mph. i allowed the truck to rest and then checked the transmission fluid and everything looked good. There was a slight squeak that had just started and appeared to be coming from the drive shaft. I am mechanically inclined but new to working on vehicles..
View 7 RepliesI bought my outback a few months ago from a dealer/mechanic who had fixed the car after it was totaled. So it has a reconstructed title, but it was hit in the back, so all the engine parts were unaffected by the crash. Since I have had the car I have experienced intermittent loss of power steering ability. Sometimes it's nearly impossible to parallel park or turn a corner gracefully, and other times, within the same short trip, the steering will be completely fine and smooth. I have had the issue looked at about three times now by different mechanics. Each time they have either replaced or tightened the belt, which temporarily fixes the problem. But within a few weeks it always comes back. Is there something not keeping the belt tight, or could the issue actually be in the power steering pump?
View 3 RepliesJust recently lowered my 3is and noticed a significant lost in low beam range. How to adjust the low beams or is everyone else just driving with 5 feet of vision at night ???
View 5 RepliesAfter small collision with dear my right front headlight was replaced, but it is misalignment. I read few post about adjusting, with VCDS and mechanical. My main problem is that I unable to turn adjusting screws, I can turn it 90 deg right or left I feel that the only mechanism deforms, but no lens move at all. Is it something blocking? I was trying with VCDS and without, with key on and off ...
View 2 RepliesIs it possible to increase the steering boost, so that the wheel is easier to turn -- like with VAG-COM? I'm not a big fan of the heavy steering.
View 5 RepliesMy father who is elderly, has difficulty disengaging the steering column lock on his 2006 Saturn Vue. I also have experienced this problem even after trying to rock the wheel back and forth while trying to turn the key over. This appears to be a known problem and we have had to tow the Vue in for have the cylinders "de-burred," but the problem persists. He has had many vehicles with this feature in the past, but we have never had any problems before. Does this feature can be disabled. I am afraid he will be stranded some place away from home because he is unable to get the car started. I realize this is an anti-theft device, but it that is a risk we are willing to take.
View 6 RepliesMy steering column lights are very dim. How do i make them brighter?
View 9 RepliesWell I think I am finally getting to the end of my lighting problems. I have them all working except for the lights on the turn signal lever, the windshield wiper lever, the cruse control and the steering wheel. So all the light on the steering column are out. I cannot find a bad fuse. Which fuse it might be, or some other items to check?
View 2 RepliesIt's a 2006 2.0 Turbo. It died last night, had it jumped, drove it 2.5 miles to get gas & wha-la ...dead. Since it was late had it towed back to the house (it's just me...no other car available). I've researched until after midnight and started seeing recalls, tsb...and not into anything about cars except counting on them! It started smelling like sulfur after many attempts to charge the battery..
View 4 RepliesSo as some have seen I have been having some startup problems with my Passat (06 2.0T, 40k miles). Took it to the Indy shop near me and he said it was a problem with the steering column lock/Interpol system and he did not have the software to do anything more to it, so I will probably be taking it to vw tomorrow. What does the Interpol system do, etc. literally any info. Also I assume this is an electrical system? Any chance it's covered under extended warranty? Calling vw today to see what they say about it as then probably going to drop it off tonight.
View 3 RepliesI have been running into new threads here and other places with the no start/column bad need to replace. Something smells really bad here.
View 24 Replies