Santa Fe (CM - 2007-12) :: Signal Lights Stop Flashing
Mar 19, 2014
I am having an issue with the turn signals on my 2010 Santa Fe. When changing lanes to the right and moving the turn signal lever up slightly, the turn signals activate normally. However, when releasing the lever, the signal lights stop flashing (as they should), but the flasher clicks at a rapid rate and won't stop. I have to jiggle the turn signal lever to get it to stop clicking. I have checked all lights and the bulbs are fine.
View 5 Replies
Advertisement
All my turn and hazard signals work normally when engaged but when it snaps back into the off position the turn signal (sound only) keeps going rapidly. It goes on and off randomly. It's the sound in the dash only. What it is? I can replace it myself I just need to figure out what it is.
View 44 Replies
I have a 2007 Santa Fe. I was at a drive thru when my instrument cluster started to go nuts.. all of the lights came on then started flashing.. the RPM gauge was bumping around too.. for a couple seconds.. then it went away.. the next day I was on the way home and it started to do the same thing as the motor began to lose power while climbing a hill then the transmission couldn't figure out which gear it wanted to be in then I could press the gas all the way but nothing would happen.. the battery was completely dead. so I replaced the battery an about a week later it did the same thing. I had the alternator checked out but it was fine..
View 7 Replies
Going down the highway the other day my '07 SE started to flash the battery and seat belt "dummy lights" in the instrument cluster. There was no discernible change in power, other lighting, or anything else that I can tell. The lights didn't seem to flash in any particular pattern either....
What this might be?.....other than gremlins?
View 38 Replies
I have a 2009 Sante Fe AWD: What it means when the battery and seat belt lights flash on the dashboard while driving? The headlights also dim slightly and sporadically as if there is a huge load on the system. No noticeably pull or drag while driving.
View 5 Replies
1998 F150 ....Left signal lights flash supper fast or not at all but if I pull the arm down (for left side again) but stop before it clicks in place, signal lights work normal. 4 ways work good; right side works good 95% of the time; all bulbs are good. So like Spotty suggested it's the signal arm switch? Does that sound right? Many years ago I changed it twice in my old Ford Taurus; twice because I was buying used from a wrecker.
View 6 Replies
2007 Santa Fe. Recently my turn signal has not been working. It seems to act finicky and not want to work every time I need it too. I noticed that this happened once every blue moon in the winter time when I purchased the vehicle new back in '07. However it has been occurring more frequently as of the past 3 days.
I have checked the fuse and it is fine. My hazard signals work when my turn signal works if that is any additional indication of what might be going on. What can be done to remedy the situation?
View 24 Replies
I've changed out all of my external lights for led's, including the turn signals. I had planned on replacing the turn signal relays with led comparable versions but have been unable to find the relays in the fuse boxes. The box that does the actual clicking under the dash seems like it could be it but it looks completely proprietary to this model, and not readily available in the compatible version.
I ended up installing resistors for now but that's caused other problems with my lights. Now when I turn my high beams on all 4 turn signals light up solid and I am unable to use them until I turn the highs off.
So, I would love to know if I do have a relay replacement option for my 2012 Santa Fe...
View 1 Replies
I bought a 1996 Toyota Camry this summer. While I was away, my parents would start it every once in a while, and the last time they did the lights would not stop flashing. The hazard lights, glove box, clock are all flashing. I have the battery disconnected until I can figure it out.
View 1 Replies
My wife's '07 has that fast-blink thing going on with the left turn signal. The thing is, none of the bulbs are out. It does appear that the front ones are dimmer than the ones on the right (which work fine).
View 8 Replies
I'm trying to figure out what has failed on my 2008 Santa Fe.
After stopping at a gas station today, my right turn signal came on and stayed on. By this I mean that the right turn arrow on the dash is illuminated and both the front and rear right turn signal bulbs are illuminated. They are all on steady, not flashing. Moving the turn signal stalk/switch does nothing. They all stay on when the car is turned off and the key removed. I have to disconnect the battery to get them to shut off. I tried pulling the turn signal, hazard and cluster fuses in the dash, but they had no effect. The switch for headlamps/park lights has no effect on the right side bulbs.
The left turn signal works normally.
Also, it may be related to having unplugged the battery a couple of times, but now the CD player shows "initializing" and I can't use it. The am/fm stereo works normally.
View 19 Replies
I cant find the location of the Turn signal relay, its not in the Relay box under the hood nor is it on the fuse panel under the dash, i'm planning on installing LED blinkers and i want to switch out the relay to a LED compatible one, where it is?
2008 Santa Fe GLS ....
View 8 Replies
My wife's 07 Santa Fe goes into limp mode while she's on the freeway. Had it towed to a mechanic. They report codes were: 0101, 0102, 1295, 2105, 2106, 2173. They said the sensors in the gas pedal were sending bad signal to throttle which burned out the actuator. So they wanted to replace throttle body and gas pedal sensors. They wanted $895.
Didn't seem right, so towed it to dealer. They said the first mechs were just guessing. Only the throttle body needs replacing. They wanted $960 total.
I bought a used throttle body off another 07 SF with similar vin number to avoid needing the ecm to be reprogrammed. Cost $225.
Couldn't find procedure for replacement in my pdf shop manual. Seems like this should be simple though. Anything special I need to know? Am I on the right track?
View 39 Replies
2008 GLS AWD, 2.7L w/ 66500mi. This happened on my way home from work this AM. Vehicle cold started normally, but I noticed a stumble as I idled out of my parking spot after a 12hr shift. All gauge indications looked OK. A few hundred yards down the road (and deep in the hood no less) I can feel an intermittent vibration/stumble and now I get the *FLASHING* (misfire) check engine light.
5am Sat morning and I'm already on the highway for my ~35mi ride home. The vehicle behaved OK, but you could feel a definite power loss, indicative of not firing on all 6. I hated to, but I had to drive it the whole ~35miles with the flashing CEL. I couldn't smell rich exhaust, nor did I notice any black smoke, etc.
Now I'm SOL. I have no warranty since I'm a subsequent owner (3rd owner of vehicle). Of course I lent out my generic code reader 2yrs ago and never got it back. My garage is currently upside down, tools packed away..etc. We just had a baby a few weeks ago and moved to a new house. Perfect timing.
View 18 Replies
My 2007 Hyundai Santa Fe right hand turn signal light bulbs flash rapidly both in the front and rear, the left hand side is normal. I am trying to locate the turn signal flasher module but without any luck, looked under the dash in the fuse box and under the hood in the relay box. Is it in the relay box...
View 7 Replies
I have a 72 F250. When I put the left turn signal on and apply the brakes, the signal stops blinking. I checked the bulb and it was fine. What is the likely cause?
View 2 Replies
I had a flat tire and used the spare. I took my 2007 santa fe in to the shop to get the tire replaced and an oil change. The 'shop' put the spare back where it belongs.
Now my keyless entry locks the doors (audible) but does not flash the lights or honk the horn. The lights flash when unlocking and when pressing the panic button. It all worked correctly when I dropped it off at the 'shop'. What to look for?
View 15 Replies
When I pull down on the turn signal to signal a left turn, my emergency lights turn on (both left and right blinkers). I tried to figure out whats going on but don't understand what to check/replace. I did notice though that if I don't pull all the way down on the turn signal then the left turn light blinks normally, but as soon as I pull down to activate it to blink on its own, it triggers both blinkers at the same time.
View 11 Replies
I have a 2008 Santa Fe with 64341 miles on it. This past weekend we had it inspected at the dealer. Drove it home, in the rain/snow, and it sat in the drive way for a day while it was raining. This morning when I went to go to work, still raining, the check engine light came on and was flashing. Went to auto zone to get the check engine light code, the said that it was a P0303 which according to them was a misfire in cylinder 3. So I brought it to the dealer to leave it and have them check it out. On the way their the check engine light started to flash, when I walked in and told the service desk that they said that it was a catastrophic failure.
View 10 Replies
I have a 2007 Passat with 60K on it and all maintenance kept up. Oil changes every 5K and all service done by a VW dealer. The car worked great yesterday when I drove it to the store but today its not responding at all. The car lights (parking in the rear only) and dash lights are flashing like a strobe and the car won't respond to the key fob. I don't have my blade key so I can't get access to the car. I suspect if I could disconnect the battery it would reset but I can't pop the hood without getting in the car.
View 2 Replies
I have a 2009 Santa Fe SE. When it is parked in the driveway a red flashing light is seen coming from the driver's side dashboard light sensor. I've searched the owner's manual and can't find anything about what it means. What it is?
View 21 Replies
