This problem started a month ago but was intermittant. Now the passenger window is down and I can not get it up. The keyless remote doesn't work at all. I open the drivers door with the key and I can open the drivers door and window from inside but not the passenger door or window.
It is now raining with my window open and a plastic trash bag over it.
2003 Sierra 2500HD crew cab, my keyless entry remote stopped working completely after I unplugged and connected some wires behind the glove box. I was digging around trying to find the cabin air filter, which I later found out this truck doesn't have one, when I unplugged some wires from a module so I could access the air box easier. I unplugged two plugs that had a handful of wires each, as well as 2 coax type cables. I re-connected all wires when I was done, but when I tried to use my keyless entry remote it didn't work. It worked perfect before this, less than an hour prior.
I had another remote battery so I went ahead and changed it, still didn't work. I tried reprogramming the remote by putting the truck in program mode with the procedure for this truck, but never got the truck to recognize the remote during this process.
I also disconnected the truck battery for 20 min, reconnected then tried reprogramming with same results, remote not recognized.
What the module is behind the glove box? Is it the BCM? Any reason unplugging these wires and plugging them back in would make my keyless entry stop working? I can't find any fuses related to keyless entry, and haven't noticed anything else on the truck not working properly. I really don't like going to a dealership, what else should I look at to diagnose this?
I have a 2003 Camry I4. My RKE stopped working. First I checked the battery in the remote, it reads 3v like it should. I searched and found how to reprogram the the receiver, so I tried that. I did the door and key dance and got to where when you pull the key out and the door locks lock then unlock. I try pushing the lock and unlock button, then just the lock button as per the instructions and I get nothing. Supposed to get one cycle of the locks if it works and tow cycles if it doesn't. I get neither of those, nothing happens. So I buy a new remote off of eBay (brand new, never used, OEM remote). I try the reprogram door dance again and get the same results. The battery in the new one reads 3v like it should as well. So I go off to a junk yard to replace the receiver door controller, I found one and replaced it and I get the same exact results.
View 8 RepliesI, like many, have had issues with my aux jack and decided to have it replaced with an aftermarket device. My aftermarket device plugs into the rear of the radio in place of the OEM aux harness. After removed the old OEM aux harness and installed the new one and put everything back together i had a problem.
The new AUX also comes with a USB slot as well and it all works properly, thats not the issue.
The issue is that my keyless remote has intermittently stopped working. I got out to lock the doors with the remote and nothing happened. I had no time to fiddle with it so i locked the doors via the keyhole and left it. The next time to went to my car, i tried to use the keyless and voila it worked! it locked AND unlocked. I was releived that it worked. Unfortunately once i drove and parked and tried to lock again - it didnt work . Needless to say it doesn't always work, ususally if i lock the doors with the key and come back more then 30 minutes, it unlocks keylessly.
The remote LED light turns on when i press any of the buttons so i know the battery is fine. I already opened the remote and confirmed the contacts are working properly. The only thing i haven't tried to do is reprogram the keyless remote (which i dont think is necessary).
Random symptoms - there are 3 circular dials (fan control, fan speed, temperature control) in the centre console. Originally ONLY the center dials LED lights would turn on. Now randomly the 3rd dials LED lights turn on again. I wanna start checking fuses but would like to know where to start.
My passenger side power window does not work from the drivers side control, but works from the passenger control. I replaced the master switch on the driver side and it still does not work. I have checked the fuses--Side, below and under the hood and have even found inline fuses below--all were good. Could the dealer have to program my new switch? I do not have child safety locks.
View 2 RepliesGot my car back today from the panel shop, everything was fine except for the auto up/down remote on the key that opens and closes the windows/sunroof by remote, this doesn't work, how to reprogramme it ?
View 16 RepliesI try the passenger window side switch and it doesn't work but the driver side switch does work for the passenger side. I got a new switch but it still is not working. I did take the child lock off already
View 20 RepliesThe passenger window on my 07 Santa Fe isn't working. I took everything apart and I even removed the motor from the door and it seems like there is just constant power going to the motor because when I plug it in the motor starts going even before I hit the switch.
I also removed the motor from the regulator too and the regulator seems fine and no cables are broken or off their wheels. When I do hit the window switch either way the window motor stops too. I'm not sure if my issue is on the driver side switch or the passenger side because both do the same thing...
Passenger side window has stopped working - the regulator was replaced about a year ago and I have tested it directly from the battery and it works up & down. I thought it unusual to have the drivers side and passenger side window switches to fail at the same time - is there a common relay I should find and replace - I am looking for a common circuit that both switches might travel through to this window motor.
View 3 RepliesI just tried to lower my passenger window, and it was completely dead. Driver's side works fine. Tried both the switch on driver's side and passenger side. Neither worked to lower passenger window.
Popped the hood and swapped out Pass & Driver's fuses. Pass side fuse is ok - ran the Driver's side ok.
Dropped the top and both windows ran down and back up ok. I'm guessing connection in driver's door(?). Maybe that switch for passenger window is bad?
I have a 2009 Sonata Limited. The passenger side front window has stopped working. Neither switch works. How to troubleshoot?
View 1 RepliesI have a 07 Sonata. The front passenger side power window is not working. How can I determine whether its the window motor or regulator?
View 1 RepliesAbout a year ago the passenger side window stopped working. It was not a huge problem and my husband kept telling me he would look at it. Well.......... as of last week none of the windows will work and the drivers side automatic lock button stopped working. I can lock and unlock it with the remote and the passenger lock button works. I just don't know. My husband looked at the wiring in the door joint and took the panel off and everything seemes secure. Also, the cd player is running an error message and I have had problems with the switch. This car is driving me crazy!!!!!!
View 1 RepliesI am looking at buying a 2004 Lariat and everything works beautifully on the truck with one exception, the passenger rear window. When the switch is pressed it not only doesn't move but there are no signs that the motor or regulator are working. The salesman grabbed the window and proceeded to say it was probably just "stuck". The window moves up and down about 1/4-1/2 an inch almost like it is not bolted to the track. Seeing as how I am new to this vehicle are there any common issues?
View 3 RepliesI have a 1999 GMC Jimmy. Today I rolled my power front passenger window down and it's still there. Main Control panel on driver side won't roll it back up and passenger switch won't roll it up either. All other windows and locks work fine and I do not hear anything when trying to roll the window up. Does this automatically mean the motor just went out all of a sudden?
View 3 RepliesThe window control panel on the driver side does not roll down my passenger window, but I can roll down the passenger window from the passenger side control, very strange.
I don't know if I have the window lock on or off, or something..
Passenger window just stopped working in closed position. Neither driver's or passenger's switch would operate it. Was told it was probably the motor. Replaced regulator and motor. Window went up from half way down position using driver's side switch, then back to not functioning at all. Window lock button off. Also, now the auto up/down for driver's window not working, needs to be depressed or lifted for open/close. Guess old motor and regulator were ok.
2005 HONDA ELEMENT 80,000 MI...
My sonata 2009 power windows for the rear passenger doors are not working. From the driver's master switch , i can control all 4 power windows with no problem. But if i go to the rear doors (LH and RH) and use the power window switch from there. The windows don't go up or done. There is no sound like the motor is moving. Not very familiar with power windows circuit. But base on the description, by deduction, does it mean the rear power windows switch is broken ? Is there anything that i should check also. Is there any sites that has a diagram on how the power windows are interconnected.
View 6 RepliesThe front passenger window on my 2007 Sonata has always been sluggish. Recently it broke (I heard something snap) when I tried to roll it down on a cold day. I decided I want to take a shot at fixing it myself before bringing it in to the mechanic. I've made some progress but I'm having trouble removing the inner door panel where the window regulator mechanism is.
The window can be pushed down or pulled up by hand fairly easily, but there's enough resistance (for now) to hold it in place and keep it from just dropping down into the door.
I removed the main door panel without any problems. The window regulator cables and mechanism are behind a second panel that I'm having trouble removing and I can see through the holes in the inner panel that the window is still attached to the two "lifters".
I haven't been able to find a lot of detailed instructions for this step. I've been following the steps outlined in some this youtube video [URL] ...., but there seems to be something I'm missing when I try to get the panel off.
I have freed the black adhesive around the edge of the panel, and I've removed all the main bolts on the inside of the door, the 3 bolts at the door latch, detached the inner door handle and removed the outer door handle, but I still can't get much movement in the panel to free it. I'm hesitant to tug or pry the panel too hard because I don't want to bend the metal at all and ruin the fit with the door.
Is there any trick to loosening the panel so that it comes out and I can get behind it? Do I need to slide or rotate it, or is it held by any clips similar to the ones that held the main door panel? Most of the resistance seems to be coming from the area to the right of the speaker (between the speaker and where the inside handle to close the door would be). I can try to provide more details if necessary.
My passenger window switch has stopped working. At first it did not want to open and close using the main switch on the driver door . (2008 1.6 3 door hatch). Then it also stopped operating on the single switch by the passenger door. Luckily its in a closed position. Is there any possible fixes, bar having to buy a new switch, as its proving hard to locate. Mostly main switches for the sedans available.
View 2 RepliesHow do I roll down my windows with keyless remote on 2007 Camry LE V6? Honda Accord has the press unlock twice and hold on the 2nd press. Does Camry have anything like that?
View 9 Replies