I have a 2005 Santa Fe that for the last week or so has been slipping/jerking at about 2500rpms (2nd and 3rd gear). This only happens after the car has been warmed up and running for 20 minutes or so. I have put it into manual and it does not do this, only when in auto.
View 2 RepliesMy 2001 santa fe has recently had a new clutch fitted as the old one was slipping but, when towing our caravan at the weekend the clutch is playing up again but, this time the clutch is slipping at anything above 2500 rpm yet she is pulling fine below this rpm.
View 4 RepliesSo dont know whats going on, but after my santa fe sat for a day, I went to go for a drive and when I left the house, the tranny slipped in 1st gear at around 3k rpms. The rpms just shot up, hammered into 2nd, then drove off as normal.
I couldn't get it to repeat it after that.
Facts:
-Car in eco mode
-Car sat for at least 24 hours
-Outside temp 70F
-slippage happened on takeoff at 3k rpm
-No CEL's
-around 11500 miles
What it could be? Should i take it in to hyundai? OR wait and see how it drives the next couple days.
My Jaguar X-Type has a 5-speed manual transmission, and when I am driving and shift up, sometimes it starts jerking pretty violently like it might be slipping out of gear, and I have to shift into another gear to get it to stop. It seems to be exacerbated if I am accelerating. I can always get it to stop by shifting, but am afraid at some point that it will not slip into another gear and I'll be stranded. I had a mechanic look at it but he has no idea what is causing the problem and I don't want to pay for multiple repairs that may or may not fix the problem! The car's got about 125,000 miles.
View 2 RepliesThe son inlaw just bought a 86 4runner. It's been beat pretty good but I know Toys are good for it. My question is, it rev's just fine in every gear but 5th. Going down a flat highway and in 5th it won't rev over 2500 no matter how much gas ya give it. It has a 22re and 31-9.50's under it. My daughter had a 86 p/u with a 22r (I believe) and 33-10.50's and it had no problem hitting 90. Is there a limiter on these things? Thought i'd ask before chasing vac lines.
View 2 RepliesI drive a 2005 Kia Rio with 48,000 miles. Every once in awhile (particularly after a bit of driving when everything is warmed up) the RPM won't go past 2,500. I'll put it in 1st gear, accelerate till 2,500, but as soon as it gets there, the engine gets groggy, the car slows down, and I have to quickly switch to 2nd and repeat the cycle on every gear. Flooring it makes it worse.
Obviously the fastest I can possibly go with this happening is about 50mph on 5th (just below 2,500). This has happened three times and it has fixed itself every time so far.
A possible clue may be that the check engine light frequently comes on, and its always the same culprit: this "flow meter" sensor. I've had it replaced three times now, but it still always trips the engine light. I now just ignore the check engine light.
I have a Chrysler Sebring 2005Engine cuts out at 2500 spurts stutters can't go above 35 mph...But still runs... No cruise available will not come on.. Engine light on... Which I guess from what I read is normal In "limp mode" Got it home.. Shut it off.. Starts back up.. I'm thinking cam/crank shaft sensor? Both of those are new.. And an ECM all from a prior problem.. Or fuel pump.?? Not enough pressure to keep up with demand..
View 4 RepliesMy 2005 2.7L 6 cylinder Sebring with 100800 miles that was running fine just started jerking on me last week. It runs fine untill I get it up to 2750RPMs. Its like its getting gas, then not getting gas and jerks forward all in less than a second and then again, and again and again, until I drop the RPMs back down. Any clue on what I should be looking for?
View 4 RepliesYesterday as I crawled my way through heavy traffic on my drive home from work, my car started lurching unexpectedly. When I let up on the gas, the lurching subsided. I was able to recreate the behavior multiple times on my drive home, as well as while parked in my driveway. As the RPM exceeded 2500 the engine would lose oomph/power and the RPM would start stuttering/oscillating between ~2500 and ~2800 RPM. The behavior was identical regardless of which gear I was in (D1, D2, D3, D, or N), regardless of my speed, and regardless of how aggressively I was pressing the accelerator pedal. Every time the RPM hit 2500, the engine freaked out.
This morning, it did NOT happen when I tested it briefly. I was able to rev up to 3500-4000 RPM without any issues. I did read a case online in which someone experienced a similar issue that only manifested after the engine had been running a while. My car has ~173k miles on it, and this is its first engine issue. What might be causing this?
Video attached; also located here: [URL] ....
So my wife's santa fe will randomly get stuck in 3rd gear and not shift up or down (automatically or manually). It does not appear to be slipping as it speeds up slows down fine. The check engine light is on but have not read the codes yet.
View 5 RepliesHow do I take off the gear shift knob? I want to replace it with an aftermarket one.
View 1 RepliesTruck: 2001Ford F350 5.4 auto 4x4
Issue: Engine seems to free rev over 2500 RPMs. Barely hits 50 MPH. Revs fine in park, no power in gear. At 1/4 throttle it will move, but sluggish at best. Once you get around 2500 RPMs it stops accelerating and just revs. Does this in every gear, and gets worse the faster you go. feels like its stuck inbetween gears almost. No CEL's
Replaced: MAF, TPS, Trans fluid and filter, fuel filter, cleaned intake system, fuel system treatment, O2 sensors. Trans fluid was dark, but no burnt smell.
I'm about to pull the exhaust and look for a clogged cat.
Santa Fe - 2004 - 2.7 liter automatic fwd.
I am experiencing an occasional jerking or hesitation while sitting stopped at lights and it also has a tendency to do the same as I begin to move from a stop at times. It almost seems like the transmission slipping or something but likely more engine related I think as I am at a stop. I have felt this slightly while at speed as well but not that often, at least not yet. It also seems more noticeable as the weather get warmer as was very noticeable late last summer and did not present itself again until spring.
Also-I have read that some threads re stalling issues(not exactly what I have) that can be related to the crankshaft position sensor and also read somewhere a while ago about an issue re the ecm needing reprogramming but have not found that recently.
I have a 06 plate Santa Fe 2.2 diesel and i think the cluch is on its way out, keeps slipping out of gear and the pedal itself is not aligned with the other two, mileage is about 79K i think.
View 4 RepliesMy 2004 4 cyl Santa Fe the check engine light came on now it jerks in all gears kinda like its missing.
View 1 RepliesI have a 2005 2.0 litre petrol Santa Fe. I recently had it serviced and after this I started to have problems with it suddenly cutting out or stalling momentarily while driving. This happens randomly, sometimes at slow and other times at high speeds, often when accelerating but a couple of times in cruise. It only lasts a second or two and picks up immediately but can sometimes happen a few times in succession. It never happened before the service. The orange check light with the exhaust icon (Malfunction indicator Light?) comes on sometimes but I haven't noticed it all the time. This problem is getting worse, more frequent. I pushed the car a bit today in 4th gear up to about 3500 rpm and it happened quite badly, a few jerks in quick succession with the light coming on then back to normal for the rest of the trip.
I brought it back to the garage who did the service (not a main dealer, nor my usual mechanic) and they ran full diagnostics on it a couple of times. Nothing showed up, no error codes and nothing logged on the car's computer. They tested the emissions and found them to be perfect. They didn't change the fuel filter because it seems to be built into the petrol pump but did put something in the system that is supposed to clear out any deposits or whatever. Not sure what it's called but some sort of fuel additive. That was why I drove it hard today. They suggested doing that to try and clear out the system. Doesn't seem to have worked.
The bottom line is they don't know what's causing this so I'll have to take it to my own mechanic or else the main dealer. I'm wondering what could be the problem. From searching the forum it looks like the symptoms could be consistent with a failing CPS, an oxygen or throttle position sensor or a faulty ignition relay. I also think it could be to do with a clogged fuel filter, dirty petrol or perhaps water in the fuel tank; we've had tons of rain lately and the car is kept outside! Given it started happening after the service I wonder if they could have fitted something wrongly, used a faulty part, maybe a plug, or left something loose/disconnected. They have however gone through it thoroughly to try and find the fault so I imagine they would have turned up something like that.
Bought a 2006 2.4L Sante Fe a few months ago. Had a couple incidents of it jerking after descending the same hill in our neighbourhood. Have a 6 month warranty so brought it to mechanic. All their "scans" were showing everything working so they guessed at replacing the fuel pump and filter. A week later did the same thing but this time it stalled out and I had to jump start to get it back to garage. My wife scanned the internet and noticed other similar complaints. The crankshaft position sensor seemed to come up as being replaced in these incidences, and apparently the "scan" will not show it as failed if it is still somewhat operable. Based on that, we told the garage to replace it as they literally could not figure out what was wrong with the car, having driven it over several days for it to repeat the jerking and stalling we had experienced. It has only been a few days so here's hoping that was the answer.......
View 1 RepliesI have a 2001 Santa Fe that I am getting road ready for my son, The engine has recently started idling very high, 2500 RPM at startup. I disconnected the IAC servo and it drops right down to about 900 RPM. I replaced the IAC with a brand new one and it does the same thing at startup, 2500+ RPM. Checked vacuum hoses / tubes. I replaced 2 crack / dry vacuum hoses. Same problem for a while, then idle went down to about 1250. Started to drive it, test ride. while accelerating, seems OK as soon as I take my foot off of the gas, idle goes to 2500 - 3000 RPM until I apply brakes and then it drops back down to 1000 or so. (SOUNDS LIKE A VACUUM LEAK PROBLEM. I CANT FIND IT, IVE BEEN THROUGH 2 CANS OF CARB CLEANER AND HOURS OF REPLACING ALL VACUUM HOSES.)
View 2 RepliesMy 2005 Elantra is jerking soon after I accelerate. It does not jerk at any other time. It's not a hard jerk. Sometimes it doesn't jerk at all after acceleration. When it does jerk, the rpm jumps up too, and goes back down after the jerk.
I took it to a transmission shop and they checked the fluid and used a diagnostic thing to check the electrical components, all of which were fine. Is there another possible reason for this jerking?
2002 santa fe gls v6. I recently brought the car used and it appears to be in great shape with 135,000 miles, however the car has issues which I'm hoping are minor. Here are my questions:
The brake light and battery light stay illuminated, can this be a bad alternator? Speaking of alternator there is a rattling sound coming form the alternator area, do the bearings go bad? If it is the alternator, does it matter if I use a 95 or 110 amp? Is the alternator difficult to replace?
There is intermittent jerking when in drive. Is it possible that a malfunctioning alternator not delivering proper voltage can cause this type of issue possibly affecting the system computer? Could the jerking be due to something else like crank position sensor?
We have a 2010 Santa Fe AWD LTD with about 140, 000km on it. It recently came back from front suspension work. The suspension is fine now, but we notice harder shifts in the transmission. Also, there seems to be a vibration just before shifting gears and when under load (like going up hill) seems to slip (like on ice) about once every second until the shift is made. Once the shift is made it drive smoothly until put under pressure again. Even stepping down a bit on the accelerator will cause this slipping feeling (or maybe its loss of power). Just had new plugs put in and a tuneup so it's not that. Could something from the suspension work cause these symptoms?
View 29 Replies