An OBD tester is reporting error code P1100. Checking online I have discovered that it is in reference to a Barometric sensor that is reading out of range. However, I cannot find any identification of the Toyota part number, its location, and whether or not it is a DIY replacement
View 1 RepliesSo, I've got a new toy (FORscan ODBII software) and a new code that isn't turning on the CEL (yet) but also didn't show up in OBDWiz either.
P1100 - Mass Air Flow (MAF) Sensor Circuit Intermittent
I cleared it, drove a few miles, checked again and it's set again.
The little troubleshooting advise window in FORscan says to monitor the MAF voltage while wiggling the MAF harness and see if the voltage goes below 0.23v or above 4.60v. I was unable to manually make that occur, no matter how I tapped on the MAF or wiggled the wiring.
However, in oscilloscope mode, look at this (at idle):
It sure looks like it went below 0.23v here. I have no time tonight to do any research. This is a relatively new MAF (one week old, Delphi unit). I think I'll swap it out for one of my two old OEM MAFs sometime this week. But if any opinion about this, pipe up. I do damned little work with scanners these days, and the tech keeps changing.
Went on a trip Sunday, and i saw my engine light come on after i put gas in the car. I pulled over, re-checked the gas cap, and it was fine. Car felt fine.
When i got home, i used my OBD2 scanner, and got the error P0304 Code - Cylinder #4 Misfire. I cleared the error and drove the car some more, no issues.
Yesterday, my wife took the car and she said it was hesitating and sputtering, but the light hasn't come back. I have an appointment at the dealer tomorrow, the car has under 80,000k, so the warranty should kick in.
Got the p0051 error code and its calling for a o2 sensor. What brand does lexus use? I rather get one on line but dealer quality.
View 12 RepliesI have a 2004 MK4 Golf 2.0l that's been throwing a CPS error code. My brother was going to come down to visit for a weekend. He had done some diagnostic work and had me order a timing kit and a camshaft position sensor from ECS.
So, with my assembled parts, I brought the car in to a reputable shop. Anyway, the guy does the work and now the car is ready and saying that the CPS took nearly 4 hours more of work.
Don't know the location of the MAP sensor for a 2008 Elantra 4-dr (HD)? I'm reading a DTC P1100, which indicates a manifold absolute pressure (MAP) sensor malfunction. The Haynes manual refers to this only being necessary for the previous model Elantra.
View 3 RepliesI have DTC code P0100 so I got to the camshaft position sensor and noticed oil in the sensor. I can't imagine an electrical sensor is a good place for oil.
View 7 RepliesMy car has been fine with no changes besides tires last week, its a 2006 Prius and yesterday I got lights on my dash, went to auto zone for a read out and got an HV error code. I was wondering what is the most affordable route for my car to get repaired. I don't notice any mpg differences and everything still charges and recharges as if the errors don't exist.
View 19 Replies2005, Gen 2 got check engine light. I've turned it off, will see if it reappears.
View 5 RepliesIts a 2009 Prius with about 75K miles on it. I have scangauge on the dash as well as mini-VCI. It is setting PO456 code time after time. I reset it, but it comes back in about 50 mils of driving. Its not the gas cap, I turn it until it clicks every time. Something is wrong with evaporative emissions system, which I wouldn't care about, except it might mask some other fault code that is more serious, as it keeps check eng. light on all the time.
View 7 RepliesHad my Check Engine light come on so I went by a local AutoZone to see if they could read the code. He said it was P0137, but what his reader can't tell is which one it is.
A co-worker pointed out where it was on my 2006 2.4, but I'm not sure if it's the sensor in the engine bay or the one closest to the catalytic converter. The engine bay looks easy to change out but I'm in no condition to be crawling around underneath.
Which sensor the P0137 is referring to?
I was driving home the other day and my CEL came on... I checked the gas cap and waited a few days to see if it cleared. When it didn't clear I had the codes read and it came back with 3 instances of P0505.
View 2 RepliesIn the last four months, I have been getting intermittent error code P0011 on my 2008 prius. I notice that it comes usually when I am going up/down a major hill or going really fast.
View 2 RepliesInstalled Rebuilt Hybrid Battery AND New 12v Yesterday. Worked great until just now. Got the cool Red Triangle and VSC... hooked up to that Cool code machine and got the P0AAC (Hybrid Battery Pack Air Temperature Sensor "A" Circuit).
What is this exactly and what should I do? If it's a simple fix, I'm sure I can do it with my dad ... after all, I did take and reinstall the battery myself. Also, is it going to hurt my car if I drive on it with this issue?
Car is 06 and has 211K miles.
I have a 2005 Prius with almost 244,000 mile and about a week and a half ago the check engine light came on. I went to an Advanced Auto and had them read the code for me, which came back with a P0505 error code. I have read several things on web that this code is a Idle Air Controller related.
I also have read that this could be to a loose or bad PCV valve, an air leak in the vacuum lines, throttle motor shaft might be binding, or a failed engine ECM.
The car runs and idle just fine, no stalling or a rough idling. The only problem that is obvious is that when the car is warm and I come to a stop or put in park, the motor will not shut off.
Which one of these would cause this to happen? Or could this be due to a MAF sensor that needs cleaned or replaced?
Just picked up a 2005 with 146k and full Toyota service history, although seems a steering recall was not done. Will run it to the dealer today to check. I need to decide a.s.a.p. if I am keeping the car or not (I know the seller, he will take it back)
Anyway to cut a long story short, two questions.
1) Car had P3190 and P0420 when I got it. Seller reset, drove home and within 5 minutes on the road the CEL was back on. Checked the codes at home and see only a P0420. Much to worry about? Seems this might be big (Cat) or small (O2). Car getting great mileage - 60mpg at 60mph and it seems to be running great. Should I worry or forget about it? Note I am in Florida with no inspections.
I had a bad Glow Plug on my 2004 F350 6.0L Diesel causing the check engine light to go on. I replaced the Glow Plug and cleared the OBD2 error. The check engine light is off now, but I can't pass the smog check because EGR Monitor "Not Ready"
I put 100+ miles city/freeway miles on the truck, but I still get EGR Monitor "Not Ready" Even tried "Drive Cycle" with no luck...
I have a 2004 Prius with 80k miles. Always has been a workhorse. Recently had a bad cell in the HV battery. Battery rebuilt with new cell and now works great.
Now it runs about 20 miles and then displays dash lights of red triangle and small exclamation (brake?) and VSC.
I took it to Advance Auto and their scanner reads C1310 'Malfunction in HV system'.
I actually replaced the entire HV battery again with the battery from my friend's car, and the 12V battery too, but no luck. Same error.
If i disconnect the 12v battery for a while, it will clear the code and the car runs fine for about 20 miles and then dash lights come on again.
Car runs perfectly, over 50mpg even with the dash lit up. What that code is?
I have a 2006 prius whose check engine light just came on 1 hour ago. I had it diagnosed and it is giving me the p1121 code, or the coolant flow control valve. I checked the coolant level and it was very low. I added fluid, but the CEL is still on. I have to make an 11 hour trip tomorrow.
View 19 RepliesI took my 2006 in for its 50,000 mile oil change today, and I was told I had the following codes related to the transmission and the park/neutral switch:
P0852 (System: Hybrid Control; shown as "hist," presumably historical)
C2315 (System: Transmission Control; shown as "curr," presumably current)
My car is running fine, and none of the dashboard lights have indicated any problem.
My car was working fine except for occasional no dash lights. Unfortunately where my dash lights don't work sometimes I can't see my gas gauge and I ran out of gas today. I manage to make it to the gas station on battery power I presume. Filled the tank up with 11 gallons and the car seemed to work fine for the remainder of my trip(about 5 miles). So I parked at my destination and went inside for 30 minutes and then I went back out and started the car. I attempted to clear the out of gas error code and all of a sudden a whole Christmas trees of lights popped on my dash. I rescanned and these codes were read out
U0293
u0100
u0111
u0293
p0a1d.
History : I had the coolant pump inverter changed 2-3 months ago by a mechanic and hybrid battery and battery ecu changed 2 years ago by myself.