Lately I've been getting the Stop! Car too low! message when I start the car if it has been sitting more than 6 hours or so. the front appears to be too low. After 20-30 seconds, the front end raises up high enough and the message goes away. It didn't do this when I first got the car. I'm going in for my 80,000 mile service soon.
View 17 RepliesI have 2004 V8 Phaeton ,the message LEVEL FAULT WORKSHOP. keeps appearing ,then disappearing, sometimes it will stay until the car is turned off,. When it comes some times even on long highway journeys I wont see it at all!. When it comes on nothing seems to change.
View 6 RepliesI can not start the car by pressing the Start / Stop button. The display shows the message "Key Non found". Remote control key with normally opens and closes the car but the car itself does not open the approach to it. I have two keys and the two are the same.
View 7 RepliesI started back up again and 10 seconds later it came back on, but then went away for the rest of the 30-minute commute. Went out during lunch today and there's no message.
I'm gonna do a vagcom scan when i get home, but wanted to know if there's any history of brake fluid leaking and needing to be topped of.
I have received this alert a few times while driving - it lasts a few seconds and then goes off. My mechanic says oil pressure is good and suspects erroneous message. I also received that message once while the engine was not running, ignition on, listening to the radio. This seems t support erroneous message.
View 6 RepliesIt is a fairly new vehicle, Touareg SN 42xxx. It has two problems, which might be inter-related, both of which have defied all the repair attempts of a very competent and concerned dealership.
First problem: The warning message "Headlight Range Control" keeps on appearing. Much work has been done to try and fix this: Alignment of lights checked, suspension level sensors checked, vehicle inspected for damaged wires, etc. Later on in the process, both headlight assemblies and the instrument cluster were replaced. The message still appears.
Second problem: This is really minor, I only mention it because it might be related to the first problem. The instrument cluster trip computer (MFA) will not store accumulated mileage over a series of trips. In other words, if the car is stopped and started a few times, the trip computer will zero out.
Came back from car wash (probably no significance) pulled in garage turned off ignition and the title message came up in the center display. Car will not start. At this point I have no Vag Com and the car will not start.
View 2 RepliesUpon starting the car this morning this was displayed -
There was no driving done. The car was turned off, and turned back on a few minutes later and the message was no longer present. The overnight temps were around -15*F, so I'm not sure if that had anything to do with it. There was no other message displayed, but the coolant light flashed for a couple of secs during the initial start but not the follow-up. Coolant level is normal, and wasn't frozen.
Does it come on for multiple reasons or only one?
I have a question, regarding the 5.0 v10. When i accelerate from stop, it has a delay, and a slow start, something like it would start in 2nd gear, but it doesn't (it's in 1st). Is the torque somehow limited whet accelerating from a complete stop? Because while driving, the acceleration is instant, and drives normally.
View 9 RepliesI did the installation of the start/stop button and it works. However, I have some unresolved issues. I have done a search in the FAQ thread but could not find anything referring to the following:
1- When I lock the car, either with the fob or with the door buttons, the alarm will sound when I enter the car if I unlock it using the door handle sensors. I can disarm the alarm with the fob, but it is not disarming with the door handles. How can I solve this issue so that the alarm is disarmed with the door handles? Can this be solved using a VAG-COM?
2- When I turn on the alarm, either with the fob or the door handle, the alarm indicating light blinks for a few seconds, then goes steady, and then blinks normally. I had not noticed this steady light state before. My alarm, I think, always went straight to blinking and stayed blinking
.
3- When they gave me the car back the adviser said that the seat would not move and the trunk would not open. However, I think they ran down the battery because the interior light was on. The dash displayed the "start the car now" message.
a) I had an almost two hour drive back home, do you think that the battery recharged in that time?
b) Was there any lasting damage done to the battery?
c) Is it safe to charge the battery with a trickle charger or do I need a special and specific charger?
The trunk now operates OK and the start/stop button also works. I wish the alarm also did.
My Phaeton is experiencing issues with the temp sensor. After running the car for a while, then a brief stop (10 minutes or less) it refuses to start. (It cranks but does not start) After a while, it starts fine. No check engine light comes up.
A quick Vagcom read (not the dealer's Vagcom) does show the temperature sensor is reading really low temperatures where it shouldn't. We think this temp sensor gone awry is messing with the fuel mix.
So in the parts book, we see only one temp sensor coming off the radiator, is this a 'easy' fix or do I need the dealer involved?
Just bought this as a daily driver. This being my first truck and USED with over 100k in miles, I got it at a deal, but I am worried it might be a lemon. The engine is giving off 8 codes (listed below) that I pulled off my obd2 wifi scanner. This morning was a failure to start with all lights appearing on the dash. There is allot of accumulation around the terminals on the battery as well but the scanner read nothing about a faulty charge. I am trying to have my truck working soon so I can stop asking for rides ... broke down (5.4L triton straight piped )...
ERROR CODES:
P1131
P0171
P0174
P0316
P1151
P0401
2015 with 35,200K on the OD. All stock! Hasn't been modded in any way.
I've been throwing a P04DB ,only, code off and on for awhile now. And now, it's constant. I know there is a couple of other codes that can go along with this but I'm not getting them.
I've somewhat started tracking when the code would return after clearing it. In the last 2 days, I've cycled the engine on and off with the key only and no code.
It appears, that the only time the P04DB code sets is when I use the remote start. I'm still testing this theory but so far that's what seems to be happening.
I'm wondering if there is a slight voltage change when using the remote start that is causing this issue? I've read where this issue is not only a 6.7 issue or even just limited to Ford.
The other thing that really sucks about this issue is if the sensor is bad you just can't get a new sensor, you have to buy the whole crank case vent filter housing too. Brilliant I say, just brilliant.
I have since purchase of the car for 9 months ago enjoyed the use of the rsap functionality with my S6 connected over the Bluetooth.
Now without any knowable change of settings or update or hardware I got a no network message after connecting to the car.
The phone and the car are still connecting over BT and the phonebook is transferred and all the adjustments within DIS are working as before, I can even make a call but without connection to a network it won't work.
I know GP2s rsap is restricted to 2G networks and if I search networks manually with DIS , the car finds 2 of them, but can not connect none of them.
My service provider Comviq is telling me that there has not been any changes on the SIM card accessibility or newly implemented improvements or updates to Android.
They could anyhow confirm the 2G net being rather weak in the area and this could be the possible reason.
This morning when I went to start my car i got a Service Now message. Once the car was started it went off and didn't come back on. I have no warning lights present on the dash what so ever. I've never seen this before.
What does it mean? I have an 04 W12 with 60,120 miles. BTW I've had all service work done for the 60,000 service. Car is beyond up to date with it's service.
Today after leaving office I switched on the ignition and for the first time I see this massage "Immobilizer activated". I went out to look at the car and found some finger prints on the driver side window.
Is the car so sensitive to touch? Or the alarm was activated for some reason and some one tried to look inside the car?
After 3 trouble free years my car had a different TPMS problem, with TPMS FAULT message popping up. The dealer initially changed one or two sensors and then the most updated module. For 1 day there were no problems and while driving on the highway the malfunction warning came up again. Now they are suggesting it could be related to the tires that are not the original ones, but same size and specs and I have been driving on them for a year without any problems.
View 4 RepliesToday I had been driving about ten minutes when I got a "Check Gas Cap" warning, inclusive of beep and appropriate icon. Pulled over, switched off but left key in (this is equivalent to a warm boot in my experience), opened gas cap and closed again (it was fine). Turned engine on, got same message, remained on until destination (approximately 20 minute drive). Parked and locked car for approximately 2 hours (equivalent to a cold boot). When I turned on the engine again, the message was gone, and remained off for the rest of the day.
The car had been sitting unused in a heated garage for a little over two weeks, and the weather today was nice, sunny, a few degrees above freezing.
In my view, it clearly was not related to the classic "fuel cap not tight enough" problem of modern cars: for one, I had not just refueled (in fact, I have a little over half a tank). Also, I always tighten the cap until I hear at least a few clicks. SO I wonder if it might be an early warning that my maintenance battery is getting weak, i.e. spurious error message triggered by low voltage?
I haven't been able to find a discussion about failure or replacement of the oil level sensor. I'm getting a error message displayed each time I start the car. I took it into the dealer for an oil change. After they completed the change, they recommended replacing the sensor. I'm inclined to wait another 5k for the next service to do that. Diagnostics did not show any error codes. Doesn't make sense to me. just replace the sensor...
View 7 RepliesWhen I park my car and shift the selector into "P" the car will not allow me to remove the key until I jiggle the selector. I get a "please shift the selector into P"
After it's jiggled it unlocks, and I can then remove the key. I would prefer to fix it myself, rather than take it to the dealership.
I am having some difficulties with the stereo in my 03 W12.
Suddenly it stopped working.
When i press the cd button - I get a message that says that there is no cd player avaliable. When i press the radio button - I cant see any stations and there is no sound.